isotopic composition of gases and interstitial fluides of ODP Site 104-644

Pleistocene- to middle Miocene-age sediment was drilled at Site 341 (67? 20.1'N, 6? 06.6'E) on the inner Voring Plateau during Leg 38 of the Deep Sea Drilling Project (DSDP). In 1985, the Ocean Drilling Program (ODP) returned to the inner Wring Plateau near Site 341 and drilled a new hole at Site 644 (66° 40.7'N, 4° 34.6'E) as part of a transect to study Norwegian Sea paleoenvironments. In Hole 341, gas expansion pockets formed in cores which were recovered from depths below 50 m. This gas was characterized as predominantly methane with delta13C values in the range of -87 to -77 per mil (Morris, 1976, doi:10.2973/dsdp.proc.38.124.1976). At Site 644, sediment gas and pore-water samples were obtained to study the geochemistry of methanogenesis. Of particular interest is the possibility that methane hydrate might be present in these sediments.

(Table 2) Geochemistry of K-feldspars and associated plagioclase phenocrysts and rims at DSDP Legs 69, 52, 51 and 19

Basalts from some holes of the Deep Sea Drilling Project contain secondary K-feldspar which forms pseudomorphs after calcic (>76% An) Plagioclase cores, whereas Plagioclase of rims and microlites (68-74% An) remains unaltered. In basalts of Hole 504B two such grains with relics of Plagioclase in the central parts of phenocysts were recovered. The composition of the Plagioclase rims and of non-replaced phenocrysts is An79-81; the composition of relics is An83. The An and Ab contents of the K-feldspar is higher than in K-feldspar from altered basalt in Hole 418A in the Atlantic Ocean near the Bermuda Rise. Replacement of plagioclases by K-feldspar evidently is caused by oxygen-rich nearbottom sea water penetrating into basalts. The temperature interval of K-feldspathization is probably in the range 30 to 80°C, more-calcic Plagioclase being replaced by K-feldspar at higher temperatures.

Mineralogy and isotope chemistry of GISP2 and potential source areas

Samples of dust from the Greenland Ice Sheet Project 2 (GISP2) ice core, Summit, Greenland, dated within marine isotope stage 2 (between 23,340 and 26,180 calendar years B.P.) around the time of the coldest, local, last glacial temperatures, have been analyzed to determine their provenance. To accomplish this, we have compared them with approximately Coeval aeolian sediments (mostly loesses) sampled in possible source areas (PSAs) from around the northern hemisphere. The <5-µm grain-size fraction of these samples was analyzed on the basis that it corresponds to the atmospheric dust component of that time and locale, which was sufficiently fine grained to be transported over long distances. On the basis of comparison of the clay mineralogy and Sr, Nd and Pb isotope composition with ice dust and PSAs and assuming that we have sampled the most important PSAs, we have determined that the probable source area of these GISP2 dusts was in eastern Asia. The dust was not derived from either the midcontinental United States or the Sahara, two more proximal areas that have been suggested as potential sources based on atmospheric circulation modeling. Except for a brief period during an interstadial, when dust transport was exceptionally low (for glacial times) and had a mineralogical composition indicative of a slightly more southern provenance, the source area of the dust did not change significantly during times of variably higher fluxes of dust with larger mean grain size or lower fluxes of dust with smaller mean grain size. This includes the high-dust period that correlates with the Heinrich 2 period of major iceberg discharge into the North Atlantic. Variable wind strengths must therefore be invoked to account for these abrupt and significant changes in dust flux and grain size.

Debris flow magnitudes: a global catalog

The episodic occurrence of debris flow events in response to stochastic precipitation and wildfire events makes hazard prediction challenging. Previous work has shown that frequency-magnitude distributions of non-fire-related debris flows follow a power law, but less is known about the distribution of post-fire debris flows. As a first step in parameterizing hazard models, we use frequency-magnitude distributions and cumulative distribution functions to compare volumes of post-fire debris flows to non-fire-related debris flows. Due to the large number of events required to parameterize frequency-magnitude distributions, and the relatively small number of post-fire event magnitudes recorded in the literature, we collected data on 73 recent post-fire events in the field. The resulting catalog of 988 debris flow events is presented as an appendix to this article. We found that the empirical cumulative distribution function of post-fire debris flow volumes is composed of smaller events than that of non-fire-related debris flows. In addition, the slope of the frequency-magnitude distribution of post-fire debris flows is steeper than that of non-fire-related debris flows, evidence that differences in the post-fire environment tend to produce a higher proportion of small events. We propose two possible explanations: 1) post-fire events occur on shorter return intervals than debris flows in similar basins that do not experience fire, causing their distribution to shift toward smaller events due to limitations in sediment supply, or 2) fire causes changes in resisting and driving forces on a package of sediment, such that a smaller perturbation of the system is required in order for a debris flow to occur, resulting in smaller event volumes.