Disponibilidade de metais pesados em Latossolo com aplicação superficial de escória, lama cal, lodos de esgoto e calcário

O objetivo deste trabalho foi avaliar alguns atributos químicos do solo e a disponibilidade de cádmio (Cd), cromo (Cr), níquel (Ni), mercúrio (Hg), chumbo (Pb) e arsênio (As), por meio da extração pelo DTPA, em conseqüência da aplicação superficial de escória de aciaria, lama cal e lodos de esgoto centrifugados e de biodigestores, nas doses 0 (testemunha), 2, 4 e 8 Mg ha-1 e um tratamento adicional composto pela calagem superficial na dose 2 Mg ha-1. O experimento foi conduzido em delineamento de blocos ao acaso, em condições de campo, em área sob sistema plantio direto, durante 2003 e 2004. A aplicação superficial de escória de aciaria, lama cal, lodo de esgoto centrifugado e de biodigestor, até a dose 8 Mg ha-1, assim como o calcário na dose 2 Mg ha-1, não trazem problemas de disponibilidade ao ambiente, com relação aos metais pesados Cd, Cr, Hg, Pb, Ni e As, quando aplicados sobre a superfície em Latossolo Vermelho distrófico, no sistema plantio direto. A fitodisponibilidade de metais pesados às culturas da soja e aveia-preta foi nula, quando foram aplicadas doses de até 8 Mg ha-1 de lodo de esgoto, escória e lama cal sobre a superfície do solo, no sistema plantio direto.

Metais pesados em águas superficiais como estratégia de caracterização de bacias hidrográficas

The input of heavy metals concentrations determinated by ICP-AES, in samples of the Cambé river basin, was evaluated by using the Principal Component Analysis. The results distinguishes clearly one site, which is strongly influenced by almost all elements studied. Special attention was given to Pb, because of the presence of one battery industry in this area. Some downstream samples were associated with the same characteristics of this site, showing residual action of contaminants along the basin. Other sites presented influence of soil elements, plus Cr near a tannery industry. This study allowed to distinguish different sites in the upper basin of the Cambé (Londrina-PR-BR), in accordance to elements input.

Avaliação quimiométrica da distribuição de metais pesados em composto de lixo urbano domiciliar

The main obstacle to the use of compost from urban waste in agriculture is the presence of heavy metals. Once in the soil, their effect is accumulative and they may contaminate crops and water. The present study reports the evaluation of the chemical distributions of Cu, Pb, Mn and Zn in three different sized fractions (unsieved, < 1,18mm and > 1,18mm) of compost, by means of a sequencial extraction procedure and a chemometric analysis of the total content of all metals in each fraction. The pattern recognition methods showed significant differences in total heavy metal contents for the different fractions. The finest one was the most contaminated. Meanwhile, this fraction presented lower amounts of metals in avaliable forms. This behavior can be attributed to the presence of metal particles in their elemental states in this fraction.

Obtenção de um material adsorvente para íons de metais pesados, através da eletropolimerização de 2-mercaptobenzimidazol à superfície de carbono vítreo reticulado

Electrochemical methods applied to organic species transformation has been used as excellent synthesis tools. C-C bonds can be established, making possible polymer synthesis by both anodic and cathodic reactions of suitable monomer species at the working electrode surface. In this study, anodic procedure was used to electropolymerization of 2-mercaptobenzimidazole at reticulated glassy carbon (RGC) surface. 2-mercaptobenzimidazole presents ligand sites towards Hg2+, Ag+ and Cu2+ ions. The obtained material has been able to adsorb the above mentioned ions in aqueous solution.

Remoção de metais pesados de efluentes industriais por aluminossilicatos

This review had as aim the bibliography research for the use of aluminosilicates to remove heavy metals from wastewaters. Advanced studies based on parameters that have influence for removal of heavy metals as pH, metal concentration, effect of ligants and removal capacity of zeolites and clays, were reported. These studies demonstrate that aluminosilicates can be successfully used for the removal of heavy metals under the optimized conditions.

Distribuição de metais pesados em sedimentos do sistema estuarino da Ilha de Vitória-ES

Heavy-metal concentration in sediment is an important parameter for identifying pollution sources and assessing pollution levels in aquatic ecosystems. In this context, the present study aimed at determining concentrations of heavy metals in sediments from the Vitória estuarine system, Brazil. Twenty nine stations were surveyed to assess the spatial distribution of heavy metals. The metals for silt-clay fractions (<63 µm) were analyzed through atomic absorption spectrometry. A discriminant analysis segregated the stations in four groups representing four areas within the estuarine system. The Espírito Santo Bay showed the lowest metal concentrations, while the Vitória harbor canal showed the highest. We concluded that concentrations of heavy metals reflect natural conditions and the contribution of human activities from sewage and industrial effluents. It was not possible to directly associate metal concentrations to specific pollution sources.

Remoção de metais pesados de efluentes aquosos pela zeólita natural escolecita - influência da temperatura e do pH na adsorção em sistemas monoelementares

Cation exchange capabilities of a Brazilian natural zeolite, identified as scolecite, were evaluated for application in wastewater control. We investigated the process of sorption of chromium(III), nickel(II), cadmium(II) and manganese(II) in synthetic aqueous effluents, including adsorption isotherms of single-metal solutions. The natural zeolite showed the ability to take up the tested heavy metals in the order Cr(III) > Cd(II) > Ni(II) > Mn(II), and this could be related to the valence and the hydration radius of the metal cations. The influence of temperature (25, 40 and 60 ºC) and initial pH value (from 4 to 6) was also evaluated. It was found that the adsorption increased substantially when the temperature was raised to 60 ºC and that maximum adsorption capacity was observed at pH 6. These results demonstrate that scolecite can be used for removal of heavy metals from aqueous effluents, under optimized conditions.

Estudo dos efeitos do silício e do fósforo na redução da disponibilidade de metais pesados em área de mineração

This study was developed with a soil contaminated by heavy metals, with the purpose of evaluating the action of silicon and phosphorus as protection agents through simple extractions by DTPA. The collected samples were prepared and incubated with five doses of silicon and five doses of phosphorus, with four replicates, amounting to 100 experimental units. After 30 and 60 days, samples of each treatment were collected, submitted to pH analyses and simple extraction by DTPA. The amounts of DTPA-extracted metals depended on the doses of silicon and phosphorus and on the pH. Treatments with silicon and phosphorus was efficient in decreasing the availability of heavy metals in soil.

Fracionamento de metais pesados em solo contaminado antes e após cultivo de arroz

The objective of the present work was to evaluate the distribution of Cd, Cu, Mn, Pb and Zn among the different fractions of contaminated soil, before and after rice cultivation. Seven soil samples with different degrees of contamination were studied using a randomized experimental design, with four replicates. Using an ICP-OES we analyzed the contents of heavy metals in fractions of soil, the organic matter therein, the oxides and the residual content before and after rice cultivation. The largest concentrations of Cd, Cu, Mn and Zn in the soil are found in the fractions with stable chemical bonds.

Extração seletiva de metais pesados em sedimentos de fundo do Rio Tietê, São Paulo

Sediment samples from Tietê river were submitted to chemical and sequential extractions of heavy metals (Cd, Cr, Cu, Ni, Pb and Zn). It was followed a single extraction by using 0.1 mol L-1 hydrochloric acid and a sequential procedure to evaluate possible chemical associations described as exchangeable, carbonate, reducible oxides, sulfide, organic matter and residual fractions. High concentrations of heavy metals were determined at Pirapora reservoir, which is closer to the Metropolitan Area of São Paulo while for Barra Bonita reservoir, the results showed low concentrations for such elements. Acid volatile sulfides, grain size distribution and carbon contents were also determined.

Avaliação da contaminação do Igarapé do Sabino (Bacia do Rio Tibiri) por metais pesados, originados dos resíduos e efluentes do Aterro da Ribeira, em São Luís, Maranhão

This work aimed to carry out an environmental monitoring in sabino narrow river (affluent of Tibiri Basin, in São Luís - MA, Brazil), in order to verify the main environmental impacts caused by effluent residues from Ribeira landfill. Chemical analysis and bibliographic and cartographic researches on this ecosystem were also carried out. In addition, heavy metals, such as Hg, Pb and Zn, were investigated in water samples by ICP-MS technique. It was observed that the contents of such heavy metals were above the tolerance limits established by the Brazilian legislation, showing a strong impact level on the evaluated ecosystem.

Retenção de metais pesados em micélio de fungos micorrízicos arbusculares

This work evaluated the kinetics as well as the retention capacity of Cu, Zn, Cd, and Pb by arbuscular mycorrhizal fungi (AMF) mycelium. The metal retention is a fast process with Cu being retained 3, 30, and 60 times faster than Zn, Cd, and Pb, respectively. Metal retention capacity varied amongst the different tested AMF species and decreased in the following order: Cu>Zn>>Cd>Pb. The Glomus clarum mycelium showed the highest retention capacity for Cu, Cd and Pb, whereas Zn was mostly retained by Gigaspora gigantea mycelium. The simultaneous application of all tested metals in solution decreased Cu and Zn retention by AMF mycelium. The high retention capacity of Cu and Zn by mycelium of G. clarum and G. gigantea suggests a promising use of these isolates in phytoremediation.

Bioacumulação de metais pesados e nutrientes no mexilhão dourado do reservatório da Usina Hidrelétrica de Itaipu Binacional

This study aims to evaluate the bioaccumulation of macronutrients and heavy metals in the golden mussel according to its collection site and seasonality in the aquaculture area of the reservoir from April/2009 to March/2010. There is no difference (p > 0.05) in the concentration of metals with respect to the point of collection. The concentrations of Cu, Fe, Mn, Zn, Cd and Pb were higher (p < 0.05) in spring and summer than in fall and winter. Values of the heavy-metal pollution index (MPI) for collection point and seasonality indicate environmental contamination in the aquaculture area.

Influência dos precursores de prata no crescimento de nanopartículas metálicas em vidros óxidos de metais pesados

In this work we report a systematic study on the influence of the chemical nature of silver precursors on the formation of glass-ceramics from oxide glasses. Thermal, structural and optical properties were analyzed as a function of the glass composition. Controlled crystallization was achieved by thermal treatment of the samples above glass transition. The influence of time of treatment on both nanoparticle growth and optical properties of the samples was studied by transmission electron microscopy and UV-Vis spectroscopy, respectively. Results showed that only glasses containing AgCl and AgNO3 led to glass-ceramics growth after thermal treatment.

Estudo da corrosão de cadinhos de SnO2-ZnO, na fusão de vidros contendo metais pesados

Neste trabalho foi estudada resistência de cadinhos de SnO2 dopados com 1%mol de ZnO frente a corrosão na fusão de vidro contendo metais pesados. Os cadinhos foram obtidos através do processo de colagem de barbotina, e a sinterização foi realizada até a temperatura de 1400ºC por 4 horas. Os vidros foram fundidos uma única vez por 1 hora, sendo que o vidro de composição 50B2O3-50PbO à 700 ºC, o de composição 60B2O3-40BaO à 1150 ºC e o de composição 66,67B2O3-33,33PbO à 700 ºC, sendo resfriados no interior dos cadinhos. Estes cadinhos foram então preparados e analisados por MEV-EDS.