995 resultados para Guaranteed Control
Resumo:
1. Eradication is often the preferred strategy in the management of new weed invasions, but recent research has shown that the circumstances under which eradication can be achieved are highly constrained. Containment is a component of an eradication strategy and also a management objective in its own right. Just as for eradication, containment of a weed invasion should be attempted only if it is considered feasible. However, very little guidance exists for the assessment of containment feasibility for weeds. 2. Numerous factors have been proposed as influencing feasibility of containment, but those that relate to the potential for management of dispersal pathways and timely detection of new foci of infestation appear to be critical. Theory suggests that the rate of spread is largely driven by long-distance dispersal (LDD). However, LDD is generally unpredictable and often occurs for species that do not appear to be adapted for it. Furthermore, many (if not most) LDD events fail to give rise to new infestations. 3. As the probability of colonisation is related to the numbers of propagules immigrating ('propagule pressure') at a point in the landscape, dispersal pathways that move relatively large numbers of propagules simultaneously and/or repeatedly should most enhance weed spread. It is these pathways whose potential for management has the greatest bearing upon containment feasibility. A key impediment to containment is undetected spread; this need not occur through LDD and is more likely to occur through dispersal to lesser distances. 4. Synthesis and applications. Feasibility of containment should be viewed in terms of the effort required to reduce weed spread rate, as well as the effectiveness of relevant management actions. Where dispersal vectors are not readily manageable and the probability of detection via structured and/or unstructured surveillance is low, a much greater reliance upon fecundity control will be needed to contain a weed. A combination of empirical and theoretical approaches should be used to develop and refine estimates of containment feasibility. Such estimates will aid decision-making with regard to whether to attempt to reduce weed spread and assist in prioritisation of different weeds for containment.
Resumo:
This work evaluated the following aspects of the use of exclusion netting in low chill stone fruit: the efficacy of protection from fruit fly for this highly susceptible crop; the effects on environmental factors; and the effects on crop development. Concurrently, an economic viability study on the use of exclusion netting was undertaken. The trial site was a 0.6-ha block of low chill stone fruit at Nambour, south-east Queensland, Australia. In this area, populations of Queensland fruit fly (Bactrocera tryoni) are known to be substantial, particularly in spring and summer. The trial block contained healthy 4-year-old trees as follows: 96 peach trees (Prunus persica cv. Flordaprince) and 80 nectarine trees (40 P. persica var. nucipersica cv. White Satin and 40 P. persica var. nucipersica cv. Sunwright). Exclusion netting was installed over approximately half of the block in february 2001. The net was a UV-stabilized structural knitted fabric made from high-density polyethylene yarn with a 10-year prorated UV degradation warranty. The results demonstrated the efficacy of exclusion netting in the control of fruit flies. Exclusion netting increased maximum temperatures by 4.4 deg C and decreased minimum temperatures by 0.5 deg C. Although exclusion netting reduced irradiance by approximately 20%, it enhanced fruit development by 7-10 days and improved fruit quality by increasing sugar concentration by 20-30% and colour intensity by 20%.
Resumo:
Amongst various methods to attain sound antibacterial and antifouling properties, surface modification of biomaterials combines efficiency, processing flexibility, and most importantly, the ability to preserve favourable bulk properties, such as mechanical strength and chemical inertness. This chapter will first briefly discuss key parameters by which the biomaterial surface can be described, namely surface chemistry and morphology, and their individual and combined contributions to cell-surface interactions. More emphasis will be placed on surface morphology as the area of much debate. The chapter will then describe a range of available methodologies for surface modification, with plasma-assisted modification as one of the foci.
Resumo:
Parthenium hysterophorus L. is a weed of global significance that has become a major weed in Australia and many other parts of the world. A combined approach for the management of parthenium weed using biological control and plant suppression, was tested under field conditions over a two-year period in southern central Queensland. The six suppressive plant species, selected for their demonstrably suppressive ability in earlier glasshouse studies, worked synergistically with the biological control agents (Epiblema strenuana Walker, Zygogramma bicolorata Pallister, Listronotus setosipennis Hustache and Puccinia abrupta var. partheniicola) present in the field to reduce the growth (above ground biomass) of parthenium weed, by between 60–86% and 47–91%, in Years 1 and 2, respectively. The biomass of the suppressive plants was between 6% and 23% greater when biological control agents were present than when the biological control agents had been excluded. This shows that parthenium weed can be more effectively managed by combining the current biological control management strategy with selected sown suppressive plant species, both in Australia and elsewhere.
Resumo:
Self-tuning is applied to the minimum variance control of non-linear multivariable systems which can be characterized by a ' multivariable Hammerstein model '. It is also shown that such systems are not amenable to self-tuning control if control costing is to be included in the performance criterion.
Resumo:
It is at the population level that an invasion either fails or succeeds. Lantana camara L. (Verbenaceae) is a weed of great significance in Queensland Australia and globally but its whole life-history ecology is poorly known. Here we used 3 years of field data across four land use types (farm, hoop pine plantation and two open eucalyptus forests, including one with a triennial fire regime) to parameterise the weed’s vital rates and develop size-structured matrix models. Lantana camara in its re-colonization phase, as observed in the recently cleared hoop pine plantation, was projected to increase more rapidly (annual growth rate, λ = 3.80) than at the other three sites (λ 1.88–2.71). Elasticity analyses indicated that growth contributed more (64.6 %) to λ than fecundity (18.5 %) or survival (15.5 %), while across size groups, the contribution was of the order: juvenile (19–27 %) ≥ seed (17–28 %) ≥ seedling (16–25 %) > small adult (4–26 %) ≥ medium adult (7–20 %) > large adult (0–20 %). From a control perspective it is difficult to determine a single weak point in the life cycle of lantana that might be exploited to reduce growth below a sustaining rate. The triennial fire regime applied did not alter the population elasticity structure nor resulted in local control of the weed. However, simulations showed that, except for the farm population, periodic burning could work within 4–10 years for control of the weed, but fire frequency should increase to at least once every 2 years. For the farm, site-specific control may be achieved by 15 years if the biennial fire frequency is tempered with increased burning intensity.
Resumo:
Cat's claw creeper, Dolichandra unguis-cati (L.) L.G. Lohman (syn: Macfadyena unguis-cati (L.) A.H. Gentry) (Bignoniaceae), a major environmental weed in Queensland and New South Wales, is a Weed of National Significance and an approved target for biological control. A leaf-mining jewel beetle, Hylaeogena jureceki Obenberger (Coleoptera: Buprestidae), first collected in 2002 from D. unguis-cati in Brazil and Argentina, was imported from South Africa into a quarantine facility in Brisbane in 2009 for host-specificity testing. H. jureceki adults chew holes in leaves and lay eggs on leaf margins and the emerging larvae mine within the leaves of D. unguis-cati. The generation time (egg to adult) of H. jureceki under quarantine conditions was 55.4 ± 0.2 days. Host-specificity trials conducted in Australia on 38 plant species from 11 families supplement and support South African studies which indicated that H. jureceki is highly host-specific and does not pose a risk to any non-target plant species in Australia. In no-choice tests, adults survived significantly longer (>32 weeks) on D. unguis-cati than on non-target test plant species (<3 weeks). Oviposition occurred on D. unguis-cati and one non-target test plant species, Citharexylum spinosum (Verbenaceae), but no larval development occurred on the latter species. In choice tests involving D. unguis-cati, C. spinosum and Avicennia marina (Avicenniaceae), feeding and oviposition were evident only on D. unguis-cati. The insect was approved for field release in Australia in May 2012.
Resumo:
The eradication of an invasive plant species can provide substantial ecological and economic benefits by eliminating completely the negative effects of the weed and reducing the high cost of continuing control. A 5-yr program toward the eradication of hill raspberry (Rubus niveus Thunb.) in Santiago Island is evaluated using delimitation and extirpation criteria, as well as assessment of the ecological community response to management techniques. Currently, hill raspberry is located in the humid zone of Santiago island. It is distributed over three main infestations, small patches, and many scattered individuals within an area of approximately 1,000 ha. New infestations are constantly being found; every year, new detections add an area of approximately 175 ha. Adult and juvenile individuals are still found, both beyond and within known infestations. Both plant and seed bank density of hill raspberry decreased over time where infestations were controlled. Species composition in the seed bank and existing vegetation were significantly different between areas under intensive control and adjacent uninvaded forest. After 5 yr of intensive management, delimitation of hill raspberry has not been achieved; new populations are found every year, increasing the infested area that requires management. Off-target effects on native species resulting from control efforts seem to be substantial. Although a vast increase in economic investment would allow intensive searching that might enable all individuals to be found and controlled, the resultant disturbance and off-targets effects could outweigh the conservation benefits of eradication.
Resumo:
A leaf-feeding geometrid, Chiasmia assimilis (Warren), was introduced into northern Queensland from South Africa in 2002 as a biological control agent for the invasive woody weed, prickly acacia, Acacia nilotica subsp. indica (Bentham) Brenan. The insect established in infestations in coastal areas between the townships of Ayr and Bowen where the larvae periodically cause extensive defoliation at some localities during summer and autumn. The impact of this herbivory on a number of plant parameters, including shoot length, basal stem diameter, root length, number of leaves, number of branches, and above and below ground biomass was investigated at one coastal site through an insect exclusion trial using potted seedlings and regular spray applications of a systemic insecticide to exclude the biological control agent. Half the seedlings, both sprayed and unsprayed, were placed beneath the prickly acacia canopy, the other half were placed in full sunlight. Larvae of C. assimilis were found on unsprayed seedlings in both situations. The effects of herbivory, however, were significant only for seedlings grown beneath the canopy. At the end of the five-month trial period, shoot length of these seedlings was reduced by 30%, basal stem diameter by 44%, root length by 15%, number of leaves by 97%, above ground biomass by 87%, and below ground biomass by 77% when compared to sprayed seedlings. Implications are that the insect, where established, may reduce seedling growth beneath existing canopies and in turn may help limit the formation of dense infestations. Crown Copyright (C) 2012 Published by Elsevier Inc. All rights reserved.
Detection of major mite pests of Apis mellifera and development of non-chemical control of varroasis
Resumo:
The in vivo pediculicidal effectiveness of 1% and 2% formulations of tea tree (Melaleuca alternifolia) oil (TTO) against sheep chewing lice (Bovicola ovis) was tested in two pen studies. Immersion dipping of sheep shorn two weeks before treatment in both 1% and 2% formulations reduced lice to non detectable levels. No lice were found on any of the treated sheep despite careful inspection of at least 40 fleece partings per animal at 2, 6, 12 and 20 weeks after treatment. In the untreated sheep louse numbers increased from a mean (+/- SE) of 2.4 (+/- 0.7) per 10 cm fleece part at 2 weeks to 12.3 (+/- 4.2) per part at 20 weeks. Treatment of sheep with 6 months wool by jetting (high pressure spraying into the fleece) reduced louse numbers by 94% in comparison to controls at two weeks after treatment with both 1% and 2% TTO formulations. At 6 and 12 weeks after treatment reductions were 94% and 91% respectively with the 1% formulation and 78% and 84% respectively with the 2% formulation. TTO treatment also appeared to reduce wool damage in infested sheep. Laboratory studies indicated that tea tree oil 'stripped' from solution with a progressive reduction in concentration as well as volume as more wool was dipped, indicating that reinforcement of active ingredient would be required to maintain effectiveness when large numbers of sheep are treated. The results of these studies suggest significant potential for the development of ovine lousicides incorporating TTO. (C) 2012 Elsevier B.V. All rights reserved.
Resumo:
Oreochromis mossambicus (Peters 1852) are native to the eastward flowing rivers of central and southern Africa but from the early 1930s they have been widely distributed around the world for aquaculture and for biological control of weeds and insects. While O. mossambicus are now not commonly used as an aquaculture species, the biological traits that made them a popular culture species including tolerance to wide ranging ecological conditions, generalist dietary requirements and rapid reproduction with maternal care have also made them a 'model' invader. Self-sustaining populations now exist in almost every region to which they have been imported. In Australia, since their introduction in the 1970s, O. mossambicus have become established in catchments along the east and west coasts and have the potential to colonise other adjacent drainages. It is thought that intentional translocations are likely to be the most significant factor in their spread in Australia. The ecological and physical tolerances and preferences, reproductive behaviour, hybridization and the high degree of plasticity in the life history traits of O. mossambicus are reviewed. Impacts of O. mossambicus on natural ecosystems including competitive displacement of native species, habitat alteration, predation and as a vector in the spread of diseases are discussed. Potential methods for eradicating or controlling invasive populations of O. mossambicus including physical removal, piscicides, screens, environmental management and genetic technologies are outlined.
Resumo:
A new two-stage state feedback control design approach has been developed to monitor the voltage supplied to magnetorheological (MR) dampers for semi-active vibration control of the benchmark highway bridge. The first stage contains a primary controller, which provides the force required to obtain a desired closed-loop response of the system. In the second stage, an optimal dynamic inversion (ODI) approach has been developed to obtain the amount of voltage to be supplied to each of the MR dampers such that it provides the required force prescribed by the primary controller. ODI is formulated by optimization with dynamic inversion, such that an optimal voltage is supplied to each damper in a set. The proposed control design has been simulated for both phase-I and phase-II study of the recently developed benchmark highway bridge problem. The efficiency of the proposed controller is analyzed in terms of the performance indices defined in the benchmark problem definition. Simulation results demonstrate that the proposed approach generally reduces peak response quantities over those obtained from the sample semi-active controller, although some response quantities have been seen to be increasing. Overall, the proposed control approach is quite competitive as compared with the sample semi-active control approach.