具有高效能量转换的沼气燃料电池

具有高效能量转换的沼气燃料电池李蒙俊杨立新（中国科学院广州能源研究所510070）随着我国经济的高速发展和人民生活水平的日益提高，我国大型制糖厂、酒精厂和大型养猪场、养牛场、养鸡场、屠宰场以及海产品制品加工厂日益增多，这些工厂（场）排出的工农业废水对...

施肥对黄土旱塬区黑垆土土壤肥力及硝态氮累积的影响

本文以长期定位试验为依托,研究了黄土高原旱塬区黑垆土大田对比试验和长期定位施肥对土壤肥力及硝态氮累积和淋溶的影响。结果表明:长期施用有机肥能够明显增加土壤养分,氮磷和有机肥配施效果显著;和1984年土壤养分状况相比,大田对比试验土壤有机质增加了27.1%,全氮和全磷提高了84.2%和34.8%,有效氮、有效磷和速效钾增加了46.9%、540.0%和10.2%,养分水平与长期定位试验中氮磷配施相近。长期定位试验中氮磷配施或与有机肥配施能够有效地减少土壤剖面中硝酸盐的累积和淋溶,氮肥单施硝态氮累积量最大,为1006.4kg/hm2,大田对比试验土壤硝态氮总累积量较长期定位试验中施用氮肥处理的总累积量少。

大震发生前加卸载响应比变化与应力积累模式研究

<正>加卸载响应比(Yin et al.,2000)是一种中短期地震预测方法,该方法依据潮汐力在地震破裂面上引起的库仑破坏应力变化计算加卸载响应比,并根据其时间序列的演化预测未来地震。我们研究了长期构造加载在地震断层面上引起的应力场变化对加卸载响应比演化的调制作用,发展了一种使用震前应力积累区域取

Annealing effects in silicon implanted with helium

Silicon samples were implanted with helium and analyzed by atomic force microscopy (AFM) and Raman spectroscopy before and after annealing in the range of 523-1273 K. After annealing at 523 K, the amorphous area induced by He-ion implantation at room temperature was partially recovered and grain sizes became larger. The surface morphology was analyzed through AFM measurements and it was observed that root mean square of the surface roughness alters upwards and then downwards with annealing temperature. (C) 2008 Elsevier B.V. All rights reserved.

Defect production in silicon carbide irradiated with Ne and Xe ions with energy of 2.3 MeV/amu

In the present work specimens of mono-crystalline silicon carbide (4H polytype) were irradiated to three successively increasing ion fluences ranging from 7.2 x 10(14) to 6.0 x 10(16) ions/cm(2) (corresponding to the peak displacement damage of 1, 4 and 13 dpa) with Ne and Xe ions respectively with the energy of 2.3 MeV/amu. The irradiated specimens were subsequently annealed at temperatures of 1173 and 1273 K. Defect structure was investigated with transmission electron microscopy (TEM) using a cross-sectional specimen preparation technique. The typical microstructures of the annealed specimens irradiated with Ne or Xe ions to high fluences are characterized by small gas bubbles in high concentration in the peak damage region and black dots and dislocation loops (located in the basal plane) in a shallower and broader depth region. Larger dislocation loops were observed in the Xe-ion irradiated specimen than in the Ne-ion irradiated specimen at the same peak damage level. The enhanced formation of dislocation loops in the case of Xe-ion irradiation is understandable by assuming stronger inclination of heavier inert-gas atoms to occupy substitute site in the peak damage region.

Study on nanohardness of helium-implanted 4H-SiC

The hardness of 4H-SiC, which was high-temperature (500 K) helium-Implanted to fluences of 3 x 10(16) Ions cm(-2) and subsequently thermally annealed at the temperature ranging from 773 to 1273 K, was studied by nanoindentation It is found that the hardness of the implanted 4H-SiC increases at the first, then decreases, and then increases again with increasing annealing tempeature in the temperature range of 500-1273 K, and significant increase in hardness is observed at 773 K. The behavior is ascribed to the changes of the density, length, and tangling of the covalent Si-C bond through the recombination of point defects, clustering of He-vacancy, and growth of helium bubbles during the thermal annealing

土石混合介质饱和导水率的研究

采用恒定水头法对土石混合介质的饱和导水率进行测定,分析不同碎石含量及碎石直径对饱和导水率的影响,同时利用实测值对Peck-W atson及Bouw er-R ice两个传统估算方程的估测精度进行比较。结果表明:(1)饱和导水率随碎石含量先增大后减小,且两者呈二项式关系;(2)饱和导水率随碎石直径增大而减小,两者呈幂函数关系;(3)碎石直径介于1.0~5.0 cm时,Bouw er-R ice和Peck-W atson方程对饱和导水率的估算结果均大于实测值。

用高级氧化技术去除植物油中的多环芳烃

应用植物油淋洗可去除土壤中高浓度多环芳烃,为进一步去除多环芳烃,采用高级氧化(臭氧氧化、过氧化氢和紫外线联合氧化)对两种含多环芳烃植物油进行处理,并考察了运行参数对多环芳烃去除效果的影响.结果表明臭氧具有氧化植物油中多环芳烃的能力,对蒽和荧蒽的氧化能力强于菲.用紫外线、10%过氧化氢,在pH=3的条件下处理MO植物油,总多环芳烃的去除率最高,为81%;按此条件对含高浓度多环芳烃EO植物油处理8 h,总多环芳烃去除率为76.5%,达到良好效果.

浙江产车前(Plantagoasiatica)种群遗传分化的主坐标分析

运用 18个有效的 10mer 寡核苷酸引物对浙江产车前 (Plantagoasiatica)的 8个种群基因组DNA进行了PCR扩增 ,共检测到 186个位点 ,其中多态位点 12 5个 ,占 6 8.70 % .应用Jaccard公式计算了 8个种群在 12 5个位点上的相似性 .以此为基础 ,应用主坐标排序 ,作出了 8个种群遗传分化的三维排序图 .结果表明 ,8个种群的遗传分化与地理位置、海拔高度有联系 .

Novel morphology of polyethylene crystals created upon melt crystallization of spin-coated film

We demonstrate a strikingly novel morphology of high-density polyethylene (HDPE) crystal obtained upon melt crystallization of spin-coated thin film. This crystal gives windmill-like morphology which contains a number of petals. A detailed inspection on this morphology reveals that each petal is actually composed of terrace-stacked PE lamellae, in which the polymer chains within crystallographic a-c planes adopt similar to 45 degrees tilting around b-axis. The surrounding domains associated with a petal of the windmill composed of twisted lamellar overgrowths with an identical orientation of their long axis, which is the crystallographic b-axis shared by the petal and its corresponding twisted lamellar overgrowths.