Geochemistry of Neogene sediments of ODP Hole 115-711A

Pelagic sedimentation in the northwest Indian Ocean has been studied using sediments from Hole 711A (the section from 0 to 70.5 mbsf, 0-22 Ma), a deep site (4428 m) drilled during Ocean Drilling Program Leg 115. The clay fraction of the sediments represents poorly developed pelagic deposits with considerably lower contents of Mn, Ba, Cu, Ni, Cr, and Zn than is typical for well-oxidized pelagic sediments formed far from the continents (e.g., in the central Indian or Pacific oceans). Geochemical provenance models, representing conservative mixing models with terrigenous, exhalative-volcanic, and biogenous matter as the only inputs, explain most of the compositional variations in the sediments. The models show that terrigenous matter accounts for about 96%-100% of all SiO2, Al2O3, TiO2, and Zr; about 73%-85% of all Fe2O3, V, and Ni; and about 40%-60% of the Cu and Zn abundances. Exhalative-volcanic matter delivers a large fra tion of Mn (78%-85%), some Fe (15%-219/o), and possibly some Cu (38%-51%). Biogenous deposition is generally of restricted significance; at most 6%-35% of all Cu and Zn may derive from biogenic matter. The exhalative-volcanic matter is slightly more abundant in the oldest deposits, reflecting a plate tectonic drift away from the volcanic Carlsberg Ridge. The Al/Ti ratio reveals that silicic crustal matter plays a somewhat larger role in the upper and lower part of the section studied, whereas the basaltic input is slightly higher in the intermediate levels (age 5-15 m.y.). The sediment abundances of Ba generally exceed those predicted by the models, an anomalous behavior also observed in equatorial Pacific sediments. This is possibly caused by poor knowledge of the input components. Several changes in accumulation rates seem to correlate with climatic changes (onset of monsoon-driven upwellings and sea-level regressions of about 50-100 m at 10, 15-16, and 20-21 Ma). A number of constituents show higher accumulation rates at or shortly after these regressions, suggesting an accelerated removal of fines from shallow oceanic areas. Furthermore, the SiO2/Al2O3 ratio shows a small increase in sediments younger than 10 Ma, implying an increase in biological productivity, particularly after the onset of monsoon-driven upwelling in the northwest Indian Ocean. This trend is paralleled by a general increase in the accumulation rates of Ba and CaCO3. However, these accumulation rates are generally significantly lower than under the biological high-productivity zone in the equatorial Pacific. The onset of these upwelling systems about 10 Ma is probably related to the closing of the gap between India and the main Asiatic continent, preventing free circulation around the Indian subcontinent.

Trace element geochemistry at DSDP Leg 82 Holes

Forty-three samples from DSDP Holes 556-559 and 561-564 were analyzed for rare earth elements (REE), Sc, Cr, Co, Hf, Ta, and Th by instrumental neutron activation analysis. The recovered basalts range from those depleted in light REE (LREE) to those enriched in LREE. The two types of basalts occur together in Holes 558 and 561. The depleted basalts have remarkably constant La/Yb, La/Sm, and La/Ti ratios and apparently derive from a large, homogeneous, mantle source underneath a segment (1200 km long) of the Mid-Atlantic Ridge. The almost twofold variation in the concentrations of incompatible trace elements in the depleted basalts is primarily due to different degrees of batch partial melting. The variation of highly to moderately incompatible elements in the Leg 82 enriched basalts can be successfully explained in terms of source mixing between depleted mantle sources and alkaline or nephelinitic magmas similar to Azores Islands magmas. However, the correlation of LREE enrichment with distance from the Azores Triple Junction is tenuous at best, and the enriched alkaline component is probably not directly related to the Azores volcanism.

Geochemistry of the Japan Trench sediments at DSDP Legs 56-57 Holes

The main objective of this investigation was to study distribution of main chemical constituents and several minor elements in sediment sections drilled during DSDP Legs 56 and 57 in the Japan Trench, in order to infer geochemical features of different lithologic types of sediments, and to find out how the geochemistry is associated with major lithologic constituents, such as terrigenous detrital matter, clay, volcanic ash, and biogenic particles. The geochemical data may help to indicate the nature of the sediments and to interpret sedimentation processes. The analyzed samples seem to be representative of most lithologic units, sub-units, and sediment types drilled at all sites on both legs, except for some shallow-water deposits at Sites 438 and 439. We analyzed bulk-sediment composition by X-ray fluorescence (Kuzmina and Turanskaya) and routine wet-chemical methods (Mikhailov); amorphous SiO2, extracted in a boiling sodium carbonate solution (Analythical Laboratory, P. P. Shirshov Institute of Oceanology); Cr, Zn, Cu, Ni, Co, and Al by atomic absorption (Gordeev); and Sn, Pb, Zn, Cu, Ni, Co, Cr, V, B, and Ag by quantitative spectrographic analyses in both bulk samples and granulometric fractions (Mikhailov). In addition, Fe, Ti, Mn, and CaCO3 have been determined in selected samples by routine wet-chemical methods (Analytical Laboratory, P. P. Shirshov Institute of Oceanology). Murdmaa was responsible for interpretation of the results.

Geochemistry of ODP Leg 135 igneous rock samples

Ocean Drilling Program Leg 135 provided igneous rock cores from six sites drilled on a transect across the Lau Basin between the Lau Ridge remnant arc and the modem spreading ridges of the Central and Eastern Lau Spreading Centers. The drill cores sampled crust from the earliest stage of backarc extension (latest Miocene time, about 6 Ma), and younger crust (late Pliocene, about 3.8-2 Ma, and middle Pleistocene, about 0.64-0.8 Ma). Nearly all of the igneous samples are from tholeiitic basalt flows; many of them are interbedded with arc-composition volcaniclastic sediments. Rock compositions range from olivine-plagioclase-clinopyroxene basalt, with up to 8% MgO, to oceanic andesites with less than 3.2% MgO and silica contents as high as 56%. The oldest rocks recovered are close in composition to rocks formed at the modern Central and Eastern Lau Spreading Centers and have MORB-like characteristics. Generation of the oldest units was coeval with arc-tholeiitic volcanism on the Lau Ridge less than 100 km to the west. The arc and backarc melts came from different mantle sources. At three sites near the center of the basin, the crust is arc-tholeiitic basalt, two-pyroxene basaltic-andesite, and two-pyroxene andesite. These rocks have many similarities to modem Tofua Arc lavas yet they were drilled within 70 km of the MORB-like Eastern Lau Spreading Center. Estimates of the minimum age for these arc-like rocks indicate that they are late Pliocene (about 2 Ma). These ages overlap the age of the nearby Eastern Lau Spreading Center. The heterogeneous crust of the Lau Basin carries many of the signatures of supra-subduction zone (SSZ) melts but also has a distinct MORB-like component. Mixing between SSZ and MORB mantle sources may explain the variations and the spatial distribution of magma types.

Chemical composition of igneous rocks and origin of the sill and pillow-basalt complex at DSDP Site 61-462

The sill and pillow complex cored on Deep Sea Drilling Project Leg 61 (Site 462) is divided into two groups, A and B types, on the basis of chemical composition and volcanostratigraphy. The A-type basalt is characterized by a higher FeO*/MgO ratio and abundant TiO2, whereas the B-type basalt is characterized by a lower FeO*/MgO ratio and scarcity of TiO2. The A type is composed of sills interbedded with hyaloclastic sediments, and the B type consists of basalt sills and pillow basalt with minor amounts of sediment. However, the structure of pillow basalts in the B type is atypical; they might be eruptive. From paleontological study of the interbedded sediments and radiometric age determination of the basalt, the volcanic event of A type is assumed to be Cenomanian to Aptian, and that of B type somewhat older. The oceanic crust in the Nauru Basin was assumed to be Oxfordian, based on the Mesozoic magnetic anomaly. Consequently, two events of intraplate volcanism are recognized. It is thus assumed that the sill-pillow complex did not come from a normal oceanic ridge, and that normal oceanic basement could therefore underlie the complex. The Site 462 basalts are quartz-normative, and strongly hypersthene-normative, and have a higher FeO*/MgO ratio and lower TiO2 content. Olivine from the Nauru Basin basalts has a lower Mg/(Mg + Fe**2+) ratio (0.83-0.84) and coexists with spinel of lower Mg/(Mg + Fe**2+) ratio when compared to olivine-spinel pairs from mid-ocean ridge (MAR) basalt. The glass of spinel-bearing basalts has a higher FeO*/(FeO* + MgO) ratio (0.58-0.60) than that of MAR (<0.575). Therefore, the Nauru Basin basalts are chemically and mineralogically distinct from ocean-ridge tholeiite. That the Nauru Basin basalts are quartz-normative and strongly hypersthene-normative and have a lower TiO2 content suggests that the basaltic liquids of Site 462 were generated at shallower depths (<5 kbar) than ocean-ridge tholeiite: Site 462 basalts are similar to basalts from the Manihiki Plateau and the Ontong-Java Plateau, but different from Hawaiian tholeiite of hot-spot type, with lower K2O and TiO2 content. We propose a new type of basalt, ocean-plateau tholeiite, a product of intraplate volcanism.

Characteristics of light and dark alternations in Owen Ridge sediments (Appendix)

Clay mineral relative abundances in approximately 450 samples from cores recovered during ODP Leg 117 in the Arabian Sea have been used to examine the paleoclimatic, paleoenvironmental, and tectonic histories of the Indus Fan, Owen Ridge, Oman margin, and adjacent continental source regions. Geographic variations in the relative abundances of minerals and correlations with depositional processes support previous interpretations that smectite has been supplied from weathering of the Deccan Traps; illite and chlorite have been supplied either from the Himalayas via marine transport or from the Iran-Makran region by winds; and palygorskite has been supplied from the Arabian peninsula and Somalia by winds. Pleistocene sediments of the Indus Fan record two modes of deposition: turbidites supplied from the Indus drainage and dominated by illite and chlorite, and pelagic carbonates containing smectites and wind-transported palygorskite. Local and regional causes for shifts between these depositional processes cannot be demonstrated conclusively with the data available, but sea-level fluctuations probably exerted a significant control on the rate of turbidite influx. Lower Miocene sediments on the Owen Ridge are also turbidites supplied by the Indus drainage; in the middle Miocene, a shift to pelagic carbonates records the uplift of the Owen Ridge, and is accompanied by the increased relative importance of wind-transported palygorskite. Associations of palygorskite and biosiliceous components in middle to upper Miocene sediments are interpreted to record vigorous monsoonal circulation and accompanying upwelling-produced biological productivity. Mineralogic and geochemical data indicate that light/dark color alternations in upper Miocene sediments on the Owen Ridge record climatic fluctuations, but the climatic significance of similar alternations in Pliocene-Pleistocene sediments is unclear. Palygorskite is the dominant clay on the Oman margin, reflecting proximity to its source areas. On the Oman margin, clay mineral relative abundances are most variable at structurally complex sites, indicating that local depositional settings have been influenced by their tectonic histories since the Miocene.