3D Analysis of Heat Transfer Intensification by Re-Entrance Flow Pin-Fins Microstructures with a Highly Thermal-Conductive Plate

Joule heat-induced hot-spot formation sets severe limits in the operation of continuous annular electrochromatography (CAEC), a new concept for preparative separation as an analog to analytical capillary electrochromatography (CEC). This may lead to eluent flow perturbance, even to boiling, which would massively weaken separation efficiency and may even hamper the stationary phase used for separation. For reasons of system integration and high-efficiency heat transfer, micro flow heat exchangers are considered with a separate coolant flow. A 3D numerical analysis of the heat transfer of water single-phase laminar flow in a square microchannel and different arrays of micro pin-fins was carried out using COMSOL Multiphysics. Several advanced materials with low electric conductivity and at the same time with high heat conductivity were put forward to be used in the CAEC system. As essential design point, it is proposed to constitute the micro heat exchanger from two different parts of the CAEC system, namely a microstructured pin-fins plate and a so-called conductive plate.

Analysis of the 3D zone of flow establishment from a ship’s propeller

In the present study an experimental investigation of the time-averaged velocity and turbulence intensity distributions from a ship’s propeller, in “bollard pull” condition (zero speed of advance), is reported. Previous studies have focused mainly on the velocity profile of not a rotating ship propeller but a plain jet. The velocity profile of a propeller is investigated experimentally in this study.
The velocity measurements were performed in laboratory by using a Laser Doppler Anemometry (LDA). The measurements demonstrated two-peaked ridges velocity profile with a low velocity core at the centre within the near wake. The two-peaked ridges combined to be one-peaked ridge at 3.68 diameters downstream indicating the end of the zone of flow establishment. The study
provides useful information from a rotating ship’s propeller rather than a simplified plain jet to researchers investigating flow velocity generated from a propeller and probably resulting local scouring.

Accounts of debates in the House of Commons, March– April 1731, supplementary to the diary of the first earl of Egmont

John Perceval (1685–1748), 1st Viscount Perceval and (from 1733) 1st Earl of Egmont, was an assiduous recorder of his own life and times. His diaries, published by the Historical Manuscripts Commission from manuscripts in the British Library, are the best source for parliamentary debates at Westminster in the 1730s. For the years 1730-1733, when Perceval sat in the Commons (as an Irish peer) they are remarkably full. His practice seems to have been to prepare two versions (presumably on the basis of notes taken in the House), the first attributing speeches to individuals, and the second, entered up in the diary, which listed speakers and summarized all arguments on each side. His letterbooks for 1731 contain accounts of five debates that embody his first editing process, with speeches attributed to individuals. They were sent to an Irish correspondent, Marmaduke Coghill, and largely omitted from the diary because Perceval had already transcribed them elsewhere. They are new to historians and cast light on two main issues: the unsuccessful attempts by Perceval and the ‘Irish lobby’ to persuade the British parliament to settle the Irish woollen trade, a question bedevilling Anglo-Irish relations in this period; and an attempt by the opposition to stir up anger against perceived Spanish aggression against Gibraltar. One of the most interesting features is the insight afforded into the Commons performances of Sir Robert Walpole: his management of debates, his own style of speaking, and his sharp exchanges with opponents like William Pulteney.

3D Analysis of Seepage under Hydraulic Structures with Intermediate Filters

Seepage flow under hydraulic structures provided with intermediate filters has been investigated. The flow through the banks of the canal has been included in the model. Different combinations of intermediate filter and canal width were studied. Different lengths of the floor, differential heads, and depths of the sheet pile driven beneath the floor were also investigated. The introduction of an intermediate filter to the floor of hydraulic structures reduced the uplift force acting on the downstream floor by up to 72%. The maximum uplift reduction occurred when the ratio of the distance of filter location downstream from the cutoff to the differential head was 1. Introducing a second filter in the downstream side resulted in a further reduction in the exit hydraulic gradient and in the uplift force, which reached 90%. The optimum locations of the two filters occurred when the first filter was placed just downstream of the cutoff wall and the second filter was placed nearly at the middistance between the cutoff and the end toe of the floor. The results showed significant differences between the three-dimensional (3D) and the two-dimensional (2D) analyses.

A Zoologist with a Taste for the Past: The Earl of Cranbrook’s Contribution to Zooarchaeological Research in Southeast Asia

The Earl of Cranbrook (V) (then Lord Medway) was fi rst introduced to archaeological research in 1958 when he participated in excavations at the Niah Caves, Sarawak Borneo. In that same year he published a paper entitled ‘Food bone in Niah Cave excavations (-1958)’ in the Sarawak Museum Journal. Unbeknownst to him at the time, his individual and intuitive research was on a par with, if not methodologically ahead of, burgeoning studies in the fi eld of zooarchaeology that were taking place at leading academic institutions in Europe and the United States. This paper recounts and lauds the signifi cant contributions the Earl of Cranbrook has made to the establishment and furtherance of a discipline over more than 50 years. 

Radiative rates for E1, E2, M1, and M2 transitions among the 3s23p5, 3s3p6, and 3s23p43d configurations of Cl-like W LVIII

We report calculations of energy levels, radiative decay rates, and lifetimes for transitions among the 3s²3p⁵, 3s3p⁶, and 3s²3p⁴3d configurations of Cl-like W LVIII. The general-purpose relativistic atomic structure package (GRASP) has been adopted for our calculations. Comparisons are made with the most recent results of Mohan et al. (Can. J. Phys. 92, 177 (2014). doi:10.1139/cjp-2013-0348) and discrepancies in lifetimes are noted, up to four orders of magnitude in some instances. Our energy levels are estimated to be accurate to better than 0.5%, whereas results for radiative rates and lifetimes should be accurate to better than 20%.

3D Reconstruction of Medical Images from Slices Automatically Landmarked with Growing Neural Models

In this study, we utilise a novel approach to segment out the ventricular system in a series of high resolution T1-weighted MR images. We present a brain ventricles fast reconstruction method. The method is based on the processing of brain sections and establishing a fixed number of landmarks onto those sections to reconstruct the ventricles 3D surface. Automated landmark extraction is accomplished through the use of the self-organising network, the growing neural gas (GNG), which is able to topographically map the low dimensionality of the network to the high dimensionality of the contour manifold without requiring a priori knowledge of the input space structure. Moreover, our GNG landmark method is tolerant to noise and eliminates outliers. Our method accelerates the classical surface reconstruction and filtering processes. The proposed method offers higher accuracy compared to methods with similar efficiency as Voxel Grid.