FT-IR spectroscopic study of the oxidation of chlorobenzene over Mn-based catalyst

Adsorption and oxidation of chlorobenzene on Al(2)O(3), TiO(2)-Al(2)O(3), and MnO(x)/TiO(2)-Al(2)O(3) have been studied by in situ Fourier transform infrared (FT-IR) spectroscopy. At room temperature, chlorobenzene is only physisorbed on Al(2)O(3), TiO(2)-Al(2)O(3), and MnO(x)/TiO(2)-Al(2)O(3), and gives the same IR spectrum as that for liquid-phase chlorobenzene. On Al(2)O(3) no further interaction and reaction take place with treatment, at higher temperatures (up to 773 K), while phenolates are observed for TiO(2)-Al(2)O(3) and MnO(x)/TiO(2)-Al(2)O(3) at 773 K. When the adsorbed chlorobenzene coexists with oxygen, formates are detected for Al(2)O(3), while acetates are additionally observed for TiO(2-)Al(2)O(3) above 573 K. For MnO(x)/TiO(2-)Al(2)O(3), maleates are present at 573 And 673 K, while formates and acetates develop at 473 and 573 K. Almost all IR bands due to formates, acetates, and maleates disappear at 773 K, indicating that these oxygen-containing species are potential intermediates for the total oxidation of chlorobenzene.

FTIR study of CO and NO adsorbed on nitrided CoMo/Al2O3 catalysts

The states of surface Co and Mo sites on nitrided CoMo supported on Al2O3 were studied by adsorption of CO and NO as IR probe molecules. Three IR bands at 2200, 2060 and 2025 cm(-1) were detected for adsorbed CO. These bands can be respectively attributed to the surface NCO species as a result of CO adsorbed on surface N sites, and linearly adsorbed CO on surface Co and Mo sites in low valence states. The addition of cobalt to the Mo nitride diminishes the band at 2200 cm(-1). This may be due to either the change of the surface structure of the supported nitride, or the formation of a new phase, CoxMoyNz, as suggested in the literature Kim et al., Catal. Lett., 1997, 43, 91 and Logan et al., Catal. Lett., 1998, 56, 165. Comparison of CO and NO adsorption on Mo2N/Al2O3 and CoMoNx/Al2O3 indicates that the presence of cobalt can promote the reduction and nitridation of Mo.

Surface-enhanced Raman scattering of xanthopterin adsorbed on colloidal silver

Surface-enhanced Raman scattering (SERS) of xanthopterin adsorbed on colloidal silver was measured and the Raman spectrum calculated by the density functional theory method was also obtained. Xanthopterin can be detected down to 5 X 10(-9) m and the enhancement of the scattering intensity is at least 10(5)-fold. Xanthopterin molecules are adsorbed flatly on the surface of the Ag particles. This study shows that SERS could be another prospective method for the detection of pterines. Copyright (C) 2001 John Wiley Sons, Ltd.

Different mechanisms for the formation of acetaldehyde and ethanol on the Rh-based catalysts

Different mechanisms for the formation of acetaldehyde and ethanol on the Rh-based catalysts were investigated by the TPR (temperature programmed reaction) method, and the active sites were studied by CO-TPD, TPSR (temperature programmed surface reaction of preadsorbed CO by H-2) and XPS techniques. The TPR results indicated that ethanol and acetaldehyde might be formed through different intermediates, whereas ethanol and methanol might result from the same intermediate. Results of CO-TPD, TPSR, and XPS showed that on the Rh-based catalyst, the structure of the active sites for the formation of C-2-oxygenates is ((RhxRhy+)-Rh-0)-O-Mn+ (M=Mn or Zr, x>>y, 2 less than or equal ton less than or equal to4). The tilt-adsorbed CO species is the main precursor for CO dissociation and the precursor for the formation of ethanol and methanol. Most of the linear and geminal adsorbed CO species desorbed below 500 K. Based on the suggested model of the active sites, detailed mechanisms for the formation of acetaldehyde and ethanol are proposed. Ethanol is formed by direct hydrogenation of the tilt-adsorbed CO molecules, followed by CH2 insertion into the surface CH2-O species and the succeeding hydrogenation step. Acetaldehyde is formed through CO insertion into the surface CH3-Rh species followed by hydrogenation, and the role of the promoters was to stabilize the intermediate of the surface acetyl species. (C) 2000 Academic Press.

Dissolution kinetics of octadecanethiolate monolayers electro-adsorbed on Au(1 1 1)

Monolayers of octadecanethiolate on Au(1 1 1) surface were formed under electrochemical control. The influence of the formation time on the reductive desorption process was studied by cyclic voltammetry and chronoamperometry. When the formation time is increased, the reductive desorption peak observed on the voltammograms is significantly shifted in the negative direction, while the cathodic charge is only slightly affected. This behaviour is attributed to a higher degree of organisation of the monolayers for longer formation times, highlighting the role of defect sites in promoting the dissolution. A good agreement was found between our experimental chronoamperograms and theoretical models describing the dissolution process by a shrinkage mechanism. It is demonstrated that a reorganisation process takes place, consisting in the merging of small condensed domains into larger ones. This annealing phenomenon is time and potential dependent, the largest condensed domains being obtained for the longest formation times and least negative potentials. © 2008 Elsevier B.V. All rights reserved.

Short-lived alpha-helical intermediates in the folding of beta-sheet proteins.

Several lines of evidence point strongly toward the importance of highly alpha-helical intermediates in the folding of all globular proteins, regardless of their native structure. However, experimental refolding studies demonstrate no observable alpha-helical intermediate during refolding of some beta-sheet proteins and have dampened enthusiasm for this model of protein folding. In this study, beta-sheet proteins were hypothesized to have potential to form amphiphilic helices at a period of <3.6 residues/turn that matches or exceeds the potential at 3.6 residues/turn. Hypothetically, such potential is the basis for an effective and unidirectional mechanism by which highly alpha-helical intermediates might be rapidly disassembled during folding and potentially accounts for the difficulty in detecting highly alpha-helical intermediates during the folding of some proteins. The presence of this potential was confirmed, indicating that a model entailing ubiquitous formation of alpha-helical intermediates during the folding of globular proteins predicts previously unrecognized features of primary structure. Further, the folding of fatty acid binding protein, a predominantly beta-sheet protein that exhibits no apparent highly alpha-helical intermediate during folding, was dramatically accelerated by 2,2,2-trifluoroethanol, a solvent that stabilizes alpha-helical structure. This observation suggests that formation of an alpha-helix can be a rate-limiting step during folding of a predominantly beta-sheet protein and further supports the role of highly alpha-helical intermediates in the folding of all globular proteins.