Performance of paddy-cum-prawn culture in rainfed low land ecosystem of Sunderbans

Performance of both paddy (Var. NC 492) and prawn Penaeus monodon were assessed for two years during wet-season in rainfed lowland ecosystem with a view to study the economic viability of paddy-cum-prawn culture in the coastal saline zone of West Bengal. Both mono and dual culture of paddy and prawn were tried in the study. Fingerlings of prawn (α 35,000 haˉ¹) of 10-15 mm size were reared for about three and half months with and without fish feed. It was observed that addition of fish feed resulted in higher (57.7%) production of prawn (2.65 mg/haˉ¹) but not rice. Such increase in prawn production was 1.6 times higher when no feed was provided and 1.4 times higher when grown as sole crop. However, paddy, whether grown as mono or mixed culture, did not differ in yield significantly. In dual culture, the benefit - cost ratio was higher (6.83) when prawn was grown with feed and it was maximum (36.0) when grown without feed as sole crop. The study, therefore, indicates that paddy-cum-prawn culture under low land ecosystem of the coastal saline zone is enterprising particularly for small and marginal farmers who fear to take risk of growing prawn alone at the cost of paddy.

METHOD FOR ASSESSING EFFECTS OF CIRCUMFERENTIAL FLOW DISTORTION ON COMPRESSOR STABILITY.

This paper describes the development of a new analysis to predict the onset of flow instability for an axial compressor operating in a circumferentially distorted inlet flow. A relatively simple model is used to examine the influence of various distortions in setting this instability point. It is found that the model reproduces known experimental trends for the loss of stability margin with increasing distortion amplitude and with changes in reduced frequency.

Stability of flow through multistage axial compressors

This paper describes measurements of the performance of a research stage operating in isolation and as part of a multistage compressor. It is shown that the stall point and the stalled performance of the stage are properties of the system in which it operates rather than a property of the stage itself. The consequences of this for the estimation of the stall point for compressors and compression systems are discussed. The support that the measurements give to assumptions made by mathematical models which use the concept of an 'underlying axisymmetric' characteristic, are highlighted.