Performance of an Al-Si-graphite particle composite piston in a diesel engine

Al-Si-graphite particle composite alloy pistons containing different percentages of about 80 μm uncoated graphite particles were successfully cast by foundry techniques. Tests with a 5 hp single-cylinder diesel engine show that Al-Si-graphite particle composite pistons can withstand an endurance test of 500 h without any apparent deterioration and do not seize during the running-in period. The use of the Al-Si-3% graphite particle composite piston also results in (a) up to 3% reduction in the specific fuel consumption, (b) considerable reduction in the wear of all four piston rings, (c) a reduction in piston wear, (d) a 9% reduction in the frictional horsepower losses of the engine as determined by the motoring test and (e) a slight increase in the exhaust gas temperature. These reductions (a)–(d) appear to be due to increased lubrication from the graphite particles which are smeared on the bearing surface, the higher damping capacity of the composite pistons and the reduced coefficient of thermal expansion of the composite pistons. Preliminary results indicate that aluminum-graphite particle composite alloy is a promising material for automotive pistons.

Investigation of Deep Defects Due to -Particle Irradiation in n-Silicon

Electrical properties of deep defects induced in n-silicon by -particles of about 10 MeV energy at a dose of 1014 and 1015 cm-2 are studied by DLTS. The levels at Ec -0.18 eV, Ec -0.26 eV, and Ec -0.48 eV are identified as A center, V2 (=/-) and V2 (-/0) on the basis of activation energy, electron capture cross section, and annealing behavior. Two other irradiation related levels at Ec -0.28 eV and Ec -0.51 eV could not be related to any known center.

Analysis of the distribution of the number of bidders in construction contract auctions

The number of bidders, N, involved in a construction procurement auction is known to have an important effect on the value of the lowest bid and the mark up applied by bidders. In practice, for example, it is important for a bidder to have a good estimate of N when bidding for a current contract. One approach, instigated by Friedman in 1956, is to make such an estimate by statistical analysis and modelling. Since then, however, finding a suitable model for N has been an enduring problem for researchers and, despite intensive research activity in the subsequent thirty years little progress has been made - due principally to the absence of new ideas and perspectives. This paper resumes the debate by checking old assumptions, providing new evidence relating to concomitant variables and proposing a new model. In doing this and in order to assure universality, a novel approach is developed and tested by using a unique set of twelve construction tender databases from four continents. This shows the new model provides a significant advancement on previous versions. Several new research questions are also posed and other approaches identified for future study.

Preparation of cast aluminium alloy-mica particle composites

The optimum conditions for producing cast aluminium alloy-mica particle composites, by stirring mica particles (40 to 120 mgrm) in molten aluminium alloys (above their liquidus temperatures), followed by casting in permanent moulds, are described. Addition of magnesium either as pieces along with mica particles on the surface of the melts or as a previously added alloying element was found to be necessary to disperse appreciable quantities (1.5 to 2 wt.%) of mica particles in the melts and retain them as uniform dispersions in castings under the conditions of present investigation. These castings can be remelted and degassed with nitrogen at least once with the retention of about 80% mica particles in the castings. Electron probe micro-analysis of these cast composites showed that magnesium added to the surface of the melt along with mica has a tendency to segregate around the mica particles, apparently improving the dispersability for mica particles in liquid aluminium alloys. The mechanical properties of the aluminium alloy-mica particle composite decrease with an increase in mica content, however, even at 2.2% the composite has a tensile strength of 14.22 kg mm–2 with 1.1% elongation, a compression strength of 42.61 kg mm–2, and an impact strength of 0.30 kgm cm–2. The properties are adequate for certain bearing applications, and the aluminium-mica composite bearings were found to run under boundary lubrication, semi-dry and dry friction conditions whereas the matrix alloy (without mica) bearings seized or showed stick slip under the same conditions.

On the number of two-line and three-line latin rectangles - an alternative approach

The number of two-line and three-line Latin rectangles is obtained by recursive methods in a setting slightly more general than usually considered. We show how this leads to a generalisation which is proved elsewhere.

Mechanism of improvement in oil spreadability of aluminium alloy-graphite particle composites

The spreadability of SAE-30 oil on Al-12 Si base (LM-13) alloy containing dispersed graphite particles about 50 μm average size in its matrix is found to be greater than on either LM-13 with no graphite or brass. It is also found that the spreadability on LM-13 base alloys increase with increasing volume of graphite dispersion in the matrix of these alloys. Further increases in the spreadability of oil on machined LM-13-graphite particle composite test surfaces occur if these are rubbed initially against control discs of either LM-13 or grey cast iron. The formation of a triboinduced graphite-rich layer, confirmed by esca, appears to be responsible for the improved oil spreadability on the rubbed test surfaces of LM-13 base alloys as compared to the as-machined test surfaces prior to rubbing. The triboinduced layer of graphite is apparently responsible for the observed reduction in the friction, wear and seizing tendency of triboelements made from aluminium alloy-graphite particle composites.

QTL for root angle and number in a population developed from bread wheats (Triticum aestivum) with contrasting adaptation to water-limited environments

Root architecture traits in wheat are important in deep soil moisture acquisition and may be used to improve adaptation to water-limited environments. The genetic architecture of two root traits, seminal root angle and seminal root number, were investigated using a doubled haploid population derived from SeriM82 and Hartog. Multiple novel quantitative trait loci (QTL) were identified, each one having a modest effect. For seminal root angle, four QTL (-log10(P) >3) were identified on 2A, 3D, 6A and 6B, and two suggestive QTL (-log10(P) >2) on 5D and 6B. For root number, two QTL were identified on 4A and 6A with four suggestive QTL on 1B, 3A, 3B and 4A. QTL for root angle and root number did not co-locate. Transgressive segregation was found for both traits. Known major height and phenology loci appear to have little effect on root angle and number. Presence or absence of the T1BL.1RS translocation did not significantly influence root angle. Broad sense heritability (h 2) was estimated as 50 % for root angle and 31 % for root number. Root angle QTL were found to be segregating between wheat cultivars adapted to the target production region indicating potential to select for root angle in breeding programs. © 2013 Springer-Verlag Berlin Heidelberg.

The identification of teaching interactions used in one-to-one teaching of number in the early years of schooling

This research paper reports on phase one of an investigation of video recorded intensive one-to-one teaching interactions with 6–7-year-old students who were in their second year of schooling in Australia and identified by the their teacher as low attaining in early number. The two-phased study from which this paper emerges was originally conducted in 1998 as part of my Bachelor of Teaching Honours (Research) program at Southern Cross University Lismore, New South Wales. That study identified teaching interactions particularly suited to one-to-one teaching in the Maths Recovery Program, a program designed for these students who were at risk of failure in early number. Since that time a great deal has not changed with limited literature available that comprehensively reports on teaching interactions in intensive one-to-one settings. Revisiting the original study is considered timely given the increasing number of withdrawal and intensive programs now funded and adopted by schools and yet, rarely reported on in terms of the effectiveness of the teaching interactions that occur in such settings. This paper then presents a discussion of a preliminary series of teaching interactions that either positively and or negatively influence an intensive one-to-one teaching and learning setting

Documents regarding number of recipients and amount of cash distributed; Juedische Winterhilfe der Juedische Gemeinde; Berlin Jewish Institutions

"25851 Personen betreute die Juedische Winterhilfe mit Regelleistungen. 2300 Barbeihilfen im Werte von 54000 Mark wurden an Betreute gezahlt"

Circulating concentrations of leptin, ovarian follicle number, and oocyte lipid content and active mitochondria, in Zebu crossbred cows maintained on standard or improved nutrition

Zebu (Bos indicus) crossbred beef cows (Droughtmaster) were maintained long-term (16 months) on standard nutrition (SN) or improved nutrition (IN). Cows on IN had better body condition and greater (P<0.05) circulating concentrations of leptin than cows on SN (0.7±0.1n/ml and 1.7±0.1n/ml, respectively). There were no outstanding differences between SN and IN cows in basal number of ovarian follicles (≤4mm, 5-8mm, and≥9mm) and there were also no differences in number of oocytes recovered by oocyte pick-up. Cows on IN had a greater (P<0.05) number of total follicles after stimulation with FSH than cows on SN. Oocytes from cows on IN had greater (P<0.05) lipid content than cows on SN (-0.23±0.16 and 0.20±0.18 arbitrary units, respectively) and oocytes of the former cows also tended to have more active mitochondria, although this was not significant. Cows on IN showed a positive relationship (R2=0.31, P<0.05) between plasma leptin and oocyte lipid content. Lipids are utilized by oocytes during high energy consumptive processes including fertilization and early cleavage. The greater lipid content of oocytes from IN cows could therefore confer a reproductive advantage. The present study has shown relationships between nutrition, body condition, circulating leptin, and oocyte lipid content, but a clear cause-and-effect requires further investigation in the cow. © 2013 Elsevier B.V.

spin Precession of a Charged Particle in a Magnetic Field Including the Effects of General Relativity

Abstract is not available.

Studies on dielectric behavior of insulator-conductor composites

This paper describes the dielectric behavior of an insulator-conductor composite, namely, the wax-graphite composite. The variation of specific capacitance of these composites with parameters such as volume fraction and grain size of the conducting particles and temperature has been studied. These observed variations have been explained using the same model [C. Rajagopal and M. Satyam, J. Appl. Phys. 49, 5536 (1978)] which explains electrical conduction in composites. The specific capacitance of these materials appears to be governed by the contact capacitance between the conducting particles and the number of contacts each particle has with its neighbors. The variation of specific capacitance with temperature is attributed to the change in contact area.