Refusal of treatment

Patients' thoughts, feelings and desires are communicated in a variety of ways, and require sympathetic, critical interpretation. Patients need clear, evidence-based medical information so that they can make their own decisions about whether to consent to or refuse medical treatment. Treatment refusal may provide an opportunity to introduce patients to advance care planning. Unconscious motivations in doctors may obstruct good clinical decision-making. Although respect for the patient's responsibility to make healthcare decisions should be a condition of the clinical relationship, healthcare decision-making is a collaborative process.

The effect of heat treatment on the toughness, hardness and microstructure of low carbon white cast irons

The effect of destabilisation and subcritical heat treatment on the impact toughness, hardness, and the amount and mechanical stability of retained austenite in a low carbon white cast iron have been investigated. The experimental results show that the impact energy constantly increases when the destabilisation temperature is raised from 950 degreesC to 1200 degreesC. Although the hardness decreases, the heat-treated hardness is still greater than the as-cast state. After destabilisation treatment at 1130 degreesC, tempering at 200 to 250 degreesC for 3 hours leads to the highest impact toughness, and secondary hardening was observed when tempering over 400 degreesC. The amount of retained austenite increased with the increase in the destabilisation temperature, and the treatment significantly improves the mechanical stability of the retained austenite compared with the as-cast state. Tempering below 400 degreesC does not affect the amount of retained austenite and its mechanical stability. But the amount of retained austenite is dramatically reduced when tempered above 400 degreesC. The relationship between the mechanical properties and the microstructure changes was discussed. (C) 2001 Kluwer Academic Publishers.

Reactions to tick antitoxin serum and the role of atropine in treatment of dogs and cats with tick paralysis caused by Ixodes holocyclus: a pilot survey

Objective To determine the incidence and nature of adverse reactions of dogs and cats to tick antitoxin serum and to re-evaluate the role of atropine in the treatment of tick paralysis. Design A retrospective questionnaire of veterinarians. Procedure Questionnaires were posted to 320 veterinarians in tick-endemic regions of Australia. Questions referred to dogs and cats treated for tick paralysis over a period of three years: the number treated, treatment protocols and adverse systemic reactions to tick antitoxin serum. Ninety completed questionnaires were returned and responses analysed. Results Veterinarians reported that approximately 3% of dogs exhibited adverse reactions immediately following treatment with tick antitoxin serum, Eighteen percent of these reactions were described as anaphylaxis, with the remaining 82% attributed to the Bezold-Jarisch reflex. Six percent of cats treated with tick antitoxin serum reacted adversely and the majority of reactions (63%) were ascribed to the Bezold-Jarisch reflex. Atropine was used routinely by 10% of responding veterinarians in the treatment of dogs and cats with tick paralysis. A similar number of veterinarians used atropine only in selected cases. Most veterinarians (76%) reported that they never used atropine in the treatment of tick paralysis in either dogs or cats. Within the survey population, premedication with atropine reduced the number of Bezold-Jarisch reactions following tick antitoxin administration approximately five-fold in dogs and four-fold in cats. Conclusions Data from this pilot survey indicate that more cats than dogs have adverse systemic reactions to tick antitoxin serum and that the majority of these reactions in both dogs and cats could be related to the Bezold-Jarisch reflex. The number of reactions to tick antitoxin serum in dogs and cats could be significantly reduced by the routine use of atropine prior to administration of tick antitoxin serum.

Mass balance characterisation of Al-7Si-Mg alloy microstructures as a function of solution treatment time

Mass balance calculations were performed to model the effect of solution treatment time on A356 and A357 alloy microstructures. Image analysis and electron probe microanalysis were used to characterise microstructures and confirm model predictions. In as-cast microstructures, up to 8 times more Mg is tied up in the pi-phase than in Mg2Si. The dissolution of pi is accompanied by a corresponding increase in the amount of beta-phase. This causes the rate of pi dissolution to be limited by the rate of beta formation. It is predicted that solution treatments of the order of tens of minutes at 540degreesC produce near-maximum T6 yield strengths, and that Mg contents in excess of 0.52 wt% have no advantage.

Integrated treatment of shrimp effluent by sedimentation, oyster filtration and macroalgal absorption: a laboratory scale study

Effluent water from shrimp ponds typically contains elevated concentrations of dissolved nutrients and suspended particulates compared to influent water. Attempts to improve effluent water quality using filter feeding bivalves and macroalgae to reduce nutrients have previously been hampered by the high concentration of clay particles typically found in untreated pond effluent. These particles inhibit feeding in bivalves and reduce photosynthesis in macroalgae by increasing effluent turbidity. In a small-scale laboratory study, the effectiveness of a three-stage effluent treatment system was investigated. In the first stage, reduction in particle concentration occurred through natural sedimentation. In the second stage, filtration by the Sydney rock oyster, Saccostrea commercialis (Iredale and Roughley), further reduced the concentration of suspended particulates, including inorganic particles, phytoplankton, bacteria, and their associated nutrients. In the final stage, the macroalga, Gracilaria edulis (Gmelin) Silva, absorbed dissolved nutrients. Pond effluent was collected from a commercial shrimp farm, taken to an indoor culture facility and was left to settle for 24 h. Subsamples of water were then transferred into laboratory tanks stocked with oysters and maintained for 24 h, and then transferred to tanks containing macroalgae for another 24 h. Total suspended solid (TSS), chlorophyll a, total nitrogen (N), total phosphorus (P), NH4+, NO3-, and PO43-, and bacterial numbers were compared before and after each treatment at: 0 h (initial); 24 h (after sedimentation); 48 h (after oyster filtration); 72 h (after macroalgal absorption). The combined effect of the sequential treatments resulted in significant reductions in the concentrations of all parameters measured. High rates of nutrient regeneration were observed in the control tanks, which did not contain oysters or macroalgae. Conversely, significant reductions in nutrients and suspended particulates after sedimentation and biological treatment were observed. Overall, improvements in water quality (final percentage of the initial concentration) were as follows: TSS (12%); total N (28%); total P (14%); NH4+ (76%); NO3- (30%); PO43-(35%); bacteria (30%); and chlorophyll a (0.7%). Despite the probability of considerable differences in sedimentation, filtration and nutrient uptake rates when scaled to farm size, these results demonstrate that integrated treatment has the potential to significantly improve water quality of shrimp farm effluent. (C) 2001 Elsevier Science B.V. All rights reserved.