Multivariate relationships between groundwater chemistry and toxicity in an urban aquifer

Multivariate statistical methods were used to investigate file Causes of toxicity and controls on groundwater chemistry from 274 boreholes in an Urban area (London) of the United Kingdom. The groundwater was alkaline to neutral, and chemistry was dominated by calcium, sodium, and Sulfate. Contaminants included fuels, solvents, and organic compounds derived from landfill material. The presence of organic material in the aquifer caused decreases in dissolved oxygen, sulfate and nitrate concentrations. and increases in ferrous iron and ammoniacal nitrogen concentrations. Pearson correlations between toxicity results and the concentration of individual analytes indicated that concentrations of ammoinacal nitrogen, dissolved oxygen, ferrous iron, and hydrocarbons were important where present. However, principal component and regression analysis suggested no significant correlation between toxicity and chemistry over the whole area. Multidimensional Scaling was used to investigate differences in sites caused by historical use, landfill gas status, or position within the sample area. Significant differences were observed between sites with different historical land use and those with different gas status. Examination of the principal component matrix revealed that these differences are related to changes in the importance of reduced chemical species.

Phylogenetic relationships of the Fox (Forkhead) gene family in the Bilateria

The Forkhead or Fox gene family encodes putative transcription factors. There are at least four Fox genes in yeast, 16 in Drosophila melanogaster (Dm) and 42 in humans. Recently, vertebrate Fox genes have been classified into 17 groups named FoxA to FoxQ [Genes Dev. 14 (2000) 142]. Here, we extend this analysis to invertebrates, using available sequences from D. melanogaster, Anopheles gambiae (Ag), Caenorhabditis elegans (Ce), the sea squirt Ciona intestinalis (Ci) and amphioxus Branchiostoma floridae (Bf), from which we also cloned several Fox genes. Phylogenetic analyses lend support to the previous overall subclassification of vertebrate genes, but suggest that four subclasses (FoxJ, L, N and Q) could be further subdivided to reflect their relationships to invertebrate genes. We were unable to identify orthologs of Fox subclasses E, H, I, J, M and Q1 in D. melanogaster, A. gambiae or C. elegans, suggesting either considerable loss in ecdysozoans or the evolution of these subclasses in the deuterostome lineage. Our analyses suggest that the common ancestor of protostomes and deuterostomes had a minimum complement of 14 Fox genes. (C) 2003 Elsevier B.V. All rights reserved.

Correlation-type structure activity relationships for the kinetics of gas-phase RO2 self-reactions and reaction with HO2

Structure activity relationships (SARs) are presented for the gas-phase reactions of RO2 with HO2, and the self- and cross-reactions of RO2. For RO2+HO2 the SAR is based upon a correlation between the logarithm of the measured rate coefficient and a calculated ionisation potential for the molecule R-CH=CH2, R being the same group in both the radical and molecular analogue. The correlation observed is strong and only for one RO2 species does the measured rate coefficient deviate by more than a factor of two from the linear least-squares regression line. For the self- and cross-reactions of RO2 radicals, the SAR is based upon a correlation between the logarithm of the measured rate coefficient and the calculated electrostatic potential (ESP) at the equivalent carbon atom in the RH molecule to which oxygen is attached in RO2, again R being the same group in the molecule and the radical. For cases where R is a simple alkyl-group, a strong linear correlation observed. For RO2 radicals which contain lone pair-bearing substituents and for which the calculated ESP<-0.05 self-reaction rate coefficients appear to be insensitive to the value of the ESP. For RO2 of this type with ESP>-0.05 a linear relationship between log k and the ESP is again observed. Using the relationships, 84 out of the 85 rate coefficients used to develop the SARs are predicted to within a factor of three of their measured values. A relationship is also presented that allows the prediction of the Arrhenius parameters for the self-reactions of simple alkyl RO2 radicals. On the basis of the correlations, predictions of room-temperature rate coefficients are made for a number of atmospherically important peroxyl-peroxyl radical reactions. (C) 2003 Elsevier Ltd. All rights reserved.

Synthesis of heterosulfamates. Search for structure-taste relationships

Thirty one new sodium heterosulfamates, RNHSO3Na, where the R portion contains mainly thiazole, benzothiazole, thiadiazole and pyridine ring structures, have been synthesized and their taste portfolios have been assessed. A database of 132 heterosulfamates ( both open-chain and cyclic) has been formed by combining these new compounds with an existing set of 101 heterosulfamates which were previously synthesized and for which taste data are available. Simple descriptors have been obtained using (i) measurements with Corey-Pauling-Koltun (CPK) space- filling models giving x, y and z dimensions and a volume VCPK, (ii) calculated first order molecular connectivities ((1)chi(v)) and (iii) the calculated Spartan program parameters to obtain HOMO, LUMO energies, the solvation energy E-solv and V-SPART AN. The techniques of linear (LDA) and quadratic (QDA) discriminant analysis and Tree analysis have then been employed to develop structure-taste relationships (SARs) that classify the sweet (S) and non-sweet (N) compounds into separate categories. In the LDA analysis 70% of the compounds were correctly classified ( this compares with 65% when the smaller data set of 101 compounds was used) and in the QDA analysis 68% were correctly classified ( compared to 80% previously). TheTree analysis correctly classified 81% ( compared to 86% previously). An alternative Tree analysis derived using the Cerius2 program and a set of physicochemical descriptors correctly classified only 54% of the compounds.

Age relationships beteen low level rock platforms and the high coastal slopes in Jersey and the surrounding area.

Recent research along the coastal cliffs and embayments of Jersey has revealed new aspects of the geomorphology of the rocky shore platform and its relationship with the steep slopes that link it to the island plateau above. Specifically, a rockhead platform meets a 10-30 m high, near vertical cliff at approximately 8-10 m above Jersey Datum (J.D.= ±0 m Ordnance Datum; likewise Guernsey Datum: G.D.), slopes down-towards mid-tide levels becoming ever more deeply dissected. Generalised contours of this platform show it to be distinct from a lower tidal rockhead platform which is comparatively smooth over large areas as it undergoes continuing contemporary abrasion. This lower platform is generally separated from the higher one by low cliffs, less than a metre high at mid-tidal levels, but two to three metres at the base of the backing cliffs. Both of these platforms are shown to antedate the Last Cold Stage (Devensian) head at a number of localities and this relationship is taken to represent the general situation, not only in Jersey, but throughout the other Channel Islands and adjacent coasts of Armorica. Whether either, or both, of these two platforms are older than Marine Oxygen Isotope Substage (MOIS) 5e (Ipswichian) as well is not known. However the considerable age of the numerous and wide intertidal shore platforms of the Channel Islands and adjacent coasts of Amorica makes a greater age quite possible.

Relationships between gluten rheological properties and hearth loaf characteristics

The rheological properties of fresh gluten in small amplitude oscillation in shear (SAOS) and creep recovery after short application of stress was related to the hearth breadbaking performance of wheat flours using the multivariate statistics partial least squares (PLS) regression. The picture was completed by dough mixing and extensional properties, flour protein size distribution determined by SE-HPLC, and high molecular weight glutenin subunit (HMW-GS) composition. The sample set comprised 20 wheat cultivars grown at two different levels of nitrogen fertilizer in one location. Flours yielding stiffer and more elastic glutens, with higher elastic and viscous moduli (G' and G") and lower tan 8 values in SAOS, gave doughs that were better able to retain their shape during proving and baking, resulting in breads of high form ratios. Creep recovery measurements after short application of stress showed that glutens from flours of good breadmaking quality had high relative elastic recovery. The nitrogen fertilizer level affected the protein size distribution by an increase in monomeric proteins (gliadins), which gave glutens of higher tan delta and flatter bread loaves (lower form ratio).

The physics of baking: rheological and polymer molecular structure-function relationships in breadmaking

Molecular size and structure of the gluten polymers that make up the major structural components of wheat are related to their rheological properties via modem polymer rheology concepts. Interactions between polymer chain entanglements and branching are seen to be the key mechanisms determining the rheology of HMW polymers. Recent work confirms the observation that dynamic shear plateau modulus is essentially independent of variations in MW amongst wheat varieties of varying baking performance and is not related to variations in baking performance, and that it is not the size of the soluble glutenin polymers, but the structural and rheological properties of the insoluble polymer fraction that are mainly responsible for variations in baking performance. The rheological properties of gas cell walls in bread doughs are considered to be important in relation to their stability and gas retention during proof and baking, in particular their extensional strain hardening properties. Large deformation rheological properties of gas cell walls were measured using biaxial extension for a number of doughs of varying breadmaking quality at constant strain rate and elevated temperatures in the range 25-60 degrees C. Strain hardening and failure strain of cell walls were both seen to decrease with temperature, with cell walls in good breadmaking doughs remaining stable and retaining their strain hardening properties to higher temperatures (60 degrees C), whilst the cell walls of poor breadmaking doughs became unstable at lower temperatures (45-50 degrees C) and had lower strain hardening. Strain hardening measured at 50 degrees C gave good correlations with baking volume, with the best correlations achieved between those rheological measurements and baking tests which used similar mixing conditions. As predicted by the Considere failure criterion, a strain hardening value of I defines a region below which gas cell walls become unstable, and discriminates well between the baking quality of a range of commercial flour blends of varying quality. This indicates that the stability of gas cell walls during baking is strongly related to their strain hardening properties, and that extensional rheological measurements can be used as predictors of baking quality. (C) 2004 Elsevier B.V. All rights reserved.

The physics of baking: rheological and polymer molecular structure-function relationships in breadmaking

Molecular size and structure of the gluten polymers that make up the major structural components of wheat are related to their rheological properties via modern polymer rheology concepts. Interactions between polymer chain entanglements and branching are seen to be the key mechanisms determining the rheology of HMW polymers. Recent work confirms the observation that dynamic shear plateau modulus is essentially independent of variations in MW amongst wheat varieties of varying baking performance and is not related to variations in baking performance, and that it is not the size of the soluble glutenin polymers, but the structural and rheological properties of the insoluble polymer fraction that are mainly responsible for variations in baking performance. The rheological properties of gas cell walls in bread doughs are considered to be important in relation to their stability and gas retention during proof and baking, in particular their extensional strain hardening properties. Large deformation rheological properties of gas cell walls were measured using biaxial extension for a number of doughs of varying breadmaking quality at constant strain rate and elevated temperatures in the range 25oC to 60oC. Strain hardening and failure strain of cell walls were both seen to decrease with temperature, with cell walls in good breadmaking doughs remaining stable and retaining their strain hardening properties to higher temperatures (60oC), whilst the cell walls of poor breadmaking doughs became unstable at lower temperatures (45oC to 50oC) and had lower strain hardening. Strain hardening measured at 50oC gave good correlations with baking volume, with the best correlations achieved between those rheological measurements and baking tests which used similar mixing conditions. As predicted by the Considere failure criterion, a strain hardening value of 1 defines a region below which gas cell walls become unstable, and discriminates well between the baking quality of a range of commercial flour blends of varying quality. This indicates that the stability of gas cell walls during baking is strongly related to their strain hardening properties, and that extensional rheological measurements can be used as predictors of baking quality.

Structure oil-absorption relationships during deep-fat frying

Analysis of the oil-absorption process in deep-fat fried potato cylinders (frying temperatures of 155degreesC, 170degreesC, and 185degreesC) allowed to distinguish 3 oil fractions: structural oil (absorbed during frying), penetrated surface oil (suctioned during cooling), and surface oil. Results showed that a small amount of oil penetrates during frying because most of the oil was picked up at the end of the process, suggesting that oil uptake and water removal are not synchronous phenomena. After cooling, oil was located either on the surface of the chip or suctioned into the porous crust microstructure, with an inverse relationship between them for increasing frying times.

Recalled relationships with parents and perceptions of professional support in mothers of infants treated for cleft lip

This study examined whether individual differences in perception of the quality of professional support available at a time of stress may be associated with security of attachment. We developed a new measure of parents' perceptions of emotional and practical support provided by a wide range of professionals involved in the treatment of infants with cleft lip. it showed good internal reliability and stability over 4 months. Mothers of 102 infants with cleft lip, with or without cleft palate, completed the measure at 2 and 6 months, together with the Parental Bonding Instrument and the General Health Questionnaire. Mean scores reflecting how much they could trust or talk frankly, or share their worst fears, with professionals, and the extent to which they saw them as a source of useful information or practical help, were lower among mothers with recollections of low maternal care in childhood, or high control. This was the case at 2 and 6 months, and there were some indications of an increasing contribution of low maternal care from 2 to 6 months. The associations were not explained by current depression. Further research is needed to clarify the role of attachment processes in parents' responses to serious medical conditions in their children, and into the implications for the way professionals in paediatric services provide support.

An empirical study of process-related attributes in segmented software cost-estimation relationships

Parametric software effort estimation models consisting on a single mathematical relationship suffer from poor adjustment and predictive characteristics in cases in which the historical database considered contains data coming from projects of a heterogeneous nature. The segmentation of the input domain according to clusters obtained from the database of historical projects serves as a tool for more realistic models that use several local estimation relationships. Nonetheless, it may be hypothesized that using clustering algorithms without previous consideration of the influence of well-known project attributes misses the opportunity to obtain more realistic segments. In this paper, we describe the results of an empirical study using the ISBSG-8 database and the EM clustering algorithm that studies the influence of the consideration of two process-related attributes as drivers of the clustering process: the use of engineering methodologies and the use of CASE tools. The results provide evidence that such consideration conditions significantly the final model obtained, even though the resulting predictive quality is of a similar magnitude.