974 resultados para joint action
Resumo:
Solder joints are often the cause of failure in electronic devices, failing due to cyclic creep induced ductile fatigue. This paper will review the modelling methods available to predict the lifetime of SnPb and SnAgCu solder joints under thermo-mechanical cycling conditions such as power cycling, accelerated thermal cycling and isothermal testing, the methods do not apply to other damage mechanisms such as vibration or drop-testing. Analytical methods such as recommended by the IPC are covered, which are simple to use but limited in capability. Finite element modelling methods are reviewed, along with the necessary constitutive laws and fatigue laws for solder, these offer the most accurate predictions at the current time. Research on state-of-the-art damage mechanics methods is also presented, although these have not undergone enough experimental validation to be recommended at present
Resumo:
The thermal stress in a Sn3.5Ag1Cu half-bump solder joint under a 3.82×108 A/m2 current stressing was analyzed using a coupled-field simulation. Substantial thermal stress accumulated around the Al-to-solder interface, especially in the Ni+(Ni,Cu)3Sn4 layer, where a maximal stress of 138 MPa was identified. The stress gradient in the Ni layer was about 1.67×1013 Pa/m, resulting in a stress migration force of 1.82×10-16 N, which is comparable to the electromigration force, 2.82×10-16 N. Dissolution of the Ni+(Ni,Cu)3Sn4 layer, void formation with cracks at the anode side, and extrusions at the cathode side were observed
Resumo:
The trend towards miniaturization of electronic products leads to the need for very small sized solder joints. Therefore, there is a higher reliability risk that too large a fraction of solder joints will transform into Intermetallic Compounds (IMCs) at the solder interface. In this paper, fracture mechanics study of the IMC layer for SnPb and Pb-free solder joints was carried out using finite element numerical computer modelling method. It is assumed that only one crack is present in the IMC layer. Linear Elastic Fracture Mechanics (LEFM) approach is used for parametric study of the Stress Intensity Factors (SIF, KI and KII), at the predefined crack in the IMC layer of solder butt joint tensile sample. Contrary to intuition, it is revealed that a thicker IMC layer in fact increases the reliability of solder joint for a cracked IMC. Value of KI and KII are found to decrease with the location of the crack further away from the solder interfaces while other parameters are constant. Solder thickness and strain rate were also found to have a significant influence on the SIF values. It has been found that soft solder matrix generates non-uniform plastic deformation across the solder-IMC interface near the crack tip that is responsible to obtain higher KI and KII.
Resumo:
Explores the issue of the share of beneficial entitlement to the family home where the legal title is jointly owned, but where there has not been an express declaration of a beneficial joint tenancy. Discusses the House of Lords judgment in Stack v Dowden which addressed this point. Explains how the judges moved the focus away from the court imposing its own sense of fairness on the parties or imputing an intention based on the circumstances to one where the concentration will be on the parties' relevant conduct. Outlines three other points of interest referred to in the judgment: (1) whether an indirect financial contribution could support a constructive trust; (2) whether proprietary estoppel and common intention constructive trusts should be assimilated; and (3) whether a mortgage liability is equivalent to a financial contribution.
Resumo:
Reviews case law illustrating the courts' approach to beneficial ownership of property purchased in joint name by means of a joint mortgage but without any declaration of beneficial interest, the resulting trust and joint beneficial interest presumptions. Contrast the approach adopted in cases where one party made no contribution to the mortgage payments with those where both parties made a contribution. Highlights the courts' treatment of the right to buy discount afforded tenant purchasers and property purchased as a commercial venture rather than a home.
Resumo:
This paper drawing from audit reports reflects upon the post-Iraq war administration the Coalition Provisional Authority (CPA). It argues that the CPA’s compliance with basic levels of decent public administration were akin to Guantanamo’s compliance with basic levels of natural justice. The audit reports demonstrate that the CPA was a chaotic administration which spent billions without proper controls or procedures and left precious Iraqi oil revenues open to fraudulent acts. The CPA failed to comply with its obligations under UN resolutions. It identifies the geopolitical/economic implications of the US government which was partly motivated by economic concerns but it was also motivated by political concerns—the imposition of US hegemony. It then turns to the broader economic imperatives of the falling rate of profit and the imposition of neoliberalism (market fundamentalism).
Resumo:
Knipholone (KP) and knipholone anthrone (KA) are natural 4-phenylanthraquinone structural analogues with established differential biological activities including in vitro antioxidant and cytotoxic properties. By using DNA damage as an experimental model, the comparative Cu(II)-dependent prooxidant action of these two compounds were studied. In the presence of Cu(II) ions, the antioxidant KA (3.1-200 [mu]M) but not KP (6-384 [mu]M) caused a concentration-dependent pBR322 plasmid DNA strand scission. The DNA damage induced by KA could be abolished by reactive oxygen species scavengers, glutathione and catalase as well as EDTA and a specific Cu(I) chelator bathocuproine disulfonic acid. In addition to Cu(II) chelating activity, KA readily reduces Cu(II) to Cu(I). Copper-dependent generation of reactive oxygen species and the subsequent macromolecular damage may be involved in the antimicrobial and cytotoxic activity of KA.
Resumo:
Epilobium parviflorum Schreb. (Onagraceae) is used for the treatment of benign prostatic hyperplasia (BPH), which is regarded as an endocrine disorder caused by age-related hormone imbalance and increased oxidative damage [1,2,3]. Epilobium can moderate the obstructive and the irritative symptoms of BPH [1] but its biological action is not entirely identified. E. parviflorum is rich in phytosterols, flavonoids (myricetin, quercetin, kaempferol and their glycosides), phenolic acids, catechins, ellagi- and gallotannins [4]. The potential biological effects of Epilobium parviflorum Schreb. have been investigated, in respect to its antioxidant, anti-inflammatory, enzyme-inhibitory and anti-androgenic effect. The whole-plant water extract showed higher antioxidant effect (IC50=1.65±0.05µg/mL) in DPPH assay than Trolox or ascorbic acid and inhibited the lipid peroxidation examined in TBA assay (IC50=2.31±0.18mg/mL). In concentrations 0.20-15.00µg/mL the extract possessed a protective effect comparable to catalase enzyme (2500 IU/mL), against oxidative damage generated on fibroblast cells. The examination of the COX-inhibitory effect showed that E. parviflorum had an anti-inflammatory effect (IC50=1.38±0.08µg/mL). Investigation of steroid receptor binding ability and the aromatase enzyme-inhibition showed negative results in the concentration range examined.
Resumo:
The presentation explores and evaluates an innovation in education and training in which two different professional trainings (nursing and social work) are integrated to produce jointly qualified specialist practitioners.
Resumo:
This chapter focuses on what the key decision makers in organizations decide after having received information on the current state of the organizational performance. Because of strong attributions to success and failure, it is impossible to predict in advance which concrete actions will occur. We can however find out what kinds of actions are decided upon by means of an organizational learning model that focuses on the hastenings and delays after performance feedback. As an illustration, the responses to performance signals by trainers and club owners in Dutch soccer clubs are analyzed.