The role of ATP7A in copper homeostasis

Menkes disease is a fatal genetic copper deficiency. The Menkes protein (ATP7A) was found to remove copper from tissues in mice that expressed the human ATP7A. Promising results were obtained with the use of a new copper complex for treatment of Menkes disease using a mouse model.

The role of copper transport proteins in the small intestines

Physiological copper homeostasis involves striking a balance between absorption and secretion. ATP7A was identified at the trans-Golgi network but relocalized to vesicles under copper exposure in the intestine. This suggests that ATP7A may be a rate limiting step in intestinal uptake of copper.

Sorption and Fractionation of Copper in soil at a sewage irrigation farm in Australia

Copper (Cu) is an important heavy metal to be considered in soil contamination, because high concentrations of copper in soil produce toxic effects and may accumulate in plant tissues. In Australia's oldest sewage irrigation farm, located in Werribee, Victoria, soil in the land filtration area is contaminated by Cu. However, Cu content in herbage tissues is in the normal range and has been trending downward since 1979. Therefore, studies on the sorption capacity and sequential extraction of Cu in soil at the Werribee Farm is of significance, not only for better understanding the mechanism of transport, chemical processes, and plant uptake of Cu, but also in providing information for the practical management of sewage farm soils. Methods of combining sorption isotherms with sequential extraction procedures were adopted, and the results showed that the soil in the land filtration area at Werribee Farm has a high sorption capacity for Cu, and distribution coefficients, K_f of Cu, were 629 L kg^-1 in surface soils (0-20 cm) and 335 L kg^-1 in subsurface soils (20-40 cm). The sequential extraction fractions demonstrate that exchangeable and carbonate fractions are very low, only comprising 3.49 to 5.49% of total copper. The other fractions are also discussed. This characteristic of Cu in soil is related to the low concentration of Cu in plant tissues.

Sub-ppt detection limits for copper ions with Gly-Gly-His modified electrodes

An electrochemical metal ion sensor has been developed with a detection limit of less than 0.2 ppt by the covalent attachment of the tripeptide Gly-Gly-His as a recognition element to a 3-mercaptopropionic acid modified gold electrode.

Characterisation of gold electrodes modified with self-assembled monolayers of l-cysteine for the adsorptive stripping analysis of copper

Electrochemical sensors for copper ions in environmental samples were prepared by modifying gold electrodes with l-cysteine by self-assembly. The adsorption of l-cysteine on gold electrodes was studied by electrochemical reductive desorption in 0.5 M KOH, and the interaction of l-cysteine with copper ions was investigated by cyclic voltammetry, chronoamperometry and X-ray photoelectron spectroscopy. At low concentrations the ratio of l-cysteine to bound Cu(II) is 2:1. At higher concentrations (0.1 M) copper reacts with adsorbed cysteine forming copper sulfide on the electrode surface. On a modified l-cysteine gold electrode, Osteryoung square wave voltammetric determination of Cu(II) with a detection limit below 5 ppb has been demonstrated.

Fast colorimetric detection of copper ions using L-Cysteine functionalized gold nanoparticles

This communication reports an efficient visual detection method of Cu²⁺ by L-cysteine functionalized gold nanoparticles in aqueous solution. Upon exposure to Cu²⁺, the gold nanoparticle solution changed from red to blue, in response to surface plasmon absorption of dispersed and aggregated nanoparticles. This colorimetric sensor allows a rapid quantitative assay of Cu²⁺ down to the concentration range of 10⁻⁵ M. Recognition of Cu²⁺ and formation of the aggregates are proposed to occur via a 2 : 1 sandwich complex between L-cysteine and Cu²⁺.

Exploring the use of the tripeptide Gly–Gly–His as a selective recognition element for the fabrication of electrochemical copper sensors

The modification of electrodes with the tripeptide Gly–Gly–His for the detection of copper in water samples is described in detail. The tripeptide modified electrode was prepared by first self-assembling 3-mercaptopropionic acid (MPA) onto the gold electrode followed by covalent attachment of the tripeptide to the self-assembled monolayer using carbodiimide coupling. The electrodes were characterized using electrochemistry, a newly developed mass-spectrometry method and quantum mechanical calculations. The mass spectrometry confirmed the modification to proceed as expected with peptide bonds formed between the carboxylic acids of the MPA and the terminal amine of the peptide. Electrochemical measurements indicated that approximately half the MPA molecules in a SAM are modified with the peptide. The peptide modified electrodes exhibited high sensitivity to copper which is attributed to the stable 4N coordinate complex the peptide formed around the metal ion to give copper the preferred tetragonal coordination. The formation of a 4 coordinate complex was predicted using quantum mechanical calculation and confirmed using mass spectrometry. The adsorption of the copper to the peptide modified electrode was consistent with a Langmuir isotherm with a binding constant of (8.1 ± 0.4) 1010 M−1 at 25 °C.

Extraction of copper(II) ions from aqueous solutions with a methimazole-based ionic liquid

The recently synthesized ionic liquid (IL) 2-butylthiolonium bis(trifluoromethanesulfonyl)amide, [mimSBu][NTf2], has been used for the extraction of copper(II) from aqueous solution. The pH of the aqueous phase decreases upon addition of [mimSBu]+, which is attributed to partial release of the hydrogen attached to the N(3) nitrogen atom of the imidazolium ring. The presence of sparingly soluble water in [mimSBu][NTf2] also is required in solvent extraction studies to promote the incorporation of Cu(II) into the [mimSBu][NTf2] ionic liquid phase. The labile copper(II) system formed by interacting with both the water and the IL cation component has been characterized by cyclic voltammetry as well as UV−vis, Raman, and 1H, 13C, and 15N NMR spectroscopies. The extraction process does not require the addition of a complexing agent or pH control of the aqueous phase. [mimSBu][NTf2] can be recovered from the labile copper−water−IL interacting system by washing with a strong acid. High selectivity of copper(II) extraction is achieved relative to that of other divalent cobalt(II), iron(II), and nickel(II) transition-metal cations. The course of microextraction of Cu2+ from aqueous media into the [mimSBu][NTf2] IL phase was monitored in situ by cyclic voltammetry using a well-defined process in which specific interaction with copper is believed to switch from the ionic liquid cation component, [mimSBu], to the [NTf2] anion during the course of electrochemical reduction from Cu(II) to Cu(I). The microextraction−voltammetry technique provides a fast and convenient method to determine whether an IL is able to extract electroactive metal ions from an aqueous solution.