Effect of low-fluoride toothpastes combined with hexametaphosphate on in vitro enamel demineralization

Objectives: The aim of this study was to evaluate the anticaries effect of low-fluoride toothpastes combined with hexametaphosphate (HMP) on enamel demineralization.Methods: Bovine enamel blocks were subjected to pH cycling and treatment with toothpaste's slurries (15 groups; 2x/day). Toothpaste mixtures contained the following: no fluoride (F) plus HMP (from 0 to 3.0%); 250 ppm F plus HMP (from 0 to 3.0%); 500 ppm F; 1100 ppm F; and a commercial toothpaste (1100 ppm F). After pH cycling, surface and cross-sectional hardness, as well as F present in the enamel were determined. The demineralization depth was analyzed using polarized light microscopy. The variables were subjected to 1-way ANOVA, followed by Student-Newman-Keuls' test (p < 0.05).Results: In the absence of fluoride, 0.5% HMP promoted the lowest mineral loss and its effect was similar to that of a 250 ppm F toothpaste (p > 0.05). The combination of 0.5% HMP and 250 ppm F resulted in lower mineral loss (p < 0.05) and similar lesion depth when compared to the 1100 ppm F toothpaste (p > 0.05).Conclusion: To conclude, the combination of 0.5% HMP and 250 ppm fluoride in a toothpaste has a similar inhibitory effect on enamel demineralization in vitro when compared to a toothpaste containing 1100 ppm F.Clinical significance: The anticaries effect of toothpaste containing 250 ppm F combined with 0.5% HMP was similar to that of a 1100 ppm F toothpaste, despite the 4-fold difference in F concentration. Although such effects still need to be demonstrated in clinical studies, it may be a viable alternative for preschool children. (C) 2013 Elsevier Ltd. All rights reserved.

Bonding durability of dental sealants to deciduous and permanent teeth

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

In situ assessment of the saliva effect on enamel morphology after microabrasion technique

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeito da microabrasão e do clareamento dental na rugosidade superficial e microdureza do esmalte dental: estudo longitudinal ‘in situ’

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

In situ evaluation of low-fluoride toothpastes associated to calcium glycerophosphate on enamel remineralization

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Limitations of enamel microabrasion technique applied in a pediatric patient: case report

Enamel microabrasion is a non-invasive method that removes intrinsic and superficial defects from teeth aimed to improve dental esthetic with minimal loss of dental tissue. This case presentation describes the attempt for teeth color correction utilizing that conservative technique in a young girl whose upper central incisor presented an opaque white stain. Scanning electron microscopy (SEM) was conducted in order to illustrate the glasslike luster and a smooth texture of microabraded enamel surface. The correct diagnosis of defect is a difficult task, when consider this conservative approach.

Hipomineralización incisivo Y molar: diagnóstico diferencial

Hypomineralized first molar often in combination with hypomineralized incisors (MIH - molar incisor hypomineralization) is a common finding in everyday practice. In this condition, hypomineralized dental enamel is fragile and soft, and it can break easily leading to an exposed dentin, and causing dental sensitivity and progression of caries lesions. The prevalence of MIH range from 3.6 to 25% in North of Europe that consider this condition a public health problem. No conclusive information was reported about the etiologic factors of MIH, however, systemic causes seem to be of importance. Several aetiological factors are mentioned as the cause of this condition and they are frequently associated with complications during pregnancy and childhood diseases during the first three years of life. MIH is frequently misinterpreted as fluorosis, hypoplasia or amelogénesis imperfect, however, this condition presents defined clinical aspects that can distinct it from the other defects.

Efeitos de diferentes sistemas de clareamento dental sobre a rugosidade e morfologia superficial do esmalte e de uma resina composta restauradora

The aim of this study was to evaluate and compare the roughness and superficial morphology of enamel and a composite restorative resin after different bleaching techniques application. Material and Methods: Bovine incisors were selected and standardized cavities were prepared on the buccal surface, which were restored with composite resin. The teeth were distributed according to the following treatments: G1- bleaching with 10% carbamide peroxide (CP); G2 - bleaching with 38% hydrogen peroxide (HP); and G3 - bleaching with 38% of HP associated to light irradiation. For G1, the bleaching gel was applied for 8 hours daily during 21 days. For G2 and G3, 3 sessions were performed, consisting of 3 applications of 15 minutes each, with 7 days of intervals between the sessions. For G3, the LED (470nm) light was used to activate the bleaching agent for 6 minutes. The surface of enamel and composite resin were evaluated before and after the bleaching procedures using a roughness tester and an atomic force microscope. Results: The results showed significant differences in surface roughness of enamel after bleaching only for G1 (Wilcoxon, p<0.05). For composite resin, neither group showed a statistical difference compared to control (Mann-Whitney, p>0.05). Conclusion: It was concluded that the increase in the roughness of enamel occurred only after bleaching therapy using a gel with 10% of CP. The bleaching procedures evaluated in this investigation did not increase the roughness or cause changes in the superficial morphology of the composite resin.

Correlation between pH and surface structural changes on human enamel submitted to different tooth whitening agents

The intense valuation of an esthetic pleasant smile guided the dentistry to bleached tooth due the popularity of whitening treatments. The consequence of it is an increasing interest in searching the effect of peroxides in hard dental tissues. The aim of this work was to analyze qualitatively in vitro the human enamel after three different bleaching treatments: Opalescence PF 10%, White Class 7.5% and Opalescence Xtra Boost 38%, correlating the structural changes in the surface of the enamel with its respective pH. A total of 40 sound human pre-molars were randomly divided into four groups of 10 elements, which had been immersed in artificial saliva during all the experiment. Bleaching protocols followed the recommendations of the respective manufacturers. Each bleached sample and control group were submitted to a scanning electronic microscopy analysis and compared with one another. Bleaching agents used in this experiment had modified the morphologic aspect of the surface of the dental enamel; however, it did not have correlation between the degrees of severity of the alterations and pH. There is a correlation between hydrogen peroxide concentration and changes in the enamel, where G4 showed more severe alterations, followed for G3 and G2.

Microhardness of the enamel exposed to whitening dentifrices

The purpose of this study is to verify the effect of three different types of dentifrices on the superficial microhardness of bovine enamel. Methods: Forty-eight 4x4mm dental fragments were polished and randomly divided into 4 groups: GI, conventional silica-based dentifrice; GII, hydrogen peroxide-based dentifrice; GIII, carbamide peroxide-based dentifrice; and GIV, immersion in artificial saliva. After polished, the specimens received five indentations of 25g static load, for 5 seconds. Subsequently, specimens from groups GI, GII and GIII were immersed in solution containing dentifrice and distilled water, in weight proportion of 1:2, for 15 minutes daily. After this period, fragments were rinsed in tap water and stored in artificial saliva at 37oC. This procedure was repeated for 21 days and then a new analysis of the microhardness was performed. Results and conclusion: The results were submitted to ANOVA and Fisher’s test at 5%. It was concluded that all samples treated with dentifrices showed hardness decrease, being most pronounced in dentifrices containing peroxide.

Effects of probiotic fermented milk on biofilms, oral microbiota, and enamel

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência de diferentes métodos de esterilização de esmalte dental sobre a sua morfologia, composição química, estrutura e formação de biofilmes in vitro

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influência de polímeros bioadesivos sobre o efeito protetor do flúor no desenvolvimento da erosão dental

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Microabrasion in tooth enamel discoloration defects: three cases with long-term follow-ups

Superficial irregularities and certain intrinsic stains on the dental enamel surfaces can be resolved by enamel microabrasion, however, treatment for such defects need to be confined to the outermost regions of the enamel surface. Dental bleaching and resin-based composite repair are also often useful for certain situations for tooth color corrections. This article presented and discussed the indications and limitations of enamel microabrasion treatment. Three case reports treated by enamel microabrasion were also presented after 11, 20 and 23 years of follow-ups.

Effects of copper vapor laser irradiation (λ = 510.6 nm) on the enamel and dentine of human teeth: An ultra-structural morphologic study

Objective: A morphological and ultra-structural study of copper vapor laser (λ = 510.6 nm) effects on enamel and dentine was performed to show the effects of this radiation. Methods: A total of 15 human molars were cut in half; 15 pieces were separated for irradiation on enamel and 15 for dentine. These two groups were further divided into five experimental groups, including a control group, comprised of three half-sections each, irradiated by a CVL laser with a power of 7 W, a repetition rate of 15,000 pulses/sec and exposed at 500, 600, and 800 msec and 1 sec irradiation times with a 5-sec interval between irradiations. Results: In an ultra-structural SEM exam, we observed that on the enamel surfaces irradiated for 1 sec there was morphological alteration that consisted of catering, flaking, and melting on the surfaces. There was no alteration for the other exposure times. On the dentine teeth irradiated for 1 sec, we observed an evident ultra-structural alteration of melted tissue and loss of morphological characteristics. In the dentine group irradiated by 800 msec, we observed ablation and a partial loss of morphological characteristics. In the dentine groups irradiated by 500 and 600 msec, no alteration was observed. Conclusions: The results showed that irradiation with CVL promoted morphologic changes in the enamel as well as in the dentine and demonstrated a need for future studies in order to establish a safe protocol for further use in the odontological practice.