Chemical and isotopic compositions of samples from the Haakon Mosby mud volcano and nearby

Authigenic carbonates in the caldera of an Arctic (72°N) submarine mud volcano with active methane-bearing fluid discharge are formed at the bottom surface during anaerobic microbial methane oxidation. The microbial community consists of specific methane-producing bacteria, which act as methanotrophic ones in conditions of excess methane, and sulfate reducers developing on hydrogen, which is an intermediate product of microbial CH4 oxidation. Isotopically light carbon (aver. d13C = -28.9 per mil) of CO2 produced during CH4 oxidation is the main carbonate carbon source. Heavy oxygen isotope ratio (aver. d18O = 5 per mil) in carbonates is inherited from seawater sulfate. Rapid sulfate reduction (up to 12 mg S/dm**3/day) results in total exhausting of sulfate ion in the upper sediment layer (10 cm). Because of this carbonates can only be formed in surface sediments near the water-bottom interface. Salinity as well as CO3/Ca and Mg/Ca ratios correspond to the field of non-magnesian calcium carbonate precipitation. Calcite is the dominant carbonate mineral in the methane seep caldera, where it occurs in the paragenetic association with barite. Radiocarbon age of carbonates is about 10 Ka.

Properties, sedimentation and accumulation rates, and chemical composition of bottom sediments from the Deryugin Basin, Sea of Okhotsk

Results of a study of contents and accumulation rates of Fe, Mn, and some trace elements in Upper Quaternary sediments of the Deryugin Basin are presented. Maps of average contents and accumulation rates of excessive Fe, Mn, Zn, Ba, Ni, Pb, Cu, and Mo in sediments of the first oxygen isotope stage (OIS) have been plotted. Anomalous contents and accumulation rates are confined to peripheral zones of the Deryugin sedimentary basin and large fracture zones. Different mechanisms of influence of fluid-dynamic processes on rate of hydrogenic and biogenic accumulation of ore elements are assumed.

Grain size, mineral and chemical compositions of modern deposits fron the northern Caspian Sea and the Volga River delta

Comprehensive investigations revealed that modern deposits in the northern Caspian Sea involve terrigenous sands and aleurites with admixture of detritus and intact bivalve shells, including coquina. Generally, these deposits overlay dark grayish viscous clays. Similar geological situation occurs in the Volga River delta; however, local deposits are much poorer in biogenic constituents. Illite prevails among clay minerals. In coarse aleurite fraction (0.100-0.050 mm) heavy transparent minerals are represented mostly by epidotes, while light minerals - mostly by quartz and feldspars. Sedimentary material in the Volga River delta is far from completely differentiated into fractions due to abundant terrigenous inflows. Comparatively better grading of sediments from the northern Caspian Sea is due to additional factors such as bottom currents and storms. When passing from the Volga River delta to the northern Caspian Sea, sediments are enriched in rare earth elements (except Eu), Ca, Au, Ni, Se, Ag, As, and Sr, but depleted in Na, Rb, Cs, K, Ba, Fe, Cr, Co, Sc, Br, Zr, ??, U, and Th. Concentrations of Zn remain almost unchanged. Sedimentation rates and types of recent deposits in the northern Caspian Sea are governed mainly by abundant runoff of the Volga River.

Chemical composition of ferromanganese concretions and host bottom sediments from the Black Sea

Ferromanganese concretions spread out on the bottom of the shallow northwest part of the Black Sea are mainly represented by Fe and Mn nodules on shells and substituted worm tubes. Element composition of these formations was measured by methods of chemical, atomic absorbtion, neutron activation, and ICP-MS analyses. It was established that Fe and Mn contents and Mn/Fe ratio in the concretions varied considerably and which controlled occurrence of several associated metals and minor elements; some of them have not been studied in Black Sea concretions before.

Composition of bottom sediments and rocks from the Philippine Trough

New data on bottom sediments and igneous rocks of the Philippine Trench are under consideration. They show differences in geological structures of the island slope and the ocean slope of the trench. The island slope is comparable to the accretionary prism formations on the Philippines; there processes of gravitational re-deposition of sediments occur. The ocean slope is an edge of the Philippine Plate sinking into the trough, where basalts of the oceanic crust are exposed.

Chemical and mineral compositions of recent and ancient sediments and sedimentary rocks from the Mariana Trench

On the bed and on the ocean slope of the southern latitudinal part of the Mariana Trench ancient sediments, as well as sedimentary and igneous rocks are exposed. In the lower part of the sampled part of the studied section Late Oligocene to Early Miocene chalk-like limestones and marls occur. Upward marly tuffites and tuffs (apparently alternating with carbonate rocks) occur. These rocks are overlain by Early Miocene tuffaceous clays and siliceous-clayey muds. In the upper part of the section there are Pleistocene pelagic clays and ethmodiscus oozes.

Chemical composition in phosphate materials from the ocean floor

Content, distribution patterns, and speciation of Cl in phosphorites and bone phosphate from the ocean floor, as well as in a set of samples from the land are studied. Total Cl content varies from 0.05 to 4.25% in phosphorites and from 2.48 to 2.75% in recent phosphate-bearing sediments. Recent phosphorites are enriched in Cl relative to ancient ones. Bound Cl content (not extractable by washing), which increases with lithification, varies from 0.17 to 0.60% in ocean and land phosphorites and from 0.02% to 1.30% in bone phosphate. Na content in most samples is higher relative to Na of NaCl due to its incorporation into the crystal lattice of apatite. However, the opposite relationship is observed in some samples indicating partial Cl incorporation into the anion complex of phosphate. Behavior of Cl in phosphorites from the present-day ocean floor is controlled by early diagenetic processes, whereas the role of weathering, catagenesis, and hydrogeological factors may be crucial for phosphorites on continents.

Composition of phosphorites from continental margins, seamounts, and islands

Behavior of molybdenum and manganese is studied in phosphorite samples from shelves, seamounts, and islands of the ocean. In shelf phosphorites molybdenum and manganese contents are 2-128 and 12-1915 ppm, respectively, while the Mo/Mn ratio varies from 0.004 to 4.5. Phosphorites from ocean seamounts impregnated with ferromanganese oxyhydroxides contain 0.84-14.5 ppm Mo and 0.1-17% Mn. The Mo/Mn ratio varies within 0.0008-0.004. Phosphate bearing ferromanganese crusts overlying seamount phosphorites contain 54-798 ppm Mo and 10-20% Mn; the Mo/Mn ratio varies within 0.002-0.005. Corresponding values for most island phosphorites are 0.44-11.2 ppm, 27-287 ppm, and 0.008-0.20. Phosphorites from reduced environment are characterized by relative enrichment in Mo and depletion in Mn, whereas the Mo/Mn ratio reaches maximum values. The ratio decreases with transition to suboxic and oxic conditions. Molybdenum content in recent shelf sediments is commonly higher than that in authigenic phosphorites from these sediments. Recent phosphorite nodules from the Namibian shelf become depleted in Mo and Mn during their lithification, but Pliocene-Pleistocene nodules of similar composition and origin from the same region are enriched in Mo and characterized by variable Mn content. Higher Mo contents in phosphate bearing ferromanganese crusts result from coprecipitation of Mo and Mn from seawater. Unweathered phosphorites on continents and phosphorites from ocean shelves are largely enriched in Mo with the Mo/Mn ratio varying from 0.01 to 1.0. This is an evidence of their formation in reduced conditions.

(Table 1) Composition of manganese-iron accumulates in the Kiel Bay, western Baltic Sea

Manganese-iron accumulates in the Kiel Bay were investigated with regard to their occurence, chemical composition and formation. Three morphologically different types were identified: a) growth on mussels, b) spherical nodules (ca. 1-3 cm) and c) disshaped symetrical and asymetrical nodules (up to 10 cm). Average values from 110 accumulates representing the three types were: Mn 29.3%, Fe 10.0%, Co 77 ppm, Ni 97 ppm, Cu 21 ppm and Zn 340 ppm. Accumulates on mussels showed the highest trace metal concentrations. A growth rate of ca. 0.6 mm/yr for type (a) was estimated. Heavy metal concentrations were determined in ca. 60 sediment and 30 pore water samples, and in 110 Baltic sea water samples. During certain periods, large increases in Mn values (up to 400 (µg/l) were found in the deeper waters. These concentrations develop during periods of strong stagnant conditions in the sediments where dissolution of Mn oxides, and diffusion mobilizes the Mn into the overlying waters. The manganese is then reprecipitated close to the boundary of the O2-enriched surface waters. This critical O2-concentration was found to be 40% saturation. In the Kiel Bay, Mn-Fe-accumulates are found in a zone which marks the upper limit sometimes reached by the deep waters of lower O2-concentration. Additionally, the availability of larger particles (especially stones or mussels) on the sediment surface is necessary. These conditions are met in the Kiel Bay in a water depth of 20-28 m at several places.