伊乐藻对Cu Cd污染底泥修复的应用研究

在自然条件下,采用人工模拟水缸培养方法,研究了湖泊底泥不同Cu、Cd处理对沉水植物伊乐藻生长、叶绿素含量以及Cu、Cd吸收和积累的影响。结果表明,较低浓度Cu刺激伊乐藻的生长(生物量、叶绿素),高浓度抑制伊乐藻的生长;随着Cd处理浓度的增加,伊乐藻的生物量、叶绿素含量均一直降低,在底泥Cd含量为168.69mg·kg-1DW(含背景值)时,植株出现死亡。随着Cu处理浓度的增加,伊乐藻体内的Cu含量一直增加,在底泥Cu含量为414mg·kg-1DW(含背景值)时,根部、叶部的富集系数均达到最大(0.21和0

淡水水体沉积物磷的环境生态效应研究进展及建议

对淡水水体沉积物磷的环境生态效应的国内外研究热点和领域进行了综述、评价;提出了尽快开展真正内源磷——地质成因磷自然释放的水环境生态效应研究,特别是天然条件下(如人为干扰少的源头河流),富磷河流水体主要初级生产者——藻类生态响应研究的建议。

On the transition from finite-volume negatively buoyant releases to continuous fountains

An experimental investigation to identify the source conditions that distinguish finite-volume negatively buoyant fluid projectile behaviour from fountain behaviour in quiescent environments of uniform density is described. Finite-volume releases are governed by their source Froude number Fr D and the aspect ratio L/D of the release, where L denotes the length of the column of fluid dispensed vertically from the nozzle of diameter D. We establish the influence of L/D on the peak rise heights of a release formed by dispensing saline solution into fresh water for 0

中山市淡水浮游动物区系调查

2005年6～7月和12月对中山市主要淡水水体的浮游动物区系进行了调查。结果表明,中山市主要淡水水体浮游动物由38目92科129属317种组成。区系特点以原生动物最丰富,有30目82科102属263种,占浮游动物物种总数的83%;其次为轮虫,有4目4科19属37种组成,占12%;枝角类和桡足类物种数最少。各样点浮游动物种类在11～168种之间,种类最少的出现在洪奇沥,最多的出现在逍遥谷。研究结果表明,中山市淡水浮游动物资源比较丰富。各区系浮游动物的分布与水体的营养状态密切相关,污染严重的水体,种类数较少,

双链RNA病毒诱导的牙鲆胚胎细胞差减cDNA文库的构建

以紫外线灭活的dsRNA病毒草鱼出血病病毒(GCHV)诱导和模拟诱导的牙鲆胚胎细胞为材料,利用抑制性差减杂交(SSH)技术,成功构建了双链RNA病毒诱导的牙鲆胚胎细胞(FEC)差减cDNA文库。以管家基因αtub lin作为差减指标,经检测,该文库差减效率达210倍,表明经病毒诱导后某些差异表达基因也得到了相应倍数的富集。将获得的cDNA片段连接到pGEM T载体,PCR检测显示差减片段在250bp~2 000bp之间。该差减cDNA文库的构建为从分子水平研究牙鲆培养细胞对dsRNA病毒的免疫反应、以及进

蓖齿眼子菜对栅藻和微囊藻的他感作用及其参数

主要报道篦齿眼子菜 (俗称红线草 )的种植水抽滤液对栅藻、微囊藻生长的他感作用试验。应用修正的逻辑斯谛 (Logistic)方程和Lotka Volterra种群竞争模型来计算篦齿眼子菜对藻类的他感作用参数。纯培养试验结果表明 :种植水抽滤液对栅藻生物量和生长率都有一定的促进作用。当浓度大于等于 5 0 %时 ,对栅藻生长的影响则是有抑制效应 ,他感作用效应与种植水的浓度没有明显的相关性 ,他感作用参数平均为 - 0 0 2 6。所有浓度设对照。微囊藻的生长都有明显的抑制作用 ,他感作用参数平均为 - 0

鳝池的建造和处理技术

根据作者多年的研究 ,提出了鳝池建造的五个基本要素 ,并从面积大小、池形、水口、鱼巢、食台和泥层等方面总结了黄鳝有土养殖池、无土养殖池和混合型养殖池的不同要求 ,还从脱碱、清池和水草投放等三方面概括了鳝池的处理技术。

Theoretical and experimental analysis of pneumatic balloon microactuators

This paper presents a theoretical and experimental analysis of a biologically inspired balloon-type pneumatic microactuator. The operation principle of pneumatic balloon actuators (PBA's) is based on an asymmetric deflection of two PDMS layers with different thicknesses or different Young's moduli that are bonded together. A new analytical 2D model that describes the complex behavior of these actuators is presented and validated using both 3D FEM models and measurements. The actuators have dimensions ranging from 11 mm × 2 mm × 0.24 mm to 4 mm × 1 mm × 0.12 mm. Their fabrication is based on micromolding of PDMS, and can therefore easily be fabricated in high throughput. Measurements showed that the analytical model provides a qualitative description of the actuator behavior, and showed that the larger actuators are capable of delivering a 7 mm stroke at a supply pressure of 70 kPa and a force of max 22 mN at a supply pressure of 105 kPa. © 2011 Elsevier B.V. All rights reserved.

The modes of a tethered, spherical balloon

Observations of a tethered meteorological balloon show that a strong vibration coupling exists between axial forcing of the tether and ovalling deformations of the balloon. Such coupling may lead to system instabilities and fatigue failure in a tethered-balloon system. This is particularly relevant in the case of a balloon launched from a moving vessel, as is proposed as part of the SPICE geoengineering project. This paper investigates the vibration characteristics of a tethered, spherical balloon using a simple analytical model: a tensioned, spherical membrane attached to a spring. The analytical solution for the natural frequencies and modeshapes of this system is compared to transfer functions obtained by laser vibrometry. These results are then used to determine the most suitable method of modelling the dynamic response of a tethered balloon.

大珠母贝精子介导外源基因转移研究

将大珠母贝(PinctadamaximaJameson)精子与“全鱼”GH基因重组体pCAgcGH和pCAgcGHc的线性DNA混合,温育30min,经6次、27、10kV脉冲电处理后,与卵子受精,得到若干贝苗。从贝苗中提取DNA,经PCR扩增和Southernblot分子杂交表明,部分受体带有外源基因,当与精子温育的外源基因浓度分别为2μg/mL,6μg/mL及18μg/mL时,相应贝苗携带外源基因比率分别为56%,20%和50%。即在此范围内,基因转移的阳性率与外源基因的浓度呈正相关。

Detailed design of242mAm breeding in pressurized water reactors

There is growing interest in the use of 242mAm as a nuclear fuel. Because of its very high thermal fission cross section and its large number of neutrons released per fission, it can be used for various unique applications, such as space propulsion, medical applications, and compact energy sources. Since the thermal absorption cross section of 242mAm is very high, the best way to obtain 242mAm is by the capture of fast or epithermal neutrons in 241Am. However, fast spectrum reactors are not readily available. In this paper, we explore the possibility of producing 242mAm in existing pressurized water reactors (PWRs) with minimal interference in reactor performance. As suggested in previous studies on the subject, the 242mAm breeding targets are shielded with strong thermal absorbers in order to suppress the thermal neutron flux that causes 242mAm destruction. Since 242mAm enrichment within the Am target mainly depends on the neutron energy distribution, which in turn depends on the Am target thickness and on the neutron filter cutoff energy (thermal absorber type), this unique Am target design was developed. In our study, Cd, Sm, and Gd were considered as thermal neutron filters, as suggested by Cesana et al. The most favorable results were obtained by irradiating Am targets covered either with Gd or Cd. In these cases, up to 8.65% enrichment of 242mAm is obtained after 4.5 yr (three successive PWR fuel cycles) of irradiation. It was also found that significant quantities [up to 1.3 kg/GW (electric)-yr] of 242mAm can be obtained in PWR reactors without notable interference with reactor performance. However, in order to maintain the original fuel cycle length, the enrichment of the driver (UO2) fuel must be increased by ∼1%, raised from the conventional 4.5 to 5.5%, depending on the thermal neutron filter used. The most important reactivity feedback coefficients for fuel assemblies containing the 242mAm breeding targets were evaluated and found to be close to those of a standard PWR. Another product of neutron capture in the 241Am reaction is 238Pu. It was found that in a typical 1000 MW (electric) PWR core with one-third of the fuel assemblies containing 241Am targets, up to 15.1 kg of 238Pu enriched to 80% can be produced per year.

武汉东湖水生植被的恢复试验研究

本文报道了在武汉东湖所作的水生植被恢复的研究结果．分别在东湖水果湖、汤林湖和后湖等三个湖建立水生植被恢复示范区．挺水植物莲Nelumbonucifera和芦苇Phragmitescommumis、浮叶植物菱Trapasp．和r－选择型的沉水植物苦草Vallisneriasp．、聚草Myriophyllumspicatum、菹草Potamogetoncrispus和大茨藻Najasmarina等在三个植被复示范区均可以恢复．而黄丝草Potamogetonmaackianus、伊乐藻Elodeacanaden