Shell-fish industries,

Mode of access: Internet.

A manual of medical jurisprudence /

Includes bibliographical references and index.

Report

Mode of access: Internet.

Method Validation for Bacterial and Viral Analysis of Geoducks

Thesis (Master's)--University of Washington, 2016-06

Galvanic corrosion of magnesium alloy AZ91D in contact with an aluminium alloy, steel and zinc

An investigation was carried out into the galvanic corrosion of magnesium alloy AZ91D in contact with zinc, aluminium alloy A380 and 4150 steel. Specially designed test panels were used to measure galvanic currents under salt spray conditions. It was found that the distributions of the galvanic current densities on AZ91D and on the cathodes were different. An insulating spacer between the AZ91D anode and the cathodes could not eliminate galvanic corrosion. Steel was the worst cathode and aluminium the least aggressive to AZ91D. Corrosion products from the anode and cathodes appeared to be able to affect the galvanic corrosion process through an alkalisation, passivation, poisoning effect or shortcut effect. (C) 2003 Elsevier Ltd. All rights reserved.

Eutectic nucleation in Al-Si alloys

In addition to a change in silicon morphology, modification of aluminium-silicon alloys with strontium or sodium increases the size of the eutectic grains. To determine the mechanism responsible, eutectic solidification in commercial purity and ultra-high purity aluminium-si I icon alloys, with and without strontium additions, was examined by a quenching technique. In the commercial unmodified alloy, nucleation was prolific while in the high-purity unmodified alloy few eutectic grains nucleated. The addition of strontium to the commercial alloy reduced the number of eutectic grains that nucleated. Addition of strontium to the high-purity alloy did not significantly alter nucleation. It is concluded that commercial purity alloys contain a large number of potent nuclei that are susceptible to poisoning by impurity modification. The flake-to-fibre transition that occurs with impurity modification is shown to be independent of any change in eutectic nucleation mode and frequency. (C) 2004 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Eutectic grains in unmodified and strontium-modified hypoeutectic aluminum-silicon alloys

Additions of strontium to hypoeutectic aluminum-silicon alloys modify the morphology of the eutectic silicon phase from a coarse platelike structure to a fine fibrous structure. Thermal analysis, interrupted solidification, and microstructural examination of sand castings in this work revealed that, in addition to a change in silicon morphology, modification with strontium also causes an increase in the size of eutectic grains. The eutectic grain size increases because fewer grains nucleate, possibly due to poisoning of the phosphorus-based nucleants, that are active in the unmodified alloy. A simple growth model is developed to estimate the interface velocity during solidification of a eutectic grain. The model confirms, independent of microstructural observations, that the addition of 100 ppm strontium increases the eutectic grain size by at least an order of magnitude compared with the equivalent unmodified alloy. The model predicts that the growth velocity varies significantly during eutectic growth. At low strontium levels, these variations may be sufficient to cause transitions between flake and fibrous silicon morphologies depending on the casting conditions. The model can be used to rationally interpret the eutectic grain structure and silicon morphology of fully solidified aluminum-silicon castings and, when coupled with reliable thermal data, can be used to estimate the eutectic grain size.

The late effects of poliomyelitis in Queensland

This paper reports an investigation of new health problems reported by Queensland residents with a prior history of poliomyelitis. 126 people with a past history of paralytic poliomyelitis were recruited from the waiting list for the trial Post Polio Clinic at Queen Elizabeth II Hospital, Brisbane. A self-administered postal questionnaire was used to examine a number of variables including acute poliomyelitis histories; presence, duration and severity of new symptoms consistent with the late effects of poliomyelitis; changes in functional status between the maximal recovery period and the time of the survey and the impact of post-polio symptoms on lifestyle and employment. The most frequent new symptoms reported were muscle weakness (87 per cent), unusual tiredness (79 per cent), joint pain (79 per cent), muscle pain (61 per cent) and muscle cramps (71 per cent). Subjects reported an increased reliance on assistive devices and a decreased level of independence with activities of daily living, particularly with mobility-related tasks. Eight three per cent of subjects had made lifestyle changes as a result of post-polio symptoms and 67 per cent of those subjects in the workforce reported making changes to their employment, such as reduced hours of work. (author abstract)