Measurement of the underlying event activity at the LHC with √s = 7 TeV and comparison with √s = 0:9 TeV

A measurement of the underlying activity in events with a jet of transverse momentum in the several GeV region is performed in proton-proton collisions at √ s = 0:9 and 7TeV, using data collected by the CMS experiment at the LHC. The production of charged particles with pseudorapidity |η|<2 and transverse momentum pT >0:5 GeV/c is studied in the azimuthal region transverse to that of the leading set of charged particles forming a track-jet. A significant growth of the average multiplicity and scalar-pT sum of the particles in the transverse region is observed with increasing pT of the leading trackjet, followed by a much slower rise above a few GeV/c. For track-jet pT larger than a few GeV/c, the activity in the transverse region is approximately doubled with a centreof- mass energy increase from 0:9 to 7TeV. Predictions of several QCD-inspired models as implemented in pythia are compared to the data.

J/ψ and ψ (2S) production in pp collisions at √s = 7 TeV

A measurement of the J/ ψ and ψ (2S) production cross sections in pp collisions at √s = 7TeV with the CMS experiment at the LHC is presented. The data sample corresponds to an integrated luminosity of 37 pb -1. Using a fit to the invariant mass and decay length distributions, production cross sections have been measured separately for prompt and non-prompt charmonium states, as a function of the meson transverse momentum in several rapidity ranges and integrated in the kinematical regions considered in this study. In addition, cross sections restricted to the acceptance of the CMS detector are given, which are not affected by the polarization of the charmonium states. The ratio of the differential production cross sections of the two states, where systematic uncertainties largely cancel, is also determined. The branching fraction of the inclusive B → ψ (2S)X decay is extracted from the ratio of the non-prompt cross sections to be: B(B → ψ (2S)X) = (3:08 ± 0:12 (stat.+syst.) ± 0:13 (theor.) ± 0:42 (BPDG)) × 10 -3: B(B → ψ(2S)X) = (3.08 ± 0.12 (stat.+syst.) ± 0.13 (theor.) ± 0.42 (B PDG)) × 10 -3.

Search for microscopic black holes in pp collisions at √ s = 7 TeV

A search for microscopic black holes in pp collisions at a center-of-mass energy of 7TeV is presented. The data sample corresponds to an integrated luminosity of 4.7 fb1 recorded by the CMS experiment at the LHC in 2011. Events with large total transverse energy have been analyzed for the presence of multiple energetic jets, leptons, and photons, which are typical signals of evaporating semiclassical and quantum black holes, and string balls. Agreement with the expected standard model backgrounds, which are dominated by QCD multijet production, has been observed for various combined multiplicities of jets and other reconstructed objects in the final state. Model-independent limits are set on new physics processes producing high-multiplicity, energetic final states. In addition, new model-specific indicative limits are set excluding semiclassical and quantum black holes with masses below 3.8 to 5.3TeV and string balls with masses below 4.6 to 4.8TeV . The analysis has a substantially increased sensitivity compared to previous searches.

Chile y Guatemala: factores que afectan la participacion femenina en la actividad economica

Incluye Bibliografía

Performance of CMS muon reconstruction in pp collision events at √s = 7TeV

The performance of muon reconstruction, identification, and triggering in CMS has been studied using 40 pb-1 of data collected in pp collisions at s = 7 TeV at the LHC in 2010. A few benchmark sets of selection criteria covering a wide range of physics analysis needs have been examined. For all considered selections, the efficiency to reconstruct and identify a muon with a transverse momentum pT larger than a few GeV/c is above 95% over the whole region of pseudorapidity covered by the CMS muon system, < 2.4, while the probability to misidentify a hadron as a muon is well below 1%. The efficiency to trigger on single muons with pT above a few GeVc is higher than 90% over the full η range, and typically substantially better. The overall momentum scale is measured to a precision of 0.2% with muons from Z decays. The transverse momentum resolution varies from 1% to 6% depending on pseudorapidity for muons with pT below 100GeV/c and, using cosmic rays, it is shown to be better than 10% in the central region up to pT = 1 TeV/c. Observed distributions of all quantities are well reproduced by the Monte Carlo simulation. © 2012 IOP Publishing Ltd and Sissa Medialab srl.

Docencia en población en América Latina

Consta de tres partes que recogen: el diagnóstico de la situación de la docencia en población en la región; una síntesis de las ponencias presentadas y las conclusiones y recomendaciones de la reunión. Los anexos contienen la lista de participantes y de ponencias y la nómina de las instituciones según las modalidades de programas en población, por países.

Variables demográficas en proyectos de desarrollo: de lo general a lo particular

Consideraciones sobre el estudio de los efectos demográficos de los proyectos de desarrollo y examen de ejemplos concretos en el caso de México.

Pacto fiscal en Guatemala: lecciones de una negociación

Incluye Bibliografía

The fiscal covenant in Guatemala: lessons learned from the negotiations

Includes bibliography

Characterization of natural rubber/gold nanoparticles SERS-active substrate

Natural rubber/gold nanoparticles membranes (NR/Au) were studied by ultrasensitive detection and chemical analysis through surface-enhanced Raman scattering and surface-enhanced resonance Raman scattering in our previous work (Cabrera et al., J. Raman Spectrosc. 2012, 43, 474). This article describes the studies of thermal stability and mechanical properties of SERS-active substrate sensors. The composites were prepared using NR membranes obtained by casting the latex solution as an active support (reducing/establishing agents) for the incorporation of colloidal gold nanoparticles (AuNPs). The nanoparticles were synthesized by in situ reduction at different times. The characterization of these sensors was carried out by thermogravimetry, differential scanning calorimetry, scanning electron microscopy (SEM) microscopy, and tensile tests. It is suggested an influence of nanoparticles reduction time on the thermal degradation of NR. There is an increase in thermal stability without changing the chemical properties of the polymer. For the mechanical properties, the tensile rupture was enhanced with the increase in the amount of nanoparticles incorporated in the material. © 2013 Wiley Periodicals, Inc.

Green synthesis of gold nanoparticles with self-sustained natural rubber membranes

Green chemistry is an innovative way to approach the synthesis of metallic nanostructures employing eco-friendly substances (natural compounds) acting as reducing agents. Usually, slow kinetics are expected due to, use of microbiological materials. In this report we study composites of natural rubber (NR) membranes fabricated using latex from Hevea brasiliensis trees (RRIM 600) that works as reducing agent for the synthesis of gold nanoparticles. A straight and clean method is presented, to produce gold nanoparticles (AuNP) in a flexible substrate or in solution, without the use of chemical reducing reagents, and at the same time providing good size's homogeneity, reproducibility, and stability of the composites. Copyright © 2013 Flávio C. Cabrera et al.

Structure-function relationships of the peptide Paulistine: A novel toxin from the venom of the social wasp Polybia paulista

Background: The peptide Paulistine was isolated from the venom of wasp Polybia paulista. This peptide exists under a natural equilibrium between the forms: oxidised - with an intra-molecular disulphide bridge; and reduced - in which the thiol groups of the cysteine residues do not form the disulphide bridge. The biological activities of both forms of the peptide are unknown up to now. Methods: Both forms of Paulistine were synthesised and the thiol groups of the reduced form were protected with the acetamidemethyl group [Acm-Paulistine] to prevent re-oxidation. The structure/activity relationships of the two forms were investigated, taking into account the importance of the disulphide bridge. Results: Paulistine has a more compact structure, while Acm-Paulistine has a more expanded conformation. Bioassays reported that Paulistine caused hyperalgesia by interacting with the receptors of lipid mediators involved in the cyclooxygenase type II pathway, while Acm-Paullistine also caused hyperalgesia, but mediated by receptors involved in the participation of prostanoids in the cyclooxygenase type II pathway. Conclusion: The acetamidemethylation of the thiol groups of cysteine residues caused small structural changes, which in turn may have affected some physicochemical properties of the Paulistine. Thus, the dissociation of the hyperalgesy from the edematogenic effect when the actions of Paulistine and Acm-Paulistine are compared to each other may be resulting from the influence of the introduction of Acm-group in the structure of Paulistine. General significance: The peptides Paulistine and Acm-Paulistine may be used as interesting tools to investigate the mechanisms of pain and inflammation in future studies. © 2013 Elsevier B.V.

Evaluacion de 10 años de planificacion de la familia en Chile

Incluye Bibliografía

Guatemala: evolución de la composición de la población y su distribución espacial

Incluye Bibliografía

Evaluación y corrección de la declaración de la edad en el Censo de Población de Perú 1981; trabajo de investigación

Incluye Bibliografía