Image quality assessment and medical physics evaluation of different portable dental X-ray units

Introduction: Recently developed portable dental X-ray units increase the mobility of the forensic odontologists and allow more efficient X-ray work in a disaster field, especially when used in combination with digital sensors. This type of machines might also have potential for application in remote areas, military and humanitarian missions, dental care of patients with mobility limitation, as well as imaging in operating rooms. Objective: To evaluate radiographic image quality acquired by three portable X-ray devices in combination with four image receptors and to evaluate their medical physics parameters. Materials and methods: Images of five samples consisting of four teeth and one formalin-fixed mandible were acquired by one conventional wall-mounted X-ray unit, MinRay (R) 60/70 kVp, used as a clinical standard, and three portable dental X-ray devices: AnyRay (R) 60 kVp, Nomad (R) 60 kVp and Rextar (R) 70 kVp, in combination with a phosphor image plate (PSP), a CCD, or a CMOS sensor. Three observers evaluated images for standard image quality besides forensic diagnostic quality on a 4-point rating scale. Furthermore, all machines underwent tests for occupational as well as patient dosimetry. Results: Statistical analysis showed good quality imaging for all system, with the combination of Nomad (R) and PSP yielding the best score. A significant difference in image quality between the combination of the four X-ray devices and four sensors was established (p < 0.05). For patient safety, the exposure rate was determined and exit dose rates for MinRay (R) at 60 kVp, MinRay (R) at 70 kVp, AnyRay (R), Nomad (R) and Rextar (R) were 3.4 mGy/s, 4.5 mGy/s, 13.5 mGy/s, 3.8 mGy/s and 2.6 mGy/s respectively. The kVp of the AnyRay (R) system was the most stable, with a ripple of 3.7%. Short-term variations in the tube output of all the devices were less than 10%. AnyRay (R) presented higher estimated effective dose than other machines. Occupational dosimetry showed doses at the operator`s hand being lowest with protective shielding (Nomad (R): 0.1 mu Gy). It was also low while using remote control (distance > 1 m: Rextar (R) < 0.2 mu Gy, MinRay (R) < 0.1 mu Gy). Conclusions: The present study demonstrated the feasibility of three portable X-ray systems to be used for specific indications, based on acceptable image quality and sufficient accuracy of the machines and following the standard guidelines for radiation hygiene. (C) 2010 Elsevier Ireland Ltd. All rights reserved.

Attempts to Improve Xenodiagnosis: Comparative Test of Sensibility Using Rhodnius neglectus, Panstrongylus megistus, Triatoma vitticeps and Triatoma infestans in Endemic Areas of Brazil

From June 1984 to July 1992, 392 xenodiagnostic tests were applied on 264 patients with chronic Chagas disease from Brazilian endemic areas of Virgem da Lapa and Coronel Murta, situated in the Jequitinhonha Valley, in the State of Minas Gerais. The susceptibilities of Rhodnius neglectus, Panstrongylus megistus, Triatoma vitticeps and Triatoma infestans were compared. Most of the time 20 nymphs (fourth instar) of each species were applied to 161 women and 103 men aged between 5 and 83 years of age. The tests were prepared to compare the susceptibilities of two species at a time, using the same patients for each test. Results showed a xenopositiveness of 26.28% (103 tests) being 27.98% in women (68 positive in 243 applied tests) and 23.49% in men (35 positive in 149 applied tests). The relative frequency of xenopositiveness displayed a great superiority of P. megistus and T. vitticeps. In tests from type I, for example, P. megistus was the unique responsible for 10.73% of positive xenodiagnosis vs. only 0.98% in T. infestans. Other parameters analized in this work confirm this superiority, and corroborate that T. infestans can be replaced by P. megistus and /or T. vitticeps in order to upgrade the efficacy of xenodiagnosis

Floristic composition of two wetland forests in Araguaian Plain, State of Tocantins, Brazil, and comparison with other areas

Seasonally inundated native forest fragments ("ipucas") located in natural landform depression swales of the Araguaian Plain are currently under land use pressure. Their composition needs to be better understood to guarantee their protection. This comparative study of fragments under different land use conditions was carried out at Lago Verde Farm, Lagoa da Confusão,Tocantins, Brazil. The location coordinates are UTM 643586 and 644060 East and 8792795 and 8799167 North. This study aimed to first analyze and compare the floristic composition of two seasonally inundated forest fragments of approximately one hectare each. The first is located in an intact (without human intervention) Gramineous-Woody Savanna region and the second in a rice cultivation region. The floristic composition of both fragments was then compared to that of other wetland forests located in the Northern, Central Western and Southeastern regions of Brazil.All the floristic compositions are affected by seasonal flooding and soil water saturation. The floristic inventory used a census method that sampled all trees and shrubs with perimeter at 1.30 m from soil (PAP) = 15cm; 665 individuals, 33 families and 49 species were recorded for the intact region and 807 individuals, 35 families and 70 species for the altered region fragment. The values of H' = 0.806 (Shannon-Weaver) and J = 3.44 nats /individual (equability) for the fragment in the region affected by rice cultivation are considered high compared to the intact region fragment values (H' = 0.761 and J = 2.97). Families contributing to floristic richness in the altered region fragment were Fabaceae (9 species), Vochysiaceae (6) and Annonaceae (4). In the intact region fragment, Fabaceae also presented the largest number of species (8) followed by Arecaceae, Chrysobalanaceae and Vochysiaceae (3 each). When comparing the forests from various regions in Brazil, floristic similarity was found to be small. Greater similarity was found when indices for the two Lagoa da Confusão fragments were compared to riparian forests located in the Federal District of Brasilia.

A quantitative approach to evolution of music and philosophy

The development of new statistical and computational methods is increasingly making it possible to bridge the gap between hard sciences and humanities. In this study, we propose an approach based on a quantitative evaluation of attributes of objects in fields of humanities, from which concepts such as dialectics and opposition are formally defined mathematically. As case studies, we analyzed the temporal evolution of classical music and philosophy by obtaining data for 8 features characterizing the corresponding fields for 7 well-known composers and philosophers, which were treated with multivariate statistics and pattern recognition methods. A bootstrap method was applied to avoid statistical bias caused by the small sample data set, with which hundreds of artificial composers and philosophers were generated, influenced by the 7 names originally chosen. Upon defining indices for opposition, skewness and counter-dialectics, we confirmed the intuitive analysis of historians in that classical music evolved according to a master apprentice tradition, while in philosophy changes were driven by opposition. Though these case studies were meant only to show the possibility of treating phenomena in humanities quantitatively, including a quantitative measure of concepts such as dialectics and opposition, the results are encouraging for further application of the approach presented here to many other areas, since it is entirely generic.

Occurrence and severity of concomitant injuries in other areas than the face in children with mandibular and midfacial fractures

To clarify the occurrence, causes, severity, and predictors of concomitant injuries in pediatric patients with facial fractures.

Paleoglaciated landscapes in Simen and other high-mountain areas of Ethiopia

In the present-day Ethiopia, glaciated landscapes do not exist, but paleoglaciated landscapes have been documented on a few mountain tops, which have altitudes higher than about 4,350 m asl in northern Ethiopia (Simen Mountains) and about 4,100 m asl in southern Ethiopia (Arsi and Bale Mountains). Glaciers were associated with the Late Pleistocene cold stages and reached as far down as 3,760 m asl in northern and 3,200 m asl in southern Ethiopia. Bale Mountains had the most extensive Late Pleistocene glaciation, covering over 190 km2, followed by Arsi Mountains (about 85 km2). In Simen, the Late Pleistocene glaciers covered merely 13 km2. In addition, paleo-periglacial slope deposits are found on all above-mentioned paleoglaciated mountains and in further mountain systems which did not host glaciers. This allows the reconstruction of the Late Pleistocene paleoclimate as being about 8 °C colder than at present (2014), much more dry, and probably without monsoon, at least in northern Ethiopia. Most probably in the Early Holocene, the re-emergence of monsoonal rains led to a strong erosion phase, which was followed by an extended stable phase with soil formation, building up about 70-cm-deep A-horizons (Andosol) on the paleo-periglacial slope deposits. These soils have been heavily degraded due to human-induced soil erosion up to about 3800 m asl since agriculture started several decades to millennia ago.

Evaluation of Polymer Gel Dosimeters for Measurements of Dose and LET in Proton Beams

This project assessed the effectiveness of polymer gel dosimeters as tools for measuring the dose deposited by and LET of a proton beam. A total of three BANG® dosimeter formulations were evaluated: BANG®-3-Pro-2 BANGkits™ for dose measurement and two BANG®-3 variants, the LET-Baseline and LET-Meter dosimeters, for LET measurement. All dosimeters were read out using an OCT scanner. The basic characteristics of the BANGkits™ were assessed in a series of photon and electron irradiations. The dose-response relationship was found to be sigmoidal with a threshold for response of approximately 15 cGy. The active region of the dosimeter, the volume in which dosimeter response is not inhibited by oxygen, was found to make up roughly one fourth of the total dosimeter volume. Delivering a dose across multiple fractions was found to yield a greater response than delivering the same dose in a single irradiation. The dosimeter was found to accurately measure a dose distribution produced by overlapping photon fields, yielding gamma pass rates of 95.4% and 93.1% from two planar gamma analyses. Proton irradiations were performed for measurements of proton dose and LET. Initial irradiations performed through the side of a dosimeter led to OCT artifacts. Gamma pass rates of 85.7% and 89.9% were observed in two planar gamma analyses. In irradiations performed through the base of a dosimeter, gel response was found to increase with height in the dosimeter, even in areas of constant dose. After a correction was applied, gamma pass rates of 94.6% and 99.3% were observed in two planar gamma analyses. Absolute dose measurements were substantially higher (33%-100%) than the delivered doses for proton irradiations. Issues encountered while calibrating the LET-Meter gel restricted analysis of the LET measurement data to the SOBP of a proton beam. LET-Meter overresponse was found to increase linearly with track-average LET across the LET range that could be investigated (1.5 keV/micron – 3.5 keV/micron).

Survey on integration of Applied Geology and Geomorphology in Civil Engineering curricula in the framework of the European Higher Education Area (EHEA) by using practical trips

The engineer must have sufficient theoretical knowledge to be applied to solve specific problems, with the necessary capacity to simplify these approaches, and taking into account factors such as speed, simplicity, quality and economy. In Geology, its ultimate goal is the exploration of the history of the geological events through observation, deduction, reasoning and, in exceptional cases by the direct underground exploration or experimentation. Experimentation is very limited in Geology. Reproduction laboratory of certain phenomena or geological processes is difficult because both time and space become a large scale. For this reason, some Earth Sciences are in a nearly descriptive stage whereas others closest to the experimental, Geophysics and Geochemistry, have assimilated progress experienced by the physics and chemistry. Thus, Anglo-Saxon countries clearly separate Engineering Geology from Geological Engineering, i.e. Applied Geology to the Geological Engineering concepts. Although there is a big professional overlap, the first one corresponds to scientific approach, while the last one corresponds to a technological one. Applied Geology to Engineering could be defined as the Science and Applied Geology to the design, construction and performance of engineering infrastructures in and field geology discipline. There has been much discussion on the primacy of theory over practice. Today prevails the exaggeration of practice, but you get good workers and routine and mediocre teachers. This idea forgets too that teaching problem is a problem of right balance. The approach of the action lines on the European Higher Education Area (EHEA) framework provides for such balance. Applied Geology subject represents the first real contact with the physical environment with the practice profession and works. Besides, the situation of the topic in the first trace of Study Plans for many students implies the link to other subjects and topics of the career (tunnels, dams, groundwater, roads, etc). This work analyses in depth the justification of such practical trips. It shows the criteria and methods of planning and the result which manifests itself in pupils. Once practical trips experience developed, the objective work tries to know about results and changes on student’s motivation in learning perspective. This is done regardless of the outcome of their knowledge achievements assessed properly and they are not subject to such work. For this objective, it has been designed a survey about their motivation before and after trip. Survey was made by the Unidad Docente de Geología Aplicada of the Departamento de Ingeniería y Morfología del Terreno (Escuela Técnica Superior de Ingenieros de Caminos, Canales y Puertos, Universidad Politécnica de Madrid). It was completely anonymous. Its objective was to collect the opinion of the student as a key agent of learning and teaching of the subject. All the work takes place under new teaching/learning criteria approach at the European framework in Higher Education. The results are exceptionally good with 90% of student’s participation and with very high scores in a number of questions as the itineraries, teachers and visited places (range of 4.5 to 4.2 in a 5 points scale). The majority of students are very satisfied (average of 4.5 in a 5 points scale).