Impact of artifact correction methods on R-R interbeat signals to quantifying heart rate variability (HRV) according to linear and nonlinear methods.

In the analysis of heart rate variability (HRV) are used temporal series that contains the distances between successive heartbeats in order to assess autonomic regulation of the cardiovascular system. These series are obtained from the electrocardiogram (ECG) signal analysis, which can be affected by different types of artifacts leading to incorrect interpretations in the analysis of the HRV signals. Classic approach to deal with these artifacts implies the use of correction methods, some of them based on interpolation, substitution or statistical techniques. However, there are few studies that shows the accuracy and performance of these correction methods on real HRV signals. This study aims to determine the performance of some linear and non-linear correction methods on HRV signals with induced artefacts by quantification of its linear and nonlinear HRV parameters. As part of the methodology, ECG signals of rats measured using the technique of telemetry were used to generate real heart rate variability signals without any error. In these series were simulated missing points (beats) in different quantities in order to emulate a real experimental situation as accurately as possible. In order to compare recovering efficiency, deletion (DEL), linear interpolation (LI), cubic spline interpolation (CI), moving average window (MAW) and nonlinear predictive interpolation (NPI) were used as correction methods for the series with induced artifacts. The accuracy of each correction method was known through the results obtained after the measurement of the mean value of the series (AVNN), standard deviation (SDNN), root mean square error of the differences between successive heartbeats (RMSSD), Lomb\'s periodogram (LSP), Detrended Fluctuation Analysis (DFA), multiscale entropy (MSE) and symbolic dynamics (SD) on each HRV signal with and without artifacts. The results show that, at low levels of missing points the performance of all correction techniques are very similar with very close values for each HRV parameter. However, at higher levels of losses only the NPI method allows to obtain HRV parameters with low error values and low quantity of significant differences in comparison to the values calculated for the same signals without the presence of missing points.

Propriedades fotoquímicas de alguns complexos de ferro(II) e rênio(I)

Neste trabalho, foram estudadas as propriedades fotoquímica e/ou fotofísica de alguns compostos de coordenação de rênio(l) e ferro(I I). A irradiação dos complexos fac-[Re(CO)3(NN)(trans-L)]+, NN= 4,7-difenil-1,10- fenantrolina (ph2phen) ou 5-cloro-1,10-fenantrolina (Clphen) e L = 1,2-bis(4-piridil)etileno (bpe) ou 4-estirilpiridina (stpy), em acetonitrila ou em filme de poli(metacrilato de metila) (PMMA) resulta em variações espectrais condizentes com a fotoisomerização trans-cis do ligante coordenado. A determinação dos rendimentos quânticos para a fotorreação pela variação espectral resultou em valores aparentes, uma vez que o reagente e o fotoproduto absorvem na mesma região. Para a determinação do rendimento quântico real, Φreal, utilizou-se a técnica de 1H RMN, na qual os sinais do fotoproduto e do reagente são observados em regiões distintas com diferentes constantes de acoplamento. Os valores de Φreal obtidos para fac-[Re(CO)3h(NN)(trans-bpe)]+ (ph2phen: Φ313= 0,43 ± 0,03; Φ365= 0,44 ± 0,02; Φ404= 0,43 ± 0,02; Clphen: Φ313= 0,56 ± 0,03; Φ365= 0,55 ± 0,04; Φ404= 0,57 ± 0,06) são independentes do comprimento de onda de irradiação, indicando a existência de um único canal para a população do estado excitado 3ILtrans-bpe. Por outro lado, para fac-[Re(CO)3(NN)(trans-stpy)]+, os valores de Φreal sob irradiação a 404 nm são menores que os determinados para os demais comprimentos de onda de irradiação (ph2phen: Φ313= 0,60 ± 0,05; Φ365= 0,64 ± 0,09; Φ404= 0,42 ± 0,03; Clphen: Φ313= 0,52 ± 0,05; Φ365= 0,58 ± 0,02; Φ404= 0,41 ± 0,06), indicando que, a energias maiores, em que o Iigante absorve significativamente, deve existir a contribuição de outro canal para a população do estado excitado 3ILtrans-stpy. A eficiência do fotoprocesso foi avaliada por meio da substituição dos ligantes NN e/ou L, e a diferença nos valores de Φreal entre os complexos deve estar relacionada principalmente com as distintas eficiências de cruzamento intersistemas. o fotoprocesso altera as propriedades fotofísicas desses complexos. Os isômeros trans apresentam fraca ou nenhuma emissão a 298 K, enquanto os fotoprodutos, fac-[Re(CO)3(NN)(cis-L)]+, apresentam intensa luminescência dominada pelo estado excitado 3MLCTRe→NN, que é sensivel à rigidez do meio. A reatividade fotoquímica dos pentacianoferratos(II) [Fe(CN)5 (NN)]3-, NN= 2aminobenzilamina (aba), 2-aminobenzamida (ab), 2-(dimetilaminometil)-3-hidroxipiridina (dmampy), 2-aminometilpiridina (ampy), 2-aminoetilpiridina (aepy) ou 2-(2metilaminoetil) piridina (maepy), também foi investigada. A irradiação desses complexos resulta na fotossubstituição do CN-, a qual só pode ser detectada quando o ligante possui um segundo grupo coordenante nas proximidades da esfera de coordenação. Os rendimentos quânticos da fotossubstituição são dependentes do comprimento de onda de irradiação (Φ313= 0,13 ± 0,01; Φ334= 0,091 ± 0,001; Φ365= 0,056 ± 0,002; Φ404= 0,022 ± 0,002; Φ436= 0,015 ± 0,001, por exemplo, para NN = aba) e indicam a existência de canais distintos pelos quais a fotorreação ocorre ou as diferentes eficiências de cruzamento intersistema para a população do estado excitado reativo. A eficiência do fotoprocesso também depende do Iigante utilizado (λirr= 365 nm: Φaba= 0,056, Φab= 0,14, Φampy= 0,046, Φaepy= 0,066, Φmaepy= 0,069 e Φdmampy= 0,12). Na série das diaminas, o rendimento quântico é maior para [Fe(CN)5(ab)]3-, que possui dois sítios para ocorrer o fechamento do anel. Na série das aminopiridinas, observa-se a influência do comprimento da cadeia na eficiência do fechamento do anel. A presença de metilas ligadas ao nitrogênio alifático deve ter pouca ou nenhuma influência na eficiência do fotoprocesso.

Azimuthal asymmetry in the risetime of the surface detector signals of the Pierre Auger Observatory.

The azimuthal asymmetry in the risetime of signals in Auger surface detector stations is a source of information on shower development. The azimuthal asymmetry is due to a combination of the longitudinal evolution of the shower and geometrical effects related to the angles of incidence of the particles into the detectors. The magnitude of the effect depends upon the zenith angle and state of development of the shower and thus provides a novel observable, (sec theta)(max), sensitive to the mass composition of cosmic rays above 3 x 10(18) eV. By comparing measurements with predictions from shower simulations, we find for both of our adopted models of hadronic physics (QGSJETII-04 and EPOS-LHC) an indication that the mean cosmic-ray mass increases slowly with energy, as has been inferred from other studies. However, the mass estimates are dependent on the shower model and on the range of distance from the shower core selected. Thus the method has uncovered further deficiencies in our understanding of shower modeling that must be resolved before the mass composition can be inferred from (sec theta)(max).

Crossing Blurred Lines: A Training Program to Train Teachers in Appropriate Sexual Boundaries

Boundaries between students and teachers were once clearly defined. Students only interacted with their teachers at school. Currently, however, boundaries are becoming increasingly unclear. As technology advances, students have more venues to interact with their teachers. In addition, teachers are asked to take on more roles in their students' lives. A significant number of teachers and students engage in inappropriate relationships and the possible damage to students is high. Unfortunately, current training programs do not adequately address how teachers can maintain appropriate boundaries with their charges. This paper outlines a proposal for a new training program to fill this gap. This program utilizes training techniques that have been shown to be useful for adult learners as it helps teachers establish and maintain boundaries as well as incorporating elements of effective prevention programs.

The influence of the sample introduction system on signals of different tin compounds in inductively coupled plasma-based techniques

The influence of the sample introduction system on the signals obtained with different tin compounds in inductively coupled plasma (ICP) based techniques, i.e., ICP atomic emission spectrometry (ICP–AES) and ICP mass spectrometry (ICP–MS) has been studied. Signals for test solutions prepared from four different tin compounds (i.e., tin tetrachloride, monobutyltin, dibutyltin and di-tert-butyltin) in different solvents (methanol 0.8% (w/w), i-propanol 0.8% (w/w) and various acid matrices) have been measured by ICP–AES and ICP–MS. The results demonstrate a noticeable influence of the volatility of the tin compounds on their signals measured with both techniques. Thus, in agreement with the compound volatility, the highest signals are obtained for tin tetrachloride followed by di-tert-butyltin/monobutyltin and dibutyltin. The sample introduction system exerts an important effect on the amount of solution loading the plasma and, hence, on the relative signals afforded by the tin compounds in ICP–based techniques. Thus, when working with a pneumatic concentric nebulizer, the use of spray chambers affording high solvent transport efficiency to the plasma (such as cyclonic and single pass) or high spray chamber temperatures is recommended to minimize the influence of the tin chemical compound. Nevertheless, even when using the conventional pneumatic nebulizer coupled to the best spray chamber design (i.e., a single pass spray chamber), signals obtained for di-tert-butyltin/monobutyltin and dibutyltin are still around 10% and 30% lower than the corresponding signal for tin tetrachloride, respectively. When operating with a pneumatic microconcentric nebulizer coupled to a 50 °C-thermostated cinnabar spray chamber, all studied organotin compounds provided similar emission signals although about 60% lower than those obtained for tin tetrachloride. The use of an ultrasonic nebulizer coupled to a desolvation device provides the largest differences in the emission signals, among all tested systems.