The Journal of physical chemistry.

Editors: 1896-1932, W. D. Bancroft (with J. E. Trevor, 1896-1909);--1933-51, S. C. Lind;--1952-<53> W. A. Noyes.

Introduction to physical chemistry /

Mode of access: Internet.

Practical physical chemistry,

Mode of access: Internet.

Outlines of physical chemistry.

Mode of access: Internet.

A system of physical chemistry,

Bibliographical footnotes.

Physical chemistry,

Mode of access: Internet.

Fundamentals of physical chemistry,

Mode of access: Internet.

A manual of practical physical chemistry.

Mode of access: Internet.

Electrochemical deposition of cupric ions for the determination of mass transfer rates to a stepped rotating cylinder electrode

The stepped rotating cylinder electrode (SRCE) geometry has been developed as a simple aid to the practical study of the flow-enhanced corrosion and applied electrochemistry problems commonly observed under conditions of disturbed, turbulent flow. The electrodeposition of cupric ions from an acid sulphate plating bath has been used to characterise differential rates of mass transfer to the SRCE. The variation in thickness of electrodeposited copperfilms has allowed the mapping of local rates of mass transfer over the active surface of this geometry. Both optical and scanning electron microscopy were used for the examination of metallographic sections to provide a high resolution evaluation of the distribution of mass transfer coefficient. Results are also discussed using the convective-diffusion model in combination with the existing direct numerical flow simulation (DNS) data for this geometry.

A Review of the Environmental and Health Effects of Termiticides under Australian Conditions

There exists a major cost issue as regards termite damage to wooden structures. A factor in this cost has been the increasing trend towards slab-on-ground construction. Current literature has been reviewed in relation to concerns about the possible public/environmental health consequences of the repeated use of termiticides in large quantities. The previous, current and projected future use patterns of termiticides are reviewed in the context of techniques appropriate for termite control and treatment priorities. The phasing out of organochlorine termiticides in Australia was undertaken to minimise impact of these substances on the environment and to a lesser extent on public health. These persistent chemicals were replaced by substances with high activity but relatively low persistence in the soil. There has also been an increase in the use of alternative methods (e.g. physical barriers) for the control of termites. The transition away from organochlorine termiticides has led to a realisation that significant information gaps exist with regard to replacement chemicals and other technologies. Although relatively persistent, the organochlorine chemicals have a limited lifespan in soils. Their concentrations are gradually attenuated by processes such as transport away from the point of application and biodegradation. Wooden structures originally treated with these substances will, with the passing of time, be at risk of termite infestation. The only available option is re-treatment with chemicals currently registered for termite control. Thus, there are likely to be substantial future increases associated with the cost of re-treatment and repairs of older slab-on-ground dwellings. More information is required on Australian termite biology, taxonomy and ecology. The risks of termite infestation need to be evaluated, both locally and nationally so that susceptible or high risk areas, structures and building types can be identified and preventive measures taken in terms of design and construction. Building regulations and designs need to be able to reduce or eliminate high-risk housing; and eliminate or reduce conditions that are attractive to termites and/or facilitate termite infestation.

Genetic algorithms in statistical tolerancing

An important aspect in manufacturing design is the distribution of geometrical tolerances so that an assembly functions with given probability, while minimising the manufacturing cost. This requires a complex search over a multidimensional domain, much of which leads to infeasible solutions and which can have many local minima. As well, Monte-Carlo methods are often required to determine the probability that the assembly functions as designed. This paper describes a genetic algorithm for carrying out this search and successfully applies it to two specific mechanical designs, enabling comparisons of a new statistical tolerancing design method with existing methods. (C) 2003 Elsevier Ltd. All rights reserved.

Hydrothermal deposition of cerium hydroxycarbonate thin films on glass

The first success in the preparation of rare earth hydroxycarbonate thin films has been achieved. Cerium hydroxycarbonate films were prepared by a hydrothermal deposition method, the sample of a single orthorhombic phase was deposited at a lower temperature while those of orthorhombic and hexagonal phases were obtained at higher temperatures. The crystals in the films could be ellipsoidal, prismatic, or rhombic, depending on the deposition conditions applied. The thin films could be candidates for developing novel optical materials and for advanced ceramics processing. (C) 2003 Elsevier Science B.V. All rights reserved.

Students' conceptions of sport and sport education

This article explores a class of Grade 5 (age 9 and 10) children’s conceptions of sport during a season of sport education at Forest Gate Primary School. The purpose, following Kirk and Kinchin (this issue), is to examine the extent to which the potential transfer of learning between school and sport as a community of practice may be possible through sport education in school physical education. With reference to student interviews and drawings we report and discuss children’s conceptions of sport, their experiences of sport outside of the school, and their emerging conceptions of sport education in light of these prior understanding and experiences. We conclude that there was an evident level of compatibility between students’ experiences of sport education and their conceptions of sport more broadly.

Listening to young people's voices: Youth sports leaders' advice on facilitating participation in sport

This article reports on a study that accepts the proposal that we listento the voices of young people in relation to sport and physical recreation.The study sought the advice of young sports leaders on what can be done to facilitate young people’s involvement in sport. The study used group interviews (Nominal Group Technique) with over 600 14–18-year-olds toelicit responses to a single question, ‘What can be done to help young people participate in sport?’ This article focuses on young people’s views on issues to do with climate and conditions. We argue that, while their advice offers support for some current initiatives in youth sport, it also provides new insights and challenges and suggests a reordering of existing priorities for youth sport and leisure provision.

Robust multivariable control of complex biological processes

This paper addresses advanced control of a biological nutrient removal (BNR) activated sludge process. Based on a previously validated distributed parameter model of the BNR activated sludge process, we present robust multivariable controller designs for the process, involving loop shaping of plant model, robust stability and performance analyses. Results from three design case studies showed that a multivariable controller with stability margins of 0.163, 0.492 and 1.062 measured by the normalised coprime factor, multiplicative and additive uncertainties respectively give the best results for meeting performance robustness specifications. The controller robustly stabilises effluent nutrients in the presence of uncertainties with the behaviour of phosphorus accumulating organisms as well as to effectively attenuate major disturbances introduced as step changes. This study also shows that, performance of the multivariable robust controller is superior to multi-loops SISO PI controllers for regulating the BNR activated sludge process in terms of robust stability and performance and controlling the process using inlet feed flowrate is infeasible. (C) 2003 Elsevier Ltd. All rights reserved.