Uma interface lab-made para aquisição de sinais analógicos instrumentais via porta paralela do microcomputador

A lab-made interface for acquisition of instrumental analog signals between 0 and 5 V at a frequency up to 670 kHz at the parallel port of a microcomputer is described. Since it uses few and small components, it was built into the connector of a printer parallel cable. Its performance was evaluated by monitoring the signals of four different instruments and similar analytical curves were obtained with the interface and from readings from the instrument' displays. Because the components are cheap (~U$35,00) and easy to get, the proposed interface is a simple and economical alternative for data acquisition in small laboratories for routine work, research and teaching.

Degradação de BTXs via processos oxidativos avançados

In this study the efficiency of advanced oxidative processes (AOPs) were investigated toward the degradation of aqueous solutions containing benzene, toluene and xylenes (BTX). The results indicated that BTX can be effectively oxidized by the UV-A-assisted photo-Fenton process. The treatment permits almost total degradation of BTX and removal of more than 80% of the phenolyc intermediates at reaction times of about 30 min. Preliminary investigations using solar light suggest a good potentiality of the process for the treatment of large volumes of aqueous samples containing these polluting species.

Extending the roughness of the data via transitive closures of similarity indexes

One main assumption in the theory of rough sets applied to information tables is that the elements that exhibit the same information are indiscernible (similar) and form blocks that can be understood as elementary granules of knowledge about the universe. We propose a variant of this concept defining a measure of similarity between the elements of the universe in order to consider that two objects can be indiscernible even though they do not share all the attribute values because the knowledge is partial or uncertain. The set of similarities define a matrix of a fuzzy relation satisfying reflexivity and symmetry but transitivity thus a partition of the universe is not attained. This problem can be solved calculating its transitive closure what ensure a partition for each level belonging to the unit interval [0,1]. This procedure allows generalizing the theory of rough sets depending on the minimum level of similarity accepted. This new point of view increases the rough character of the data because increases the set of indiscernible objects. Finally, we apply our results to a not real application to be capable to remark the differences and the improvements between this methodology and the classical one

Selecting Scientific Papers for Publication via Citation Auctions

The scientific community has been suffering from peer review for decades. This process (also called refereeing) subjects an author's scientific work or ideas to the scrutiny of one or more experts in the field. Publishers use it to select and screen manuscript submissions, and funding agencies use it to award research funds. The goal is to get authors to meet their discipline's standards and thus achieve scientific objectivity. Publications and awards that haven't undergone peer review are often regarded with suspicion by scholars and professionals in many fields. However, peer review, although universally used, has many drawbacks. We propose replacing peer review with an auction-based approach: the better the submitted paper, the more scientific currency the author likely bid to have it published. If the bid correctly reflects the paper's quality, the author is rewarded in this new scientific currency; otherwise, the author loses this currency. We argue that citations are an appropriate currency for all scientists. We believe that citation auctions encourage scientists to better control their submissions' quality. It also inspire them to prepare more exciting talks for accepted papers and to invite discussion of their results at congresses and conferences and among their colleagues. In the long run, citation auctions could have the power to greatly improve scientific research

Caracterização de 2,2',4,4',6,6'-hexanitroestilbeno via análises instrumentais

2,2',4,4',6,6'-hexanitrostilbene (HNS) is a very important high explosive that is used in a range of military, aerospace and industrial formulations owing to its suitable properties. It is an insensitive and thermaly stable explosive that can be produced from 2,4,6-trinitrotoluene (TNT). This paper shows the characterization of synthesized HNS by different techniques, such as elementary analysis, differential scanning calorimetry (DSC), thermogravimetric analysis (TG), Fourier transform infrared spectroscopy (FT-IR) and through the determination of the heat of combustion in a calorimeter.

Recuperação de metais de catalisadores de hidrorrefino usados via fusão com KHSO4

This work describes a process for metal recovery from spent NiMo and CoMo/Al2O3 commercial hydrorefining catalysts. The samples were treated by fusion with potassium hydrogen sulfate (5 h, 600 ºC) with a KHSO4/catalyst mass ratio of 10:1. After fusion the solid was solubilized in water (100 ºC), leaving silicon compounds as residue. Losses of nickel and cobalt may reach 16 wt% of the amount present in the sample, depending on the silicon content. Soluble metals were isolated by selective precipitation techniques (nickel, cobalt, aluminum) or by solvent extraction with methyl-isobutyl ketone (molybdenum) in a hydrochloric acid medium. All metals were recovered in very good yields except for nickel and cobalt in the presence of considerable amounts of silicon. Soluble wastes consist of potassium/sodium sulfates/chlorides. Solid wastes correspond to about 4 wt% of the catalyst and can be discarded in industrial dumps.

Análises quali- e quantitativa de cafés comerciais via ressonância magnética nuclear

Coffee is one of the beverages most widely consumed in the world and the "cafezinho" is normally prepared from a blend of roasted powder of two species, Coffea arabica and Coffea canephora. Each one exhibits differences in their taste and in the chemical composition, especially in the caffeine percentage. There are several procedures proposed in the literature for caffeine determination in different samples like soft drinks, coffee, medicines, etc but most of them need a sample workup which involves at least one step of purification. This work describes the quantitative analysis of caffeine using ¹H NMR and the identification of the major components in commercial coffee samples using 1D and 2D NMR techniques without any sample pre-treatment.

Influência da temperatura do ar de secagem sobre o teor e a composição química do óleo essencial de Lippia alba (Mill) N. E. Brown

Leaves of Lippia alba were submitted to six different drying treatments, using air at ambient temperature and heated up to 80 °C. The essential oil was extracted by steam distillation and analyzed by GC-MS. For the dried leaves, the oil content was reduced by 12 to 17% when compared with the fresh plant (0.66%). The major oil component was citral, representing 76% for the fresh plant, and varying from 82 to 84% for the dried material. These results showed that L. alba can be submitted to a drying process of up to 80 ºC without degradation and/or loss of the major, [LC1] active component.

Biodiesel de babaçu (Orbignya sp.) obtido por via etanólica

Biodiesel was obtained by transesterification of babassu oil in anhydrous ethanol and methanol, employing NaOH as catalyst. The products obtained were characterized by physico-chemical and thermogravimetric analysis. It could be concluded that the properties of the two types of biodiesel (ethanolic and methanolic) are very similar when compared with diesel oil.

Recuperação de cádmio de baterias níquel-cádmio via extração seletiva com tributilfosfato (TBP)

This work describes a recovery process of cadmium from spent nickel-cadmium batteries by a new hydrometallurgical route based on the selective extraction in hydrochloric acid medium with tributylphosphate (TBP), alone or dissolved in kerosene. The best results were obtained when TBP concentration was at least 75 vol%. Nickel extraction was negligible under these conditions. It was isolated after processing the rafinate through an anionic ion-exchange column. Final wastes generated are basically sodium chloride solutions, with no turbidity, color or heavy metals present in significant amounts.

Sistema d'adquisició de temperatures de 2 canals via R.F.

Poder mesurar i enregistrar diferents tipus de magnituds com pressió, força, temperatura etc. s’ha convertit en una necessitat per moltes aplicacions actuals. Aquestes magnituds poden tenir procedències molt diverses, tals com l’entorn, o poden ser generades per sistemes mecànics, elèctrics, etc. Per tal de poder adquirir aquestes magnituds, s’utilitzen els sistemes d’adquisició de dades. Aquests sistemes, prenen mostres analògiques del món real, i les transformen en dades digitals que poden ser manipulades per un sistema electrònic. Pràcticament qualsevol magnitud es pot mesurar utilitzant el sensor adient. Una magnitud molt utilitzada en sistemes d’adquisició de dades, és la temperatura. Els sistemes d’adquisició de temperatures estan molt generalitzats, i podem trobar-los com a sistemes, on l’objectiu és mostrar les dades adquirides, o podem trobar-los formant part de sistemes de control, aportant uns inputs necessaris per el seu correcte funcionament, garantir-ne l’estabilitat, seguretat etc. Aquest projecte, promogut per l’empresa Elausa, s’encarregarà d’adquirir, el senyal d’entrada de 2 Termoparells. Aquests mesuraran temperatures de circuits electrònics, que es trobaran dintre la càmera climàtica de Elausa, sotmesos a diferents condicions de temperatura, per tal de rebre l’homologació del circuit. El sistema haurà de poder mostrar les dades adquirides en temps real, i emmagatzemar-les en un PC que estarà ubicat en una oficina, situada a uns 30 m de distància de la sala on es farà el test. El sistema constarà d’un circuit electrònic que adquirirà, i condicionarà el senyal de sortida dels termoparells, per adaptar-lo a la tensió d’entrada d’un convertidor analògic digital, del microcontrolador integrat en aquesta placa. Seguidament aquesta informació, s’enviarà a través d’un mòdul transmissor de radiofreqüència, cap al PC on es visualitzaran les dades adquirides. Els objectius plantejats són els següents: - Dissenyar el circuit electrònic d’adquisició i condicionament del senyal. - Dissenyar, fabricar i muntar el circuit imprès de la placa d’adquisició. - Realitzar el programa de control del microcontrolador. - Realitzar el programa per presentar i desar les dades en un PC. - El sistema ha d’adquirir 2 temperatures, a través de Termoparells amb un rang d’entrada de -40ºC a +240ºC - S’ha de transmetre les dades via R.F. Els resultats del projecte han estat satisfactoris i s’han complert els objectius plantejats.

Ensaios para determinar a (Bio)disponibilidade de chumbo em solos contaminados: revisão

Incidental ingestion of contaminated soils is a major route of Pb uptake by humans, especially by children. Lead speciation in soils controls its bioavailability. Bioavailability assessment requires the determination of the amount of absorbed lead if a contaminated soil is ingested. In vivo tests, which employ animals, are considered the best model to infer absorption of Pb. But they have some logistic limitations and several authors proposed in vitro methods, which simulate conditions of human digestion. Many of them present results which correlate with in vivo essays. Several authors consider in vitro tests a good and reliable alternative to infer lead bioavailability.

Influência da temperatura de secagem sobre o rendimento e a composição química do óleo essencial de Tanaecium nocturnum (barb. Rodr.) bur. & K. Shum

The yields and chemical compositions of the essential oils obtained by steam distillation of the fresh and dried (30 and 40 ºC) leaves, stems and roots of Tanaecium nocturnum are reported. The identification and quantification of the volatile constituents were accomplished by GC/MS and GC/FID, respectively. The essential oils obtained from the various parts of the plant were constituted mainly of benzaldehyde. Large losses and variations in the quantities of the components during the drying process were observed. The presence of mandelonitrile in higher concentration in the stem and roots indicates that this species produces cyanogenic glycosides.

Stereoselective syntheses of (+)- isoretronecanol and (+)-5-epi-tashiromine via addition of chiral titanium (iv) enolates to cyclic n-acyliminium ions

The stereoselective addition of the titanium (IV) enolates derived from (S)-4-isopropyl-N-4-chlorobutyryl-1,3-thiazolidine-2-thione (8) and from (S)-4-isopropyl-N-4-chloropentanoyl-1,3-thiazolidine-2-thione (9) to N-Boc-2-methoxypyrrolidine (5b) afforded the addition products (+)-10 and (+)-11 in 84% yield in both cases, as 8.6:1 and 10:1 diastereoisomeric mixtures, respectively. A three-step sequence allowed to convert these adducts to (+)-isoretronecanol (1) and (+)-5-epi-tashiromine (2) in 43% and 49% overall yield, respectively.

Monoglicerídeos: produção por via enzimática e algumas aplicações

Monoglycerides (MAG) are non-ionic surfactants, widely used in the pharmaceutical, food and cosmetic industries. Although MAGs are manufactured on an industrial scale by chemical glycerolysis of oils and fats, new developments in lipase catalyzed synthesis have been studied as an alternative to the classical method seeking to use clean technology and green chemistry. In this work, different methods such as glycerolysis, selective hydrolysis of fats and oils, and esterification of fatty acids or transesterification of esters with glycerol are presented. The properties and applications of the monoglycerides are also included in this review.