Development and characterization of the 2,4,6-trichlorophenol (2,4,6-TCP) aerobic degrading granules in sequencing batch airlift reactor

2,4,6-trichlorophenol (2,4,6-TCP) aerobic degrading granules were successfully developed in the sequencing batch airlift reactor. The key strategy used in cultivation of the granules was dosing glucose and acetate as co-substrates. After granulation, average concentrations of 2,4,6-TCP and COD in the effluent were less than 8mgL-1 and 59mgL-1, respectively. The removal efficiencies of 2,4,6-TCP and COD were above 93% and 90%, respectively. The specific degradation rate of 2,4,6-TCP peaked at 61mg 2,4,6-TCP gVSS-1h-1 when inoculated at the concentration of 400mgL-1. The extracellular polymeric substance (EPS) contents of the 2,4,6-TCP aerobic degrading granules were decreased compared with the contents in seed sludge. Two peaks attributed to the protein-like fluorophores were identified by three-dimensional excitation emission matrix (EEM) fluorescence spectra. The decrease of fluorescence parameters, e.g., peak locations, intensities, indicated quenching effect of 2,4,6-TCP on the EPS fluorescence. Meanwhile, the shift of peak position indicated chemical changes of the EPS.

Implementação do protocolo TCP/IP para sistemas de intrumentação

Baseado na tecnologia de interligação de redes, este trabalho apresenta uma proposta de conexão de dois sistemas com processamento próprio com o intuito de troca de informações, utilizando a pilha de protocolos TCP/IP. Este sistema será empregado em ambientes de controle industrial, permitindo o envio de informações do servidor de dados para o cliente. Os dados são constituídos de leituras feitas em equipamentos de campo, apresentando ao cliente remoto, medições dos mais diversos tipos. Por outro lado, o cliente poderá enviar comandos aos equipamentos de campo visando o telecontrole. Como ponto de partida para a elaboração do trabalho prático, foi utilizado o ambiente de controle do sistema de potência da companhia energética do estado do Rio Grande do Sul (CEEE). Um microcomputador com um browser acessa, através de uma rede local, os equipamentos controlados, que poderão ser qualquer tipo de equipamento de campo empregado em subestações de energia elétrica, como disjuntores, transformadores ou chaves. Para permitir o acesso remoto de tais equipamentos, foi elaborado um servidor de dados constituído de um controlador de rede do tipo Ethernet e um microcontrolador de aplicação específica que se encarrega do processamento da pilha de protocolos. O controlador Ethernet utilizado é um circuito integrado dedicado comercial, que executa o tratamento dos sinais de nível físico e de enlace de dados conforme o padrão IEEE 802.2. O processador TCP/IP, enfoque principal deste trabalho, foi elaborado através da linguagem de programação C, e a seguir traduzido para o Java, que é o ponto de partida para a ferramenta SASHIMI, de geração da descrição em VHDL do microcontrolador de aplicação específica utilizado. O processador TCP/IP encarrega-se da aquisição de dados do equipamento de campo, do processamento da pilha de protocolos TCP/IP, e do gerenciamento do controlador Ethernet. A partir desta descrição VHDL, foi sintetizado o hardware do microcontrolador em um FPGA, que juntamente com o software aplicativo, também fornecido pela ferramenta utilizada, desempenha o papel de processador TCP/IP para o sistema proposto. Neste ambiente, então, o cliente localizado no centro de operação, acessa através de um browser o equipamento de campo, visando obter suas medições, bem como enviar comandos, destacando o aspecto bidirecional para a troca de dados e a facilidade de conexão de dois sistemas heterogêneos. Este sistema pretende apresentar baixo custo de aquisição e de instalação, facilidade de interconexão local ou remota e transparência ao usuário final.

TCP HolyWood

We introduce a new end-to-end, sender side Transport Control Protocol called TCP HolyWood or in short TCP-HW. In a simulated wired environment, TCP HolyWood outperforms in average throughput, three of the more important TCP protocols ever made, we are talking about TCP Reno, TCP Westwood, and TCP Vegas; and in average jitter to TCP Reno and TCP Vegas too. In addition, according to Jain’s index, our proposal is as fair as TCP Reno, the Standard.

Uma ferramenta de manipulação de pacotes para análise de protocolos de redes industriais baseados em TCP/IP

This work presents a packet manipulation tool developed to realize tests in industrial devices that implements TCP/IP-based communication protocols. The tool was developed in Python programming language, as a Scapy extension. This tool, named IndPM- Industrial Packet Manipulator, can realize vulnerability tests in devices of industrial networks, industrial protocol compliance tests, receive server replies and utilize the Python interpreter to build tests. The Modbus/TCP protocol was implemented as proof-of-concept. The DNP3 over TCP protocol was also implemented but tests could not be realized because of the lack of resources. The IndPM results with Modbus/TCP protocol show some implementation faults in a Programmable Logic Controller communication module frequently utilized in automation companies

Simulation in NS-2 of DNP3 protocol encapsulated over TCP/IP in smart grid applications

In dealing with computer networks, these allow the flow of information through the resources of various equipment's. This work describes the implementation through the encapsulation of Protocol DNP3, usually employed in Smart Grid communication, in a simulator of discrete events. The NS-2 is a simulator in open source of network events, that facilitate the development of communication networks scenarios considering the protocols involved, in wireless or wired technologies. The objective of this work is to develop the DNP3 protocol encapsulation over a TCP/IP in the in the discrete event Simulator NS-2, allowing an analysis of behavior of a middle or large network sized in Smart Grid applications. © 2013 IEEE.

Performance analysis of smart grid communication protocol DNP3 over TCP/IP in a heterogeneous traffic environment

This paper presents simulation results of the DNP3 communication protocol over a TCP/IP network, for Smart Grid applications. The simulation was performed using the NS-2 network simulator. This study aimed to use the simulation to verify the performance of the DNP3 protocol in a heterogeneous LAN. Analyzing the results it was possible to verify that the DNP3 over a heterogeneous traffic network, with communication channel capacity between 60 and 85 percent, it works well with low packet loss and low delay, however, with traffic values upper 85 percent, the DNP3 usage becomes unfeasible because the information lost, re-transmissions and latency are significantly increased. © 2013 IEEE.

Monitoramento de hosts em redes tcp/ip sobre base georreferenciada com métricas de qualidade

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

ALBA-TCP: uma cultura de integração regional alternativa para a América Latina?

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento de parafuso de interferência bioabsorvível para cirurgia de joelho em PLDL (poli ácido lático) e compósito PLDL + βTCP (beta trifosfato de cálcio)

Pós-graduação em Engenharia Mecânica - FEB

Análise clínica, tomográfica e histológica comparativa entre ha+β-tcp isolado ou associado a proteínas derivadas do esmalte utilizadas como enxertos após a elevação da membrana do seio maxilar e colocação de implantes: estudo piloto

The aim of this study was to evaluate the clinical, tomographic, and histological similarity within the use of HA+β-TCP (Boneceramic) alone or associated with enamel matrix derived (EMD) proteins in sinus lifting procedures with subsequent dental implant placement. We selected two patients with residual bony ridges between 3 mm and 5 mm in height in need of bone grafts. Six months later, eight implants were installed (two implants at each site). Biopsies were made, and the tissue was processed and stained with HE solution. Tomographic evaluation showed bone height gain up to 10.0 mm on average. Histology showed new bone formation for both groups, with similar bone density and trabecular interconnectivity. It can be concluded that the HA+β-TCP graft isolated or associated to EMD provided bone height gain in sinus lifting procedures, with similar clinical, tomographic and histological characteristics.

In vitro and in vivo biological behavior of CDHA/OCP/β-TCP scaffold

The biological behavior of a new bioactive material composed of calcium-deficient hydroxyapatite, octacalcium phosphate, and beta-tricalcium phosphate was investigated by in vitro indirect and direct cytotoxicity, cell adhesion and proliferation tests, and by in vivo subcutaneous and bone implantation in rats. The results of the in vitro studies showed that the material is biocompatible and no cytotoxic. Slightly poorer initial cell adhesion and lower cell proliferation than in control was observed, which were attributed to the reactivity and roughness of the material surface, In vivo results showed that the material is biodegradable and bioactive in bone tissue, but only biocompatible and partially biodegradable in soft tissue.

Router and Firewall Redundancy with OpenBSD and CARP

As more reliance is placed on computing and networking systems, the need for redundancy increases. The Common Address Redundancy Protocol (CARP) protocol and OpenBSD’s pfsync utility provide a means by which to implement redundant routers and firewalls. This paper details how CARP and pfsync work together to provide this redundancy and explores the performance one can expect from the open source solutions. Two experiments were run: one showing the relationship between firewall state creation and state synchronization traffic and the other showing how TCP sessions are transparently maintained in the event of a router failure. Discussion of these simulations along with background information gives an overview of how OpenBSD, CARP, and pfsync can provide redundant routers and firewalls for today’s Internet.