Geochronological data from the Faxinal coal succession, southern Parana Basin, Brazil: A preliminary approach combining radiometric U-Pb dating and palynostratigraphy

A radiometric zircon age of 285.4 +/- 8.6 Ma (IDTIMS U-Pb) is reported from a tonstein layer interbedded with coal seams in the Faxinal coalfield, Rio Grande do Sul, Brazil. Calibration of palynostratigraphic data with the absolute age shows that the coal depositional interval in the southern Parana Basin is constrained to the Sakmarian. Consequently, the basal Gondwana sequence in the southern part of the basin should lie at the Carboniferous-Permian boundary, not within the Sakmarian as previously considered. The new results are significant for correlations between the Parana Basin and the Argentinian Paganzo Basin (302 +/- 6 Ma and 288 +/- 7 Ma) and with the Karoo Basin, specifically with the top of the Dwyka Tillite (302 +/- 3 Ma and 299.2 +/- 3.2 Ma) and the lowermost Ecca Group (288 +/- 3 Ma and 289.6 +/- 3.8 Ma). The evidence signifies widespread latest Carboniferous volcanic activity in western Gondwana. (C) 2007 Elsevier Ltd. All rights reserved.

Small-Sample Corrections for Score Tests in Birnbaum-Saunders Regressions

In this article, we deal with the issue of performing accurate small-sample inference in the Birnbaum-Saunders regression model, which can be useful for modeling lifetime or reliability data. We derive a Bartlett-type correction for the score test and numerically compare the corrected test with the usual score test and some other competitors.

Three Bartlett-type corrections for score statistics in symmetric nonlinear regression models

We present simple matrix formulae for corrected score statistics in symmetric nonlinear regression models. The corrected score statistics follow more closely a chi (2) distribution than the classical score statistic. Our simulation results indicate that the corrected score tests display smaller size distortions than the original score test. We also compare the sizes and the powers of the corrected score tests with bootstrap-based score tests.

Retrospective application of remote sensing to the Tasmanian lakeland

This thesis describes the research undertaken for a degree of Master of Science in a retrospective study of airborne remotely sensed data registered in 1990 and 1993, and field captured data of aquatic humus concentrations for ~ 45 lakes in Tasmania. The aim was to investigate and describe the relationship between the remotely sensed data and the field data and to test the hypothesis that the remotely sensed data would establish further evidence of a limnological corridor of change running north-west to south- east. The airborne remotely sensed data consisted of data captured by the CSIRO Ocean Colour Scanner (OCS) and a newly developed Canadian scanner, a compact airborne spectrographic imager (CASI). The thesis investigates the relationship between the two kinds of data sources. The remotely sensed data was collected with the OCS scanner in 1990 (during one day) and with both the OCS and the CASI in 1993 (during three days). The OCS scanner registers data in 9 wavelength bands between 380 nm and 960 nm with a 10-20 nm bandwidth, and the CASI in 288 wavelength bands between 379.57 nm and 893.5 nm (ie. spectral mode) with a spectral resolution of 2.5 nm. The remotely sensed data were extracted from the original tapes with the help of the CSIRO and supplied software and digital sample areas (band value means) for each lake were subsequently extracted for data manipulation and statistical analysis. Field data was captured concurrently with the remotely sensed data in 1993 by lake hopping using a light aircraft with floats. The field data used for analysis with the remotely sensed data were the laboratory determined g440 values from the 1993 water samples collated with g440 values determined from earlier years. No spectro-radiometric data of the lakes, data of incoming irradiance or ancillary climatic data were captured during the remote sensing missions. The sections of the background chapter in the thesis provide a background to the research both in regards to remote sensing of water quality and the relationship between remotely sensed spectral data and water quality parameters, as well as a description of the Tasmanian lakes flown. The lakes were divided into four groups based on results from previous studies and optical parameters, especially aquatic humus concentrations as measured from field captured data. The four groups consist of the ‘green” clear water lakes mostly situated on the Central Plateau, the ‘brown” highly dystrophic lakes in western Tasmania, the ‘corridor” lakes situated along a corridor of change lying approximately between the two lines denoting the Jurassic edge and 1200 mm isohyet, and the ‘eastern, turbid” lakes make up the fourth group. The analytical part of the research work was mostly concerned with manipulating and analysing the CASI data because of its higher spectral resolution. The research explores methods to apply corrections to this data to reduce the disturbing effects of varying illumination and atmospheric conditions. Three different methods were attempted. In the first method two different standardisation formulas are applied to the data as well as ‘day correction” factors calculated from data from one of the lakes, Lake Rolleston, which had data captured for all three days of the remote sensing operations. The standardisation formulas were also applied to the OCS data. In second method an attempt to reduce the effects of the atmosphere was performed using spectro-radiometric captured in 1988 for one of the lakes flown, Great Lake. All the lake sample data were time normalised using general irradiance data obtained from the University of Tasmania and the sky portion as calculated from Great Lake upwelling irradiance data was then subtracted. The last method involved using two different band ratios to eliminate atmospheric effects. Statistical analysis was applied to the data resulting from the three methods to try to describe the relationship between the remotely sensed data and the field captured data. Discriminant analysis, cluster analysis and factor analysis using principal component analysis (pea) were applied to the remotely sensed data and the field data. The factor scores resulting from the pca were regressed against the field collated data of g440 as were the values resulting from last method. The results from the statistical analysis of the data from the first method show that the lakes group well (100%) against the predetermined groups using discriminant analysis applied to the remotely sensed CASI data. Most variance in the data are contained in the first factor resulting from pca regardless of data manipulation method. Regression of the factor scores against g440 field data show a strong non- linear relationship and a one-sided linear regression test is therefore considered an inappropriate analysis method to describe the dataset relationships. The research has shown that with the available data, correction and analysis methods, and within the scope of the Masters study, it was not possible to establish the relationships between the remotely sensed data and the field measured parameters as hoped. The main reason for this was the failure to retrieve remotely sensed lake signatures adequately corrected for atmospheric noise for comparison with the field data. This in turn is a result of the lack of detailed ancillary information needed to apply available established methods for noise reduction - to apply these methods we require field spectroradiometric measurements and environmental information of the varying conditions both within the study area and within the time frame of capture of the remotely sensed data.

Modelling of fibre-diameter-dependent light scattering to determine diameter corrections for colour measurement of wool

In this paper, fibre-diameter-dependent light scattering during measurement of wool colour was quantified using the extended multiplicative signal correction technique. Furthermore, a simple-to-apply model has been developed to correct each of the CIE (International Commission on Illumination) X, Y and Z values obtained from colour measurement of fibrous masses. The model was successfully applied to both polypropylene (PP) and wool fibres, though different parameter values were used in each case, indicating different patterns of internal light scattering between PP and wool fibres. After the model corrections, the diameter dependence of measured wool yellowness (Y - Z) was either eliminated or significantly reduced for each of seven sheep flocks distributed widely over the wool-growing regions of Australia.

Case management in community corrections : current status and future directions

Case management is commonly regarded as the foundation of effective service provision across a wide range of human service settings. This article considers the case management that is offered to clients of community corrections, identifying the distinctive features of case management in this particular setting, and reviewing the empirical evidence relating to the effectiveness of different approaches. It is concluded that models of correctional case management that are clearly informed by the principles of risk, need, and responsivity, and which encourage case managers to form strong and meaningful relationships with their clients, are likely to be the most effective.

The corrections Victoria program change manual

This manual has been written to guide the assessment of change in each of the programs currently offered by the Offending Behaviour Programs Branch, Corrections Victoria. The aim is to identify a set of outcome measures that can be used to both evaluate the overall effectiveness of a program as well as inform judgements about the changes that individual offenders have made over the course of their program participation. Accordingly, the focus is on the assessment of short-term change and not on other areas of assessment, such as assessing changes in risk of reoffending, identifying intervention needs, or establishing an offender’s suitability or eligibility to take part in a program.

Application of ionospheric corrections in the equatorial region for L1 GPS users

In the absence of the selective availability, which was turned off on May 1, 2000, the ionosphere can be the largest source of error in GPS positioning and navigation. Its effects on GPS observable cause a code delays and phase advances. The magnitude of this error is affected by the local time of the day, season, solar cycle, geographical location of the receiver and Earth's magnetic field. As it is well known, the ionosphere is the main drawback for high accuracy positioning, when using single frequency receivers, either for point positioning or relative positioning of medium and long baselines. The ionosphere effects were investigated in the determination of point positioning and relative positioning using single frequency data. A model represented by a Fourier series type was implemented and the parameters were estimated from data collected at the active stations of RBMC (Brazilian Network for Continuous Monitoring of GPS satellites). The data input were the pseudorange observables filtered by the carrier phase. Quality control was implemented in order to analyse the adjustment and to validate the significance of the estimated parameters. Experiments were carried out in the equatorial region, using data collected from dual frequency receivers. In order to validate the model, the estimated values were compared with ground truth. For point and relative positioning of baselines of approximately 100 km, the values of the discrepancies indicated an error reduction better than 80% and 50% respectively, compared to the processing without the ionospheric model. These results give an indication that more research has to be done in order to provide support to the L1 GPS users in the Equatorial region.

RINEX_HO: second- and third-order ionospheric corrections for RINEX observation files

When GNSS receivers capable of collecting dual-frequency data are available, it is possible to eliminate the first-order ionospheric effect in the data processing through the ionosphere-free linear combination. However, the second- and third-order ionospheric effects still remain. The first-, second- and third-order ionospheric effects are directly proportional to the total electron content (TEC), although the second- and third-order effects are influenced, respectively, by the geomagnetic field and the maximum electron density. In recent years, the international scientific community has given more attention to these kinds of effects and some works have shown that for high precision GNSS positioning these effects have to be taken into consideration. We present a software tool called RINEX_HO that was developed to correct GPS observables for second- and third-order ionosphere effects. RINEX_HO requires as input a RINEX observation file, then computes the second- and third-order ionospheric effects, and applies the corrections to the original GPS observables, creating a corrected RINEX file. The mathematical models implemented to compute these effects are presented, as well as the transformations involving the earth's magnetic field. The use of TEC from global ionospheric maps and TEC calculated from raw pseudorange measurements or pseudoranges smoothed by phase is also investigated.

Black string corrections in variable tension braneworld scenarios

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Optimal attitude corrections for cylindrical spacecraft

A first order analytical model for optimal small amplitude attitude maneuvers of spacecraft with cylindrical symmetry in an elliptical orbits is presented. The optimization problem is formulated as a Mayer problem with the control torques provided by a power limited propulsion system. The state is defined by Seffet-Andoyer's variables and the control by the components of the propulsive torques. The Pontryagin Maximum Principle is applied to the problem and the optimal torques are given explicitly in Serret-Andoyer's variables and their adjoints. For small amplitude attitude maneuvers, the optimal Hamiltonian function is linearized around a reference attitude. A complete first order analytical solution is obtained by simple quadrature and is expressed through a linear algebraic system involving the initial values of the adjoint variables. A numerical solution is obtained by taking the Euler angles formulation of the problem, solving the two-point boundary problem through the shooting method, and, then, determining the Serret-Andoyer variables through Serret-Andoyer transformation. Numerical results show that the first order solution provides a good approximation to the optimal control law and also that is possible to establish an optimal control law for the artificial satellite's attitude. (C) 2003 COSPAR. Published by Elsevier B.V. Ltd. All rights reserved.