Numerical prediction of load-displacement behaviors of adhesively bonded joints at different extension rates and temperatures

The present work focuses on simulation of nonlinear mechanical behaviors of adhesively bonded DLS (double lap shear) joints for variable extension rates and temperatures using the implicit ABAQUS solver. Load-displacement curves of DLS joints at nine combinations of extension rates and environmental temperatures are initially obtained by conducting tensile tests in a UTM. The joint specimens are made from dual phase (DP) steel coupons bonded with a rubber-toughened adhesive. It is shown that the shell-solid model of a DLS joint, in which substrates are modeled with shell elements and adhesive with solid elements, can effectively predict the mechanical behavior of the joint. Exponent Drucker-Prager or Von Mises yield criterion together with nonlinear isotropic hardening is used for the simulation of DLS joint tests. It has been found that at a low temperature (-20 degrees C), both Von Mises and exponent Drucker-Prager criteria give close prediction of experimental load-extension curves. However. at a high temperature (82 degrees C), Von Mises condition tends to yield a perceptibly softer joint behavior, while the corresponding response obtained using exponent Drucker-Prager criterion is much closer to the experimental load-displacement curve.

The effectiveness of peer-based interventions on health promoting behaviors in older people: A systematic review protocol of quantitative evidence

Peer-based interventions have the potential to enhance quality of life and functioning; however their role specifically within the older population has not been fully investigated. The objective of this review therefore is to locate, appraise and synthesise evidence on the effectiveness of peer-based interventions on changes in health behaviors, specifically for the older population. The specific question to be answered is: “what is the effectiveness of peer-based interventions on health promoting behaviors in older adults, when compared to non peer-based interventions?”

International survey of bicycling exposure, crash involvement, behaviors, and attitudes: Preliminary results

This paper presents some results from preliminary analyses of the data of an international online survey of bicycle riders, who reported riding at least once a month. On 4 July 2015, data from 7528 participants from 17 countries was available in the survey, and were subsequently cleaned and checked for consistency. The median distance ridden ranged from 30 km/week in Israel to 150 km/week in Greece (overall median 54 km/week). City/hybrid bicycles were the most common type of bicycle ridden (44%), followed by mountain (20%) and road bikes (15%). Almost half (47%) of the respondents rode “nearly daily”. About a quarter rode daily to work or study (27%). Overall, 40% of respondents reported wearing a helmet ‘always’, varying from 2% in the Netherlands to 80% in Norway, while 25% reported ‘never’ wearing a helmet. Thus, individuals appeared to consistently either use or not use helmets. Helmet wearing rates were generally higher when riding for health/fitness than other purposes and appeared to be little affected by the type of riding location, but some divergences in these patterns were found among countries. Almost 29% of respondents reported being involved in at least one bicycle crash in the last year (ranging from 12% in Israel to 53% in Turkey). Among the most severe crashes for each respondent, about half of the crashes involved falling off a bicycle. Just under 10% of the most severe crashes for each respondent were reported to police. Among the bicycle-motor vehicle crashes, only a third were reported to police. Further analyses will address questions regarding the influence of factors such as demographic characteristics, type of bicycle ridden, and attitudes on both bi-cycle use and helmet wearing rates.

An intraindividual perspective on pro-environmental behaviors at work

Ones and Dilchert (2012) highlight the importance of examining workplace environmental sustainability at the interindividual (or between-person) and organizational levels. In this commentary, we aim to extend these authors’ framework by focusing on pro-environmental behaviors and their potential predictors at the intraindividual, or within-person, level. To this end, we will first describe the intraindividual perspective, its benefits, and the diary study methodology often used to operationalize this perspective. Secondly, we will share how the intraindividual perspective was useful in an empirical study we conducted on multilevel relationships among employees’ pro-environmental attitude, daily affect, and daily proenvironmental behaviors. Finally, we will discuss a number of possible limitations of the diary study methodology, ways to Correspondence concerning this article should be addressed to Megan J. Bissing-Olson. E-mail: m.bissing-olson@uq.edu.au Address: School of Psychology, The University of Queensland, Brisbane, Queensland 4072, Australia overcome them, and directions for future research.

Unpacking the impact of attachment to project teams on boundary-spanning behaviors

As business environments become even more competitive, project teams are required to make an effort to operate external linkages from within an organization or across organizational boundaries. Nevertheless, some members boundary-span less extensively, isolating themselves and their project teams from external environments. Our study examines why some members boundary-span more or less through the framework of group attachment theory. Data from 521 project-team members in construction and engineering industries revealed that the more individuals worry about their project team’s acceptance (group attachment anxiety), the more likely they are to perceive intergroup competition, and thus put more efforts into operating external linkages and resources to help their own teams outperform competitors. In contrast, a tendency to distrust their project teams (group attachment avoidance) generates members’ negative construal of their team’s external image, and thus fewer efforts are made at operating external linkages. Thus, project leaders and members with high group-attachment-anxiety may be best qualified for external tasks.

Ambidextrous leadership and employees' self-reported innovative performance: The role of exploration and exploitation behaviors

The ambidexterity theory of leadership for innovation proposes that leaders' opening and closing behaviors positively predict employees' exploration and exploitation behaviors, respectively. The interaction of exploration and exploitation behaviors, in turn, is assumed to influence employee innovative performance, such that innovative performance is highest when both exploration and exploitation behaviors are high. The goal of this study was to provide the first empirical test of these hypotheses at the individual employee level. Results based on self-report data provided by 388 employees were consistent with ambidexterity theory, even after controlling for employee reports of their leaders' transformational and transactional leadership behaviors as well as employees' openness to experience, conscientiousness, and positive affect. The findings extend previous research on ambidexterity at the team and organizational levels and suggest a possible way for leaders to enhance employee self-reported innovative performance.

Fatigue self-management behaviors in patients with advanced cancer: A prospective longitudinal survey

Purpose: To explore the fatigue self-management behaviors and factors associated with effectiveness of these behaviors in patients with advanced cancer. Design: Prospective longitudinal interviewer-administered survey. Setting: A tertiary cancer center in Queensland Australia. Sample: One hundred fifty two outpatients with metastatic breast, lung, colorectal and prostate cancer experiencing fatigue (>3/10) were recruited. Main Research Variables: Fatigue self-management behaviors outcomes (perceived effectiveness, self-efficacy and frequency), medical/demographic characteristics (including sites of primary cancer and metastasis, comorbidity, performance status), social support, depressive, anxiety, and other symptoms were assessed. Findings: The participants reported moderate levels of fatigue at baseline (M=5.85, SD 1.44), and maintained moderate levels at 4 weeks and 8 weeks. On average, participants consistently used approximately nine behaviors at each time point. Factors significantly associated with higher levels of perceived effectiveness of fatigue self-management behaviors were higher self-efficacy (p<.001), higher education level (p=.02), and lower levels of depressive symptoms (p=.04). Conclusions: The findings of this study demonstrate that patients with cancer, even with advanced disease, still want and are able to use a number of behaviors to control their fatigue. Self-management interventions that aim to enhance self-efficacy and address any concurrent depressive symptoms have the potential to reduce fatigue severity. Implications for Nursing: Nurses are well positioned to play a key role in supporting patients in their fatigue self-management. Knowledge Translation: This study particularly focused on the perspectives of patients about fatigue self-management, highlighting a number of issues requiring further attention in clinical practice and the potential for future research.

GyrI: a counter-defensive strategy against proteinaceous inhibitors of DNA gyrase

DNA gyrase is the target of two plasmid-encoded toxins CcdB and microcin B17, which ensure plasmid maintenance. These proteins stabilize gyrase-DNA covalent complexes leading to double-strand breaks in the genome. In contrast, the physiological role of chromosomally encoded inhibitor of DNA gyrase (Gyrl) in Escherichia coli is unclear and its mechanism of inhibition has not been established. We demonstrate that the mode of inhibition of GyrI is distinct from all other gyrase inhibitors. It inhibits DNA gyrase prior to, or at the step of, binding of DNA by the enzyme. Gyrl reduces intrinsic as well as toxin-stabilized gyrase-DNA covalent complexes. Furthermore, Gyri reduces microcin B17-mediated double-strand breaks in vivo, imparting protection to the cells against the toxin, substantiating the in vitro results. Thus, Gyrl is an antidote to DNA gyrase-specific proteinaceous poisons encoded by plasmid addiction systems.

Frequency characteristics and dynamical behaviors of self-modulation in vertical-cavity surface-emitting lasers

The frequency characteristics of a VCSEL with a quarter-wave plate (QWP) and an external reflector are investigated with the translation matrix of the vectorial field. Two series of eigenmode with a shift of half the free spectrum range are linearly polarized, respectively, along the neutral axes of QWP. We also numerically explore the polarization self-modulation phenomenon by using a vectorial laser equation and considering the inhomogeneous broadening of the gain medium. If the external cavity is so short that the shift is bigger than the homogeneous broadening, two stable longitudinal modes oscillate, respectively, on the neutral axes of QWP because they consume different carriers. With a long external cavity, the competition of the modes for the common carriers causes the intensity fluctuation of the modes with a period of one round-trip time of the external cavity.

Experimental Study on Hydrodynamic Behaviors of High-Speed Gas Jets in Still Water

The present paper describes experimental investigation on the flow pattern and hydrodynamic effect of underwater gas jets from supersonic and sonic nozzles operated in correct- and imperfect expansion conditions. The flow visualizations show that jetting is the flow regime for the submerged gas injection at a high speed in the parameter range under consideration. The obtained results indicate that high-speed gas jets in still water induce large pressure pulsations upstream of the nozzle exit and the presence of shock-cell structure in the over- and under-expanded jets leads to an increase in the intensity of the jet-induced hydrodynamic pressure.

Basic Mechanical Behaviors And Mechanics Of Shear Banding In Bmgs

In this paper, some basic mechanical behaviors of bulk metallic glasses (BMGs) were discussed. It can be found from the discussions that the mechanical behaviors of BMGs are mainly due to the formation and operation of shear bands in BMGs. Furthermore, the relevant mechanics of shear banding were investigated in the paper. The theoretical analysis of deformation coupling thermal softening and free volume creation softening demonstrates that the free volume creation and thermal softening can jointly promote the formation of shear bands in BMGs, and the observed post mortem. shear band width looks more like that governed by free volume creation. (C) 2007 Elsevier Ltd. All rights reserved.

On the tensile behaviors of a hard chromium coating plated on a steel substrate with periodic subsurface inclusions

The tensile behaviors of a hard chromium coating plated on a steel substrate with periodic laser pre-quenched regions have been investigated by experimental and theoretic analysis. In the experiment, three specimens are adopted to study the differences between homogeneous and periodic inhomogeneous substrates as well as between periodic inhomogeneous substrate of relatively softer and stiffer materials. The unique characteristics have been observed in the specimen of periodic inhomogeneous substrate under quasi-static tension loading. With the periodic laser pre-quenched regions being treated as periodic subsurface inclusions (PSI), the unique stress/strain pattern of the specimen is obtained by analytical modeling and FEM analysis, and the mechanisms accounting for the experimental results is preliminarily illustrated.

Anisotropic, gradient and metal-like mechanical behaviors of teeth and their implications on tooth functions

The anisotropy and gradient of the elastic modulus and the hardness of teeth were investigated by means of instrumented indentation method. Such properties are attributed to the unique microstructures of teeth based on scanning electron microscopic analysis. By comparing the relationship between the ratio of hardness to the reduced elastic modulus and the ratio of elastic unloading work to the total work of teeth in course of indentation to those of other materials, we found that the material behaviors of teeth display metal-like characteristics rather than ceramics as considered traditionally. These material behaviors and relevant functions are discussed briefly.

A general theory on media with randomly distributed inclusions .1. The average field behaviors

In this paper, a theory is developed to calculate the average strain field in the materials with randomly distributed inclusions. Many previous researches investigating the average field behaviors were based upon Mori and Tanaka's idea. Since they were restricted to studying those materials with uniform distributions of inclusions they did not need detailed statistical information of random microstructures, and could use the volume average to replace the ensemble average. To study more general materials with randomly distributed inclusions, the number density function is introduced in formulating the average field equation in this research. Both uniform and nonuniform distributions of inclusions are taken into account in detail.