Comparison of the NMR enantiodifferentiation of a chiral ruthenium(II) complex of C2 symmetry using the TRISPHAT anion and a lanthanide shift reagent

The tris[tetrachlorobenzenediolato]phosphate(v) anion (TRISPHAT) is known to be an efficient NMR chiral shift agent for various chiral cationic species. Here we compare the efficiency of TRISPHAT and of a chiral lanthanide shift reagent for the determination of the enantiomeric purity of the chiral building block [Ru(phen)[2]PY[2]][2][+] which possesses C[2] symmetry. We also discuss our results in terms of the geometry of interaction between the Ru(II) complex and the TRISPHAT anion.

Interaction between 3’,5’-cyclic monophosphate, volume-regulated anion channels and the Na+-HCO3- cotransporter NBCe1 in the regulation of nutrient- and hypotonicity-induced insulin release from rat pancreatic islets and tumoral insulin-producing BRIN-BD11 cells

info:eu-repo/semantics/published

Is anoctamin 1 (Ano1) the volume regulated anion channel of ß cells?

info:eu-repo/semantics/published

Fractionation of Corynebacterium pekinense AS 1.299 phage subtypes by anion-exchange chromatography

A novel method to fractionate phage into its subtypes while fully retaining biological function is reported. Corynebacterium pekinense AS 1.299 phage samples, purified by either conventional ultracentrifugation or gel chromatography on a Superose® 6 Prep column (0.78×30 cm), were fractionated further into four fractions by anion-exchange chromatography on a Toyopearl SuperQ 650C column (0.5×20 cm) with a linear gradient of NaCl concentration from 0.2 to 1.0 M in 0.02 M carbonate–biocarbonate buffer, pH 10.0. Two peaks were identified to be C. pekinense AS 1.299 phages by their ability to infect the host bacteria when inoculated into the culture media, and when examined by electron microscopy. These two types of the phage were found to be morphologically the same except for the difference in the length of their non-contractile tails. Both possessed an isometric head with a diameter of 50±3 nm, while their tails were 170±10 and 210±10 nm, respectively. This simple technique provides a convenient method for phage isolation not only to its species homogeneity, but also to determine its subtype or variant homogeneity.

Oxidation of N,N,N ',N '-tetraalkyl-para-phenylenediamines in a series of room temperature ionic liquids incorporating the bis(trifluoromethylsulfonyl)imide anion

The five room temperature ionic liquids: 1-alkyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([CnMIM][N(Tf)(2)], n = 2, 4, 8, 10) and n-hexyltriethylammonium bis(trifluoromethylsulfonyl)imide ([N-6222][N(Tf)(2)]) were investigated as solvents in which to study the electrochemical oxidation of N,N,N',N'-tetramethyl-para-phenylenediamine (TMPD) and N,N,N',N'-tetrabutyl-paraphenylenediamine (TBPD), using 20 mul micro-samples under vacuum conditions. The effect of dissolved atmospheric gases on the accessible electrochemical window was probed and determined to be less significant than seen previously for ionic liquids containing alternative anions. Chronoamperometric transients recorded at a microdisk electrode were analysed via a process of non-linear curve fitting to yield values for the diffusion coefficients of the electroactive species without requiring a knowledge of their initial concentration. Comparison of experimental and simulated cyclic voltammetry was then employed to corroborate these results and allow diffusion coefficients for the electrogenerated species to be estimated. The diffusion coefficients obtained for the neutral compounds in the five ionic liquids via this analysis were, in units of 10(-11) m(2) s(-1), 2.62, 1.87, 1.12, 1.13 and 0.70 for TMPD. and 1.23, 0.80, 0.40, 0.52 and 0.24 for TBPD (listed using the same order for the ionic liquids as stated above). The most significant consequence of changing the cationic component of the ionic liquid was found to be its effect on the solvent viscosity; the diffusion coefficient of each species was found to be approximately inversely proportional to viscosity across the series of ionic liquids, in accordance with Walden's rule. (C) 2003 Elsevier B.V. All rights reserved.

The effects of the specific adsorption of anion on the reactivity of the Ru(0001) surface towards CO adsorption and oxidation: in situ FTIRS studies

The dynamics of adsorption and oxidation of CO on Ru(0001) electrode in sulfuric acid solution have been studied using in situ FTIR spectroscopy under potential control and at open circuit, the latter at 20 and 55 degrees C. The in situ IR data show clearly that the bisulfate anion adsorbs on the Ru(0001) surface over the potential range from -200 mV to 350 mV (vs. Ag/AgCl) at 20 degrees C in the absence and presence of adsorbed CO; however, increasing the temperature to 55 degrees C and/ or increasing the concentration of dissolved O-2 reduces the bisulfate adsorption. The formation of surface (hydro-) oxide at higher potentials replaces the bisulfate adsorbates. Both linear (COL) and three-fold hollow bonded CO (COH) adsorbates were produced following CO adsorption at Ru(0001) in H2SO4, as was observed in our previous studies in HClO4. However, the amount of adsorbed CO observed in H2SO4 was ca. 10% less than that in HClO4; in addition, the COL and COH frequencies were higher in H2SO4, and the onset potential for COads oxidation 25 mV lower. These new results are interpreted in terms of a model in which the adsorbed bisulfate weakens the CO adlayer, allowing the active Ru oxide layer to form at lower potentials. Significantly different results were observed at open circuit in H2SO4 compared both to the data under potential control and to our earlier data in HClO4, and these observations were rationalized in terms of the adsorbed HSO4- anions (pre-adsorbed at -200 mV) inhibiting the oxidation of the surface at open circuit (after stepping from the initial potential of -200 mV), as the latter was no longer driven by the imposed electrochemical potential but via chemical oxidation by trace dissolved O-2. Results from experiments at open circuit at 55 degrees C and using oxygen-saturated H2SO4 supported this model. The difference in Ru surface chemistry between imposed electrochemical control and chemical control has potential implications with respect to fuel cell electrocatalysis.

The comparison of fac and mer ruthenium(II) trischelate complexes in anion binding

The synthesis of three new homoleptic trischelate ruthenium( II) complexes bearing new 2,2'-bipyridine ligands, 5,5'-dibenzylamido-2,2'-bipyridine (L1) and 5-benzylamido-2,2'- bipyridine (L2) has been achieved. In the case of [Ru(L2)(3)](2+), the mer and fac isomers have been separated. H-1 NMR spectroscopic anion binding studies indicate that the two C-3-symmetric pockets provided by [ Ru(L1)(3)](2+) is conducive to receive a range of anions, although this is not readily reflected in the photophysical behaviour. The fac-isomer of [Ru(L2)(3)](2+) does appear to have an enhancement in the binding interactions over the mer form with dihydrogenphosphate salts, although the difference is much less marked with the spherical chloride ions. From X-ray crystallographic evidence, the ability to hold water in the "anion" binding cleft can inhibit the strength of the interactions with anions, giving rise to the observed selectivity for directional oxoanions such as dihydrogen phosphate.

1-butyl-3-methylimidazolium 3,5-dinitro-1,2,4-triazolate: a novel ionic liquid containing a rigid, planar energetic anion

The novel ionic liquid, 1-butyl-3-methylimidazolium 3,5-dinitro-1,2,4-triazolate has been synthesized and exhibits an unexpectedly low melting point (35 degreesC) considering the size and shape of the rigid, planar anion; analogous tetraalkylammonium salts (methyl, ethyl and n-butyl) have also been prepared and the tetraethylammonium example was characterized by single crystal X-ray diffraction.

Crystal structures of imidazolium bis(trifluoromethanesulfonyl)imide 'ionic liquid' salts: the first organic salt with a cis-TFSI anion conformation

Crystal structures of two examples of an important class of ionic liquids, 1,3-dimethylimidazolium and 1,2,3-triethylimidazolium bis(trifluoromethanesulfonyl)imide have been characterized by single crystal X-ray diffraction. The anion in the 1,3-dimethylimidazolium example (mp 22 degreesC), adopts an unusual cis-geometry constrained by bifurcated cation-anion C-H...O hydrogen-bonds from the imidazolium cation to the anion resulting in the formation of fluorous layers within the solid-state structure. In contrast, in the 1,2,3-triethylimidazolium salt (mp 57 degreesC), the ions are discretely packed with only weak C-H...O contacts between the ions close to the van der Waals separation distances, and with the anion adopting the twisted conformation observed for all other examples from the limited set of organic bis( trifluoromethanesulfonyl) imide crystal structures. The structures are discussed in terms of the favorable physical properties that bis(trifluoromethanesulfonyl) imide anions impart in ionic liquids.

Influence of the anion on the electrodeposition of cobalt from imidazolium ionic liquids

Cyclic voltammetry and absorption spectrophotometry were used to examine the complex formation of cobalt (II) in the ionic liquids 1-butyl-3-methylimidazolium chloride ([C(4)mim] Cl) and 1-butyl-3-methylimidazolium bis (trifluoromethylsulfonyl) imide ([C(4)mim][Tf2N]). In [C(4)mim]Cl, cobalt(II) is complexed as [CoCl4](2-) at CoCl2 concentrations less than 33 mol %. Cyclic voltammograms show that cobalt cannot be electrodeposited at these concentrations. However, cobalt metal can be electrodeposited at CoCl2 concentrations above the threshold concentration of 33 mol %. In the ionic liquid [C(4)mim][Tf2N] there is no threshold CoCl2 concentration for electrodeposition due to the absence of [CoCl4](2-). (C) 2007 The Electrochemical Society.

Bridging the Gap between Ionic Liquids and Molten Salts: Group 1 Metal Salts of the Bistriflamide Anion in the Gas Phase

Fourier transform ion cyclotron resonance mass spectrometry experiments showed that liquid Group 1 metal salts of the bistriflamide anion undergoing reduced-pressure distillation exhibit a remarkable behavior that is in transition between that of the vapor-liquid equilibrium characteristics of aprotic ionic liquids and that of the Group 1 metal halides: the unperturbed vapors resemble those of aprotic ionic liquids, in the sense that they are essentially composed of discrete ion pairs. However, the formation of large aggregates through a succession of ion-molecule reactions is closer to what might be expected for Group I metal halides. Similar experiments were also carried out with bis{(trifluoromethyl)sulfonyl}amine to investigate the effect of H+, which despite being the smallest Group 1 cation, is generally regarded as a nonmetal species. In this case, instead of the complex ion-molecule reaction pattern found for the vapors of Group I metal salts, an equilibrium similar to those observed for aprotic ionic liquids was observed.