Hydrography and water chemistry of the open Mediterranean Sea

On a cruise from the eastern into western Mediterranean Sea in November/December 1978 a total of 126 samples were collected from 8 vertical profiles and 7 coastal stations for trace metal analysis. The sampling, processing and analysis was performed under strict "clean room" conditions. The concentration of the open-sea samples are close to oceanic results gathered under similar conditions. The grand averages from all profiles (± st. dev. of the individual samples) of 0.40 ± 0.16 µg/l Zn, 17.4 ± 7.4 ng/l Cd, 0.21 ± 0.07 µg/l Cu, 0.21 ± 0.13 µg/l Mn and 0.25 ± 0.09 µg/l Fe indicate that a "metal problem" does not exist in the open Mediterranean. A biologically mediated deplition in surface waters or correlation with nutrients have not been observed under the conditions established on this cruise. This is probably due top low primary production and seasonal advection processes prevailing in this sea. The data for manganese show generally higher values in the surface layer (0-75 m) than in deep waters. This could evidently proved in the nearshore profile indicating a terrigenous source for manganese.

Seismic velocities and elastic properties of gabbroic rocks from ODP Hole 118-735B

The nearly continuous recovery of 0.5 km of generally fresh, layer 3 gabbroic rocks at Hole 735B, especially near the bottom of the section, presents scientists an unusual opportunity to study the detailed elastic properties of the lower oceanic crust. Extending compressional-wave and density shipboard measurements at room pressure, Vp and Vs were measured at pressures from 20 to 200 MPa using the pulse transmission method. All of the rocks exhibit significant increases in velocity with increasing pressure up to about 150 MPa, a feature attributed to the closing of microcrack porosity. Measured velocities reflect the mineralogical makeup and microstructures acquired during the tectonic history of Hole 735B. Most of the undeformed and unaltered gabbros are approximately 65:35 plagioclase/clinopyroxene rocks plus olivine or oxide minerals, and the observed densities and velocities are fully consistent with the Voigt-Reuss-Hill (VRH) averages of the component minerals and their proportions. Depending on their olivine content, the predominant olivine gabbros at 200 MPa have average Vp = 7.1 ± 0.2 km/s, Vs = 3.9 ± 0.1 km/s, and grain densities of 2.95 ± 0.5 g/cm3. The less abundant iron-titanium (Fe-Ti) oxide gabbros average Vp = 6.75 ± 0.15 km/s, Vs = 3.70 ± 0.1 km/s, and grain densities of 3.22 ± 0.05 g/cm3, reflecting the higher densities and lower velocities of oxide minerals compared to olivine. About 30% of the core is plastically deformed, and the densities and directionally averaged velocities of these shear-zone tectonites are generally consistent with those of the gabbros, their protoliths. Three sets of observations indicate that the shear-zone metagabbros are elastically anisotropic: (1) directional variations in Vp, both vertical and horizontal and with respect to foliation and lineation; (2) discrepancies among Vp values for the horizontal cores and the VRH averages of the component minerals and their mineral proportions, suggesting preferred crystallographic orientations of anisotropic minerals; and (3) variations of Vs of up to 7%, with polarization directions parallel and perpendicular to foliation. Optical inspection of thin sections of the same samples indicates that plagioclase feldspar, clinopyroxene, and amphibole typically display crystallographic-preferred orientations, and this, plus the elastic anisotropy of these minerals, suggests that preferred orientations are responsible for much of the observed anisotropy, particularly at high pressure. Alteration tends to be localized to brittle faults and brecciated zones, and typical alteration minerals are amphibole and secondary plagioclase, which do not significantly change the velocity-density relationships.

Pollen ages and depths in ODP Site 184-1144

A high-resolution pollen record (sampling interval averages 820 years) has been obtained from ODP Site 1144 (water depth 2037 m), northern South China Sea. The 504-m sequence (in composition length) covers the last 1.03 million years according to micropaleontological and isotopic stratigraphy. The pollen assemblages are characterized by high proportions of Pinus and herb pollen, and by their frequent alternations. Based on these alternations, 29 pollen zones have been recognized that are closely correlated to the Marine Oxygen Isotope Stages (MIS) 1-29. Pinus- dominant pollen zones correspond to interglacial periods with lighter delta18O values, while herb-marked ones relate to the heavier delta18O stages assigned to glacials. Judging from the pollen data, the exposed northern continental shelf of the South China Sea during the glacials was covered by grassland, and the extensive northern shelf has formed only since MIS 6 (ca. 150 ka), probably as a result of tectonic subsidence. Tree pollen influx values are indicative of winter monsoon which began to intensify 600 ka ago. The summer monsoon variations can be approximated by the fern percentage within the total pollen and spore abundance, and the result shows high values in general occurring at interglacials, with the maxima at MIS 15, 5e and 1. The relatively high fern percentage with smaller amplitude in variations before 600 ka might suggest more stable humid conditions before the intensification of winter monsoon.

Processed data from CTD casts and fluorospectrometer measurements from the SONNE SO226/3 cruise track

The Sonne transit cruise SO226-3 DipFIP took place from March 4th (Wellington, New Zealand) to March 28th (Kaohsiung, Taiwan) in 2013. CTD data for 16 stations along the cruise track were recorded using the onboard a SEABIRD SBE 9 plus CTD down to depth of 800m. Obtained hydrographic data were binned to 1 m intervals with the available SBE software. Obvious outliers in the readings of the oxygen sensor close to the sea surface have been manually removed. Fluorospectrometer (bbe Moldaenke) pigment data measured for 24 depth intervals are available for 10 stations. Measurements were conducted in the shipboard laboratory on water samples from the CTD rosette. Data are averages of a least 30 readings per sample.

(Table) Bacterial counts and Fe, Mn and SO4 content in sediments and pore waters of two cores from Lake Baikal

Sediments at the bottom of Lake Baikal are mostly oxidized at their surface, and the oxidized sedimentary deposits are enriched in Fe and Mn hydroxides. The thickness of the oxidized zone of the pelagic sediments averages at 5 cm and locally reaches 10-15, occasionally exceeding 20 cm. Both the thickness of the oxidized layer and the degree of its enrichment in iron and manganese hydroxides are controlled by the depth to which oxygen can penetrate into the sedimentary deposits, which is, in turn, closely related to the sedimentation conditions in the lake (which broadly vary). The sedimentation rate far off the shores of Lake Baikal ranges from <0.02 mm/year to 1.5 mm/year, and the content of organic matter buried in the sediments varies from 0.1 to >4%. The variability of the sedimentation process makes Lake Baikal very convenient to study its diagenetic processes related to redox reactions in sediments, first of all, processes responsible for the redistribution of Fe and Mn compounds. Although the diagenetic enrichment of Fe and Ni in bottom sediments is known to be of biogenic character, very scarce information is available so far on the microorganisms involved in the redistribution of these elements in sediments in Lake Baikal, which lately led us to explore this issue in detail. Our research was centered on the role played by the microbial community in the diagenetic transformations of Fe and Mn with reference to sedimentation conditions in Lake Baikal.

Concentration of total organic carbon in waters of the Atlantic Ocean

In pursuance of previous studies water samples were taken in the Atlantic and Mediterranean during the 12th, 14th and 15th cruises of RV Mikhail Lomonosov in 1962-1964 to determine total and particulate organic carbon and permanganate oxidizability. Preliminary processing of the water samples was carried out in the normal manner in the on-board laboratory immediately after they had been taken: destruction of bicarbonates and carbonates by precise addition of acid (by alkalinity) and evaporation to dryness at 50-60°C. It is quite probable that the corresponding volatile fraction of organic matter is lost under these conditions. In discussion it was demonstrated that it may now be assumed that the carbon of the volatile fraction averages approximately 15% of total carbon, i.e., 15% of the sum of organic carbon of the volatile and nonvolatile fractions. Oxidizability was determined in all samples in the on-board laboratory.

Sea surface temperature estimation for MIS 16 of IODP Site 306-U1313

Hudson Strait (HS) Heinrich Events, ice-rafting events in the North Atlantic originating from the Laurentide ice sheet (LIS), are among the most dramatic examples of millennial-scale climate variability and have a large influence on global climate. However, it is debated as to whether the occurrence of HS Heinrich Events in the (eastern) North Atlantic in the geological record depends on greater ice discharge, or simply from the longer survival of icebergs in cold waters. Using sediments from Integrated Ocean Drilling Program (IODP) Site U1313 in the North Atlantic spanning the period between 960 and 320 ka, we show that sea surface temperatures (SSTs) did not control the first occurrence of HS Heinrich(-like) Events in the sedimentary record. Using mineralogy and organic geochemistry to determine the characteristics of ice-rafting debris (IRD), we detect the first HS Heinrich(-like) Event in our record around 643 ka (Marine Isotope Stage (MIS) 16), which is similar as previously reported for Site U1308. However, the accompanying high-resolution alkenone-based SST record demonstrates that the first HS Heinrich(-like) Event did not coincide with low SSTs. Thus, the HS Heinrich(-like) Events do indicate enhanced ice discharge from the LIS at the end of the Mid-Pleistocene Transition, not simply the survivability of icebergs due to cold conditions in the North Atlantic.

(Table 1) Physical properties of sediments at DSDP Holes 69-504 and 69-505

Values of physical properties measured in the upper sections of sediment cores recovered at Sites 504 and 505 exhibit a remarkable similarity. Below a depth of 145 m Site 504 sediments appear to have undergone changes which are reflected in physical property values. This alteration may have been due to high temperatures in the sediment. In most of Site 505, and in Site 504 above 145 m, seismic velocity averages 1.51 km/s, wet bulk density 1.32 g/cm**3, porosity 80%, and thermal conductivity 0.80% W/m °K. Below 145 m at Site 504 and 210 m at Site 505, mean density increases to 1.40 g/cm**3, porosity decreases to 67%, seismic velocity increases to 1.53 km/s, and thermal conductivity increases to values in excess of 1.0 W/m °K. A good correlation between independent measurements of water content and thermal resistivity supports the existence of small but regular variation in the measured parameters on the scale of 10 m and less.

Environmental context of selected samples from the Tara Oceans Expedition (2009-2013)

The present data set provides contextual environmental data for samples from the Tara Oceans Expedition (2009-2013) that were selected for publication in a special issue of the SCIENCE journal (see related references below). The data set provides calculated averages of mesaurements made at the sampling location and depth, calculated averages from climatologies (AMODIS, VGPM) and satellite products.