Effect of butadiene/styrene ratio, block structure and carbon nanotube content on the mechanical and electrical properties of thermoplastic elastomers after UV ageing

Thermoplastic elastomers based on a triblock copolymer styrene-butadiene-styrene (SBS) with different butadiene/styrene ratios, block structure and carbon nanotube (CNT) content were submitted to accelerated weathering in a Xenontest set up, in order to evaluate their stability to UV ageing. It was concluded that ageing mainly depends on butadiene/styrene ratio and block structure, with radial block structures exhibiting a faster ageing than linear block structures. Moreover, the presence of carbon nanotubes in the SBS copolymer slows down the ageing of the copolymer. The evaluation of the influence of ageing on the mechanical and electrical properties demonstrates that the mechanical degradation is higher for the C401 sample, which is the SBS sample with the largest butadiene content and a radial block structure. On the other hand, a copolymer derivate from SBS, the styrene-ethylene/butadiene-styrene (SEBS) sample, retains a maximum deformation of ~1000% after 80 h of accelerated ageing. The hydrophobicity of the samples decreases with increasing ageing time, the effect being larger for the samples with higher butadiene content. It is also verified that cytotoxicity increases with increasing UV ageing with the exception of SEBS, which remains not cytotoxic up to 80 h of accelerated ageing time, demonstrating its potential for applications involving exposition to environmental conditions.

Physiological stress responses in the warm-water fish matrinxã (Brycon amazonicus ) subjected to a sudden cold shock

The present work evaluated several aspects of the generalized stress response [endocrine (cortisol), metabolic (glucose), hematologic (hematocrit and hemoglobin) and cellular (HSP70)] in the Amazonian warm-water fish matrinxã (Brycon amazonicus ) subjected to an acute cold shock. This species farming has been done in South America, and growth and feed conversion rates have been interesting. However, in subtropical areas of Brazil, where the water temperature can rapidly change, high rates of matrinxã mortality have been associated with abrupt decrease in the water temperature. Thus, we subjected matrinxã to a sudden cold shock by transferring the fish directly to tanks in which the water temperature was 10ºC below the initial conditions (cold shock from 28ºC to 18ºC). After 1h the fish were returned to the original tanks (28ºC). The handling associated with tank transfer was also imposed on control groups (not exposed to cold shock). While exposure to cold shock did not alter the measured physiological conditions within 1h, fish returned to the ambient condition (water at 28º C) significantly increased plasma cortisol and glucose levels. Exposure to cold shock and return to the warm water did not affect HSP70 levels. The increased plasma cortisol and glucose levels after returning the fish to warm water suggest that matrinxã requires cortisol and glucose for adaptation to increased temperature.

Abstract computation in schizophrenia detection through artificial neural network based systems

Schizophrenia stands for a long-lasting state of mental uncertainty that may bring to an end the relation among behavior, thought, and emotion; that is, it may lead to unreliable perception, not suitable actions and feelings, and a sense of mental fragmentation. Indeed, its diagnosis is done over a large period of time; continuos signs of the disturbance persist for at least 6 (six) months. Once detected, the psychiatrist diagnosis is made through the clinical interview and a series of psychic tests, addressed mainly to avoid the diagnosis of other mental states or diseases. Undeniably, the main problem with identifying schizophrenia is the difficulty to distinguish its symptoms from those associated to different untidiness or roles. Therefore, this work will focus on the development of a diagnostic support system, in terms of its knowledge representation and reasoning procedures, based on a blended of Logic Programming and Artificial Neural Networks approaches to computing, taking advantage of a novel approach to knowledge representation and reasoning, which aims to solve the problems associated in the handling (i.e., to stand for and reason) of defective information.

Thrombophilia screening: An artificial neural network approach

Thrombotic disorders have severe consequences for the patients and for the society in general, being one of the main causes of death. These facts reveal that it is extremely important to be preventive; being aware of how probable is to have that kind of syndrome. Indeed, this work will focus on the development of a decision support system that will cater for an individual risk evaluation with respect to the surge of thrombotic complaints. The Knowledge Representation and Reasoning procedures used will be based on an extension to the Logic Programming language, allowing the handling of incomplete and/or default data. The computational framework in place will be centered on Artificial Neural Networks.

Álbuns narrativos e aprendizagens no pré-escolar. Um estudo de caso

Tese de Doutoramento em Estudos da Criança (área de especialização em Literatura para a Infância).

Antibacterial properties of fibrous stents coated with silver oxide nanocoatings

Stents are rigid and perforated tubular structures, which are inserted into blood vessels in order to prevent or inhibit the constriction of blood flow, restoring the normal blood flow, when blood vessels are clogged, being used in 70% of angioplasties. These medical devices assume great importance in the treatment of cardiovascular diseases (CVD) which are the leading cause of death worldwide. In the European Union CVD account for 40% of deaths and assume an estimated annual cost of 196 billion euros[1]. Stents must possess certain requirements, in order to, adequately, perform its function, such as biocompatibility (so that its use does not c ause damage on the health of its user), mechanical strength, radiopacity (so that it is easy to view), longitudinal flexibility, ease of handling, corrosion resistance and having high strength and high radial expansion ability to recover. Stents can be made of different materials, but metals, particularly stainless steel, are the most common. However, metallic stents present several dRawbacks such as corrosion and restenosis, leading to health complications for the patient, or even death. In order to minimize these disadvantages, new materials, like fibrous materials, have been used [2]. Monofilaments present high potential for stents development because, in addition to its biocompatibility, these materials allow the application of various surface treatments, such as antibacterial coatings. Furthermore, monofilament exhibit excellent mechanical properties, like greater stiffness and good results when subjected to compression, tensile and bending forces, since these forces will be directly supported by the monofilament [3]. To minimize the reaction of the human body and Limit the adhesion of microorganisms to the stent surface, some coatings have been developed, including the use of novel metals with antimicrobial properties, like silver. The main objective of this study was the development of fibrous stents, incorporation of silver oxide nanocoating. For the development of the stent, polyester monofilaments with 0.27mm of diameter were used in braiding technology, with a mandrel diameter of 6mm and a braiding angle of 35⁰. The mechanical behaviour of the stent were evaluated by mechanical testing under longitudinal and radial compression, bending. The results of compressive strength tests are according with value from literature: 1.13 to 2.9 N for radial compression and 0. 16-5.28N to longitudinal compression. From literature is also possible to verify that stents must present 75% of unchanged diameter during the bending test and must possess a porosity between 70% and 80% [4]. The produced polyester stent presents values of 1.29N for radial compression, 0.23N for longitudinal compression, 80% of porosity and 85.5% of unchanged diameter, during bending tests. For the antibacterial functionalization, silver oxide nanocoatings were prepared, through reactive magnetron g, with an Ag target in an Ar +O2 atmosphere. In order to evaluate the nanostructure and morphology of the coatings, d ifferent technique s like X-ray diffraction (XRD), scanning electron microscopy (SEM) and and X- ray photoelectron spectroscopy (XPS were used. From the analyses of XRD it is possible to verify that the peaks corresponds to planes of Ag2 O and MATERIAIS 2015 Porto, 21-23 June, 2015 characterize a cubic phase. The presence of Ag2 O is corroborated by XPS spectrum, where it is possible to observe silver, not only, in oxide state, but a lso in mettalic state, and it is possible to verify the presence of silver clusters, confirmed by SEM analysis. Films’ roughness and topography, parameters influencing the wettability of the surface and microorganism adhesion, were measured by Atomic Force Microscopy (AFM), and it was observed that the roughness is very low (under 10 nm). Coatings’ hydrophobicity and surface tension parameters were determined by contact angle measurement, and it was verified the hydrophobic behavior of the coatings. For antibacterial tests were used Staphylococcus epidermidis strain (IE186) and Staphylococcus aureus(ATCC 6538), and halo inhibition zone tests were realized. Ag+release rates were studied by means of inductively coupled plasma mass spectrometry (ICP -MS). The obtained results suggest that silver oxide coatings do not modify significantly surface properties of the substrate, like hydrophobicity and roughness, and present antimicrobial properties for both bacteria used.

Honours students: good marks and what else?

Currently in Portugal academic excellence in higher education is given recognition through merit prizes. Because honours students can be seen as having the potential to achieve imporant levels of professional expertise, especially if they have some personal skills, it is important to know not only the marks of the students but also the personal characteristics that contribute to academic success and which may also be important for career success. Some theoretical models of giftedness and excellence agree with this idea and this work considers the latest contribution of Renzulli (2005) where it is pointed out that excellent achievements result from the combination of motivational, intellectual and creative factors as well as from co-cognitive factors which are most associated with personality functioning in a particular context. The main purpose of this paper is to analyze how honours students differ from their classmates in various psychological dimensions: Cognition-creativity, Motivation and Learning Strategies, Persistence, Social Interaction, Drive for Excellence and Cultural Interest. These dimensions were measured by the Inventory of Psychological Characteristics Associated with Academic Performance (ICPADA), which was constructed taking into consideration the previous study of Scaeger et al. (2012). The sample included 914 Portuguese higher educatoin students from a first cycle degree in the Bologna process. Participants were selected from three different fields of study: Social and Human Sciences; Science and Technology; Arts and Humanities. The data collected through the administration of the ICPADA was presented, and the results revealed a higher self-perception by honours students in all areas analyzed, with the exception of the dimension of social interaction. In addition an interaction effect was revealed for persistence, social interaction, and cultural interest. The field of study and whether the participants were honours students or not were also taken into account. Some implications for future studies are presented here along with possible interventions for honours students.

The trading relationship between the EU and Mercosur: the mediatory role of Brazil

Dissertação de mestrado em European and Transglobal Business Law

Mycotoxin contamination of Maize and Guinea corn from markets in Plateau State, Nigeria

Maize (Zea mays) and guinea corn (Sorghum bicolor) are major food items in Plateau state, Nigeria. A multistage sampling technique was used to select the markets and store/warehouses used for this study; sample collection employed a simple random sampling method from different sampling points within designated areas. A total of 18 representative samples were collected and analyzed for the following mycotoxins: aflatoxins (Aflatoxin B1 - AFB1, Aflatoxin B2 - AFB2, Aflatoxin G1 - AFG1 and Aflatoxin G2 - AFG2), fumonisins (Fumonisin B1 - FB1 and Fumonisin B2 - FB2 ) and cyclopiazonic acid (CPA). Out of 12 samples analyzed for Aflatoxins, AFB1 was detected in 5, AFB2 in 1, AFG1 in 1 and AFG2 in 6 samples respectively. The highest concentration of AFB1 and AFG2 were found in maize samples from Pankshin market. Only maize samples from Mangu market were contaminated with AFB2 and also harboured the lowest concentration of AFG2. AFG1 contamination occurred in only guinea corn from Shendam market. and FB1 was detected in all 18 samples analyzed. The mycotoxin CPA was not detected in any of the samples. Aflatoxins levels in analyzed samples were regarded as safe based on Nigerian and European Union maximum permissible levels of 4g/kg. With the exception of two samples, FB1 levels in analyzed maize samples were within European Union maximum permissible levels of 1,000 to 3000g/kg. The health and food safety implications of these results for the human and animal population are further discussed.

Review of robotic technology for keyhole transcranial stereotactic neurosurgery

The research of stereotactic apparatus to guide surgical devices began in 1908, yet a major part of today's stereotactic neurosurgeries still rely on stereotactic frames developed almost half a century ago. Robots excel at handling spatial information, and are, thus, obvious candidates in the guidance of instrumentation along precisely planned trajectories. In this review, we introduce the concept of stereotaxy and describe a standard stereotactic neurosurgery. Neurosurgeons' expectations and demands regarding the role of robots as assistive tools are also addressed. We list the most successful robotic systems developed specifically for or capable of executing stereotactic neurosurgery. A critical review is presented for each robotic system, emphasizing the differences between them and detailing positive features and drawbacks. An analysis of the listed robotic system features is also undertaken, in the context of robotic application in stereotactic neurosurgery. Finally, we discuss the current perspective, and future directions of a robotic technology in this field. All robotic systems follow a very similar and structured workflow despite the technical differences that set them apart. No system unequivocally stands out as an absolute best. The trend of technological progress is pointing toward the development of miniaturized cost-effective solutions with more intuitive interfaces.

Performance assessment of electrically small antennas for implantable microsystems with wireless power and communications

Dissertação de mestrado integrado em Engenharia Biomédica (área de especialização em Eletrónica Médica)

Reengenharia do sistema de armazenamento duma empresa do setor da metalomecânica

Dissertação de mestrado em Engenharia Industrial

Predation of bat (Molossus molossus: Molossidae) by the centipede Scolopendra viridicornis (Scolopendridae) in Southern Amazonia

Centipedes are opportunistic carnivore predators, and large species can feed on a wide variety of vertebrates, including bats. The aim of this study was to report the third record of bat predation by centipedes worldwide, the first record in the Amazon region, while covering aspects of foraging, capture and handling of prey. We observed the occurence in a fortuitous encounter at Cristalino State Park, located in the Amazon region of the state of Mato Grosso, Brazil. The attack took place in a small wooden structure, at about three meters from the floor, and was observed for 20 minutes. During the observation, the centipede stung the neck and abdominal region of the bat several times, grabbing the prey with its 15 pairs of front legs while hanging from the ceiling with its hind legs. This type of observation suggests that vertebrates can be important preys for invertebrates such as giant centipedes, both for its nutritional composition and for the amount of energy available in a single prey.

Máquina-ferramenta CNC para gravação: desenvolvimento de protótipo de baixo-custo

Dissertação de mestrado em Engenharia Mecatrónica

Processamento e caracterização de compósitos de Ti-HAP para aplicações biomédicas

Dissertação de mestrado integrado em Engenharia de Materiais