The use of landforms to predict the variability of soil and orange attributes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of lipopolysaccharides to characterize Bradyrhizobium spp.

Three methods of extraction of lipopolysaccharide (LPS) were compared-the conventional hot phenol-water method with 40% phenol, a modified form of this method using 10% phenol, and the hot saline method. Good recovery of LPS was achieved by each of the three methods, with the LPS found in the aqueous phase with the two phenol-based procedures. The application of SDS-PAGE to the LPS extracts, followed by silver staining, showed similar banding with all three methods of extraction. When the hot saline extraction LPS fraction from eight strains of Bradyrhizobium spp. and eight strains of Bradyrhizobium japonicum was compared with SDS-PAGE, characteristic profiles were achieved. Serological analysis of eight strains of Bradyrhizobium spp., using antisera prepared against whole cells in agglutination reactions, showed extensive sharing of antigens. When antisera was prepared using outer membrane LPS, extracted by the hot saline method, the amount of cross-reaction was reduced greatly. The results indicated that LPS provide an efficient means of obtaining monospecific antisera to be used for serological identification of strains of Bradyrhizobium spp. and that the hot saline extraction method is recommended for a fast, simple and efficient way to obtain LPS and characterize this bacterium.

Use of Rubidium to Label Lysiphlebus testaceipes (Hymenoptera: Braconidae), a Parasitoid of Greenbugs (Homoptera: Aphididae), for Dispersal Studies

A reliable method of labeling is needed to study dispersal of the braconid parasitoid, Lysiphlebus testaceipes (Cresson), an important biological control of greenbugs, Schizaphis graminum (Rondani), on grain sorghum, Sorghum bicolor (L.) Moench. The feasibility of using aqueous solutions of rubidium chloride (RbCl) applied as a foliar spray or soil drench to label greenbugs and L. testaceipes developing within greenbugs was studied. Laboratory and field studies were conducted to identify the minimal concentration of RbCl to assure labeling of greenbugs and wasps, persistence of Rb throughout the wasp's life span, mobility of Rb to unsprayed sorghum leaves, and feasibility of studying dispersal using a release-recapture technique with Rb-labeled wasps. Both greenbugs and wasps could be labeled using RbCl at concentrations of 2,500-10,000 ppm. Rubidium content in labeled wasps did not significantly vary during the first 7 d after emergence. Greenbugs feeding on unsprayed leaves were labeled up to 4 wk after leaves were sprayed. Rb-labeled wasps were found at the maximum trap distance from the release site (60 m) within 1 d after release.

The use of CPT to evaluate the effect of helical pile installation in tropical soils

The uplift capacity of helical piles depends on the shear resistance of the soil above the helical plates. During helical pile installation, the soil traversed by the plates are sheared and displaced laterally, and consequently the soil structure is disturbed. Considering this fact, the aim of this paper is presenting the effect of helical piles installation in the soil mass by means of CPT tests carried out close to the soil cylinder above the pile helices. The CPT tests were performed at the CRHEA site from the Sao Carlos School of Engineering, Sao Carlos city, inland of Sao Paulo State, Brazil. In addition, an interpretation of CPT tests data for stratigrafic logging are presented and compared to Standard Penetration Tests (SPT) carried out at this site. This study showed that the CPT sleeve friction fs data were affected by the installation of helical pile in this particular tropical soil site. © 2013 Taylor & Francis Group.

Fat body, hemolymph and ovary routes for delivery of substances to ovary in Melipona quadrifasciata anthidioides: Differences among castes through the use of electron-opaque tracers

The yolk protein precursor, vitellogenin (Vg), in bees is synthesized in the fat body trophocytes, delivered to the hemolymph and ultimately absorbed from there during the vitellogenic phase of oocytes in the active ovary. The routes tracing the material exchange that occurs between the trophocytes and the hemolymph, in addition to the transportation from the hemolymph to the ovarian follicles, were marked by alkaline phosphatase and lanthanum nitrate (LN). Active ovaries from nurse workers and physogastric queens, as well as inactive ovaries of virgin queens, were examined by transmission electron microscopy. The LN permitted better visualization of the routes of exchanges between the organs and the hemolymph. Both methods demonstrate the apparent differences between the phases of the ovary and the bee caste. In inactive ovaries of the virgin queens, the routes from the follicular epithelium to the oocyte remain closed; conversely, they are open in active ovaries of the nurse workers and physogastric queens. The differences between the methods and classes of bees are discussed. © The Author 2013. Published by Oxford University Press [on behalf of The Japanese Society of Microscopy]. All rights reserved.

Use of PCR to estimate the prevalence of Equus caballus papillomavirus in aural plaques in horses

Aural plaques occur on the skin of the medial surface of the pinnae of horses. In this study the presence of Equus caballus papillomavirus (EcPV)-3 and -4 DNA was assessed in 45 such plaques using a 'touchdown' PCR. Papillomaviruses (PVs) were detected in 62.3% (28/45) of samples: EcPV-3 and -4 DNA in 8.89% (4/45) and 37.78% (17/45) of samples, respectively, with 15.56% (7/45) of samples exhibiting co-infection. Viral DNA was not detected in 37.78% (17/45) of samples, suggesting the possible existence of other equine PVs. Neither EcPV-3 nor -4 were detected in negative control skin. This study is the first to evaluate the prevalence of these two viruses in equine aural plaques. © 2013 Elsevier Ltd.

Fluid-dynamic assessment of sugarcane bagasse to use as feedstock in bubbling fluidized bed gasifiers

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

What is the best additive to use at the ensiling of sugarcane SP81-3250?

Our objective was to determine the best additive to use for the ensiling of sugarcane SP81-3250 based on the nutritional properties and aerobic stability of the silages. The additives evaluated were (1) and (2): salt (NaCl) at rates of 1.0 or 2.0 kg/100 kg fresh sugarcane (as-is basis), respectively; (3) and (4): quicklime (CaO) at rates of 1.0 or 2.0 kg/100 kg fresh sugarcane, respectively; (5) and (6): commercial inoculants Silobac (R) and Maize All (R); and a control treatment. The addition of quicklime reduced the NDF and ADF contents of the silages by 11% compared with the control treatment, but did not increase the digestibility. On the other hand, after 24 h of in vitro fermentation, the application of 1.0 and 2.0% salt reduced the gas production by 34.15 and 33.55 mL/g OM, respectively, and the IVOMD was reduced 5.74 and 5.90%, respectively, compared with the untreated silage. Moreover, the addition of quicklime elevated the pH of the sugarcane silages, with a trend towards an increase in the DM recovery. In contrast, the bacterial inoculants did not alter the pH values, but there was an upward trend for a DM recovery. After the silos were opened, the silages that were treated with salt (independent of the dose) and 1.0% quicklime exhibited greater stability. We recommend applying 1.0 kg of quicklime to each 100 kg of sugarcane at the time of ensiling to improve the nutritional characteristics of sugarcane silage variety SP81-3250.

The association of chlorhexidine digluconate and calcium chloride to use as vehicle of a silicate calcium-based cement

Objective: The purpose of this study was to evaluate the influence of the addition of 2% chlorhexidine digluconate (CHX) associated with 5% calcium chloride (CaCl2 ) on antimicrobial activity, setting time, pH and calcium release of gray mineral trioxide aggregate (GMTA). Materials and Methods: GMTA powder was mixed with water, 2% CHX alone or 2% CHX combined with 5% CaCl2 . Antimicrobial activity was determined against Enterococcus faecalis (ATCC 29212) strains by agar diffusion test. Data obtained were submitted to kruskal wallis tests. Analysis of the setting time was evaluated by American society for testing and materials C266-03 requirements. The pH and calcium release analysis were evaluated, in 24 h, 7, 14 and 28 days using pH meter equipment and atomic absorption spectrophotometer, respectively. Data obtained were analyzed by ANOVA, in 5% significance level. Results: Significant differences were seen (P < 0.01) among the zones of bacterial growth inhibition produced by 5% CaCl2 + 2% CHX combination against E. faecalis when compared with water (P < 0.05). Regarding the setting time, that combination had the shortest setting time (P < 0.05). All associations were alkaline and released calcium. No statistical difference was observed between the experimental groups at the different periods of analysis (P > 0.05). Conclusion: Combination of 5% CaCl2 + 2% CHX reduced the setting time and enhanced the antimicrobial activity of GMTA without changing the pH and calcium release.

Use of probiotics to reduce faecal shedding of Shiga toxin-producing Escherichia coli in sheep

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The use of grafting to improve the net photosynthesis of cucumber

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

RB34-6 The Relation of Drouth to Water-Use in Nebraska

Three severe drouths have occurred in Nebraska and adjacent states within the past eighty years, and less severe ones have come at moderately regular intervals. Their influence on the agricultural development of the state is well known, but their relation to water supply in general is not so well understood. This research bulletin is a brief review of the relation of drouth to soil moisture, surface water, and groundwater supplies.

Use of Chlorine to Remove Magnesium from Molten Aluminum

Removal of Mg from aluminum scraps, known as demagging, has been widely applied in the,aluminum industry. This work discusses bubble-formation theories and magnesium kinetic removal from aluminum scraps using chlorine and inert gas fluxing. The interfacial area of the bubbles and residence time were estimated using a mathematical model. To inject gaseous chlorine, three types of nozzles were used with varying internal diameter. In addition, a porous plug, as well as varying input chlorine flow and concentration were used. The use of lower chlorine concentration improves efficiency because the interfacial tension is reduced therefore, more and smaller bubbles are formed. The model proposed herein is consistent with the experimental data. [doi:10.2320/matertrans.M2011256]