Análise comparativa entre simuladores de linha de fluxo e diferenças finitas para um reservatório de petróleo submetido a injeção de água

Water injection is the most widely used method for supplementary recovery in many oil fields due to various reasons, like the fact that water is an effective displacing agent of low viscosity oils, the water injection projects are relatively simple to establish and the water availability at a relatively low cost. For design of water injection projects is necessary to do reservoir studies in order to define the various parameters needed to increase the effectiveness of the method. For this kind of study can be used several mathematical models classified into two general categories: analytical or numerical. The present work aims to do a comparative analysis between the results presented by flow lines simulator and conventional finite differences simulator; both types of simulators are based on numerical methods designed to model light oil reservoirs subjected to water injection. Therefore, it was defined two reservoir models: the first one was a heterogeneous model whose petrophysical properties vary along the reservoir and the other one was created using average petrophysical properties obtained from the first model. Comparisons were done considering that the results of these two models were always in the same operational conditions. Then some rock and fluid parameters have been changed in both models and again the results were compared. From the factorial design, that was done to study the sensitivity analysis of reservoir parameters, a few cases were chosen to study the role of water injection rate and the vertical position of wells perforations in production forecast. It was observed that the results from the two simulators are quite similar in most of the cases; differences were found only in those cases where there was an increase in gas solubility ratio of the model. Thus, it was concluded that in flow simulation of reservoirs analogous of those now studied, mainly when the gas solubility ratio is low, the conventional finite differences simulator may be replaced by flow lines simulator the production forecast is compatible but the computational processing time is lower.

Comportamento mecânico de um agregado reciclado a partir de resíduos de construção e demolição submetido a carregamentos cíclicos

Tese (doutorado)—Universidade de Brasília, Faculdade de Tecnologia, Programa de Pós-Graduação em Geotecnia, 2016.

Modelaje geométrico de estructura ósea

En CAD/CAGC/CG la organización topológica de datos de formas geométricas presenta dificultades: (i) las características matemáticas de la superficie dependen de la consideraciones no geométricas, (ii) los datos presentan una aleatoriedad por efectos del muestreo, y, (iii) una digitalización xyz incluye en general varias direcciones e intervalos de muestreo -- En consecuencia, esta investigación presenta herramientas (portables a diferentes servidores CAD) para la organización topológica de datos de digitalizaciones y un caso de recuperación de formas óseas -- En los dos casos los resultado obtenidos rompen la combinación cerrada hardware - software propietarios tradicionales, con la consecuente reducción en costos de tecnología