EXPERIMENTAL INCIPIENT NEST TRANSPLANTS AND SURVIVORSHIP OF SOLENOPSIS-INVICTA BUREN (HYM, FORMICIDAE) IN BRAZIL

Transplants of incipient colonies of the fire ant, Solenopsis invicta into areas in which mature colonies had been eliminated did not result in higher rates of success than in areas in which mature colonies were present. However for both types of sites, Pogonomyrmex (Ephebomyrmex) nagelli colonies were found in cleared sites used for transplants, with the number of translocated P. nagelli nests higher in areas which had not been treated with Mirex for S. invicta colony reduction. These results suggest that small colonies may be displaced by larger colonies of other species.

PATTERNS OF COLONIZATION AND INCIPIENT NEST SURVIVAL IN ACROMYRMEX-NIGER AND ACROMYRMEX-BALZANI (HYMENOPTERA, FORMICIDAE)

Patterns of colonization by queens and incipient nest survival of the leaf-cutting ants Acromyrmex niger and Acromyrmex balzani were studied by means of belt transects and individually marked incipient nests. No relation was found between colony density and the number of colonization attempts. Both species are not claustral, and high rates of queen mortality were attributed to conspecific executions and predation. of other discernable mortality factors, failure of fungal garden establishment was the most important. Only 34 of 296 A. balzani and 13 of 154 A. niger marked colonies were alive at the end of one year. These figures are higher than those reported for species of Atta. These results are contrasted with those of claustral-founding Atta species. Small colonies are occasionally raided by larger colonies which robbed brood.

Determination and statistical treatment of short-circuit currents for faults on the lines of networks of 440 kV CESP system

The distribution of short-circuit current is investigated by means of two methods, one direct and the other analytic; both methods consider uniform probability distribution of line faults. In the direct method, the procedure consists of calculating fault currents at equidistant points along the line, starting from one of the end points and considering the other end open. The magnitude of the current is classified according to Brazilian standards (regulation NBR-7118). The analytic method assumes that the distribution of short-circuit currents through the busbar and the distribution of the line length connected to it are known, as well as the independence of values. The method is designed to determine the probability that fault currents through a line will surpass the pre-established magnitude, thus generating frequency distribution curves of short-circuit currents along the lines.

Swarming and incipient colonies of Coptotermes havilandi (Isoptera, Rhinotermitidae)

Coptotermes havilandi Holmgren is an oriental species introduced into Brazil. Despite its economic impact as structural pest, very little is known about the biology of this termite. This paper describes observations of C. havilandi swarming in the city of Rio Claro (SP, Brazil), and reports the first data on incipient colonies reared in a laboratory in Brazil. The preoviposition period lasted about a week after pairing; oviposition began in most of the incipient colonies during the second week. Antennal mutilation occurred on all reproductives. The mean number of the first batch of eggs was 13. In general, first instar brood hatched 60-70 days after set up of the colonies. After two years of pairing there was a small population (less than 100 individuals) and limited soldier production (n=2) in incipient colonies of C. havilandi.

Growth patterns of incipient colonies of Coptotermes havilandi (Isoptera, Rhinotermitidae) initiated in the laboratory from swarming alates

Fifty two colonies of Coptotermes havilandi were set up under laboratory conditions using alates collected from an urban area during a period of swarming. The first artificial nest used for each royal couple was a 6cm diameter Petri dish (22ml) filled with a moistened matrix of decayed pine sawdust. After 6 months, these colonies were transferred to 250ml plastic containers with the same culturing matrix. After 24 months a census of all colonies was performed. Each young colony had a live royal pair and the population size of all colonies indicated a nonlinear development. The total population (workers + soldiers + immatures + reproductives) of these incipient colonies ranged from 64 to 1, 164, with a mean of 345 individuals. The number of workers ranged from 53 to 830 individuals, and the number of soldiers ranged from 6 to 83. The present data showed a higher population of incipient colonies than our previous record for the species. We also compared the development of 12 transferred colonies to that of 12 untransferred incipient colonies. The results showed a higher population in transferred colonies, but in both incipient colonies (transferred and untransferred) there was a wide variation in total population. The correlation between queen weight and population size was positive in all 24 colonies.

Investigating effects of neutral wire and grounding in distribution systems with faults

In some applications like fault analysis, fault location, power quality studies, safety analysis, loss analysis, etc., knowing the neutral wire and ground currents and voltages could be of particular interest. In order to investigate effects of neutrals and system grounding on the operation of the distribution feeders with faults, in this research a hybrid short circuit algorithm is generalized. In this novel use of the technique, the neutral wire and assumed ground conductor are explicitly represented. Results obtained from several case studies using IEEE 34-node test network are presented and discussed.

Location of single line-to-ground faults on distribution feeders using voltage measurements

This paper proposes a dedicated algorithm for lation of single line-to-ground faults in distribution systems. The proposed algorithm uses voltage and current phasors measured at the substation level, voltage magnitudes measured at some buses of the feeder, a database containing electrical, operational and topological parameters of the distribution networks, and fault simulation. Voltage measurements can be obtained using power quality devices already installed on the feeders or using voltage measurement devices dedicated for fault location. Using the proposed algorithm, likely faulted points that are located on feeder laterals geographically far from the actual faulted point are excluded from the results. Assessment of the algorithm efficiency was carried out using a 238 buses real-life distribution feeder. The results show that the proposed algorithm is robust for performing fast and efficient fault location for sustained single line-to-ground faults requiring less than 5% of the feeder buses to be covered by voltage measurement devices. © 2006 IEEE.

Stacking faults in SiCf/SiC composite obtained by chemical vapor reaction process

SiC fiber-reinforced SiC matrix composite (SiCf/SiC) is one of the leading candidates in ceramic materials for engineering applications due to its unique combination of properties such as high thermal conductivity, high resistance to corrosion and working conditions. Fiber-reinforced composites are materials which exhibit a significant improvement in properties like ductility in comparison to the monolithic SiC ceramic. The SiCf/SiC composite was obtained from a C/C composite precursor using convertion reaction under high temperature and controlled atmosphere. In this work, SiC phase presented the stacking faults in the structure, being not possible to calculate the unit cell size, symmetry and bond lengths but it seem equal card number 29-1129 of JCPDS.

Metodologia baseada em sistema fuzzy intervalar do tipo-2 para detecção e identificação de faltas de incipientes em motores de indução

Desde a incorporação da automação no processo produtivo, a busca por sistemas mais eficientes, objetivando o aumento da produtividade e da qualidade dos produtos e serviços, direcionou os estudos para o planejamento de estratégias que permitissem o monitoramento de sistemas com o intuito principal de torna-los mais autônomos e robustos. Por esse motivo, as pesquisas envolvendo o diagnóstico de faltas em sistemas industriais tornaram-se mais intensivas, visto a necessidade da incorporação de técnicas para monitoramente detalhado de sistemas. Tais técnicas permitem a verificação de perturbações, falta ou mesmo falhas. Em vista disso, essa trabalho investiga técnicas de detecção e diagnostico de faltas e sua aplicação em motores de indução trifásicos, delimitando o seu estudo em duas situações: sistemas livre de faltas, e sobre atuação da falta incipiente do tipo curto-circuitoparcial nas espiras do enrolamento do estator. Para a detecção de faltas, utilizou-se analise paramétrica dos parâmetros de um modelo de tempo discreto, de primeira ordem, na estrutura autoregressivo com entradas exógenas (ARX). Os parâmetros do modelo ARX, que trazem informação sobre a dinâmica dominante do sistema, são obtidos recursivamente pela técnica dos mínimos quadrados recursivos (MQR). Para avaliação da falta, foi desenvolvido um sistema de inferência fuzzy (SIF) intervala do tipo-2, cuja mancha de incerteza ou footprint of uncertainty (FOU), características de sistema fuzzy tipo-2, é ideal como forma de representar ruídos inerentes a sistemas reais e erros numéricos provenientes do processo de estimação paramétrica. Os parâmetros do modelo ARX são entradas para o SIF. Algoritmos genéricos (AG’s) foram utilizados para otimização dos SIF intervalares tipo-2, objetivando reduzir o erro de diagnóstico da falta identificada na saída desses sistemas. Os resultados obtidos em teste de simulação computacional demonstram a efetividade da metodologia proposta.

Desenvolvimento de um sistema inteligente para o diagnóstico e prognóstico de falhas em sistemas de distribuição de energia elétrica

Pós-graduação em Engenharia Elétrica - FEIS

Demineralization and hydrogen peroxide penetration in teeth with incipient lesions

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Expert system to detect incipient fauts in rotating machines using fuzzy logic and virtual instrumentation

This paper refers to the design of an expert system that captures a waveform through the use of an accelerometer, processes the signal and converts it to the frequency domain using a Fast Fourier Transformer to then, using artificial intelligence techniques, specifically Fuzzy Reasoning, it determines if there is any failure present in the underlying mode of the equipment, such as imbalance, misalignment or bearing defects.