Optical characteristics of Er3+-Yb3+ doped SnO2 xerogels

Er3+ doped SnO2 xerogels have been obtained from aqueous colloidal suspensions. Emission and excitation spectra were obtained and allowed the identification of two main families of sites for Er3+. In the first one Er3+ substitutes for Sn4+ in the SnO2 cassiterite structure. In the second Er3+ are found adsorbed at the SnO2 particle surface. For the first family of sites the technological important infrared Er3+ emission about 1.5 mum is efficiently excited through absorption at the SnO2 conduction band at 3.8 eV. on the other hand the emission due to adsorbed ions appears inhomogeneously broadened by the statistical distribution of sites available for Er3+ ions at the surface of the particles. Moreover it is not excited by the host. The emission of this second family of sites could be also excited by an energy transfer mechanism involving Yb3+ ions also adsorbed a posteriori at particles surface. Results are compared with spectra obtained for Eu3+ doped samples. (C) 2002 Elsevier B.V. B.V. All rights reserved.

Influence of membrane-solution interface on the selectivity of SnO2 ultrafiltration membranes

SnO2 supported membranes, presenting 3.0 nm average pore size, have been produced by sol casting on alumina tubular substrate using aqueous colloidal suspensions prepared by sol-gel route. The selectivity and flux throughout SnO2 membrane were analyzed by permeation experiments, using a laboratory tangential filtration pilot equipped with a monotubular membrane. To evaluate the effect of the surface charge at the membrane-solution interface, aqueous salt solutions (NaCl, Na2SO4, CaCl, and CaSO4) of different ionic strength have been filtered and the results correlated with the values of zeta potential measured at several pH. The results show that the retention coefficient is dependent on the electrolyte present in aqueous solution decreasing as: (dication, monoanion) > (monocation, monoanion) approximate to (monocation, dianion) > (dication, dianion). The surface charge and the cation adsorption capacity play a determinant role in these selectivity sequences. (C) 2001 Elsevier B.V. B.V. All rights reserved.

Rare Earth Doped SnO(2) Nanoscaled Powders and Coatings: Enhanced Photoluminescence in Water and Waveguiding Properties

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biocompatible microemulsion modifies the pharmacokinetic profile and cardiotoxicity of doxorubicin

Doxorubicin (DOX) is an anthracycline antibiotic with a broad antitumor spectrum. However, the clinical use of DOX is limited because of its cardiotoxicity, a dose-dependent effect. Colloidal drug delivery systems, such as microemulsions (MEs), allow the incorporation of drugs, modifying the pharmacokinetic (PK) profile and toxic effects. In this study, we evaluated the PK profile and cardiotoxicity of a new DOX ME (DOX-ME). The PK profile of DOX-ME was determined and compared with that of the conventional DOX after single-dose administration (6mg/kg, intravenous) in male Wistar rats (n = 12 per group). The cardiotoxicity of DOX formulations was evaluated by serum creatine kinase MB (CKMB) activity in both animal groups before and after drug administration. The plasma DOX measurements were performed by high-performance liquid chromatography with fluorescence detection, and the CKMB levels were assayed using the CKMB Labtest® kit. The ME system showed a significant increase in plasma DOX concentrations and lower distribution volume when compared with conventional DOX. Serum CKMB activity increased after conventional DOX administration but was unchanged in the DOX-ME group. These results demonstrate modifications in drug access to susceptible sites using DOX-ME. DOX-ME displayed features that make it a promising system for future therapeutic application. © 2012 Wiley Periodicals, Inc.

Comparison of the nanoparticles performance in the photocatalytic degradation of a styrene-butadiene rubber nanocomposite

Much has been talking about the advantages of polymeric nanocomposites, but little is known about the influence of nanoparticles on the stability of these materials. In this sense, we studied the influence of both oxides of zirconium and titanium, known to have photocatalytic properties, as well as the influence of synthetic clay Laponite on the photodegradation of styrene-butadiene rubber (SBR). SBR nanocomposites were prepared by the colloidal route by mixing commercial polymer lattices and nanometric anatase TiO2, monoclinic ZrO2 or exfoliated Laponite clays colloidal suspensions. To better understand the degradation mechanisms that occur in these nanocomposites, the efficiency of different photocatalysts under ultraviolet radiation was monitored by FT-IR and UV-vis spectroscopies and by differential scanning calorimetric. It was observed that TiO2 and ZrO2 nanoparticles undoubtedly acted as catalysts during the photodegradation process with different efficiencies and rates. However, when compared to pure SBR samples, the polymer degradation mechanism was unaffected. Unlike studies with nanocomposites montmorillonite, exfoliated laponite clay effectively acts as a photostabilizer of polymer UV photodegradation. Copyright © 2012 Wiley Periodicals, Inc.

Estudo do comportamento coloidal de suspensão de fibra de celulose, carbonato de cálcio, amido catiônico: variação da força iônica e do pH

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Síntese, caracterização e aplicação de filmes a base de óxido de zinco

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Estudo da formação de espumas cerâmicas à base de zircônio a partir do processo sol-gel

Pós-graduação em Química - IQ

Análise da ação de nanopartículas de prata sobre o biofilme de espécies de Candida

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Surfactant-cosurfactant interactions and process parameters involved in the formulation of stable and small droplet-sized benznidazole-loaded soybean O/W emulsions

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Formação e crescimento do óxido de zinco e óxido de zinco dopado com cobre

Pós-graduação em Química - IQ

Caracterização bioclimática de sistemas ao ar livre e confinado para a criação de matrizes suínas gestantes

O confinamento de matrizes suínas foi criado com o intuito de maximizar a produtividade; entretanto, existem problemas relacionados ao bem-estar animal. Objetivou-se avaliar a criação de matrizes suínas gestantes no sistema de confinamento e ao ar livre, com relação ao ambiente térmico e às respostas fisiológicas. O experimento foi realizado em Monte Mor/SP. A avaliação fisiológica foi realizada por meio do registro das variáveis: frequência respiratória e temperatura de pele. Foram registradas as variáveis meteorológicas: temperatura de bulbo seco, temperatura de bulbo úmido e temperatura de globo negro, caracterizando o ambiente por meio da entalpia e índice de temperatura de globo e umidade. Foram utilizados seis animais por tratamento. O delineamento experimental foi inteiramente casualizado em parcelas subdivididas, e as médias comparadas pelo teste de Tukey. As variáveis fisiológicas e meteorológicas apresentaram valores superiores no confinamento. O sistema de criação ao ar livre potencializou as trocas térmicas entre os animais e o ambiente, o que refletiu em menor estresse por calor observado nos animais.

Realisierung einer 3D-Kreuzkorrelationsanlage zur Untersuchung von Struktur und Dynamik hochkonzentrierter Kolloide

Realisierung einer 3D-Kreuzkorrelationsanlage zur Untersuchung von Struktur und Dynamik hochkonzentrierter Kolloide Im Rahmen dieser Arbeit wird eine neuartige 3D-Kreuzkorrelationsanlage zur mehrfachstreufreien Untersuchung des diffusiven Verhaltens hochkonzentrierter kolloidaler Suspensionen vorgestellt. Hierzu werden zwei Lichtstreuexperimente gleichzeitig am gleichen Streuvolumen und mit dem gleichen Streuvektor durchgeführt. Aus der so gewonnenen Kreuzkorrelationsfunktion kann das dynamische Verhalten der Kolloide bestimmt werden. Für die Diffusion der Partikel spielen neben der direkten Wechselwirkung elektroviskoser Effekt und die hydrodynamische Wechselwirkung eine entscheidende Rolle. Insbesondere bei hohen Konzentrationen kann keiner der drei Effekte vernachlässigt werden. Die zu messenden Unterschiede in den Diffusionskoeffizienten sind sehr klein. Daher wurde der experimentelle Aufbau detailliert charakterisiert. Hierbei konnten theoretische Überlegungen hinsichtlich des Nachpulsens und der Totzeit der verwendeten Si-Avalanche-Photodioden überprüft werden. Der Kurzzeitselbstdiffusionskoeffizient hochkonzentrierter geladener kolloidaler Suspensionen wurde gemessen. Um die Daten bei hohen Konzentrationen korrekt zu normieren, wurde der elektroviskose Effekt bei geringen Konzentrationen ausführlich untersucht. Hierbei zeigte sich, dass der elektroviskose Einzelteilcheneffekt zu einer monotonen Abnahme des Diffusionskoeffizienten bei abnehmender Ionenstärke führt. Anhand der volumenbruchabhängigen Daten des Kurzzeitselbstdiffusionskoeffizienten konnte zum ersten Mal gezeigt werden, dass die hydrodynamische Wechselwirkung einen geringeren Einfluss auf die Diffusion hat, falls das direkte Wechselwirkungspotential ein Coulomb-Potential anstelle eines Harte-Kugel-Potentials ist.

Optische Mikroskopie an kolloidalen Suspensionen unter Nichtgleichgewichtsbedingungen

Kolloidale Suspensionen eignen sich aufgrund der für sierelevanten Längeskalen hervorragend zur Beobachtung mittelsoptischer Mikroskopie. Die Verwendung speziellerKontrastierverfahren kann bestimmte Aspekte kolloidalerStrukturen besonders hervorheben und eine verbesserteAnalyse von Nichtgleichgewichtszuständen in kolloidalenSystemen ermöglichen. Mittels Phasen- und Interferenzkontrast konnte die Ursachedes Kleinwinkelstreumaximums in der Lichtstreuung an einerSuspension aus Mikronetzteilchen auf die unterschiedlichenStrukturfaktoren von Kristall und Korngrenze zurückgeführtwerden.Der Zusammenhang von Struktur und Farbe eingetrockneterMultilagen wurde in hochauflösender Durchlichtmikroskopiedemonstriert und zur Analyse der inneren Struktur derKristalldomänen inklusive von Versetzungen und Stapelfehlernbenutzt.Mit der Polarisationsmikroskopie konnte die Veränderung derPartikelzahldichte um ein Ionentauscherbruchstück auf einenSalzkonzentrationsgradienten zurückgeführt werden. Die Untersuchung kolloidaler Suspensionen in einem Scherfeldmittels Fourier-Mikroskopie lieferte im Bereich fluiderGleichgewichtsstrukturen den Nachweis scherinduzierterhexagonaler Strukturen. Die Ultramikroskopie mit erweiterterSchärfentiefe ermöglichte die direkte Beobachtung desGleitmechanismus von verscherten hexagonalen Lagen und dieKlassifizierung durch die entwickelte2D-Partikelkorrelation. Die Scherung induziert in fluidenStrukturen hexagonale Ordnung und zerstört bei großenScherraten existierende Ordnung. Es wird eineWandstabilisierung der hexagonalen Strukturen beobachtet. Mittels Bragg-Mikroskopie konnte unter Scherung dieHomogenität der Struktur innerhalb der Scherzelledokumentiert werden sowie nach Scherung die Entstehung derGleichgewichts bcc Phase.

Fluidodinamica biomedica computazionale del flusso sanguigno in presenza di affezioni strumentali e/o patologiche

La tesi di Dottorato studia il flusso sanguigno tramite un codice agli elementi finiti (COMSOL Multiphysics). Nell’arteria è presente un catetere Doppler (in posizione concentrica o decentrata rispetto all’asse di simmetria) o di stenosi di varia forma ed estensione. Le arterie sono solidi cilindrici rigidi, elastici o iperelastici. Le arterie hanno diametri di 6 mm, 5 mm, 4 mm e 2 mm. Il flusso ematico è in regime laminare stazionario e transitorio, ed il sangue è un fluido non-Newtoniano di Casson, modificato secondo la formulazione di Gonzales & Moraga. Le analisi numeriche sono realizzate in domini tridimensionali e bidimensionali, in quest’ultimo caso analizzando l’interazione fluido-strutturale. Nei casi tridimensionali, le arterie (simulazioni fluidodinamiche) sono infinitamente rigide: ricavato il campo di pressione si procede quindi all’analisi strutturale, per determinare le variazioni di sezione e la permanenza del disturbo sul flusso. La portata sanguigna è determinata nei casi tridimensionali con catetere individuando tre valori (massimo, minimo e medio); mentre per i casi 2D e tridimensionali con arterie stenotiche la legge di pressione riproduce l’impulso ematico. La mesh è triangolare (2D) o tetraedrica (3D), infittita alla parete ed a valle dell’ostacolo, per catturare le ricircolazioni. Alla tesi sono allegate due appendici, che studiano con codici CFD la trasmissione del calore in microcanali e l’ evaporazione di gocce d’acqua in sistemi non confinati. La fluidodinamica nei microcanali è analoga all’emodinamica nei capillari. Il metodo Euleriano-Lagrangiano (simulazioni dell’evaporazione) schematizza la natura mista del sangue. La parte inerente ai microcanali analizza il transitorio a seguito dell’applicazione di un flusso termico variabile nel tempo, variando velocità in ingresso e dimensioni del microcanale. L’indagine sull’evaporazione di gocce è un’analisi parametrica in 3D, che esamina il peso del singolo parametro (temperatura esterna, diametro iniziale, umidità relativa, velocità iniziale, coefficiente di diffusione) per individuare quello che influenza maggiormente il fenomeno.