Combustion and emission characteristics of a typical biodiesel engine operated on waste cooking oil derived biodiesel

Waste cooking oils can be converted into fuels to provide economical and environmental benefits. One option is to use such fuels in stationary engines for electricity generation, co-generation or tri-generation application. In this study, biodiesel derived from waste cooking oil was tested in an indirect injection type 3-cylinder Lister Petter biodiesel engine. We compared the combustion and emission characteristics with that of fossil diesel operation. The physical and chemical properties of pure biodiesel (B100) and its blends (20% and 60% vol.) were measured and compared with those of diesel. With pure biodiesel fuel, full engine power was achieved and the cylinder gas pressure diagram showed stable operation. At full load, peak cylinder pressure of B100 operation was almost similar to diesel and peak burn rate of combustion was about 13% higher than diesel. For biodiesel operation, occurrences of peak burn rates were delayed compared to diesel. Fuel line injection pressure was increased by 8.5-14.5% at all loads. In comparison to diesel, the start of combustion was delayed and 90% combustion occurred earlier. At full load, the total combustion duration of B100 operation was almost 16% lower than diesel. Biodiesel exhaust gas emissions contained 3% higher CO2 and 4% lower NOx, as compared to diesel. CO emissions were similar at low load condition, but were decreased by 15 times at full load. Oxygen emission decreased by around 1.5%. Exhaust gas temperatures were almost similar for both biodiesel and diesel operation. At full engine load, the brake specific fuel consumption (on a volume basis) and brake thermal efficiency were respectively about 2.5% and 5% higher compared to diesel. Full engine power was achieved with both blends, and little difference in engine performance and emission results were observed between 20% and 60% blends. The study concludes that biodiesel derived from waste cooking oil gave better efficiency and lower NOx emissions than standard diesel. Copyright © 2012 SAE International.

Novos adsorventes para aplicação na remoção de enxofre de combustíveis

Currently the market requires increasingly pure oil derivatives and, with that, comes the need for new methods for obtaining those products that are more efficient and economically viable. Considering the removal of sulfur from diesel, most refineries uses catalytic hydrogenation process, the hydrodesulfurization. These processes needs high energy content and high cost of production and has low efficiency in removing sulfur at low concentrations (below 500 ppm). The adsorption presents itself as an efficient and economically viable alternative in relation to the techniques currently used. With that, the main purpose of this work is to develop and optimize the obtaining of new adsorbents based on diatomite, modified with two non ionic surfactants microemulsions, adding efficiency to the material, to its application on removal of sulfur present in commercial diesel. Analyses were undertaken of scanning electron microscopy (SEM), x-ray diffraction (XRD), x-ray fluorescence (XRF), thermogravimetry (TG) and N2 adsorption (BET) for characterization of new materials obtained. The variables used for diatomite modification were: microemulsion points for each surfactant (RNX 95 and UNTL 90), microemulsion aqueous phase through the use or non-use of salts (CaCl2 and BaCl2), the contact time during the modification and the contact form. The study of adsorption capacity of materials obtained was performed using a statistical modeling to evaluate the influence of salt concentration in the aqueous phase (20 ppm to 1500 ppm), finite bath temperature (25 to 60° C) and the concentration of sulphur in diesel. It was observed that the temperature and the concentration of sulphur (300 to 1100 ppm) were the most significant parameters, in which increasing their values increase the ability of modified clay to adsorb the sulphur in diesel fuel. Adsorption capacity increased from 0.43 to mg/g 1.34 mg/g with microemulsion point optimization and with the addition of salts.

Occupational exposure to particles during hotel´s rooms cleaning

Background: The majority of studies investigated ambient particles, although in most industrialized countries people spend most of their time indoors and significant emissions of fine and ultrafine particles leading to human exposure are caused by various indoor tasks, including cleaning tasks. Objective: To characterize the occupational exposure to particles during cleaning of hotel's rooms. Methodology: Measurements of mass concentration and particle number concentration were performed before and during cleaning tasks in two rooms with different floor types (wood and carpet) with the equipment Lighthouse, model 3016 IAQ. Results: Considering mass concentration, particles with higher were responsable for higher leves of contamination, particularly PM5.0 and PM10.0. However, considering the particle number concentration, the smaller particle size obtained the higher values. Conclusion: It was observed higher number of particles of the smaller size in all tasks, which is associated with worse health effects. It was observed that the room with wood in the floor has lower values when compared to the room with carpet. The tasks with greater exposure were the 'vacuuming' and 'clean up powder'.

Do Global CO2 Emissions from Fossil-Fuel Consumption Exhibit Long Memory? A Fractional Integration Analysis

In this article we use an autoregressive fractionally integrated moving average approach to measure the degree of fractional integration of aggregate world CO2 emissions and its five components – coal, oil, gas, cement, and gas flaring. We find that all variables are stationary and mean reverting, but exhibit long-term memory. Our results suggest that both coal and oil combustion emissions have the weakest degree of long-range dependence, while emissions from gas and gas flaring have the strongest. With evidence of long memory, we conclude that transitory policy shocks are likely to have long-lasting effects, but not permanent effects. Accordingly, permanent effects on CO2 emissions require a more permanent policy stance. In this context, if one were to rely only on testing for stationarity and non-stationarity, one would likely conclude in favour of non-stationarity, and therefore that even transitory policy shocks

Identification of the biodiesel source using an electronic nose

Biodiesel is an important new alternative fuel. The feedstock used and the process employed determines whether it fulfills the required specifications. In this work, an identification method is proposed using an electronic nose (e-nose). Four samples of biodiesel from different sources and one of petrodiesel were analyzed and well-recognized by the e-nose. Both pure biodiesel and B20 blends were studied. Furthermore, an innovative semiquantitative method is proposed on the basis of the smellprints correlated by a feed-forward artificial neural network. The results have demonstrated that the e-nose can be used to identify the biodiesel source and as a preliminary quantitative assay in place of expensive equipment.

Gestão da rede de hidrogénio da Refinaria de Matosinhos

Até há bem pouco tempo o hidrogénio não era considerado um elemento crucial nas refinarias, sendo por isso queimado juntamente com o fuel gás. Actualmente, o hidrogénio é considerado uma utilidade do processo e como tal deverá ser utilizado de forma eficiente. A procura crescente está também relacionada com as limitações ambientais exigidas bem como as especificações que os combustíveis devem apresentar, nomeadamente o teor de enxofre. Assim, torna-se necessário um melhor aproveitamento do hidrogénio presente na refinaria e como tal procede-se à gestão da rede de produção/distribuição/consumo do mesmo, dado ser um subproduto dos processos de refinação. Com tudo isto, a integração de processos tem sido a base de inúmeras metodologias sistemáticas que permitem identificar o ponto onde se poderá intervir. A gestão da rede de hidrogénio é baseada na metodologia pinch, que apresenta um procedimento que permite estabelecer a meta mínima de importação de hidrogénio à rede assim como localizar a corrente onde se pode aproveita-lo, e com isso reduzir os custos associados e obter novas especificações dos combustíveis. Esta dissertação de mestrado, teve como objectivo minimizar o hidrogénio presente no fuel gás da Refinaria de Matosinhos de forma a ser aproveitado na UN3700, unidade de hidrodessulfuração do gasóleo. Foi desenvolvida com base no trabalho proposto por Alves (1999), pois as correntes são consideradas em termos de qualidade (pureza em H2) e quantidade (caudal). Devido à existência de duas situações distintas nos resultados obtidos, concluise que para a situação em que se considera a corrente de reciclo, consegue-se obter uma percentagem de 55,21% de hidrogénio no fuel gás. Para a situação sem a corrente de reciclo é possível obter uma percentagem de 49,90%. Em ambas as situações será benéfico a ligação da UN1500 à UN1700 bem como do acumulador D- 4701 à UN1700.

Children’s Indoor Exposures to (Ultra)Fine Particles in an Urban Area: Comparison Between School and Home Environments

Due to their detrimental effects on human health, scientific interest in ultrafine particles (UFP), has been increasing but available information is far from comprehensive. Children, who represent one of the most susceptible subpopulation, spend the majority of time in schools and homes. Thus, the aim of this study is to (1) assess indoor levels of particle number concentrations (PNC) in ultrafine and fine (20–1000 nm) range at school and home environments and (2) compare indoor respective dose rates for 3- to 5-yr-old children. Indoor particle number concentrations in range of 20–1000 nm were consecutively measured during 56 d at two preschools (S1 and S2) and three homes (H1–H3) situated in Porto, Portugal. At both preschools different indoor microenvironments, such as classrooms and canteens, were evaluated. The results showed that total mean indoor PNC as determined for all indoor microenvironments were significantly higher at S1 than S2. At homes, indoor levels of PNC with means ranging between 1.09 × 104 and 1.24 × 104 particles/cm3 were 10–70% lower than total indoor means of preschools (1.32 × 104 to 1.84 × 104 particles/cm3). Nevertheless, estimated dose rates of particles were 1.3- to 2.1-fold higher at homes than preschools, mainly due to longer period of time spent at home. Daily activity patterns of 3- to 5-yr-old children significantly influenced overall dose rates of particles. Therefore, future studies focusing on health effects of airborne pollutants always need to account for children’s exposures in different microenvironments such as homes, schools, and transportation modes in order to obtain an accurate representation of children overall exposure.

Associations of short-term particle and noise exposures with markers of cardiovascular and respiratory health among highway maintenance workers

BACKGROUND: Highway maintenance workers are constantly and simultaneously exposed to traffic-related particle and noise emissions, and both have been linked to increased cardiovascular morbidity and mortality in population-based epidemiology studies. OBJECTIVES: We aimed to investigate short-term health effects related to particle and noise exposure. METHODS: We monitored 18 maintenance workers, during as many as five 24-hour periods from a total of 50 observation days. We measured their exposure to fine particulate matter (PM2.5), ultrafine particles, noise, and the cardiopulmonary health endpoints: blood pressure, pro-inflammatory and pro-thrombotic markers in the blood, lung function and fractional exhaled nitric oxide (FeNO) measured approximately 15 hours post-work. Heart rate variability was assessed during a sleep period approximately 10 hours post-work. RESULTS: PM2.5 exposure was significantly associated with C-reactive protein and serum amyloid A, and negatively associated with tumor necrosis factor α. None of the particle metrics were significantly associated with von Willebrand factor or tissue factor expression. PM2.5 and work noise were associated with markers of increased heart rate variability, and with increased HF and LF power. Systolic and diastolic blood pressure on the following morning were significantly associated with noise exposure after work, and non-significantly associated with PM2.5. We observed no significant associations between any of the exposures and lung function or FeNO. CONCLUSIONS: Our findings suggest that exposure to particles and noise during highway maintenance work might pose a cardiovascular health risk. Actions to reduce these exposures could lead to better health for this population of workers.

Iowa Leading Indicators Index Report, July 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, August 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, September 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, October 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, November 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, December 2006

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.

Iowa Leading Indicators Index Report, January 2007

The Iowa Leading Indicators Index (ILII) is a tool for monitoring the future direction of the Iowa economy and State revenues. Its eight components include an agricultural futures price index, an Iowa stock market index, average weekly manufacturing hours in Iowa, initial unemployment claims in Iowa, an Iowa new orders index, diesel fuel consumption in Iowa, residential building permits in Iowa, and the national yield spread.