Analysis of CFRP strap-strengthened reinforced concrete beams using the modified compression field theory (MCFT)

External, prestressed carbon fiber reinforced polymer (CFRP) straps can be used to enhance the shear strength of existing reinforced concrete beams. In order to effectively design a strengthening system, a rational predictive theory is required. The current work investigates the ability of the modified compression field theory (MCFT) to predict the behavior of rectangular strap strengthened beams where the discrete CFRP strap forces are approximated as a uniform vertical stress. An unstrengthened control beam and two strengthened beams were tested to verify the predictions. The experimental results suggest that the MCFT could predict the general response of a strengthened beam with a uniform strap spacing < 0.9d. However, whereas the strengthened beams failed in shear, the MCFT predicted flexural failures. It is proposed that a different compression softening model or the inclusion of a crack width limit is required to reflect the onset of shear failures in the strengthened beams.

Effects of solution exposure on the combined axial-shear behaviour of unidirectional CFRP rods

In fibre reinforced polymer (FRP) prestressed concrete applications, an FRP tendon must sustain high axial tensile stresses and, if cracks occur, additional dowel forces. The tendon may also be exposed to solutions and so the combined axial-shear stress performance after long-term environmental exposure is important. Experiments were conducted to investigate the combined axial-shear stress failure envelope for unidirectional carbon FRP tendons which had been exposed to either water, salt water or concrete pore solution at 60 °C for approximately 18 months. The underlying load resisting mechanisms were found to depend on the loading configuration, restraint effects and the initial stress state. When saturated, CFRP tendons are likely to exhibit a reduced shear stiffness. However, the ultimate limit state appeared to be fibre-dominated and was therefore less susceptible to reductions due to solution uptake effects. © 2012 Elsevier Ltd. All rights reserved.

Caratterizzazione proteomica di fluidi e tessuti in diverse condizioni fisio-patologiche

This thesis has been focused on the proteomic characterization of human saliva from donors of different ages, starting from birth up to adult age, and pediatric brain tumor tissues. The first study has been performed in order to compare the acid-insoluble fraction of saliva from preterm with at-term newborns and adults and establish if differences exist. In the second study medulloblastoma and pilocytic astrocytoma pediatric brain tumor extracts have been compared. In both studies 2- DE analysis was coupled with high resolution tandem mass spectrometry (MS/MS). The proteomic characterization of the acid-insoluble fractions of saliva from preterm newborns allowed to integrate data previously obtained on the acid-soluble fraction by HPLC-electrospray ionization (ESI)-mass spectrometry (MS), and to evidence several differences between preterm newborns, at-term newborns and adults. Spots differentially expressed between the three groups, according to image analysis of the gels, were submitted to in-gel tryptic digestion and the peptide mixture analyzed by high performance HPLC-ESI-MS/MS for their characterization. By this strategy, we identified three over-expressed proteins in atterm newborns with respect to preterm newborns and adults (BPI fold-containing family A member 1, two proteoforms of annexin A1, and keratin type 1 cytoskeletal 13), and several over-expressed proteins in adults (fatty acid-binding protein, S100A6, S100A7, two proteoforms of S100A9, several proteoforms of prolactin-inducible protein, Ig kappa chain, two proteoforms of cystatin SN, one proteoform of cystatin S and several proteoforms of α-amylase 1). Moreover, for the first time, it was possible to assign by MS/MS four spots of human saliva 2-DE, already detected by other authors, to different proteoforms of S100A9. The strategy applied used a sequential staining protocol to the 2-DE gels, first with Pro-Q Diamond, that allows specific detection of phosphoproteins, and successively with total protein SYPRO Ruby stain. In the second study, proteomic analysis of two pediatric brain tumor tissues pointed out differences between medulloblastoma, the prevalent malignant tumor in childhood, and pilocytic astrocytoma, the most common, that only rarely shows a malignant progression. Due to the limited availability of bioptic tissue, the study was performed on pooled tumor tissues, and was focused on acid-insoluble fraction to integrate the characterization performed by a group of colleagues in Rome on the acid-soluble fraction by high performance HPLC-ESI-MS/MS. The results indicated that the two tumors exhibit different proteomic profiles and evidenced interesting differential expression of several proteins. Among them, peroxiredoxin- 1, peptidyl-prolyl cis–trans isomerase A, heterogeneous nuclear ribonucleoproteins A2/B1, mitochondrial isoform of malate dehydrogenase, nucleoside diphosphate kinase A, glutathione S-transferase P and fructose bisphosphate aldolase A resulted significantly over-expressed in medulloblastoma while glial fibrillary acidic protein, serotransferrin, α crystallin B chain, ferritin light chain, annexin A5, fatty acid-binding protein (brain), sorcin and apolipoprotein A-I resulted significantly over-expressed in pilocytic astrocytoma. In conclusion, the work done allowed to evidence the usefulness of using an integrated bottom-up/top-down approach, based on 2-DE-MS analysis and high performance MS in order to obtain a complete characterization of the proteome under investigation, revealing and identifying, not only peptides and small proteins, but also proteins with higher MW, that often it is not possible to identify by using exclusively a top-down ESI-MS approach.

Caratterizzazione geo-petrografica, petrologica e geochimica di rocce anatettiche del nord Sardegna

The High Grade Metamorphic Complex (HGMC) of Variscan basement of north Sardinia is characterized by the widespread of migmatites. This study is focused on two localities of NE Sardinia (Porto Ottiolu and Punta Sirenella) where ortho- and para-derivates migmatites outcrop. A geological and structural survey was carried out, leading to the realization of a geological schematic map of Punta Sirenella area. Several samples of different rocks were collected for petrographic, micro-structural minero-chemical and geochemical analyses. In the Porto Ottiolu area three main deformation phases have been identified; D1, characterized by tight folds with sub-horizontal axes, rarely preserved in paragneisses; D2, that produce a pervasive foliation oriented N100° 45°SW marked by biotite and sillimanite blastesis and locally transposed by shear zone oriented N170°; D3, late deformation phase caused symmetric folds with sub-horizontal axes with no axial plane schistosity. Leucosomes form pods and layers along S2 schistosity but also leucosomes along shear zones have been observed. In the Punta Sirenella area, three main deformation phases have been identified; D1, is manifested by the transposition of centimeter-sized leucosomes and is rarely observed in paragneisses were produce open folds with sub-vertical axes; D2, NW-SE oriented on whose XY plane three mineralogical lineation (quartz+plagioclase, fibrolite+quarz and muscovite) lie; D3, a ductile-brittle deformation phase that produce a mylonitc S3 foliation that locally become the most evident schistosity in the field oriented N140° steeply dipping toward NE. In both areas, leucosomes of sedimentary-derived migmatites are generally trondhjemitic pointing out for a H2O fluxed melting reaction, but also granitic leucosomes have been found, produced by muscovite dehydration melting. Leucosomes of migmatitic orthogneiss instead, have granitic compositions. Migmatization started early, during the compressional and crustal thickening (sin-D1, pre-D2) and was still active during exhumation stage. For each studied outcrop of migmatite pseudosections for the average mesosome composition have been calculated; these pseudosections have been used to model the P-T conditions of anatexis on the basis of the melt volume (%) of melt, Si/Al and Na/K molar ratios, modal content of garnet and Si content in metamorphic white mica. Further pseudosections have been calculated for the average composition of leucosomes in order to define the P-T conditions of the end of the crystallization through intersection of solidus curve and isopleths of Si content in white mica and/or XMg ratio in biotite. Thermodynamic modeling on ortho- and sedimentary-derived migmatites of Punta Sirenella yield P-T conditions of 1.1-1.3 GPa - 670-740°C for migmatitic event and 0.75-0.90 GPa - 660-730°C for the end of crystallization. These conditions are fit well with previous studies on adjacent rocks. Modeling of Porto Ottiolu ortho- and sedimentary-derived migmatites yield P-T conditions of 0.85-1.05 GPa - 690-730°C for migmatitic event and 0.35-0.55 GPa - 630-690°C strongly affected by re-equilibration during exhumation, expecially for crystallization conditions. Geochemical analyses of samples belonging to Porto Ottiolu and Punta Sirenella orthogneisses show a strong link with those of other orthogneisses outcropping in NE Sardinia (for instance, Lode-Mamone and Golfo Aranci) that are considered the intrusive counterparts of middle-Ordovician metavolcanics rocks outcropping in the Nappe Zone. Thus, the studied ortogneiss bodies, even lacking radiometric data, can be considered as belonging to the same magmatic cycle.

Strengthening an in-service reinforcement concrete bridge with prestressed CFRP bar

Carbon fiber reinforced polymer (CFRP) bars were prestressed for the structural strengthening of 8 T-shaped reinforced concrete (RC) beams of a 21-year-old bridge in China. The ultimate bearing capacity of the existing bridge after retrofit was discussed on the basis of concrete structures theory. The flexural strengths of RC beams strengthened with CFRP bars were controlled by the failure of concrete in compression and a prestressing method was applied in the retrofit. The field construction processes of strengthening with CFRP bars—including grouting cracks, cutting groove, grouting epoxy and embedding CFRP bars, surface treating, banding with the U-type CFRP sheets, releasing external prestressed steel tendons—were introduced in detail. In order to evaluate the effectiveness of this strengthening method, field tests using vehicles as live load were applied before and after the retrofit. The test results of deflection and concrete strain of the T-shaped beams with and without strengthening show that the capacity of the repaired bridge, including the bending strength and stiffness, is enhanced. The measurements of crack width also indicate that this strengthening method can enhance the durability of bridges. Therefore, the proposed strengthening technology is feasible and effective.

Stiffener debonding mechanisms in post-buckled CFRP aerospace panels

This paper describes the fractographic analysis of five CFRP post-buckled skin/stringer panels that were tested to failure in compression. The detailed damage mechanisms for skin/stiffener detachment in an undamaged panel were characterised and related to the stress conditions during post-buckling; in particular the sites of peak twist (at buckling nodes) and peak bending moments (at buckling anti-nodes). The initial event was intralaminar splitting of the +45 degrees plies adjacent to the skin/stiffener interface, induced by high twist at a nodeline. This was followed by mode II delamination, parallel to +/- 45 degrees plies and then lengthwise (0 degrees) shear along the stiffener centreline. The presence of defects or damage was found to influence this failure process, leading to a reduction in strength. This research provides an insight into the processes that control post-buckled performance of stiffened panels and suggests that 2D models and element tests do not capture the true physics of skin/stiffener detachment: a full 3D approach is required.

Predicting the ultimate load of a CFRP wingbox

The finite element method in conjunction with the Soutis-Fleck model is used to predict the residual strength after impact of a carbon-fibre reinforced plastic wingbox subjected to a cantilever type loading. The maximum stress failure criterion further validates the Soutis-Fleck model predictions. The Soutis-Fleck model predicts that the wingbox fails at a tip load of 99.2 kN, approximately 5.5% less than the experimental observation