Physical properties and fluidization behaviour of fresh green bean particulates during fluidized bed drying

Changes in the physical properties (such as particle density, bulk density of the bed, shrinkage and bed porosity) of fresh green bean particulates were investigated during drying. Three length:diameter ratios (1:1, 2:1 and 3:1) were considered, using drying conditions of 50 +/- 2 degrees C and 13 +/- 2% relative humidity in a heat pump dehumidifier system. The fluidization behaviour was also evaluated at 10 levels of moisture content. The fluidization experiments demonstrated that the minimum fluidization velocity decreases as the drying proceeds due to the reduced moisture content and changes in the physical properties of the bean particulates. Empirical relationships of the following nature were developed for the change in shrinkage [VR = 1 - Be-kMR], particle density [rho(p) = A + BMR + C (exp)(-D MR)], bulk density [rho(b) = a(1) + b(1)MR + c(1)MR(2)] and bed porosity [epsilon = a(2) + b(2)MR + c(2)MR(2)] with the moisture content during fluidized bed drying.

Prejudiced attitudes, group norms, and discriminatory behaviour

Most current attitude research focuses on range of non-social attitudinal targets, including health-related and consumer outcomes. In this paper, a program of research that considers the relations among intergroup attitudes, group norms, and behavior will be described. The first study examined the effect of ingroup norms relating to multiculturalism on the extent to wich participants hehaviourally enacted their attitudes. Consistent with social identity theory, attitudebehaviour consistency in relation was influenced by ingroup norms, particularly when national identity was salient. The results of a large scale field study that essential replicated this pattern of results will also be discussed.

Foraging and vein-cutting behaviour of Euploea core corinna (W.S. Macleay) (Lepidoptera : Nymphalidae) caterpillars feeding on latex-bearing leaves

Caterpillars of Euploea core corinna (W. S. Macleay) sever leaf veins prior to feeding on their latex-bearing host plants, which restricts the flow of latex at feeding sites. The severing of leaf veins by insects feeding on latex-bearing plants is commonly referred to as 'sabotaging' and is thought to be an evolved response by the insect to counter the negative effects of feeding on latex-rich leaves. Sabotaging behaviour is described for all instars of E. core corinna, with particular attention given to neonates. Vein cutting by neonate E. core corinna caterpillars can occur within 2 h of hatching, with most caterpillars establishing feeding sites within 10 h. Commonly, first instars cut an are-shaped row of leaf side-veins parallel to the leaf margin, but they may also cut the leaf mid-rib in a fashion similar to older instar larvae. From a sample of 50 E. core corinna larvae, representing all instars, we found that the diameters of the veins cut by caterpillars are closely correlated to larval head width (r=0.90). Through manipulative experiments, we demonstrate for the first time that sabotaging behaviour in neonate caterpillars imposes no detectable short-term physiological costs on those caterpillars.

Expression, purification, and characterization of biol: A carbon-carbon bond cleaving cytochrome P450 involved in biotin biosynthesis in Bacillus subtilis

Pimelic acid formation for biotin biosynthesis in Bacillus subtilis has been proposed to involve a cytochrome P450 encoded by the gene biol. We have subcloned bioI and overexpressed the encoded protein, BioI. A purification protocol was developed utilizing ion exchange, gel filtration, and hydroxyapatite chromatography, Investigation of the purified BioI by UV-visible spectroscopy revealed spectral properties characteristic of a cytochrome P450 enzyme. BioI copurifies with acylated Escherichia coil acyl carrier protein (ACP), suggesting that in vivo a fatty acid substrate may be presented to BioI as an acyl-ACP. A combination of electrospray mass spectrometry of the intact acyl-ACP and GCMS indicated a range of fatty acids were bound to the ACP. A catalytically active system has been established employing E. coli flavodoxin reductase and a novel, heterologous flavodoxin as the redox partners for BioI. In this system, BioI cleaves a carbon-carbon bond of an acyl-ACP to generate a pimeloyl-ACP equivalent, from which pimelic acid is isolated after base-catalyzed saponification. A range of free fatty acids have also been explored as potential alternative substrates for BioI, with C16 binding most tightly to the enzyme. These fatty acids are also metabolized to dicarboxylic acids, but with less regiospecificity than is observed with acyl-ACPs. A possible mechanism for this transformation is discussed. These results strongly support the proposed role for BioI in biotin biosynthesis. In addition, the production of pimeloyl-ACP explains the ability of BioI to function as a pimeloyl CoA source in E. coli, which, unlike B. subtilis, is unable to utilize free pimelic acid for biotin production. (C) 2000 Academic Press.

Use of an Arrhenius model to predict rheological behaviour in some Australian honeys

Rheological properties of nine unprocessed unifloral Australian honeys (bloodwood, blue top iron bark, gum top, heath, narrow leafed iron bark, stringy bark, tea tree yapunyah and yellow box) were analysed over a range of temperatures (1-40 degreesC) The temperature effect on the viscosity follow ed an Arrhenius-type relationship and ail honey varieties exhibited Newtonian behaviour. if the Arrhenius equation constants (mu (0) and E-a) for a particular honey are known, the Arrhenius model can be used to calculate the viscosity of these honeys at specific temperatures, negating the need for tedious viscosity determination. (C) 2000 Academic Press.

Antioxidant behaviour of thia fatty acids

Eight thia fatty acids and other sulfides have been studied as inhibitors of autoxidation of arachidonic acid. The inhibitors extend the lag phase of the oxidation, to varying degrees. A carboxyl group in the vicinity of the sulfur reduces the antioxidant activity, while unsaturated sulfides are more effective than their saturated analogues. The results are consistent with the sulfides acting to reduce fatty acid hydroperoxides, which otherwise accumulate during the early stages of reaction and propagate the free-radical oxidation process.

An agent-based approach to modelling driver route choice behaviour under the influence of real-time information

This paper presents an agent-based approach to modelling individual driver behaviour under the influence of real-time traffic information. The driver behaviour models developed in this study are based on a behavioural survey of drivers which was conducted on a congested commuting corridor in Brisbane, Australia. Commuters' responses to travel information were analysed and a number of discrete choice models were developed to determine the factors influencing drivers' behaviour and their propensity to change route and adjust travel patterns. Based on the results obtained from the behavioural survey, the agent behaviour parameters which define driver characteristics, knowledge and preferences were identified and their values determined. A case study implementing a simple agent-based route choice decision model within a microscopic traffic simulation tool is also presented. Driver-vehicle units (DVUs) were modelled as autonomous software components that can each be assigned a set of goals to achieve and a database of knowledge comprising certain beliefs, intentions and preferences concerning the driving task. Each DVU provided route choice decision-making capabilities, based on perception of its environment, that were similar to the described intentions of the driver it represented. The case study clearly demonstrated the feasibility of the approach and the potential to develop more complex driver behavioural dynamics based on the belief-desire-intention agent architecture. (C) 2002 Elsevier Science Ltd. All rights reserved.

Bond strength of an adhesive system irradiated with Nd : YAG laser in dentin treated with Er : YAG laser

The purpose of this in vitro study was to verify through micro tensile bond test the bond strength of an adhesive system irradiated with Nd:YAG laser in dentine previously treated with Er:YAG laser. Twenty caries free extracted human third molars were used. The teeth were divided in four experimental groups (n = 5): (G1) control group; (G2) irradiation of the adhesive system with the Nd:YAG laser; (G3) dentin treatment with Er:YAG laser; (G4) dentin treatment with Er:YAG laser followed by the irradiation of the adhesive system with Nd:YAG laser. The Er:YAG laser fluency parameter for the dentin treatment was of 60 J/cm(2). ne adhesive system was irradiated with the Nd:YAG laser with fluency of 100 J/cm(2). Dental restorations were performed with Adper Single Bond 2/Z250. One tooth from each group was prepared for the evaluation of the adhesive interface under SEM and bond failure tests were also performed and evaluated. The statistical analysis showed statistical significant difference between the groups G1 and G3, G1 and G4, G2 and G3, and G2 and G4; and similarity between the groups G1 and G2, and G3 and G4. The adhesive failures were predominant in all the experimental groups. The SEM analysis showed an adhesive interface with features confirming the results of the mechanical tests. The Nd:YAG laser on the adhesive system did not influence the bond strength in dentin treated or not with the Er:YAG laser.

Investigating the gap between citizens` sustainability attitudes and food purchasing behaviour: empirical evidence from Brazilian pork consumers

Consumers worldwide are increasingly concerned with sustainable production and consumption. Recently, a comprehensive study ranked 17 countries in regard to their environmentally friendly behaviour among consumers. Brazil was one of the top countries in the list. Yet, several studies highlight significant differences between consumers` intentions to consume ethically, and their actual purchase behaviour: the so-called `Attitude-Behaviour Gap`. In developing countries, few studies have been conducted on this issue. The objective of this study is therefore to investigate the gap between citizens` sustainability-related attitudes and food purchasing behaviour using empirical data from Brazil. To this end, Brazilian citizens` attitudes towards pig production systems were mapped through conjoint analysis and their coexistence with relevant pork product-related purchasing behaviour of consumers was investigated through cluster analysis. The conjoint experiment was carried Out with empirical data collected from 475 respondents surveyed in the South and Center-West regions of Brazil. The results of the conjoint analysis were used for a subsequent cluster analysis in order to identify clusters of Brazilian citizens with diversified attitudes towards pig production systems, using socio-demographics, attitudes towards sustainability-related themes that are expected to influence the way they evaluate pig production systems, and consumption frequency of various pork products as clusters` background information. Three clusters were identified as `indifferent`, `environmental conscious` and `sustainability-oriented` citizens. Although attitudes towards environment and nature had indeed an influence on citizens` specific attitudes towards pig farming at the cluster level, the relationship between `citizenship` and consumption behaviour was found to be weak. This finding is similar to previous research conducted with European consumers: what people (in their role of citizens) think about pig production systems does not appear to significantly influence their pork consumption choices. Improvements in the integrated management of this chain would better meet consumers` sustainability-related expectations towards pig production systems.

Fight versus flight: the interaction of temperature and body size determines antipredator behaviour in tegu lizards

Ectotherm antipredator behaviour might be strongly affected both by body temperature and size: when environmental temperatures do not favour maximal locomotor performance, large individuals may confront predators, whereas small animals may flee, simply because they have no other option. However, integration of body size and temperature effects is rarely approached in the study of antipredator behaviour in vertebrate ectotherms. In the present study we investigated whether temperature affects antipredator responses of tegu lizards, Tupinambis merianae, with distinct body sizes, testing the hypothesis that small tegus (juveniles) run away from predators regardless of the environmental temperature, because defensive aggression may not be an effective predator deterrent, whereas adults, which are larger, use aggressive defence at low temperatures, when running performance might be suboptimal. We recorded responses of juvenile (small) and adult (large) tegu lizards to a simulated predatory attack at five environmental temperatures in the laboratory. Most differences between the two size classes were observed at low temperatures: large tegus were more aggressive overall than were small tegus at all temperatures tested, but at lower temperatures, the small lizards often used escape responses whereas the large ones either adopted a defensive posture or remained inactive. These results provide strong evidence that body size and temperature affect the antipredator responses of vertebrate ectotherms. We discuss the complex and intricate network of evolutionary and ecological parameters that are likely to be involved in the evolution of such interactions. (C) 2009 The Association for the Study of Animal Behaviour. Published by Elsevier Ltd. All rights reserved.

Loose abrasive truing and dressing of resin bond diamond cup wheels for grinding fibre optic connectors

A loose abrasive lapping technology was developed for truing and dressing ultrafine diamond cup wheels for grinding spherical end faces of fibre optic connectors. The relative densities of exposed grits and grit pull-outs measured from wheel surfaces prepared using the loose abrasive lapping and the bonded abrasive dressing were compared. It was found that the lapping method with loose abrasives produced wheel surfaces with more exposed grits and less grit pull-outs, especially for finer grit size wheels. For dressing ultrafine grit size wheels, the particle size of the lapping paste should be smaller than the wheel grit size to achieve a better result. It is also found that the wheels dressed using the lapping method demonstrate an excellent grinding performance. (C) 2004 Elsevier B.V.. All rights reserved.

The link between prejudiced attitudes and discriminatory behaviour: The role of ingroup norms

In the present research, a reconceptualisation of the role of norms in the link between prejudiced attitudes and discriminatory behaviour — along the lines suggested by the social identity perspective — was tested. In the first study, group salience and group norm were manipulated. As expected, participants ascribed negative traits to significantly fewer Asian university students when they had received consensus information along these lines from a salient ingroup rather than from a salient outgroup. These results were replicated on a measure of strength of motivation to appear nonprejudiced. In a second study, group salience and norm were once again manipulated and strength of attitude and perceived group threat were measured. As predicted, people's negative attitudes towards globalisation were more likely to predict congruent behavioural responses to the extent that the group norm supported the attitude and group salience was high, particularly when high levels of group threat were perceived.

Asymptotic behaviour of two-dimensional time-delayed Navier-Stokes equations

We consider the two-dimensional Navier-Stokes equations with a time-delayed convective term and a forcing term which contains some hereditary features. Some results on existence and uniqueness of solutions are established. We discuss the asymptotic behaviour of solutions and we also show the exponential stability of stationary solutions.