947 resultados para 133-811
Resumo:
Vorbesitzer: Bernhard Waldschmidt
Resumo:
The euphotic depth (Zeu) is a key parameter in modelling primary production (PP) using satellite ocean colour. However, evaluations of satellite Zeu products are scarce. The objective of this paper is to investigate existing approaches and sensors to estimate Zeu from satellite and to evaluate how different Zeu products might affect the estimation of PP in the Southern Ocean (SO). Euphotic depth was derived from MODIS and SeaWiFS products of (i) surface chlorophyll-a (Zeu-Chla) and (ii) inherent optical properties (Zeu-IOP). They were compared with in situ measurements of Zeu from different regions of the SO. Both approaches and sensors are robust to retrieve Zeu, although the best results were obtained using the IOP approach and SeaWiFS data, with an average percentage of error (E) of 25.43% and mean absolute error (MAE) of 0.10 m (log scale). Nevertheless, differences in the spatial distribution of Zeu-Chla and Zeu-IOP for both sensors were found as large as 30% over specific regions. These differences were also observed in PP. On average, PP based on Zeu-Chla was 8% higher than PP based on Zeu-IOP, but it was up to 30% higher south of 60°S. Satellite phytoplankton absorption coefficients (aph) derived by the Quasi-Analytical Algorithm at different wavelengths were also validated and the results showed that MODIS aph are generally more robust than SeaWiFS. Thus, MODIS aph should be preferred in PP models based on aph in the SO. Further, we reinforce the importance of investigating the spatial differences between satellite products, which might not be detected by the validation with in situ measurements due to the insufficient amount and uneven distribution of the data.
Resumo:
Paleontological studies conducted subsequent to the completion of Leg 133 led to refinements of the biostratigraphy for the Leg 133 sites. These biostratigraphic refinements bear on the calculations of sedimentation rates and on the age-depth plots prepared for the Initial Reports volume for Leg 133. To make available the revised data to anyone who may wish to make use of it, the revised biostratigraphic information is presented here in tabulated form. Revised age-depth plots also are presented for all of the sites to facilitate comparison of sedimentation rate curves and to identify intervals where significant changes have been made based on post-cruise studies. The revised age-depth plots include calcareous nannofossils only, and the revised data have been taken from thechapters contributed for this volume (Gartner et al., 1993, doi:10.2973/odp.proc.sr.133.213.1993; Wei and Gartner, 1993, doi:10.2973/odp.proc.sr.133.216.1993). Planktonic foraminifer biostratigraphy revisions became available subsequently and could not be readily incorporated. The age-depth plots for Sites 812 through 818 were made with the (ADP) program provided to ODP by Dave Lazarus.
Resumo:
Fil: Pró, Diego F..
Resumo:
A principal objective at Site 820, situated on the outer shelf, upper slope of the northeastern Australian continental margin, was to test the relationships between changes in Pleistocene sea level and sedimentary packages produced on a mixed carbonate-siliciclastic continental margin. To this end, we have examined the downcore distribution of grain size, magnetic susceptibility, and calcium-carbonate content throughout Hole 820A and, in particular, the top 35 meters below the seafloor (mbsf). These data are compared with variations in the oxygen-isotope signal defined for the same hole and are interpreted as indicating sea-level oscillations. The distribution of sand, mud, calcium carbonate of the mud fraction and total sample, and magnetic susceptibility during the last 20,000 yr defines the position of a sea-level regression (41,000-18,000 yr B.P.), a lowstand, early (18,000-9,400 yr B.P.) and late transgressions (9400-900 yr B.P.), and a highstand (4900 yr to the present). The regression is seen first in a high-carbonate content peak. Calcium carbonate constituents mainly comprise skeletal carbonate grains, with abundant planktonic and benthic foraminifers, and lime muds. The lowstand is characterized by a maximum abundance of the sand fraction, which contains dominantly skeletal carbonate grains and a minor abundance of lithoclasts. Sand-sized terrigenous sediments are proposed to have bypassed the continental shelf during a lowstand of sea level. Sedimentation rates throughout the regression and lowstand are low (3.0 cm/k.y.). The early transgression, marked by highest values in magnetic susceptibility, displays a rapid increase in sedimentation rate that coincided with an increase in terrigenous mud. Highest sedimentation rates of 82.3 cm/k.y. occurred during the late transgression, with increasing percentages of lime-mud. A decrease in noncarbonate constituents in the mud fraction during the late transgression and highstand of sea level is thought to be the result of restricted inner-shelf sedimentation of terrigenous sediments. The same relationship is also seen in the major sea-level oscillation, which is interpreted as isotope stage 6.
Resumo:
Stable isotopic data obtained from planktonic and benthic foraminifers were used to study paleoceanographic changes along the northeastern Australian margin from late Miocene (10 Ma) to Holocene time, and to evaluate the influence of these changes on reef growth. The data indicate that variations in surface-water temperatures may have had an important effect on the reef complexes on the Queensland Plateau and possibly off the northeastern Australian margin. Three sites were studied: Leg 21, Site 209 on the eastern edge of the Queensland Plateau, and Leg 133, Site 811 on the western margin, and Site 817 on the lower southern slope of the plateau. Shallow-water bioclasts recovered from Holes 811A and 817A indicate extensive reef growth on the Queensland Plateau during the middle Miocene (before 12 Ma), signifying surface-water temperatures of 20°C or greater. The amount of reefal detritus produced during the late Miocene (10.0-5.2 Ma) decreased progressively, resulting in a reduction in area of the reef complexes. The isotopic data from planktonic foraminifers in these late Miocene age sediments indicate the presence of relatively cool surface waters (16°-19°C), which may have been a major factor contributing to the demise of the reefs on the Queensland Plateau. Surface waters remained cool until the middle Pleistocene (1.2-0.5 Ma), when the surface-water temperature apparently increased to approximately 25°C, recorded both in the isotopic data and by renewed reef growth. This increase occurred simultaneously (within the error of the age model) with the initiation of the Great Barrier Reef. We propose that cooling of surface waters during the early late Miocene contributed to reef decline on the Queensland Plateau, and that subsequent warming of surface waters during the middle Pleistocene promoted the initiation of reef growth on the northeastern Australian margin. Reef development on the Queensland Plateau never recovered to the middle Miocene extent because of a combination of tectonic (accelerated subsidence of the plateau) and paleoceanographic (the cooler surface waters present from the late Miocene throughout the Pliocene) factors. Variations in seafloor d18O appear to be controlled by regional factors, as indicated by the similarity of data from Sites 811 and 817 to those from Site 590 on Lord Howe Rise.
Resumo:
Oxygen-isotope ratio measurements are presented for the planktonic species Globigerinoides ruber collected from shallow-water, upper-slope sediments from Holes 820A and 820B in 280 m of water, on the seaward edge of the Great Barrier Reef. Correlation of the Site 820 isotope curve with deep-sea reference curves of the Pacific Ocean (Core V28-238, Hole 677A, Hole 607A) permits the definition of isotope stages 1 to 19 in the top 145 m of Holes 820A and 820B. However, paleontological data indicate that stages 4 and 7 might be missing and that two hiatuses occur at a depth of 8.05 to 12.1 and 34.55 to 35.8 mbsf. Using deep-sea Hole 677A as a reference for ice-volume variations, we determine the difference in isotopic signature between it and Site 820. We propose that this difference is a regional signal representing a progressive 4°C increase in surface-water temperature at Site 820. The proposed temperature change was initiated at about 400 k.y. and corresponds to a change from high-to-low frequency variations in Pleistocene isotope signals. We postulate that these changes may have catalyzed the growth of the Great Barrier Reef. The shift also coincides with changes in seismic character and some physical and chemical sediment characteristics.
Resumo:
Paleomagnetic analysis of sediment samples from Ocean Drilling Program (ODP) Leg 133, Site 820, 10 km from the outer edge of the Great Barrier Reef, is undertaken to investigate the mineral magnetic response to environmental (sea level) changes. Viscous remanent magnetization (VRM) of both multidomain and near-superparamagnetic origin is prevalent and largely obscures the primary remanence, except in isolated high-magnetization zones. The Brunhes/Matuyama boundary cannot be identified, but is expected to be below 120 mbsf. The only evidence that exists for a geomagnetic excursion occurs at about 33 mbsf (-135 k.y.). Only one-half the cores were oriented, and many suffered from internal rotation about the core axis, caused by coring and/or slicing. The decay of magnetic remanence below the surface layer (0-2 mbsf) is attributed to sulfate reduction processes. The magnetic susceptibility (K) record is central for describing and understanding the magnetic properties of the sediments, and their relationship to glacio-eustatic fluctuations in sea level. Three prominent magnetic susceptibility peaks, at about 7, 32, and 64 mbsf, are superimposed on a background of smaller susceptibility oscillations. Fluctuations in susceptibility and remanence in the ôbackgroundö zone are controlled predominantly by variations in the concentration, rather than the composition of ferrimagnetics, with carbonate dilution playing an important role (type-A properties). The sharp susceptibility maxima occur at the start of the marine transgressions following low stands in sea level (high d18O, glacial maxima), and are characterized by a stable single-domain remanence, with a significant contribution from ultra-fine, superparamagnetic grains (type-C properties). During the later marine transgression, the susceptibility gradually returns to low values and the remanence is carried by stable single-domain magnetite (type-B properties). The A, B, and C types of sediment have distinctive ARM/K ratios. Throughout most of the sequence a strong inverse correlation exists between magnetic susceptibility and both CaCO3 and d18O variations. However, in the sharp susceptibility peaks (early transgression), more complex phase relationships are apparent among these parameters. In particular, the K-d18O correlation switches to positive, then reverts to negative during the course of the late transgression, indicating that two distinct mechanisms are responsible for the K-d18O correlation. Lower in the sequence, where sea-level-controlled cycles of upward-coarsening sediments, we find that the initial, mud phase of each cycle has been enriched in high-coercivity magnetic material, which is indicative of more oxic conditions. The main magnetic characteristics of the sediments are thought to reflect sea-level-controlled variations in the sediment source regions and related run-off conditions. Some preliminary evidence is seen that biogenic magnetite may play a significant role in the magnetization of these sediments.