Influence of TiO2 and AI(2)O(3) on the electrical and microstructural properties of SnO2 ceramics obtained by the Pechini method

Tin oxide has wakened up great scientific and technological interest for its potential use in varistors production and as gas sensor. In order to improve the microstructural and electrical properties in SnO2 varistor ceramics, the influence of differents dopants used, like TiO2 and Al2O3, is under research. The effect of TiO2 and Al2O3 on the properties of Sn-Co-Nb varistor systems obtained by the Pechini method has been investigated in this work. Characterization of synthesized raw material was performed by X-Ray Diffraction (XRD) and Scanning Electronic Microscopy (SEM). The microstructural and electrical characterization of sintered samples show that the TiO2 favors the grain growth and the Al2O3 contributes to the decrease it, effect that is manifested in the Sn-Co-Nb varistor systems. Breakdown field increase up to 6300V/cm with increasing Al2O3 content and non-linear coefficients with alpha=22 were obtained.

AI automates substation control

An overview is given on the possibility of controlling the status of circuit breakers (CB) in a substations with the use of a knowledge base that relates some of the operation magnitudes, mixing status variables with time variables and fuzzy sets. It is shown that even when all the magnitudes to be controlled cannot be included in the analysis, it is possible to control the desired status while supervising some important magnitudes as the voltage, power factor, and harmonic distortion, as well as the present status.

The effect of type of vaginal insert and dose of pLH on embryo production, following fixed-time AI in a progestin-based superstimulatory protocol in Nelore cattle

The objective was to analyze and report field data focusing on the effect of type of progesterone-releasing vaginal insert and dose of pLH on embryo production, following a superstimulatory protocol involving fixed-time artificial insemination (FTAI) in Nelore cattle (Bos taurus indicus). Donor heifers and cows (n = 68; 136 superstimulations over 2 years) received an intravaginal, progesterone-releasing insert (CIDR® or DIB®, with 1.9 or 1.0 g progesterone, respectively) and 3-4 mg of estradiol benzoate (EB) i.m. at random stages of the estrous cycle. Five days later (designated Day 0), cattle were superstimulated with a total of 120-200 mg of pFSH (Folltropin-V®), given twice daily in decreasing doses from Days 0 to 3. All cattle received two luteolytic doses of PGF2α at 08:00 and 20:00 h on Day 2 and progesterone inserts were removed at 20:00 h on Day 3 (36 h after the first PGF2α injection). Ovulation was induced with pLH (Lutropin-V®, 12.5 or 25 mg, i.m.) at 08:00 h on Day 4 with FTAI 12, 24 and in several cases, 36 h later. Embryos were recovered on Days 11 or 12, graded and transferred to synchronous recipients. Overall, the mean (±S.E.M.) number of total ova/embryos (13.3 ± 0.8) and viable embryos (9.4 ± 0.6) and pregnancy rate (43.5%; 528/1213) did not differ among groups, but embryo viability rate (overall, 70.8%) was higher in donors with a DIB (72.3%) than a CIDR (68.3%, P = 0.007). In conclusion, the administration of pLH 12 h after progesterone removal in a progestin-based superstimulatory protocol facilitated fixed-time AI in Nelore donors, with embryo production, embryo viability and pregnancy rates after embryo transfer, comparable to published results where estrus detection and AI was done. Results suggested a possible alternative, which would eliminate the need for estrus detection in donors. © 2006 Elsevier Inc. All rights reserved.

Effects of vaccination against reproductive diseases on reproductive performance of beef cows submitted to fixed-timed AI in Brazilian cow-calf operations

The objectives were to assess incidence of pregnancy losses, associate this outcome with immunization programs against reproductive diseases, and evaluate the effects of vaccination against bovine herpesvirus-1 (BoHV-1), bovine viral diarrhea virus (BVDV), and Leptospira spp., on reproductive efficiency of Brazilian cow-calf operations. In experiment 1, 7614 lactating Nelore cows from 18 ranches were assigned to the same estrus synchronization and fixed-time AI protocol (ESFTAI; Days -11 to 0). Pregnancy status was determined with transrectal ultrasonography on Days 30 and 120 after AI. Pregnancy loss was deemed to have occurred when cows were pregnant on Day 30 but nonpregnant on Day 120. Incidence of pregnancy loss across all ranches was 4.1%; pregnancy losses were detected (P < 0.10) in 14 ranches but not detected (P > 0.11) in four ranches. Pregnancy loss was lower (P ≤ 0.02) in ranches that vaccinated against BoHV-1, BVDV, and Leptospira spp. compared with ranches that did not vaccinate, or only vaccinated against Leptospira spp. In experiments 2 and 3, lactating Nelore cows (N = 1950 and 2793, respectively) from ranches that did not have a history of vaccinating against reproductive diseases (experiment 2), or only vaccinated against Leptospira spp. (experiment 3), were assigned to the same ESFTAI used in experiment 1. Within each ranch, cows received (VAC) or not (CON) vaccination against BoHV-1, BVDV, and Leptospira spp. at the beginning of the ESFTAI (Day -11) and 30 days after (Day 41) AI. In experiment 2, VAC cows had greater (P ≤ 0.05) pregnancy rates compared with CON on Days 30 and 120. In experiments 2 and 3, pregnancy loss was reduced (P ≤ 0.03) in primiparous VAC cows compared with CON cohorts. In experiment 4, 367 primiparous, lactating Nelore cows previously vaccinated against Leptospira spp. were assigned to the same ESFTAI used in experiment 1. Cows received VAC, or the same vaccine 30 days before (Day -41) and at the beginning (Day -11) of the ESFTAI (PREVAC). Pregnancy rates on Days 30 and 120 were greater (P ≤ 0.05) in PREVAC cows compared with VAC cows. In conclusion, pregnancy losses affected reproductive and overall efficiency of Brazilian cow-calf operations, and might be directly associated with BoHV-1, BVDV, and Leptospira spp. infections. Hence, vaccinating cows against these pathogens, particularly when both doses are administered before fixed-time AI, improved reproductive performance in Brazilian cow-calf systems. © 2013 Elsevier Inc.

Effects of vaccination against reproductive diseases on reproductive performance of lactating dairy cows submitted to AI

Four experiments evaluated the effects of vaccination against bovine herpesvirus-1 (BoHV-1), bovine viral diarrhea virus (BVDV), and Leptospira spp. on reproductive performance of lactating dairy cows without (experiments 1, 2, and 3) or with previous vaccination against these diseases (experiment 4). Cows were assigned to a fixed-time AI protocol (FTAI; d -11 to 0) in all experiments, as well as AI 12. h upon estrus detection in experiment 3. Pregnancy status was determined with transrectal ultrasonography on d 30 and 71 (d 60 for experiment 3) after AI. Pregnancy loss was considered in cows pregnant on d 30 but non-pregnant on the subsequent evaluation. In experiment 1, 853 cows received (VAC) or not (CON) vaccination against BoHV-1, BVDV, and Leptospira spp. at the beginning of the FTAI (d -11) and 30. d after AI. Pregnancy loss was reduced (P=0.03) in VAC cows compared with CON. In experiment 2, 287 cows received VAC or CON 30. d prior to (d -41) and at the beginning (d -11) of the FTAI. Pregnancy rates on d 30 and 71 were greater (P≤0.03) in VAC cows compared with CON. In experiment 3, 1680 cows with more than 28. d in milk were randomly assigned to receive VAC or CON with doses administered 14. d apart, and inseminated within 15-135. d after the second dose. Pregnancy rates on d 30 and 60 were greater (P≤0.02) in VAC cows compared with CON. In experiment 4, 820 cows received (REVAC) or not (CON) revaccination against BoHV-1, BVDV, and Leptospira spp. at the beginning of the FTAI protocol (d -11). Pregnancy rates and loss were similar (P≥0.54) between treatments. Hence, vaccinating naïve cows against BoHV-1, BVDV, and Leptospira spp. improved reproductive efficiency in dairy production systems, particularly when both doses were administered prior to AI. © 2013 Elsevier B.V.

Apropriação e inserção na contra-arte da geração AI-5

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Confecção de discos de desbaste a partir de AI2O3 e pó de vidro

Este trabalho descreve o desenvolvimento de discos abrasivos e de corte confeccionados com Al²O³ e pó de vidro reciclado para aplicação em ferramenta de corte. Os discos são utilizados para micromizar termoplásticos pós-consumo rígidos e levá-los a diversos tipos de processamento, como por exemplo, a rotomoldagem. Este disco abrasivo utiliza pó de vidro como um aditivo ligante e fundente, e pó de poli(tereftalato de etileno) pós-consumo como plastificante, facilitando um melhor preenchimento do molde. As proporções de pó de vidro reciclado foram analisadas a partir de estudos anteriores com outros minerais, como o diopsídio e o feldspato, já que os estudos com o pó de vidro reciclado substituindo os minerais naturais são recentes. O desenvolvimento dos discos acontece em duas etapas. A primeira é de homogeneização dos componentes com os percentuais calculados. Posteriormente é prensado e levado a mufla até uma temperatura de 900 ^oC para obter a percolação da resina e a consequente degradação do poli (tereftalato de etileno), pré-sinterização e amolecimento dos silicatos . Após a obtenção destes compostos verdes acontece a segunda e última etapa, que consiste na sinterização dos corpos de prova para a diminuição da porosidade e consequente aumento da resistência mecânica, seguida de acabamento superficial e testes de corte.

A importância da definição das áreas de influência(AI's) no licenciamento ambiental para a sociedade - estudo de caso: as minas de caulim no município de Ipixuna do Pará-PA

A pesquisa sobre a relevância da definição de áreas de influências (AI) para a sociedade, abordou sobre Estudos de Impactos Ambientais (EIA‟s) de empreendimentos de extração mineral. Foram analisados 11 (onze) Estudos de Impactos Ambientais protocolados na Secretaria de Estado de Meio Ambiente – SEMA, envolvendo a dé-cada de 1990 a 2000, além de legislações e literaturas especializadas. Para tanto, foi abordado à mineração no Estado do Pará e o processo de licenciamento ambien-tal, definição das áreas de influência em projetos de mineração e criação de seis critérios, específicos para esta dissertação, visando a avaliação da AI‟s apresenta-das nos 11 EIA‟s, para o meio antrópico. Os resultados da análise levaram a detec-tar as razões que confirmam a relevância das AI‟s, assim como suas implicações associadas à qualidade do EIA/RIMA e sua funcionalidade para a sociedade. Bus-cando subsídios que fortalecessem o argumento defendido sobre a relevância das AI‟s, foram realizadas trabalhos de campo nas minas de caulim. As referidas minas já se encontram em funcionamento há mais de 10 anos, e foi possível perceber al-gumas mudanças ocorridas em suas AI‟s. O resultado do campo, confirmou a análi-se realizada nos 11 EIA‟s, pois foi evidente detectar que a decisão para selecionar e definir as AI‟s, apresentados nos EIA‟s objetivando o licenciamento das minas de caulim, desencadeia conseqüências para a sociedade local que pode influenciar ao longo da vida útil do projeto licenciado. Assim, desperta-se a necessidade de elabo-ração de estudos científicos que sejam capazes de contribuir com metodologias es-pecíficas de definição de AI‟s para a região amazônica e com isso, tratar o processo de licenciamento ambiental a partir de legislações direcionadas ao Estado do Pará.