Demodicose bovina no estado da Paraíba

Cases of bovine demodicosis caused by Demodex bovis were reported in a Sindhi herd from December 1989 to January 1992. Both localized and generalized forms were diagnosed. This is the first report of the generalized form in Brazil. In the first two years, demodicosis was diagnosed only in cattle < 2 years old, whereas animals of all ages were positive in the last two years. Prevalence varied from 20.4% (11/54) to 53.1% (26/49) and 13.2% (12/91) to 14.8% (9/61) for cattle < 2 years old and > 2 years old, respectively. Clinical signs varied from a few small nodules to a thickened skin with soft large nodules in the localized and generalized forms, respectively. Main microscopic features of the nodules in the generalized form consisted of acanthosis with hyperqueratosis, chronic sebaceous adenitis, subcutaneous muscular necrosis, focal cellular degeneration of the epidermis basal layer and presence of large number of mites inside the lumen of dilated hair follicles. In addition, a chronic perifoliculitis was observed, characterized by lymphoplasmocytic infiltrate which also contained macrophages and neutrophils. It is suggested that poor nutrition and stress due to prolonged drought probably contributed to the increase of susceptibility of the herd to mite infestation.

Cysts reabsorption in the testis of the bee wax pest Achroia grisella (Lepidoptera, Pyralidae) during spermatogenesis

The present paper reports the occurrence of testicular cysts degeneration during spermatogenesis of Achroia grisella, a Lepidoptera with dimorphic spermatogenesis, through ultrastrucutural studies. Signs of cysts degeneration can be detected in the last larval instar but it increases during pupation and early adulthood. The degeneration affects the eupyrene, as well apyrene cysts but it is not always possible to recognize which cysts are degenerating. Some morphological features of cysts degeneration resemble apoptosis.

Flow evolution of a metallic slurry during thixoextrusion of an automotive valve

The aim of this work is to characterize a metallic slurry (Al-4.5%Cu) flow during thixoforming of an automotive valve. The necessary globular structure was obtained by first inoculating the alloy with TIBAL (5%Ti, 1%B, Al - rest) at 750.0°C, and then reheating to a state between liquidus and solidus prior to thixoforming. Two metallic slurries, with a solid phase of approximately 86.1 and 78.2 percent, were used to generate different experimental flow patterns during the thixoforming process. The flow of the material into the die was observed for total, and partial displacement (2.7, 5.4, 7.5mm) of the punch. The first displacement shows formation of the valve rod. The patterns at each step of displacement of the punch were preserved by quenching in water, thus revealing the profile of the die fill and microstructural evolution. Degeneration of the globular phase was observed along the piece thixoextruded. Thixoextrusion forces versus time curves were generated for partial and full displacement of the punch. Porosity was visible along the billet prior to thixoforming. However, some areas show that the porosity gradually decreased to zero as the thixoextrusion pressure increased. Turbulent, transient and laminar flow are analyzed in this work.

Effect of mating delay in the ovary of Apis mellifera L. (Hymenoptera, Apidae) queens: Histological aspects

This paper reports the effect of mating delay on the queen Apis mellifera ovaries based on a light microscopy analysis. Soon after a queen emerges from the brood cell, oocytes start to differentiate in the ovaries, but if mating does not occur at the correct age (about 6 days after emergence) cell degeneration begins. Ovaries of 15-day-old virgin queens show extensive disorganization with cell death affecting all types of ovariole cells. Types of cell death and the possible causes are discussed.