986 resultados para 178-1097
Resumo:
Purpose. To investigate whether diurnal variation occurs in retinal thickness measures derived from spectral domain optical coherence tomography (SD-OCT). Methods. Twelve healthy adult subjects had retinal thickness measured with SD-OCT every 2 h over a 10 h period. At each measurement session, three average B-scan images were derived from a series of multiple B-scans (each from a 5 mm horizontal raster scan along the fovea, containing 1500 A-scans/B-scan) and analyzed to determine the thickness of the total retina, as well as the thickness of the outer retinal layers. Average thickness values were calculated at the foveal center, at the 0.5 mm diameter foveal region, and for the temporal parafovea (1.5 mm from foveal center) and nasal parafovea (1.5 mm from foveal center). Results. Total retinal thickness did not exhibit significant diurnal variation in any of the considered retinal regions (p > 0.05). Evidence of significant diurnal variation was found in the thickness of the outer retinal layers (p < 0.05), with the most prominent changes observed in the photoreceptor layers at the foveal center. The photoreceptor inner and outer segment layer thickness exhibited mean amplitude (peak to trough) of daily change of 7 ± 3 μm at the foveal center. The peak in thickness was typically observed at the third measurement session (mean measurement time, 13:06). Conclusions. The total retinal thickness measured with SD-OCT does not exhibit evidence of significant variation over the course of the day. However, small but significant diurnal variation occurs in the thickness of the foveal outer retinal layers.
Resumo:
BACKGROUND: The effect of extreme temperature has become an increasing public health concern. Evaluating the impact of ambient temperature on morbidity has received less attention than its impact on mortality. METHODS: We performed a systematic literature review and extracted quantitative estimates of the effects of hot temperatures on cardiorespiratory morbidity. There were too few studies on effects of cold temperatures to warrant a summary. Pooled estimates of effects of heat were calculated using a Bayesian hierarchical approach that allowed multiple results to be included from the same study, particularly results at different latitudes and with varying lagged effects. RESULTS: Twenty-one studies were included in the final meta-analysis. The pooled results suggest an increase of 3.2% (95% posterior interval = -3.2% to 10.1%) in respiratory morbidity with 1°C increase on hot days. No apparent association was observed for cardiovascular morbidity (-0.5% [-3.0% to 2.1%]). The length of lags had inconsistent effects on the risk of respiratory and cardiovascular morbidity, whereas latitude had little effect on either. CONCLUSIONS: The effects of temperature on cardiorespiratory morbidity seemed to be smaller and more variable than previous findings related to mortality.
Resumo:
The National Morbidity, Mortality, and Air Pollution Study (NMMAPS) was designed to examine the health effects of air pollution in the United States. The primary question was whether particulate matter was responsible for the associations between air pollution and daily mortality. Secondary questions concerned measurement error in air pollution and mortality displacement.1 Since then, NMMAPS has been used to answer many important questions in environmental epidemiology...
Resumo:
Australian women make decisions about return to paid work and care for their child within a policy environment that presents mixed messages about maternal employment and child care standards. Against this background an investigation of first-time mothers’ decision-making about workforce participation and child care was undertaken. Four women were studied from pregnancy through the first postnatal year using interview and diary methods. Inductive analyses identified three themes, all focused on dimensions of family security: financial security relating to family income, emotional security relating to child care quality, and pragmatic security relating to child care access. The current policy changes that aim to increase child care quality standards in Australia present a positive step toward alleviating family insecurities but are insufficient to alleviate the evidently high levels of tension between workforce participation and family life experienced by women transitioning back into the workforce in Australia.
Resumo:
Sugarcane bagasse pulp normally has high dewatering resistance and poor strength properties. In a previous study it was shown that highly depithed bagasse chemical pulp has excellent dewatering properties which may improve the production rate of bagasse based tissue, paper and board. In this study pulp properties of this highly depithed bagasse pulp were tested and compared favourably with regular depithed bagasse pulp. In addition to better dewatering rates, the pulp yield, tear strength and water retention value seemingly improved. Whilst a slight reduction in burst, tensile and short-span compression strengths occurred, they were still comparable to values reported for a regular bagasse pulp.
Resumo:
This paper reports an observation investigation of pedestrian crossing behaviors conducted at signalized crosswalks in urban areas in Singapore and Beijing on typical workdays. Each crosswalk was observed 3 times in different periods, i.e. normal hours, lunch hours, and rush hours. A total of 103,956 pedestrians were observed. The results showed that lane type, lane number, intersection type, and culture had significant effect on illegal pedestrian crossing in both cities; observation period had no significant effect on pedestrian violation in both cities; the violation rate in Singapore was lower than that in Beijing. However, observers reported that illegal crossing of vulnerable pedestrians, e.g. pregnant, the lame, old men and women, was more obvious in Singapore than that in Beijing. Evidence proved the hypothesis that the violations were related to pedestrians’ cognition of the definition of safety.
Resumo:
The criticality of service innovation in building and sustaining competitive advantage is gaining increasing recognition in the marketplace. Using empirical data from US and Australian project-oriented firms, the study uses a multi-staged multi-method research program to demonstrate how entrepreneurial service firms strategically combine resources at hand (bricolage) to innovate and stay ahead of rivals. The research shows that service entrepreneurship (SE) and bricolage influence two forms of service innovation (interactive and supportive), which in turn is associated with sustained competitive advantage (SCA). The results suggest that SE and bricolage indirectly relate to SCA through service innovation. The findings offer novel insights into how project-oriented service firms engage in innovation. In short, the findings encourage the “making do by combining resources at hand” as higher levels of entrepreneurial bricolage are associated with higher levels of interactive and supportive innovation enabling SCA, suggesting a new model.
Resumo:
Purpose - The purpose of this paper is to examine the possibility of an inverted U-shaped relationship between job demands and work engagement, and whether social support moderates this relationship. Design/methodology/approach – This study uses 307 technical and information technology (IT) managers who responded to an online survey. Multiple regressions are employed to examine linear and curvilinear relationship among variables. Findings – Overall, results support the applicability of the quadratic effect of job demands on employee engagement. However, only supervisor support, not colleague support, moderated the relationship between job demands and work engagement. Originality/value – The paper is the first to shed light on the quadratic effect of job demands on work engagement. The findings have noteworthy implications for managers to design optimal job demands that increase employee engagement.
Resumo:
Green building is building that the focus is to maximize the energy efficiency and resources used. While, retrofitting is the process of renovate or refurnish the existing building. Therefore by retrofit existing buildings that comply with green building requirement, it improves the environmental attributes of the buildings. In Malaysia, existing buildings and its communities contribute over 40% of green house gases to the environment. This paper describes a study that explores the potential to retrofit existing campus buildings that response to sustainable green building standard. A validation survey was carried out and the data collected was analysed using SPSS in order to confirm the significance of retrofitting Universiti Teknologi Malaysia (UTM) buildings toward green building initiative. The results show that all the twenty eight identified green elements recorded average index of higher than 3.5 which means that there is significant needs to retrofit the existing buildings to green buildings. This study concludes that it is urgently need for the campus to response to green building requirements in order to achieve higher energy effeciency and this can be done through effective etrofitting of existing buildings.