Obtenção de biodiesel através da transesterificação do óleo de farelo de arroz utilizando KI/Al2O3

This study proposes to find a biodiesel through transesterification of rice bran oil with KI/Al2O3 checking the influence of two types of alumina (Amorphous and Crystalline) for conversion into methyl esters. The catalyst was synthesized by the wet impregnation method. Adding 30 mL of 35% KI(aq.) in 10 g of alumina, under stirring at 80 °C for 3 hours. The reaction conditions used in this study were optimized, with a molar ratio methanol:oil of 15:1, 8 h of reaction time and reflux temperature. The catalyst amount was varied in the range of 1 to 5 % wt. The solid catalysts materials were analyzed by: x-ray diffraction (XRD), thermogravimetry (TG), N2 adsorption/desorption, scanning electron microscopy (SEM) and basicity, for the identification of its structure and composition, verifying the presence of basic sites. The results showed that Al2O3(A) presents an amorphous structure, high surface area and a better catalytic activity, in relation to the catalyst synthesized with Al2O3(C) support that proved to have a more crystalline structure, having as well, a lesser surface area, enabling difficulties for the incorporation of active sites. The obtained biodiesel with 5% wt. KI/Al2O3(A) presented physicochemical properties within the standards specified by the Resolution No 7/2008 ANP and obtained the best reaction yield with 95.2%, according to quantitative measurement from the TG, which showed 96.2% conversion into methyl esters. It was furthermore found that with the increasing amount of the quantity of the catalyst in the reaction, there was also an increase in the ester content obtained. The specific mass and the kinematic viscosity were reduced with the increase of the amount of quantity of the catalyst, indicating an increase in the conversion of triglycerides

External control of the public water supply in 29 Brazilian cities

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

RH maps of bovine chromosomes 15 and 29: conservation of human chromosomes 11 and 5

Comparative mapping data on evolutionary conserved coding sequences and synteny maps between human and cattle are insufficient to define the extent and distribution of conserved segments between these two species, because the order of loci is often rearranged. A 5000-rad cattle whole-genome radiation hybrid (WG-RH) panel was constructed to provide high-resolution comparative maps and also to integrate linkage maps of microsatellites with evolutionary conserved genes and transcripts in a single ordered map. We used the WG-RH panel to construct radiation hybrid maps of bovine Chromosomes (Chrs) 15 and 29 (BTA15 and BTA29), integrating microsatellites from published linkage maps with selected genes. The comprehensive map of BTA15 consists of 24 markers. 13 of which were placed in the framework map. Eleven molecular markers compose the comprehensive map of BTA29. seven of which were placed in the framework map. We identified the homologous regions between bovine Chr 15 (BTA15) and human Chrs 5 and 11 (HSA5 and HSA11), as well as between BTA29 and HSA11, the present study demonstrates that WG-RH mapping is an efficient method for integrating multiple genetic maps into one map and for incorporating monomorphic Type I loci into ordered maps for comparison between species.

Determination of acetaldehyde in fuel ethanol by high-performance liquid chromatography with electrochemical detection

The cyclic voltammetric behavior of acetaldehyde and the derivatized product with 2,4-dinitrophenylhydrazine (DNPHi) has been studied at a glassy carbon electrode. This study was used to optimize the best experimental conditions for its determination by high-performance liquid chromatographic (HPLC) separation coupled with electrochemical detection. The acetaldehyde-2,4-dinitrophenyl.hydrazone (ADNPH) was eluted and separated by a reversed-phase column, C-18, under isocratic conditions with the mobile phase containing a binary mixture of methanol/LiCl(aq) at a concentration of 1.0 x 10(-3) M (80:20 v/v) and a flow rate of 1.0 mL min(-1). The optimum condition for the electrochemical detection of ADNPH was +1.0 V vs. Ag/AgCl as a reference electrode. The proposed method was simple, rapid (analysis time 7 min) and sensitive (detection limit 3.80 mu g L-1) at a signal-to-noise ratio of 3:1. It was also highly selective and reproducible [standard deviation 8.2% +/- 0.36 (n = 5)]. The analytical curve of ADNPH was linear over the range of 3-300 mg L-1 per injection (20 mu L), and the analytical recovery was > 99%.

Electrochemical decomposition of cyanides on tin dioxide electrodes in alkaline media

The electrochemical oxidation of cyanide in alkaline media was studied at different pH levels on SnO2 doped with Sb supported on titanium, at 25 degrees C, the electrooxidation of CN- at constant current follows a first-order rate law with a half life of t(1/2) = 35 min on SnO2-SbOx electrodes and t(1/2) = 69 min on SnO2-SbOx-RuO2 electrodes, in K2SO4(aq), pH 12, the reaction rate increases with the applied current and tends to reach a plateau when j > 20 mA cm(-2), In the pH range 10-13.5 the reaction rate diminishes as pH is increased owing to an increasing competition between CN- and OH- ions for the electrode surface. Addition of chloride to the solution does not alter the rate law but increases the reaction rate, A mechanism is proposed to explain the observed behaviour.

Determination of aldehydes and ketones in fuel ethanol by high-performance liquid chromatography with electrochemical detection

A new methodology was developed for analysis of aldehydes and ketones in fuel ethanol by high-performance liquid chromatography (HPLC) coupled to electrochemical detection. The electrochemical oxidation of 5-hydroxymetkylfurfural, 2-furfuraldehyde, butyraldehyde, acetone and methyl ethyl ketone derivatized with 2,4-dinitrophenylhydrazine (DNPH) at glassy carbon electrode present a well defined wave at +0.94 V; +0.99 V; +1.29 V; +1.15 V and +1.18 V, respectively which are the basis for its determination on electrochemical defector. The carbonyl compounds derivatized were separated by a reverse-phase column under isocratic conditions with a mobile phase containing a binary mixture of methanol /LiClO4(aq) at a concentration of 1.0 x 10(-3) mol L-1 (80:20 v/v) and a flow-rate of 1.1 mL min(-1). The optimum potential for the electrochemical detection of aldehydes-DNPH and ketones-DNPH was +1.0 V vs. Ag/AgCl. The analytical curve of aldehydes-DNPH and ketones-DNPH presented linearity over the range 5.0 to 400.0 ng mL(-1), with detection limits of 1.7 to 2.0 ng mL(-1) and quantification limits from 5.0 to 6.2 ng mL(-1), using injection volume of 20 mu L. The proposed methodology was simple, low time-consuming (15 min/analysis) and presented analytical recovery higher than 95%.

Spectroscopy and electrochemical characterization of Langmuir-Blodgett and physical vapor thin films of 29-membered diazocrown ether 1 with two n-octyl substituents

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Trisomy X and 1 29 translocation in infertile heifers

In a group of 12 Pitangueiras breed heifers exhibiting a high return rate to service, three were noted to be carriers of the 1 29 translocation. One of the heifers exhibited trisomy for the X-chromosome in addition to the 1 29 translocation. The appearance and external genitalia of the 1 29 T; trisomy X heifer were not altered, although on rectal examination the internal genitalia, including the ovaries, appeared similar to that of a prepubertal heifer. © 1987.

Níveis críticos de fósforo no solo e nas folhas para a implantação de Eucalyptus grandis Hill ex Maiden, em quatro tipos de solos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Políticas sobre desarrollo institucional e innovación en biocombustibles en América Latina y el Caribe: Memoria del diálogo de políticas realizado en la CEPAL, Santiago, el 28 y 29 de marzo de 2011

Incluye Bibliografía

Discurso pronunciado por el Sr. Raúl Prebisch en la Cuarta Sesión de la Comisión Económica para América Latina, el 29 de mayo de 1951 en la ciudad de México, DF

Incluye Bibliografía

Acta resumida de la 70a sesión celebrada La Paz el miércoles 29 de mayo a las 11.45 horas

Incluye Bibliografía