Effects Of Preservation On Wet Weight Dry-Weight Nitrogen And Carbon Contents Of Calanus-Helgolandicus (Crustacea Copepoda)

The lengths, wet and dry weights, nitrogen and carbon contents of fresh, frozen and formaldehyde-fixed specimens of Calanus helgolandicus (Claus) were determined. Samples were collected during May 1980 in the Celtic Sea. Individual Copepodite Stages 3, 4, 5, and Adult Male and Female Stage 6 were measured and analysed, and 36 linear regression equations derived for these variables together with mean values, standard deviations and 95% confidence limits. The range of nitrogen values in the fresh material, expressed as a percentage of dry weight, ranged from 8.08%±0.80 (Copepodite Stage 3) to 10.89%±0.27 (adult female); carbon values changed from 41.6%±3.05 (mean ±95% confidence limits) for Copepodite Stage 3 to 50.97%±2.63 in Copepodite Stage 5. The adult females had a high nitrogen and relatively low carbon content, while the converse was true for Stage 5 copepodites. There was a loss of dry weight from the frozen samples (57%) and the fixed samples (38%) compared with the mean of the fresh dry weight of all stages. The material lost from the copepods was rich in nitrogen, thus, artificially high percentage carbon values were determined from the frozen and fixed samples (52.0 to 60.3% and 44.7 to 58.5%, respectively).

Uptake of carbon, nitrogen and phosphorus by phytoplankton along the 20 degrees W meridian in the NE Atlantic between 57.5 degrees N and 37 degrees N

Phytoplankton biomass and rate of production were measured along a transect from 57.54 degreesN to 37.01 degreesN in the northeast Atlantic during July 1996 and at a series of stations over a 7-day period at 37 degreesN 20 degreesW. Surface nutrient concentrations ranged from 4 mu mol l(-1) NO3-, and 0.35 mu mol l(-1) PO43- at 57.54 degreesN to <10 nmol l(-1) NO3- and similar to 10 nmol l(-1) PO43- at 37.01 degreesN. The greatest phytoplankton biomass and production were measured in the vicinity of a frontal system at 50 degreesN, and there was a general decline in total phytoplankton biomass and production to the south of the transect. Production was measured in three size fractions. At the station with the highest chlorophyll concentrations (50.34 degreesN), phytoplankton cells larger than 5 mum dominated the assemblage, accounting for 72% of the chlorophyll concentration (22.9 mg m(-2)) and 51% of primary production (54.1 mmol Cm-2 d(-1)), but picophytoplankton production was also high (43%). At 57 degreesN, carbon fixation by the > 5 mum fraction accounted for 75% of the daily production of 60.75 mmol Cm-2 d(-1). At 37 degreesN, picophytoplankton was the dominant group, accounting for similar to 58% (10 mg m(-2)) of chlorophyll and similar to 64% (46 mmol Cm-2 d(-1)), of primary production. Nitrate, ammonium and phosphate uptake rates also were determined. Although high nitrate uptake rates were measured in the surface water at similar to 50 degreesN, the greatest uptake rates of both depth-integrated nitrate and ammonium were at the south of the transect. At 37 degreesN, a deep euphotic zone was present and light penetrated through the nitracline; total nitrate uptake was enhanced because of assimilation at the base of the euphotic zone. As a consequence, high values of depth-integrated f-ratio were measured in the oligotrophic waters at the south of the transect. Phosphate was predominantly incorporated into the picoplankton fraction, which included heterotrophic and autotrophic components, at all stations and a significant proportion of phosphate uptake occurred in the dark. The C:N:P assimilation ratios were variable throughout the region; phosphate uptake was generally greater than would be expected if nutrient assimilation were in proportion to the Redfield ratio. (C) 2001 Elsevier Science Ltd. All rights reserved.

The pressure distribution along the stone column in soft clay when subjected to consolidation and foundation loading

The mechanism whereby the foundation loading is transmitted through stone the column (included in soft clay) has received less attention from researchers. This paper reports on some interesting findings obtained from a laboratory-based model study in respect of this issue. The stone column, included in the soft clay bed was subjected to foundation loading under drained conditions. The results show, probably for the first time, how the foundation loadings are transmitted through the column and indeed the existence of “negative skin friction” (a widely accepted phenomena in solid piles) in granular columns in soft clays.

The pressure distribution along stone columns in soft clay under consolidation and foundation loading

The mechanism whereby foundation loading is transmitted through the column has received little attention from researchers. This paper reports on some interesting findings obtained from a laboratory-based model study in respect of this issue. The model tests were carried out on samples of soft clay, 300 mm in diameter and 400 mm high. The samples were reinforced with fully penetrating stone columns, of three different diameters, made of crushed basalt. Four pressure cells were located along each stone column. The 60 mm diameter footing used in the model was supported on a clay bed reinforced with a stone column and subjected to foundation loading under drained conditions. The results show that the dissipation of excess pore water pressure developed during the initial application of total stresses, when the foundation was subjected to no loading, generated considerable stresses within the column, and that this was directly attributable to the development of negative skin friction. The pressure distributions in the column during foundation loading showed some complex behaviour.

Cycloalkenyl Halide Substitution Reactions of Enantiopure Arene cis-Tetrahydrodiols with Boron, Nitrogen and Phosphorus Nucleophiles

Enantiopure arene cis-tetrahydrodiols of bromobenzene and iodobenzene have been obtained in good yields, from chemoselective hydrogenation (rhodium-graphite) of the corresponding cis-dihydrodiol metabolites. Palladium-catalysed substitution of the halogen, by hydrogen, boron, nitrogen and phosphorus nucleophiles, in the acetonide derivatives, has yielded highly functionalised products for application in synthesis with potential as scaffolds for chiral ligands.

Liquid nitrogen and salicylic/lactic acid paint in the treatment of cutaneous warts in general practice

Patients with common hand warts and simple plantar warts attending a general practice wart clinic in Northern Ireland were assigned to one of three treatment groups - liquid nitrogen applied weekly, daily application of wart paint (lactic acid one part, salicylic acid one part, collodion four parts), or a combination of the two. Combination therapy cured 87% of common hand warts over a six week period, and was significantly more effective than either agent used separately (P

Reactions of nitrogen and oxygen surface groups in nanoporous carbons under inert and reducing atmospheres

The reactions of surface functional groups have an important role in controlling conversion of char nitrogen to NOx during coal combustion. This study involved an investigation of the thermal stability and reactions of nitrogen surface functional groups in nanoporous carbons. Four suites of carbons, which were used as models for coal chars, were prepared with a wide range of nitrogen and oxygen contents and types of functional groups. The porous structures of the carbons were characterized by gas adsorption methods while chemical analysis, X-ray photoelectron spectroscopy, and X-ray near edge structure spectroscopy were used to characterize the surface functional groups. Temperature programmed desorption and temperature programmed reduction methods were used to study the reactivity of the surface functional groups during heat treatment under inert and reducing conditions. Heat treatment studies show that the order of stability of the functional groups is quaternary nitrogen > pyridinic > pyrrolic > pyridine N-oxide. Pyridine N-oxide surface groups desorb NO and form N-2 via surface reactions at low temperature. Pyrrolic and pyridinic functional groups decompose and react with surface species to give NH3, HCN, and N-2 as desorption products, but most pyrrolic groups are preferentially converted to pyridinic and quaternary nitrogen. The main desorption product is N-2. Approximately 15-40 wt % of the original nitrogen was retained in the carbons mainly as quaternary nitrogen after heat treatment to 1673 K. The results are discussed in terms of decomposition ranges for surface functional groups and reaction mechanisms of surface species.