Development of an injectable grout for concrete repair and strengthening

This paper deals with the coupled effect of temperature and silica fume addition on rheological, mechanical behaviour and porosity of grouts based on CEMI 42.5R, proportioned with a polycarboxylate-based high range water reducer. Preliminary tests were conducted to focus on the grout best able to fill a fibrous network since the goal of this study was to develop an optimized grout able to be injected in a mat of steel fibers for concrete strengthening. The grout composition was developed based on criteria for fresh state and hardened state properties. For a CEMI 42.5R based grout different high range water reducer dosages (0%, 0.2%, 0.4%, 0.5%, 0.7%) and silica fume (SF) dosages (0%, 2%, 4%) were tested (as replacement of cement by mass). Rheological measurements were used to investigate the effect of polycarboxylates (PCEs) and SF dosage on grout properties, particularly its workability loss, as the mix was to be injected in a matrix of steel fibers for concrete jacketing. The workability behaviour was characterized by the rheological parameters yield stress and plastic viscosity (for different grout temperatures and resting times), as well as the procedures of mini slump cone and funnel flow time. Then, further development focused only on the best grout compositions. The cement substitution by 2% of SF exhibited the best overall behaviour and was considered as the most promising compared to the others compositions tested. Concerning the fresh state analysis, a significant workability loss was detected if grout temperature increased above 35 degrees C. Below this temperature the grout presented a self-levelling behaviour and a life time equal to 45 min. In the hardened state, silica fumes increased not only the grout's porosity but also the grout's compressive strength at later ages, since the pozzolanic contribution to the compressive strength does not occur until 28 d and beyond. (C) 2012 Elsevier Ltd. All rights reserved.

Bat rabies in the north-northwestern regions of the state of São Paulo, Brazil: 1997-2002

OBJECTIVE: Reports on bat rabies in Brazil are sporadic and isolated. This study aimed at describing the detection of rabies virus in bats in the state of São Paulo. METHODS: A total of 7,393 bats from 235 municipalities of the north and northwestern areas of the state of São Paulo, Southeastern Brazil, were assessed according to their morphological and morphometric characteristics from 1997 to 2002. Fluorescent antibody test and mice inoculation were used for viral identification. RESULTS: Of all samples examined, 1.3% was rabies virus positive, ranging from 0.2% in 1997 to 1.6% in 2001. There were found 98 bats infected, 87 in the urban area. Fluorescent antibody test was detected in 77 positive samples, whereas 92 produced rabies signs in mice; incubation period ranging from 4 to 23 days. In 43 cities at least one rabid bat was observed. The highest proportion (33.7%) of rabies virus was found in Artibeus lituratus. Eptesicus and Myotis were the most frequent positive species (24.5%) of the Vespertilionidae family. The species Molossus molossus and Molossus rufus showed 14.3% positive bats. There were no differences in the distribution of positive rabies between females (33; 48.5%) and males (35; 51.5%). CONCLUSIONS: Rabies-infected bats were found in environments that pose a risk to both human and domestic animal population and there is a need for actions aiming at the control of these species and public education.

Avaliação de fatores determinantes e da taxa de incidência da condição DFD (Dark, Firm, Dry) na carne de bovinos abatidos no matadouro da ilha Terceira

Dissertação de Mestrado, Engenharia Zootécnica, 13 de Junho de 2014, Universidade dos Açores.