A parametric, experimental analysis of conical vortices on curved roofs of low-rise buildings

Different methods to reduce the high suction caused by conical vortices have been reported in the literature: vertical parapets, either solid or porous, placed at the roof edges being the most analysed configuration. Another method for alleviating the high suction peaks due to conical vortices is the use of some non-standard parapet configuration like cantilever parapets. In this paper the influence of roof curvature on the conical vortex pattern appearing on a curved roof (Fig. 1) when subject to oblique winds is experimentally analysed by testing the mean pressure distribution on the curved roofs of low-rise building models in a wind tunnel. Also, the efficiency of cantilever parapets to reduce mean suction loads on curved roofs is experimentally checked. Very high suction loads have been measured on curved roofs, the magnitude of these high suction loads being significantly decreased when cantilever parapets are used. Thus, the suitability of these parapets to reduce wind pressure loads on curved roofs is demonstrated.

Stability Analysis of a Run-of-River Diversion Hydropower Plant With Surge Tank And Spillway in the Head Pond

Run-of-river hydropower plants usually lack significant storage capacity; therefore, the more adequate control strategy would consist of keeping a constant water level at the intake pond in order to harness the maximum amount of energy from the river flow or to reduce the surface flooded in the head pond. In this paper, a standard PI control system of a run-of-river diversion hydropower plant with surge tank and a spillway in the head pond that evacuates part of the river flow plant is studied. A stability analysis based on the Routh-Hurwitz criterion is carried out and a practical criterion for tuning the gains of the PI controller is proposed. Conclusions about the head pond and surge tank areas are drawn from the stability analysis. Finally, this criterion is applied to a real hydropower plant in design state; the importance of considering the spillway dimensions and turbine characteristic curves for adequate tuning of the controller gains is highlighted

Advanced Characterisation of a Coffee Fermenting Tank by Multi-distributed Wireless Sensors: Spatial Interpolation and Phase Space Graphs

The fermentation stage is considered to be one of the critical steps in coffee processing due to its impact on the final quality of the product. The objective of this work is to characterise the temperature gradients in a fermentation tank by multi-distributed, low-cost and autonomous wireless sensors (23 semi-passive TurboTag® radio-frequency identifier (RFID) temperature loggers). Spatial interpolation in polar coordinates and an innovative methodology based on phase space diagrams are used. A real coffee fermentation process was supervised in the Cauca region (Colombia) with sensors submerged directly in the fermenting mass, leading to a 4.6 °C temperature range within the fermentation process. Spatial interpolation shows a maximum instant radial temperature gradient of 0.1 °C/cm from the centre to the perimeter of the tank and a vertical temperature gradient of 0.25 °C/cm for sensors with equal polar coordinates. The combination of spatial interpolation and phase space graphs consistently enables the identification of five local behaviours during fermentation (hot and cold spots).

Comparative Life Cycle Assessment of the Conventional Façade SOS Natura and the Natural Water Tank Façade

The construction industry produces great environmental impacts to the planet. In order to tackle this problem, the European Union has put into effect Regulation No 305/2011, which compels the construction products manufacturers to carry out environmental performance studies of these products and thus make public the impact they cause on the environment. The aim of this research is to make known the environmental impacts of the SOS Natura Conventional Façade (CF) solution, obtained within the research project "SOS Natura, Vegetal Architectural Solutions" developed by the Department of Construction and Technology in Architecture of the School of Architecture of the Technical University of Madrid (Spain). In addition, we report an environmental comparative with the Natural Water Tank Façade (NWTF), studied previously by the same work group and included in the same research project.We present as well an uncertainty analysis for both façades. Following the study conducted we conclude that the NWTF profile has a slightly better environmental behaviour when compared to the CF profile for the entire life cycle in most of the impact categories analysed in this study. However it should also be noted that, in detail and at stage level, the NWTF presents a higher environmental impact than the CF.

Do pingers cause stress in fish? An experimental tank study with European sardine, Sardina pilchardus (Walbaum, 1792) (Actinopterygii, Clupeidae), exposed to a 70 kHz dolphin pinger

Date of acceptance: 06/12/2014 Acknowledgments The study was funded by the Portuguese Ministry of Science (Fundac¸a˜o para a Cieˆncia e Tecnologia– FCT) through a PhD Grant of SG (SFRH/BD/47931/2008). We would like to thank the captain of the purse-seiner (Jose´ Manuel Saveedra) and his crew for facilitating the capture and transport of live fish. Moreover, we want to thank Ana Marc¸alo for suggestions on the experimental design, Manuel Garci for technical advice on underwater video recordings and James Turner from the company Future Oceans for providing technical details on the 70 kHz dolphin pingers. We would also like to acknowledge the scientific advice of Dr. Jose´ Iglesias and the technical and logistic support for the preparation of the laboratory and the materials for tank experiments by Enrique Martı´nez Gonza´lez, Ricardo Pazo´and other staff at the aquaculture facilities of the Spanish Institute for Oceanography (IEO) and the Marine Sciences Station of Toralla (ECIMAT) in Vigo. Furthermore, we are grateful to Francisco de la Granda Grandoso for his practical assistance during the fish tank experiments and to Juan Santos Blanco for helping with statistical analysis. Finally, we would like to thank Pilar Riobo´ Agula, Amelia Fernandez Villamarin, Jose´ Franco Soler, Jose´ Luis Mun˜oz, Angela Benedetti, Marcos Antonio Lopez Patin˜o and Marta Conde Sieira for scientific advice and practical support with cortisol analysis and Rosana Rodrı´guez for preparing histological samples for us.