Indução a espermiação do mandi-pintado, Pimelodus britskii no período reprodutivo (Teleostei: Pimelodidae)

Pós-graduação em Aquicultura - FCAV

Chromatic changes to artificial irises produced using different techniques

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Time reduction of light curing: Influence on conversion degree and microhardness of orthodontic composites

Introduction: The aim of this study was to assess the influence of curing time and power on the degree of conversion and surface microhardness of 3 orthodontic composites. Methods: One hundred eighty discs, 6 mm in diameter, were divided into 3 groups of 60 samples according to the composite used-Transbond XT (3M Unitek, Monrovia, Calif), Opal Bond MV (Ultradent, South Jordan, Utah), and Transbond Plus Color Change (3M Unitek)-and each group was further divided into 3 subgroups (n = 20). Five samples were used to measure conversion, and 15 were used to measure microhardness. A light-emitting diode curing unit with multiwavelength emission of broad light was used for curing at 3 power levels (530, 760, and 1520 mW) and 3 times (8.5, 6, and 3 seconds), always totaling 4.56 joules. Five specimens from each subgroup were ground and mixed with potassium bromide to produce 8-mm tablets to be compared with 5 others made similarly with the respective noncured composite. These were placed into a spectrometer, and software was used for analysis. A microhardness tester was used to take Knoop hardness (KHN) measurements in 15 discs of each subgroup. The data were analyzed with 2 analysis of variance tests at 2 levels. Results: Differences were found in the conversion degree of the composites cured at different times and powers (P < 0.01). The composites showed similar degrees of conversion when light cured at 8.5 seconds (80.7%) and 6 seconds (79.0%), but not at 3 seconds (75.0%). The conversion degrees of the composites were different, with group 3 (87.2%) higher than group 2 (83.5%), which was higher than group 1 (64.0%). Differences in microhardness were also found (P < 0.01), with lower microhardness at 8.5 seconds (35.2 KHN), but no difference was observed between 6 seconds (41.6 KHN) and 3 seconds (42.8 KHN). Group 3 had the highest surface microhardness (35.9 KHN) compared with group 2 (33.7 KHN) and group 1 (30.0 KHN). Conclusions: Curing time can be reduced up to 6 seconds by increasing the power, with a slight decrease in the degree of conversion at 3 seconds; the decrease has a positive effect on the surface microhardness.

Bleaching effectiveness, hydrogen peroxide diffusion, and cytotoxicity of a chemically activated bleaching gel

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Using phenological cameras to track the green up in a cerrado savanna and its on-the-ground validation

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Novos parâmetros para o clareamento dental: avaliação da eficácia, citotoxicidade e efeitos moleculares

Pós-graduação em Reabilitação Oral - FOAR

Efeito de diferentes fontes luminosas e pré-condicionamento do esmalte na alteração de cor, penetração de H2O2 e citotoxicidade em dentes clareados

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Caracterizaçãode biofilme àbase de zeína e ácido oléico adicionado de nanocarbonato

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

A cor do citrino: efeito de irradiação e tratamento térmico

Quartz crystals under natural or artificial irradiation can acquire dark shades and variations btween smoky, black and brown but when submitted at heat-treatment they can become greenish, yellowish or brownish, called citrine at gem shops. In this work a lot of samples was collected from different places in Brazil (Corinto - MG, Diamantina - MG, Sento Sé - BA and Santana do Araguaia – PA) and at first they were submitted at artificial irradiation resulting in dark colours. After that they were submitted at heat-treatment in differents temperatures and time of exposure to record when color change happened to light colours. It variated according to each origin, temperature, time of expousure and different aluminiun and other chemical elements content. Its was possible to define the ideal conditions to results better colours and related it with geology and chemical quartz composition.

Desenvolvimento de recobrimento submicrométrico de óxido de nióbio para aplicação em tubulações de prospecção de petróleo

Pós-graduação em Engenharia Mecânica - FEG

Influência da concentração de peróxido de hidrogênio nos agentes clareadores na cor e penetração através da estrutura dental

Pós-graduação em Odontologia Restauradora - ICT

Fotocromismo e luminescência de compostos a base de tungstênio e íons terras raras trivalentes via síntese hidrotérmica

Pós-graduação em Química - IQ

Efeito da escovação dentária no manchamento de braquetes estéticos cerâmicos

Objective: this study aimed to analyze the in vitro effect of brushing on the color stability of ceramic brackets immersed in dye solutions. Materials and Methods: seven ceramic brackets of four commercial brands were tested: two monocrystalline and two polycrystalline. The parameters of color were obtained by spectrophotometer before and after 21 days of immersion of the brackets in coffee, red wine, Coca-Cola, black tea and artificial saliva. Another group of brackets of each brand were also immersed in the same solutions and for an equal time to the previous group, but with intervals of daily brushing performed by a toothbrushing machine (Mavtec). The data were evaluated by analysis of variance, multiple comparison tests for means and Student's t-test. Results: the mean color change of the brackets without brushing ranged from 0.46 to 7.61, while in the group with brushing these means ranged from 0.36 to 2.50. The staining still remained noticeable (change of color greater than 3.7) for all brackets when immersed in black tea. Conclusion: daily brushing helped significantly in the color stability of ceramic brackets, maintaining the color change to levels considered not visible to the human eye, except for the solution of black tea in which the staining remained relevant.

Clareamento para dentes despolpados: revisão de literatura e considerações

The esthetics of the teeth is not a privilege of our days, because concerns in that effect have been reported since 1860. Faced with an endodontically treated tooth that presents any type of color change, professionals can use intracoronary bleaching, which is more conservative attempt to restore the normal color of teeth. Bleaching aims to remove pigments by oxidizing agents and for that, various techniques were developed. Among the risks of tooth whitening the external resorption is the most severe, which occurs when the whitening penetrates through the dentin tubules to the periodontal ligament and initiates an inflammatory response. To prevent external resorption is required to place an intracoronal bleaching barrier. It is important to know the time between the bleaching treatment for restoring procedure for getting a good sealing to prevent microleakage. This study aims to review the literature about the different types of bleaching agents and their risks.

Violence against children and adolescents: the importance of knowledge of the spectrum of bruise colors in its diagnosis

Introduction: One of the violence types more observed against children is the physical abuse, which produces many types of traumatic injuries. Contusions are common trauma signs and may indicate aggression when frequently present in locations where accidental injuries are rare. Contusions in skin undergo color changes with the passage of time, and such change in color is called “spectrum of bruise colors of Legrand du Saulle”. Thus, it is possible to estimate the age of the lesion based on the evaluation of color. Injuries caused by child abuse often reach regions of head, face and neck, because they are exposed and easily accessible. Therefore, the dentist is responsible with regard to the diagnosis and the actions to be undertaken against the cases of child abuse. Objective: To present and discuss the significance of the spectrum of bruise colors as a considerable visible trace in suspicion of violence against children and adolescents, during dentists’ clinical routine. Literature review: The study of the “spectrum of bruise colors of Legrand du Saulle” refers to the estimation of the age of the injury, in respect to the color change. The application of this study is of great value for identify if a lesion occurred from a single incident or from multiple incidents, especially in cases where it occurs in the same region of the body, indicative of repetitive trauma. Conclusion: The spectrum of bruise colors is very important for health professionals, such as dentists, for the identification or suspicion of cases of abuse against children and adolescents. As great part of the lesions originated of abuse involve the areas of head and neck, it is unacceptable that these professionals are unaware of the basic signs to help in early diagnosis, which is the case of the colors of the lesions. However, concerning the chronology of the spectrum of bruise colors, it is not possible to establish rigorous times.