Sites of dental erosion are saliva-dependent

Acid demineralization of teeth causes occlusal erosion and attrition and associated non-carious cervical lesions at sites relatively unprotected by saliva. Associations of occlusal pathology and cervical lesions were looked for in 450 patients with toothwear, and 174 subjects with cervical lesions were identified. Associations of occlusal attrition, or erosion, or no wear, with cervical lesions at 72 buccal and lingual sites were recorded from epoxy resin replicas of the subjects' dentitions (3241 teeth). Criteria used to discriminate occlusal erosion from attrition; and shallow from grooved and wedge-shaped cervical lesions were delineated by scanning electron microscopy (SEM). In the absence of occlusal pathology, cervical lesions were very rare (

High-speed MAS F-19 NMR analysis of an irradiated fluoropolymer

The effect of gamma-radiation on a perfluoroalkoxy (PFA) resin was examined using solid-state high-speed magic angle spinning (MAS) F-19 NMR spectroscopy. Samples were prepared for analysis by subjecting them to gamma-radiation in the dose range 0.5-3 MGy at either 303, 473, or 573 K. New structures identified include new saturated chain ends, short and long branches, and unsaturated groups. The formation of branched structures was found to increase with increasing irradiation temperature; however, at all temperatures the radiation chemical yield (G value) of new chain ends was greater than the G value of long branch points, suggesting that chain scission is the net process.

Dry matter production and boron concentrations of vegetative and reproductive tissues of canola and sunflower plants grown in nutrient solution

Canola (Brassica napus L.) and sunflower (Helianthus annuus L.), two important oilseed crops, are sensitive to low boron (B) supply. Symptoms of B deficiency are often more severe during the reproductive stage, but it is not known if this is due to a decreased external B supply with time or an increased sensitivity to low B during this stage. Canola and sunflower were grown for 75 days after transplanting (DAT) in two solution culture experiments using Amberlite (IRA-743) B-specific resin to maintain constant B concentration in solution over the range 0.6 - 53 muM. Initially, the vegetative growth of both crops was good in all treatments. With the onset of the reproductive stage, however, severe B deficiency symptoms developed and growth of canola and sunflower was reduced with less than or equal to 0.9 and less than or equal to 0.7 muM B, respectively. At these concentrations, reproductive parts failed to develop. The critical B concentration (i.e. 90% of maximum shoot dry matter yield) in the youngest opened leaf was 18 mg kg(-1) in canola and 25 mg kg(-1) in sunflower at 75 DAT. The results of this study indicate that the reproductive stage of these two oilseed crops is more sensitive than the vegetative stage to low B supply.

Combined chemical separation of Lu, Hf, Sm, Nd, and REEs from a single rock digest: Precise and accurate isotope Determinations of Lu-Hf and Sm-Nd using multicollector-ICPMS

A combined procedure for separating Lu, Hf, Sm, Nd, and rare earth elements (REEs) from a single sample digest is presented. The procedure consists of the following five steps: (1) sample dissolution via sodium peroxide sintering; (2) separation of the high field strength elements from the REEs and other matrix elements by a HF-free anion-exchange column procedure; (3) purification of Hf on a cation-exchange resin; (4) separation of REEs from other matrix elements by cation exchange; (5) Lu, Sm, and Nd separation from the other REEs by reversed-phase ion chromatography. Analytical reproducibilities of Sm-Nd and Lu-Hf isotope systematics are demonstrated for standard solutions and international rock reference materials. Results show overall good reproducibilities for Sm-Nd systematics independent of the rock type analyzed. For the Lu-Hf systematics, the reproducibility of the parent/daughter ratio is much better for JB-1 (basalt) than for two analyzed felsic crustal rocks (DR-N and an Archaean granitoid). It is demonstrated that this poorer reproducibility of the Lu/Hf ratio is truly caused by sample heterogeneity; thus, results are geologically reasonable.

The current status of laser applications in dentistry

A range of lasers. is now available for use in dentistry. This paper summarizes key current and emerging applications, for lasers in clinical practice. A major diagnostic application of low power lasers is the detection of caries, using fluorescence elicited from hydroxyapatite or from bacterial by-products. Laser fluorescence is an effective method for detecting and quantifying incipient occlusal and cervical,carious lesions, and with further refinement could be used in the, same manner for proximal lesions. Photoactivated dye techniques have been developed which use low power lasers to elicit a photochemical reaction, Photoactivated dye techniques' can be used to disinfect root canals, periodontal pockets, cavity preparations and sites of peri-implantitis. Using similar principles, more powerful lasers tan be used for photodynamic therapy in the treatment of malignancies of the oral mucosa. Laser-driven photochemical reactions can also be used for tooth whitening. In combination with fluoride, laser irradiation can improve the resistance of tooth structure to demineralization, and this application is of particular benefit for susceptible sites in high caries risk patients. Laser technology for caries' removal, cavity preparation and soft tissue surgery is at a high state of refinement, having had several decades of development up to the present time. Used in conjunction with or as a replacement for traditional methods, it is expected that specific laser technologies will become an essential component of contemporary dental practice over the next decade.

Recombinant expression of Munc18c in a baculovirus system and interaction with syntaxin4

Two protein families that are critical for vesicle transport are the Syntaxin and Munc18/Sec1. families of proteins. These two molecules form a high affinity complex and play an essential role in vesicle docking and fusion. Munc18c was expressed as an N-terminally His-tagged fusion protein from recombinant baculovirus in Sf9 insect cells. His-tagged Munc18c was purified to homogeneity using both cobalt-chelating affinity chromatography and gel filtration chromatography. With this simple two-step protocol, 3.5 mg of purified Munc18c was obtained from a 1 L culture. Further, the N-terminal His-tag could be removed by thrombin cleavage while the tagged protein was bound to metal affinity resin. Recombinant Munc18c produced in this way is functional, in that it forms a stable complex with the SNARE interacting partner, syntaxin4. Thus we have developed a method for producing and purifying large amounts of functional Munc18c-both tagged and detagged-from a baculovirus expression system. We have also developed a method to purify the Munc18c:syntaxin4 complex. These methods will be employed for future functional and structural studies. Crown copyright (C) 2003 Published by Elsevier Inc. All rights reserved.

Cross-linking of PFA by electron beam irradiation

The effect of electron beam radiation on a perfluoroalkoxy (PFA) resin was examined using solid-state high-speed magic angle spinning F-19 NMR spectroscopy and FT-IR spectroscopy. Samples were prepared for analysis by subjecting them to electron beam radiation in the dose range 0.5-2.0 MGy at 633 K, which is above the crystalline melting temperature. The new structures were identified and include new saturated chain ends, short and long branches, unsaturated groups, and cross-links. The radiation chemical yield (G value) of new long branch points was greater than the G value of new chain ends, suggesting that cross-linking is the net radiolytic process. This conclusion was supported by an observed decrease in the crystallinity and an increase in the optical clarity of the polymer.

O trabalho e a competência industriosa no beneficiamento de granitos : uma cartografia ergológica

O intuito inicial desta pesquisa foi acompanhar processos de trabalho à luz do referencial teórico da Ergologia e, portanto, concebendo o trabalho como relação dialética entre técnica e ação humana. O objetivo era cartografar o trabalho no processo de beneficiamento de granitos em uma organização de grande porte localizada no Espírito Santo e, após algum tempo em campo, o problema delineou- se do seguinte modo: como se constitui a competência industriosa no beneficiamento de granitos em uma organização de grande porte? A pesquisa justifica-se uma vez que, a despeito da relevância econômica, o cenário capixaba de rochas ornamentais apresenta problemas precários no que diz respeito à gestão. Para os Estudos Organizacionais, a relevância é reforçada pelo fato de aproximar desta área a abordagem ergológica e demarcar no debate sobre competência a noção de competência industriosa, ainda não explorada nesse campo de estudo. Para realização da pesquisa, foi praticada uma cartografia ergológica, a partir da articulação das pistas cartográficas com o referencial teórico-conceitual da Ergologia, sendo utilizadas como técnicas: observação participante durante 6 meses, com uma média de 3 visitas a campo por semana; 8 entrevistas semiestruturadas e em profundidade de cerca de 50 minutos cada com trabalhadores operacionais; uma entrevista com gerente de produção e outra com representante da área de Gestão de Pessoas; conversas com os demais trabalhadores, a fim de enriquecer o diário de campo; novas conversas e observações ao final da análise, para confrontação-validação com os trabalhadores. A sistematização dos procedimentos de análise pode ser assim descrita: a) leituras flutuantes com objetivo de fazer emergirem aspectos centrais relacionados às duas dimensões do trabalho, técnica e ação humana; b) leituras em profundidade com objetivo de fazer emergirem singularidades e especificidades relativas à dialética entre ambas; c) leituras em profundidade com objetivo de fazer emergirem aspectos relativos aos ingredientes da competência industriosa. A despeito da não delimitação de categorias analíticas e subcategorias, a partir da análise emergiram cinco eixos analíticos: 1) os procedimentos a serem empregados no processo de beneficiamento de granitos, englobando: as etapas do beneficiamento; as funções a serem desempenhadas e as tarefas a serem desenvolvidas; as normas regulamentadoras; os conhecimentos técnicos necessários para programação e operação de máquinas; a ordem de produção prescrita pelo setor comercial; 2) o trabalho real, diferenciado do trabalho como emprego de procedimentos pelo foco dado à ação humana no enfrentamento de situações reais, repletas de eventos e variabilidades, em todo o processo, englobando: preparo de carga; laminação; serrada; levigamento; resinagem; polimento-classificação; retoque; fechamento de pacote; ovada de contêiner; 3) diferentes modos de usos de si que, em tendência, são responsáveis pela constituição do agir em competência em cada etapa do processo, na dialética entre técnica e ação humana; 4) o modo como cada ingrediente da competência industriosa atua e se constitui, bem como sua concentração, em tendência, em cada etapa do processo, a partir dos tipos de usos de si que, também em tendência, são mais responsáveis pelo agir em competência, apresentando assim o perfil da competência industriosa no beneficiamento de granitos na empresa em análise; 5) dois possíveis fatores potencializadores dos ingredientes da competência industriosa, a saber, a transdução e os não-humanos. A partir de todo o exposto, as últimas considerações problematizam aspectos relativos ao debate sobre competências e práticas de gestão de pessoas a partir da competência compreendida da seguinte forma: mestria no ato de tirar partido do meio e de si para gerir situações de trabalho, em que a ação consiste na mobilização de recursos dificilmente perceptíveis e descritíveis, inerentes ao trabalhador, porém constituídos e manifestos por usos de si por si e pelos outros no e para o ato real de trabalho, marcadamente num nível infinitesimal, diante de situações que demandam aplicação de protocolos concomitante à gestão de variabilidades e eventos em parte inantecipáveis e inelimináveis.

On the origin of the electrical response of vapor grown carbon nanofiber + epoxy composites

The origin of the electrical response of vapor grown carbon nanofiber (VGCNF) + epoxy composites is investigated by studying the electrical behavior of VGCNF with resin, VGCNF with hardener and cured composites, separately. It is demonstrated that the onset of the conductivity is associated to the emergence of a weak disorder regime. It is also shown that the weak disorder regime is related to a hopping depending on the physical properties of the polymer matrix.

Temperature dependence of the electrical conductivity of vapor grown carbon nanofiber/epoxy composites with different filler dispersion levels

The influence of the dispersion of vapor grown carbon nanofibers (VGCNF) on the electrical properties of VGCNF/epoxy composites has been studied. A homogeneous dispersion of the VGCNF does not imply better electrical properties. The presence of well distributed clusters appears to be a key factor for increasing composite conductivity. It is also shown that the main conduction mechanism has an ionic nature for concentrations below the percolation threshold, while above the percolation threshold it is dominated by hopping between the fillers. Finally, using the granular system theory it is possible to explain the origin of conduction at low temperatures.

The role of disorder on the AC and DC electrical conductivity of vapour grown carbon nanofibre/epoxy composites

Four dispersion methods were used for the preparation of vapour grown carbon nanofibre (VGCNF)/epoxy composites. It is shown that each method induces certain levels of VGCNF dispersion and distribution within the matrix, and that these have a strong influence on the composite electrical properties. A homogenous VGCNF dispersion does not necessarily imply higher electrical conductivity. In fact, it is concluded that the presence of well distributed clusters, rather than a fine dispersion, is more important for achieving larger conductivities for a given VGCNF concentration. It is also found that the conductivity can be described by a weak disorder regime.