Analysis on turning Ti-6Al-4V with different cooling methods

The aim of this paper is to optimize the machining of Ti-6Al-4V alloy, by studying the chip formation, roughness and tool wear for different cooling conditions. The results were compared between cooling methods, minimal quantity of fluid (MQF) and flooding, and also without fluid for the tool H13A. The turning of Ti-6Al-4V has shown good results on roughness (0, 8μm) and tool life, which was 11% lower with MQF than with the flooding method. The tool wear causes variation of the shear angle, which promotes strength hardening of the chip. As a result, the machined surface could be damaged. The use of the cutting fluid helps to save the cutting edge and could reduce the strength hardening. Nevertheless, it could also facilitate the formation of built-up edge. The nucleation of alpha lamellar colonies can occur due to a combination of deformation rates and temperature, mainly when the flooding is used, but it's not conclusive. The lamellar colonies were also found with the MQF in some regions, however, this structure did not show hardness variation compared to equiaxial. For all this reasons, the machining parameters might be carefully chosen.

Hatching, survival and deformities of piracanjuba (Brycon orbignyanus) embryos subjected to different cooling protocols

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Accumulation rates of volcanic glass and ice-rafted debris in sediments of the North Pacific Ocean

Mass accumulation rates (MAR) of different components of North Pacific deep-sea sediment provide detailed information about the timing of the onset of major Northern Hemisphere glaciation that occurred at 2.65 Ma. An increase in explosive volcanism in the Kamchatka-Kurile and Aleutian arcs occured at this same time, suggesting a link between volcanism and glaciation. Sediments recovered by piston-coring techniques during ODP Leg 145 provide a unique opportunity to undertake a detailed test of this possibility. Here we use volcanic glass as a proxy for explosive volcanism and ice-rafted debris (IRD) as a proxy for glaciation. The MAR of both glass and IRD increase markedly at 2.65 Ma. Further, the flux of the volcanic glass increased just prior the flix of ice-radted material, suggesting that the cooling resulting from explosive volcanic eruptions may have been the ultimate trigger for the mid-Pliocene glacial intensification.

Age, annual coral growth rates and stable isotopes of coral sample Ningaloo

116-year record of coral skeletal delta18O is presented from a colony of Porites lutea from Ningaloo Reef, western Australia. Interannual variability of sea-surface temperatures (SST) inferred from skeletal delta18O is dominated by a 9.5-year period, and may constitute a characteristic signal of the Leeuwin Current. On long-terms coral skeletal delta18O indicates a near-continuous increase of SST at Ningaloo Reef over one century. The skeletal delta18O time series was checked for the presence of seasonal cooling events resulting from major volcanic eruptions. An ~1 °C cooling is evident following the eruption of Pinatubo in 1991, which reproduces the results of previous investigations. However, only weak or no signals can be related to the eruptions of Krakatau (1883) and Agung (1963).

Sedimentation rates and isotope data of Pyrgo murrhina from DSDP Hole 14-141

Oxygen and carbon stable isotope data of Pyrgo murrhina and flux rates of calcium carbonate in the bio- and magnetostratigraphically dated sediment sequence at DSDP Site 141 were used for a reconstruction of the deep-water circulation in the Northeast Atlantic during Late Miocene and Pliocene times. A distinct change towards reduced advection of deep water recorded near 5.4 Ma is contemporaneous with the cessation of the outflow of the saline Mediterranean water into the Atlantic. During the Pliocene, between 4.5 and 2.75 Ma and between 2.1 and 1.8 Ma, North Atlantic Deep Water (NADW) circulation was sluggish and Site 141 possibly influenced by Antarctic Bottom Water (AABW). Near 2.75 Ma, the advection of well-oxidized NADW was strongly intensified. This change is related to an onset of major Arctic ice growth and/or a major cooling of NADW.

Quartz content and mass accumulation rates at DSDP Hole 86-576A

The amount and the accumulation rate of quartz were measured in 33 samples from Hole 576A. The amount and source of mineral aerosol being deposited in the northwest Pacific during the Cenozoic are evaluated using these data. When Hole 576A is compared to a Cenozoic record in the central North Pacific, a strong uniformity in the composition of the mineral aerosol across the North Pacific is seen. The data suggest that Hole 576A entered the influence of the westerlies about 15 m.y. ago and that since that time the rates of sediment deposition have increased. Only the dramatic change in quartz accumulation 2.5 m.y. ago can be clearly related to a climatic event, but a gradual increase in quartz accumulation through the Miocene and early Pliocene is probably a result of increasing Northern Hemisphere aridity and intensified atmospheric activity associated with global cooling during the interval.

Accumulation rates, carbon composition and Eocene carbonate compensation depths of ODP Sites 199-1218 and 199-1219

CaCO3, Corg, and biogenic SiO2 were measured in Eocene equatorial Pacific sediments from Sites 1218 and 1219, and bulk oxygen and carbon isotopes were measured on selected intervals from Site 1219. These data delineate a series of CaCO3 events that first appeared at ~48 Ma and continued to the Eocene/Oligocene boundary. Each event lasted 1-2 m.y. and is separated from the next by a low CaCO3 interval of a similar time span. The largest of these carbonate accumulation events (CAE-3) is in Magnetochron 18. It began at ~42.2 Ma, lasted until ~40.3 Ma, and was marked by higher than average productivity. The end of CAE-3 was abrupt and was associated with a large-scale carbon transfer to the oceans prior to warming of high-latitude regions. Changes in carbonate compensation depth associated with CAE excursions were small in the early part of the middle Eocene but increased to as much as 800 m by the late middle Eocene before decreasing into the late Eocene. Oxygen isotope data indicate that the carbonate events are associated with cooling conditions and may mark small glaciations in the Eocene.

Stable isotope ratios and organic carbon accumulation rates of late Pleistocene sediments of ODP Hole 117-724C

Stable isotope records of coexisting benthic foraminifers Uvigerina spp. and Cibicidoides spp. and planktonic G. ruber (white variety) from Site 724 are used to study the late Pleistocene evolution of surface and intermediate water hydrography (593 m water depth) at the Oman Margin. Glacial-interglacial d18O amplitudes recorded by the benthic foraminifers are reduced when compared to the estimated mean ocean changes of d18Oseawater . Epibenthic d13C remains at its modern level or is increased during glacial times. This implies that Red Sea outflow waters which are enriched in d18Oseawater and d13C (Sum CO2) have been replaced during glacial periods by intermediate waters still positive in d13C (Sum CO2) but more negative in d18Oseawater. Glacial-interglacial amplitudes of the planktonic d18O record exceed those of the mean ocean d18Oseawater variation and imply decreased surface water temperatures (SST) during glacial times. Throughout most of the records these cooling events correlate with enhanced rates of carbon accumulation. However, both negative (colder) SST and positive Corg accumulation rate anomalies do not correlate with potential physical upwelling maxima as inferred from the orbital monsoon index. This is in conflict with the established hypothesis that upwelling in the estern Arabia Sea should be strongest during maxima of the southwest monsoon.

Grain size analysis and sedimentation rates of ODP Hole 175-1085A off the Namibian coast

Sediments from the ODP Site 1085A were studied to investigate the impacts of global cooling in the Middle and Late Miocene on the climate in Southwestern Africa. The size composition of the sediment was analysed emphasising the silt fraction. A comparison with the modern grain size distribution and suitable transport processes made it possible to assign specific transport processes to the grain size composition. Three processes are considered for transport of terrigeneous silt: while there was no evidence found for (1) transport by ocean currents, the analyses showed signals of (2) wind transport indicating dry conditions associated with a cool climate and (3) fluvial transport that points to humid and warm conditions. Three climatic phases were defined. The first phase from 13.8 to 11.8 Myr reveals a stable humid climate in Southwest Africa independent of the Antarctic glaciations. During the second phase from 11.8 to 10.4 Myr the regional climate cooled considerably but was not drier. Additionally, the climate during this phase reacted to the Antarctic glaciations. This cooling-trend continued during phase 3 from 10.4 to 9.0 Myr with a significant increase in dust input, pointing to overall drier conditions. However, fluvial transport still remained as the main source.