X-Ray studies of the physics of matter around super-massive black-holes in nearby Seyfert galaxies

Seyfert galaxies are the closest active galactic nuclei. As such, we can use them to test the physical properties of the entire class of objects. To investigate their general properties, I took advantage of different methods of data analysis. In particular I used three different samples of objects, that, despite frequent overlaps, have been chosen to best tackle different topics: the heterogeneous BeppoS AX sample was thought to be optimized to test the average hard X-ray (E above 10 keV) properties of nearby Seyfert galaxies; the X-CfA was thought the be optimized to compare the properties of low-luminosity sources to the ones of higher luminosity and, thus, it was also used to test the emission mechanism models; finally, the XMM–Newton sample was extracted from the X-CfA sample so as to ensure a truly unbiased and well defined sample of objects to define the average properties of Seyfert galaxies. Taking advantage of the broad-band coverage of the BeppoS AX MECS and PDS instruments (between ~2-100 keV), I infer the average X-ray spectral propertiesof nearby Seyfert galaxies and in particular the photon index (~1.8), the high-energy cut-off (~290 keV), and the relative amount of cold reflection (~1.0). Moreover the unified scheme for active galactic nuclei was positively tested. The distribution of isotropic indicators used here (photon index, relative amount of reflection, high-energy cut-off and narrow FeK energy centroid) are similar in type I and type II objects while the absorbing column and the iron line equivalent width significantly differ between the two classes of sources with type II objects displaying larger absorbing columns. Taking advantage of the XMM–Newton and X–CfA samples I also deduced from measurements that 30 to 50% of type II Seyfert galaxies are Compton thick. Confirming previous results, the narrow FeK line is consistent, in Seyfert 2 galaxies, with being produced in the same matter responsible for the observed obscuration. These results support the basic picture of the unified model. Moreover, the presence of a X-ray Baldwin effect in type I sources has been measured using for the first time the 20-100 keV luminosity (EW proportional to L(20-100)^(−0.22±0.05)). This finding suggests that the torus covering factor may be a function of source luminosity, thereby suggesting a refinement of the baseline version of the unifed model itself. Using the BeppoSAX sample, it has been also recorded a possible correlation between the photon index and the amount of cold reflection in both type I and II sources. At a first glance this confirms the thermal Comptonization as the most likely origin of the high energy emission for the active galactic nuclei. This relation, in fact, naturally emerges supposing that the accretion disk penetrates, depending to the accretion rate, the central corona at different depths (Merloni et al. 2006): the higher accreting systems hosting disks down to the last stable orbit while the lower accreting systems hosting truncated disks. On the contrary, the study of the well defined X–C f A sample of Seyfert galaxies has proved that the intrinsic X-ray luminosity of nearby Seyfert galaxies can span values between 10^(38−43) erg s^−1, i.e. covering a huge range of accretion rates. The less efficient systems have been supposed to host ADAF systems without accretion disk. However, the study of the X–CfA sample has also proved the existence of correlations between optical emission lines and X-ray luminosity in the entire range of L_(X) covered by the sample. These relations are similar to the ones obtained if high-L objects are considered. Thus the emission mechanism must be similar in luminous and weak systems. A possible scenario to reconcile these somehow opposite indications is assuming that the ADAF and the two phase mechanism co-exist with different relative importance moving from low-to-high accretion systems (as suggested by the Gamma vs. R relation). The present data require that no abrupt transition between the two regimes is present. As mentioned above, the possible presence of an accretion disk has been tested using samples of nearby Seyfert galaxies. Here, to deeply investigate the flow patterns close to super-massive black-holes, three case study objects for which enough counts statistics is available have been analysed using deep X-ray observations taken with XMM–Newton. The obtained results have shown that the accretion flow can significantly differ between the objects when it is analyzed with the appropriate detail. For instance the accretion disk is well established down to the last stable orbit in a Kerr system for IRAS 13197-1627 where strong light bending effect have been measured. The accretion disk seems to be formed spiraling in the inner ~10-30 gravitational radii in NGC 3783 where time dependent and recursive modulation have been measured both in the continuum emission and in the broad emission line component. Finally, the accretion disk seems to be only weakly detectable in rk 509, with its weak broad emission line component. Finally, blueshifted resonant absorption lines have been detected in all three objects. This seems to demonstrate that, around super-massive black-holes, there is matter which is not confined in the accretion disk and moves along the line of sight with velocities as large as v~0.01-0.4c (whre c is the speed of light). Wether this matter forms winds or blobs is still matter of debate together with the assessment of the real statistical significance of the measured absorption lines. Nonetheless, if confirmed, these phenomena are of outstanding interest because they offer new potential probes for the dynamics of the innermost regions of accretion flows, to tackle the formation of ejecta/jets and to place constraints on the rate of kinetic energy injected by AGNs into the ISM and IGM. Future high energy missions (such as the planned Simbol-X and IXO) will likely allow an exciting step forward in our understanding of the flow dynamics around black holes and the formation of the highest velocity outflows.

Accretion disk winds in active galactic nuclei: an X-ray view

This Thesis focuses on the X-ray study of the inner regions of Active Galactic Nuclei, in particular on the formation of high velocity winds by the accretion disk itself. Constraining AGN winds physical parameters is of paramount importance both for understanding the physics of the accretion/ejection flow onto supermassive black holes, and for quantifying the amount of feedback between the SMBH and its environment across the cosmic time. The sources selected for the present study are BAL, mini-BAL, and NAL QSOs, known to host high-velocity winds associated to the AGN nuclear regions. Observationally, a three-fold strategy has been adopted: - substantial samples of distant sources have been analyzed through spectral, photometric, and statistical techniques, to gain insights into their mean properties as a population; - a moderately sized sample of bright sources has been studied through detailed X-ray spectral analysis, to give a first flavor of the general spectral properties of these sources, also from a temporally resolved point of view; - the best nearby candidate has been thoroughly studied using the most sophisticated spectral analysis techniques applied to a large dataset with a high S/N ratio, to understand the details of the physics of its accretion/ejection flow. There are three main channels through which this Thesis has been developed: - [Archival Studies]: the XMM-Newton public archival data has been extensively used to analyze both a large sample of distant BAL QSOs, and several individual bright sources, either BAL, mini-BAL, or NAL QSOs. - [New Observational Campaign]: I proposed and was awarded with new X-ray pointings of the mini-BAL QSOs PG 1126-041 and PG 1351+640 during the XMM-Newton AO-7 and AO-8. These produced the biggest X-ray observational campaign ever made on a mini-BAL QSO (PG 1126-041), including the longest exposure so far. Thanks to the exceptional dataset, a whealth of informations have been obtained on both the intrinsic continuum and on the complex reprocessing media that happen to be in the inner regions of this AGN. Furthermore, the temporally resolved X-ray spectral analysis field has been finally opened for mini-BAL QSOs. - [Theoretical Studies]: some issues about the connection between theories and observations of AGN accretion disk winds have been investigated, through theoretical arguments and synthetic absorption line profiles studies.

Study of the X(3872) state with the CMS experiment at LHC

The surprising discovery of the X(3872) resonance by the Belle experiment in 2003, and subsequent confirmation by BaBar, CDF and D0, opened up a new chapter of QCD studies and puzzles. Since then, detailed experimental and theoretical studies have been performed in attempt to determine and explain the proprieties of this state. Since the end of 2009 the world’s largest and highest-energy particle accelerator, the Large Hadron Collider (LHC), started its operations at the CERN laboratories in Geneva. One of the main experiments at LHC is CMS (Compact Muon Solenoid), a general purpose detector projected to address a wide range of physical phenomena, in particular the search of the Higgs boson, the only still unconfirmed element of the Standard Model (SM) of particle interactions and, new physics beyond the SM itself. Even if CMS has been designed to study high energy events, it’s high resolution central tracker and superior muon spectrometer made it an optimal tool to study the X(3872) state. In this thesis are presented the results of a series of study on the X(3872) state performed with the CMS experiment. Already with the first year worth of data, a clear peak for the X(3872) has been identified, and the measurement of the cross section ratio with respect to the Psi(2S) has been performed. With the increased statistic collected during 2011 it has been possible to study, in bins of transverse momentum, the cross section ratio between X(3872) and Psi(2S) and separate their prompt and non-prompt component.

Teos-based consolidants for stone conservation: evaluation of the effects and testing by x-ray imaging

Natural stones have been widely used in the construction field since antiquity. Building materials undergo decay processes due to mechanical,chemical, physical and biological causes that can act together. Therefore an interdisciplinary approach is required in order to understand the interaction between the stone and the surrounding environment. Utilization of buildings, inadequate restoration activities and in general anthropogenic weathering factors may contribute to this degradation process. For this reasons, in the last few decades new technologies and techniques have been developed and introduced in the restoration field. Consolidants are largely used in restoration and conservation of cultural heritage in order to improve the internal cohesion and to reduce the weathering rate of building materials. It is important to define the penetration depth of a consolidant for determining its efficacy. Impregnation mainly depends on the microstructure of the stone (i.e. porosity) and on the properties of the product itself. Throughout this study, tetraethoxysilane (TEOS) applied on globigerina limestone samples has been chosen as object of investigation. After hydrolysis and condensation, TEOS deposits silica gel inside the pores, improving the cohesion of the grains. X-ray computed tomography has been used to characterize the internal structure of the limestone samples,treated and untreated with a TEOS-based consolidant. The aim of this work is to investigate the penetration depth and the distribution of the TEOS inside the porosity, using both traditional approaches and advanced X-ray tomographic techniques, the latter allowing the internal visualization in three dimensions of the materials. Fluid transport properties and porosity have been studied both at macroscopic scale, by means of capillary uptake tests and radiography, and at microscopic scale,investigated with X-ray Tomographic Microscopy (XTM). This allows identifying changes in the porosity, by comparison of the images before and after the treatment, and locating the consolidant inside the stone. Tests were initially run at University of Bologna, where characterization of the stone was carried out. Then the research continued in Switzerland: X-ray tomography and radiography were performed at Empa, Swiss Federal Laboratories for Materials Science and Technology, while XTM measurements with synchrotron radiation were run at Paul Scherrer Institute in Villigen.

General considerations on rapid desensitization for drug hypersensitivity - a consensus statement

Drug hypersensitivity reactions can occur with most drugs, are unpredictable, may affect any organ or system, and range widely in clinical severity from mild pruritus to anaphylaxis. In most cases, the suspected drug is avoided in the future. However, for certain patients, the particular drug may be essential for optimal therapy. Under these circumstances, desensitization may be performed. Drug desensitization is defined as the induction of a temporary state of tolerance of a compound responsible for a hypersensitivity reaction. It is performed by administering increasing doses of the medication concerned over a short period of time (from several hours to a few days) until the total cumulative therapeutic dose is achieved and tolerated. It is a high-risk procedure used only in patients in whom alternatives are less effective or not available after a positive risk/benefit analysis. Desensitization protocols have been developed and are used in patients with allergic reactions to antibiotics (mainly penicillin), insulins, sulfonamides, chemotherapeutic and biologic agents, and many other drugs. Desensitization is mainly performed in IgE-mediated reactions, but also in reactions where drug-specific IgE have not been demonstrated. Desensitization induces a temporary tolerant state, which can only be maintained by continuous administration of the medication. Thus, for treatments like chemotherapy, which have an average interval of 4 weeks between cycles, the procedure must be repeated for every new course. In this paper, some background information on rapid desensitization procedures is provided. We define the drugs and drug reactions indicated for such procedures, describe the possible mechanism of action, and discuss the indications and contraindications. The data should serve as background information for a database (accessible via the EAACI-homepage) with standardized protocols for rapid desensitization for antibiotics, chemotherapeutic agents, monoclonal antibodies/fusion proteins, and other drugs.

Behaviour of general dental practitioners in Germany regarding posterior restorations with flowable composites

Because the recommendation to use flowables for posterior restorations is still a matter of debate, the objective of this study was to determine in a nationwide survey in Germany how frequently, for what indications, and for what reasons, German dentists use flowable composites in posterior teeth. In addition, the acceptance of a simplified filling technique for posterior restorations using a low stress flowable composite was evaluated. Completed questionnaires from all over Germany were returned by 1,449 dentists resulting in a response rate of 48.5%; 78.6% of whom regularly used flowable composites for posterior restorations. The most frequent indications were cavity lining (80.1%) and small Class I fillings (74.2%). Flowables were less frequently used for small Class II fillings (22.7%) or other indications (13.6%). Most frequent reasons given for the use of flowables in posterior teeth were the prevention of voids (71.7%) and superior adaptation to cavity walls (72.9%), whereas saving time was considered less important (13.8%). Based on the subjective opinion of the dentists the simplified filling technique seemed to deliver advantages compared to the methods used to date particularly with regard to good cavity adaptation and ease of use. In conclusion, resin composites are the standard material type used for posterior restorations by general dental practitioners in Germany and most dentists use flowable composites as liners.

Oral and general health status in patients treated in a dental consultation clinic of a geriatric ward in Bern, Switzerland

This audit reports on the oral and general health of patients who were treated in a dental consultation clinic of a geriatric hospital.

Educational achievement in Swiss childhood cancer survivors compared with the general population

The objective of this study was to describe educational achievements of childhood cancer survivors in Switzerland compared with the general population. In particular, the authors investigated educational problems during childhood, final educational achievement in adulthood, and its predictors.

Clustering of health behaviours in adult survivors of childhood cancer and the general population

Little is known about engagement in multiple health behaviours in childhood cancer survivors.