983 resultados para José Ingenieros


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Sulfur and carbon isotope compositions of ten scapolites from granulite-facies rocks of the São José do Rio Pardo area, Guaxupé Complex, Brazil, were measured. Scapolite is the primary and major rock-forming mineral in these rocks (up to 40 volume %). The isotopic composition of the sulfate and carbonate group in the scapolite structure has δ34S values of +1.0‰ to +6.7‰, and δ13C values of -14.3‰ to -6.3‰, respectively. The sulfur isotope data may be related to an upper mantle (external) or lower crustal (internal) source for the sulfur, whereas the carbon appears to have been derived from an internal source. Thus, the carbon and sulfur isotope data can be explained without invoking an external (mantle) source. © 1993.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Introduction: An epidemiological study of the mortality rates by injuries in São José do Rio Preto, State of São Paulo, Brazil, has been carried out. The period considered is 1996-1998. Objectives: To show injuries mortality rates in São José do Rio Preto-SP in 1996-98. Methods: The study was based on official data from the Mortality Information Service of the Brazilian Ministry of Health, and in a survey based on data from medical forensic examiners (IML). Software Epinfo6.0 and Tabwin was utilized for data analises. Results: The results were compared to values obtained in the literature for the other cities of São Paulo and Brazil. In the case of São José do Rio Preto, was observed a decrease in the number of deaths associated with external causes in the period, but particularly in deaths due to traffic accidents with motor vehicles an increase in cases of pedestrians killed by hit-and-run drivers, that is much larger than the corresponding values for Brazil and for the State of São Paulo. The study showed increase in rates of homicides, mainly in the 15 to 39 years age group. Conclusion: This result suggests that is important to start programs to reduce the number of deaths by injuries, as well as the necessity of monitoring locally all these data.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Water is the raw material used most in the production of diverse pharmaceutical forms and, being a constituent of the formulation itself, is subject to a number of physico-chemical and microbiological specifications. In addition, it is indispensable for laboratory tests and the cleaning of equipment and apparatus. The aim of this study was to ascertain the degree of physicochemical and microbiological contamination of purified water used in compounding pharmacies in the city of São José do Rio Preto, SP, Brazil. Samples were taken as recommended in the USP Pharmacopeia, with careful aseptic technique, and sent immediately the to quality control laboratory. Physicochemical properties were analyzed, including appearance, pH, conductivity, residue after evaporation, ammonia, calcium, chloride, heavy metals, sulfate and oxidizable substances, and microbiological tests were performed: total aerobic microbial count and detection of total and thermotolerant coliforms and Pseudomonas aeruginosa. Results showed that some parameters did not conform to the standards, especially pH, conductivity, inorganic impurities, oxidizable substances and microbiological test data, in 10%, 17%, 10%, 14% and 20% of the analyzed samples, respectively, This points to the need for greater care in the production and/or storage of purified water in these pharmaceutical establishments.