Electrocatalytic mechanism for formaldehyde oxidation on the highly dispersed gold microparticles and the surface characteristics of the electrode

Electrocatalytic mechanism for the electrochemical oxidation of formaldehyde (HCHO) on the highly dispersed Au microparticles electrodeposited on the surface of the glass carbon (GC) electrode in the alkaline Na2CO3/NaHCO3 solution and the surface characteristics of the Au microparticle-modified glass carbon (Au/GC) electrode were studied with in situ FTIR spectroscopy, scanning electron microscopy (SEM) and X-ray diffraction (XRD). It was found that the final products of HCHO oxidation is HCOO- at the Au/GC electrode and CO2 at the bulk Au electrode. The difference may be ascribed to the different surface characteristics between the Au/GC electrode and the bulk Au electrode. (C) 1999 Elsevier Science B.V. All rights reserved.

Electrocatalytic oxidation of methanol at the titanium oxide electrode modified with Pt microparticles

The electrocatalytic oxidation of methanol at the Titanium oxide (TiOx, x<2) film modified with Pt microparticles has been studied. The results show that the modified electrodes exhibit a significant electrocatalytic activity and good stability for the oxidation of methanol. Under the optimal conditions, the peak current density at 0.58 V for the oxidation of methanol in the positive-going sweep is about 526 mA/cm(2) at the scan rate of 5 mV/s in 0.5 mol/L CH3OH and 0.5 mol/L H2SO4 solution and the over potential of the methanol oxidation at the modified electrode increases about 30 similar to 40 mV after 70 minutes at the current density of 100 mA/cm(2) and 50 mA/cm(2). The enhanced electrocatalytic activity and good stability are ascribed to the high dispersion of Pt microparticles in and on the TiOx film and the synergistic effect between Pt microparticles and TiOx.

Catalysis of the rare earth containing mixed oxides Ln(2)CuO(4) in phenol hydroxylation

Mixed oxides Ln(2)CuO(4+/-lambda)(Ln = La, Pr, Nd, Sm, Gd) with K2NiF4 structure were prepared. Their crystal structures were studied with XRD and IR spectra. Meanwhile, the average valence of Cu ions and nonstoichiometric oxygen (lambda) were determined through chemical analyses. Catalysis of the above-mentioned mixed oxides in the phenol hydroxylation was investigated. Results show that the catalysis of these mixed oxides has close relation with their structures and composition. Substitution of A site atom in Ln(2)CuO(4+/-lambda) has a great influence on their catalysis in the phenol hydroxylation.

Electrocatalytic oxidation of methanol on polypyrrole film modified with platinum microparticles

The electrocatalytic oxidation of methanol on polypyrrole (PPy) film modified with platinum microparticles has been studied by means of electrochemical and in situ Fourier transform infrared techniques. The Pt microparticles, which were incorporated in the PPy film by the technique of cyclic voltammetry, were uniformly dispersed. The modified electrode exhibits significant electrocatalytic activity for the oxidation of methanol. The catalytic activities were found to be dependent on Pt loading and the thickness of the PPy film. The linearly adsorbed CO species is the only intermediate of electrochemical oxidation of methanol and can be readily oxidized at the modified electrodes. The enhanced electrocatalytic activities may be due to the uniform dispersion of Pt microparticles in the PPy film and the synergistic effects of the highly dispersed Pt microparticles and the PPy film. Finally, a reaction mechanism is suggested.

Electrocatalytic Oxidation of Methanol on Polythionine Film Modified with Pt Microparticles

The electrocatalytic oxidation of methanol on polythionine(PTn) film modified with Pt microparticles has been studied by means of cyclic voltammetry and in-situ FTIR spectroscopy. The Pt microparticles produced by cyclic voltammetry were highly dispersed in and on the PTn film. The modified electrodes exhibit significant electrocatalytic activity for the oxidation of methano and the catalytic activity was found in dependence on the Pt loading. The linearly adsorbed CO species is the only intermediate in the oxidation of methanol and the abnormal IR spectra for adsorbed CO were observed. On such modified electrodes, adsorbed CO species derived from methanol can be readily oxidized. The enhanced electrocatalytic activity may be ascribed to the high dispersion of Pt microparticles in and on the PTn film and the synergestic effect between Pt microparticles and the polymer. From the above results, a possible reaction mechanism was proposed.

Abnormal IR spectra of CO adsorbed on the surface of glass carbon electrode modified with polypyrrole film with platinum microparticles

Abnormal IR spectra of CO adsorbed at the surface of glass carbon electrode modified with polypyrrole film with Pt microparticles are reported.

Preparation of highly dispersed gold microparticles and their electrocatalytic activity for the oxidation of formaldehyde

The electrochemical preparation of highly dispersed Au microparticles on the surfaces of glassy carbon (GC) electrodes and their electrocatalytic activities for the oxidation of formaldehyde were studied. It was found that the reduction of Au3+ to Au is controlled by diffusion and the formation mechanism of Au microparticles on the GC surfaces corresponds to an instantaneous nucleation and diffusion-controlled three dimensional growth process. The particle size is about 80-90 nm in diameter after the electrochemical ageing treatment. These highly dispersed Au microparticles have high surface areas and exhibit better electrocatalytic activity than that of bulk-form Au toward the electrochemical oxidation of formaldehyde in alkaline media.

活性炭酸处理对CuO／C催化剂上NO还原反应的影响

４种国产活性炭被用于ＮＯ还原反应；其中，山楂核炭和山桃核炭具有较高的ＮＯ还原转化率。实验发现，表面含氧基团－ＣＯＯ－对话性炭自身的还原性和对ＮＯ的还原活性有根重要的影响。对表面富－ＣＯＯ－基团的活性炭，稀盐酸处理使表面－ＣＯＯ－显著分解。浓硝酸处理使活性炭表面含氧量及－ＣＯＯ－基团都明显增加。这是浓硝酸处理使活性炭在较低反应温度下产生较高ＮＯ还原转化率的重要原因。对原始活性较差的煤质炭，这种作用表现得更为明显。

活性炭的表面化学性质及对CuO/C催化剂上NO还原性能的影响

活性炭是一种十重要的吸附剂和催化剂载体.它属于微晶结构,主要在低衍射角处产生一个比较大的弥散峰,因而人们尚不能够获得关于活性炭的清晰的空间结构特征.一般认为,活性炭的含氧量是影响其化学性质的一个重要因素.而含氧量和含氧基团分布与活化方式有关.遗憾的是,也还不能通过活化方式控制含氧量和含氧基团分布.目前,关于这些基团的组成和分布在催化剂制备的某些关键步骤中和催化反应中的行为都还知道得很少.本工作选取了4种市售国产活性炭:椰壳炭、山楂核炭、山桃核炭和煤质炭.实验表明,当活性炭本身做催化剂时,含氧基团起到了活性中心作用;在制备负载催化剂的浸渍阶段,含氧基团起着成核中心作用,含氧基团的分布可以影响金属离子的分散度.1 实验部分1.l 反应性能评价以等体积浸渍法制备担载量6.25%质量分数硝酸铜/活性炭催化剂.首先室温下真空干燥24h,然后烘箱中65℃下烘4h,再120℃下烘6℃.性能评价在连续流动微型反应装置上进行.石英反应管内径8mm,催化剂用量500mg(20～35目).反应前催化剂在He气中200℃下处理0.5h,然后350℃下热分解1h.反应气NO浓度1.5%摩尔分数(配在He气中),F/W=50mL/...

CuO／活性炭和Fe_2O_3／活性炭催化还原NO

ＣｕＯ／活性炭和Ｆｅ_２Ｏ_３／活性炭催化还原ＮＯ高志明，赵震，杨向光，吴越（中国科学院长春应用化学研究所长春１３００２２）关键词活性炭，还原，ＮＯ，氧化铜，氧化铁目前，对固定源的ＮＯ处理是采用Ｖ２Ｏ５／ＴｉＯ２作催化剂，ＮＨ３作还原剂的选择催化还原方...

超微Y_2O_3、CuO和BaCO_3粉末的制备

本文采用固体草酸作沉淀剂,沉淀样品在水蒸汽气氛下焙烧分解,制成超微CuO、Y_2O_3和BaCO_3。用热分解法探讨其在水蒸汽下的分解机理,X射线衍射、红外光谱分析和元素分析对产物组成进行鉴定。通过电镜观察,超微粒子的粒径为:Y_2O_30.01～0.02μm、CuO0.02～0.03μm、BaCO_3～0.1μm。用空气吸附法测定其比表面积分别为146m~2g~(-1)、80m~2g~(-1)、20m~2g~(-1)。

Endothelial microparticles released in thrombotic thrombocytopenic purpura express von Willebrand factor and markers of endothelial activation

It has been suggested that endothelial apoptosis is a primary lesion in the pathogenesis of thrombotic thrombocytopenic purpura (TTP). We tested this hypothesis by examining the phenotypic signatures of endothelial microparticles (EMP) in TTP patients. In addition, the effect of TTP plasma on microvascular endothelial cells (MVEC) in culture was further delineated. EMP released by endothelial cells (EC) express markers of the parent EC; EMP released in activation carry predominantly CD54 and CD62E, while those in apoptosis CD31 and CD105. We investigated EMP release in vitro and in TTP patients. Following incubation of MVEC with TTP plasma, EMP and EC were analysed by flow cytometry for the expression of CD31, CD51, CD54, CD62E, CD105, CD106 and von Willebrand factor (VWF) antigen. EMP were also analysed in 12 TTP patients. In both EC and EMP, CD62E and CD54 expression were increased 3- to 10-fold and 8- to 10-fold respectively. However, CD31 and CD105 were reduced 40-60% in EC but increased twofold in EMP. VWF expression was found in 55 +/- 15% of CD62E(+) EMP. Markers of apoptosis were negative. In TTP patients, CD62E(+) and CD31(+)/CD42b(-) EMP were markedly elevated, and preceded and correlated well with a rise in platelet counts and a fall in lactate dehydrogenase. CD62E(+) EMP (60 +/- 20%) co-expressed VWF and CD62E. The ratio of CD31(+)/42b(-) to CD62E(+) EMP exhibited a pattern consistent with activation. In conclusion, our studies indicate endothelial activation in TTP. EMP that co-express VWF and CD62E could play a role in the pathogenesis of TTP.

Endothelial cells release phenotypically and quantitatively distinct microparticles in activation and apoptosis

Background: Endothelial cells (EC) shed endothelial microparticles (EMP) in activation and apoptosis. Objectives: We compared the antigenic expression of EMP species released during activation as compared to apoptosis, in three cell lines. Methods: EC from renal and brain microvascular (MiVEC) and coronary macrovascular (MaVEC) origin were incubated with TNF-alpha to induce activation, or deprived of growth factors to induce apoptosis. Antigens expressed on EMP and EC were assayed flow cytometrically and included constitutive markers (CD31, CD51/61, CD105), inducible markers (CD54, CD62E and CD106), and annexin V binding. Results: It was found that in apoptosis, constitutive markers in EMP were markedly increased (CD31>CD105), with a concomitant decrease in expression in EC. Annexin V EC surface binding and annexin V+ EMP were more sharply increased in apoptosis than in activation. In contrast, in activation, inducible markers in EMP were markedly increased in both EMP and EC (CD62E>CD54>CD 106). Coronary MaVEC released significantly less EMP than MiVEC. Conclusion: EC release qualitatively and quantitatively distinct EMP during activation compared to apoptosis. Analysis of EMP phenotypic signatures may provide clinically useful information on the status of the endothelium. (C) 2003 Elsevier Science Ltd. All rights reserved.