977 resultados para Pre-strain
Resumo:
Biochemical composition of the muscle of juveniles belonging to 18 different species of freshwater fishes showed that the protein percentage in juveniles was higher than the adults. The fat, on the other hand, was much lower. This suggests that the body fat increases with the onset of maturity. No clear inverse relationship was found between fat and protein in juveniles. Moisture percentage was very high in juveniles. This was probably because of low fat content. In most species the sum of fat and water contents (F + W) was found to be constant. The percentages of ash, calcium and phosphorus were higher in juveniles than those of adults. Dry matter percentage varied inversely with the moisture and in most species carbohydrate was generally low. In juveniles although the calorific value of protein-fraction was high the total calorific value was lower than the adults.
Resumo:
Comparative study on growth of fry in nursery system of Genetically Improved Farmed Tilapia (GIFT) and Existing strain of Nile tilapia (Oreochromis niloticus) was performed. The trials were conducted in a series of hapa for two months. The initial mean weight of GIFT and Existing strains of tilapia were 1.03 and 1.12g, respectively and the stocking density for both the strains was maintained at 150/m³. Fishes were fed with supplementary feed 31.29% of protein level. After two months the final cumulative mean weight of GIFT and Existing strain were observed to be 8.38 and 5.51g, respectively. The net gain for weight of GIFT and existing strain were estimated to be 666% and 368% and the mean survival were 95.75% and 81.25%, respectively. The GIFT strain showed significantly (P<0.05) higher net gain in growth in weight and also higher (P<0.01) survival than that of existing strain.
Resumo:
A method is described for measuring the mechanical properties of polymers in compression at strain rates in the range approximately 300-500 s-1. A gravity-driven pendulum is used to load a specimen on the end of an instrumented Hopkinson output bar and the results are processed by a microcomputer. Stress-strain curves up to high strains are presented for polycarbonate, polyethersulphone and high density polyethylene over a range of temperatures. The value of yield stress, for all three polymers, was found to vary linearly with log (strain rate) at strain rates up to 500 s-1. © 1985.
Resumo:
An optical fiber strain sensing technique, based on Brillouin Optical Time Domain Reflectometry (BOTDR), was used to obtain the full deformation profile of a secant pile wall during construction of an adjacent basement in London. Details of the installation of sensors as well as data processing are described. By installing optical fiber down opposite sides of the pile, the distributed strain profiles obtained can be used to give both the axial and lateral movements along the pile. Measurements obtained from the BOTDR were found in good agreement with inclinometer data from the adjacent piles. The relative merits of the two different techniques are discussed. © 2007 ASCE.
Resumo:
The paper describes the use of optical fiber Brillouin Optical Time Domain Reflectometry (BOTDR) to monitor the strain distribution in an existing tunnel while a twin tunnel was bored at close-proximity. The twin circular bored tunnels between Serangoon and Bartley stations on the new Circle Line Stage 3 subway in Singapore were constructed at close-proximity to avoid underpinning the foundations of adjacent buildings. The minimum clear separation of the two tunnels is 2.3m (0.4 times the tunnel diameter). The Outer Tunnel was constructed first, followed by the Inner Tunnel, with the earth-pressure balance tunnel boring machines maintained at a minimum of 100m apart. In this trial application of BOTDR, the strain distribution along the Outer Tunnel was measured, in order to monitor its deformation due to the boring of the Inner Tunnel at close-proximity. The aim of the trial application was to determine the practicality of this monitoring method for future use in 'live' tunnels. This paper compares the measurements obtained from optical fiber BOTDR with conventional methods of tunnel monitoring and describes preliminary installation and workmanship guidelines derived from lessons learnt during this trial. © 2007 ASCE.
Resumo:
A packaging technique suited to applying MEMS strain sensors realized on a silicon chip to a steel flat surface is described. The method is based on adhesive bonding of the silicon chip rear surface on steel using two types of glue normally used for standard piezoresistive strain sensors (Mbond200/ 600), using direct wire bonding of the chip to a Printed Circuit Board, also fixed on steel. In order to protect the sensor from the external environment, and to improve the MEMS performance, the silicon chip is encapsulated with a metal cap hermetically sealed-off under vacuum condition with a vacuum adhesive in which the bonding wires are also protected from possible damage. In order to evaluate the mechanical coupling of the silicon chip with the bar and thestress transfer extent to the silicon surface, commercial strain sensors have been applied on the chip glued on a steel bar in alaboratory setup able to generate strain by inflection, yielding a stress transfer around 70% from steel to silicon. © 2008 IEEE.
Resumo:
A study on the breeding biology of the GIFT strain of Nile tilapia, Oreochromis niloticus, was conducted for a period of five months. The sex ratio of the parent individuals was optimized for performance in spawn production, where the best results were obtained with a sex ratio of female to male of 4:1 compared to those of 3:1 and 2:1. The diameter of eggs obtained from the GIFT stock had major and minor axes of 2.19±0.09 and 1.72±0.07 mm, respectively, with no significant differences between the treatments. The average number of eggs produced was 392±22 per female, with fertilization and hatching rates ranging between 94-96% and 85-88%, respectively. No significant variation was observed between the treatments. Breeding frequencies per female in the three treatment groups ranged between 10-40 days and the highest value was obtained at a female to male sex ratio of 4: l. In an other experiment, l7 aMethyltestosterone (MT) was applied orally to the fry at their first feeding stage with treatments- 1, 2, 3 and 4 at the dosage of 100, 80, 60 and 40 mg/kg feed respectively, for the period of 28 days. The mean percentage of males obtained in treatments, 1, 2, 3 and 4 were 98, 97, 95 and 68, respectively. Treatments-1, 2 and 3 did not differ significantly (P>0.05) from each other but treatment 4 showed significant variation (P<0.05) from other treatments. The results showed that MT-100, 80 and 60 mg/kg feed administered for 28 days produced close to cent percent male population of the GIFT strains in aquaria.
Resumo:
Effect of water depth on recovery rate, growth performance and fish yield of GIFT in the rice-fish production systems was studies in experimental plots of 123 m2 with a pond refuge of I meter deep which covered 10% of the total land area. Mortality rate of fish was very low ranging from 0.81-1.63%. However, at harvest, recovery rate ranged from 76.69-82.93% with the highest recovery at 11-15 em of water depth. Significantly the highest absolute growth (99.97) and specific growth rate (2.42%) were found at 21-25 cm water depth. The same treatment also produced significantly higher fish yield (909.76 kg/ha) although statistically similar to the fish yield (862.60 kg/ha) obtained at ll-15 em of water depth. Results also suggested that higher water depth can produce bigger fish but no significant effects of water depth was found on fish yield in the treatments 11-15 cm and 21-25 cm water depths of this experiment.
Resumo:
The aim of this study was to evaluate growth performance of the GIFT (Genetically Improved Farmed Tilapia) strain after one generation of selection for increased body weight at Bangladesh Fisheries Research Institute. Founder stock comprised of 30 families having 300 individuals of the GIFT strain were introduced from Malaysia through \X!orldFish Center in March 2005. The founder stock was reared in 100 m2 hapa for three months and then individually tagged using Passive Integrated Transponder (PIT) at the weight between 30 and 40 g. After tagging, all the fish were communally grown out in pond until harvest. Breeding value for body weight was estimated using SAS and ASREML ranging from 4.17 to 9.70 g for males and 4.24 to 9.36 g for females. The best 40 females and 40 males from the founder stock were then selected to produce progeny of the first generation (F-1). From each family 25 female and 25 male fingerlings were sampled and tagged using PIT. A total of 2,000 tagged fish from 40 families were stocked in a pond (1000 m2) for a continuation of the selection program. In addition, surplus fish after tagging were also reared together with progeny of the founder stock in cistern ecology for growth evaluation. The mean weight of the F-1 generation of GIFT fish was 7.2% greater than that of the founder population (non selected population).
Resumo:
Phenoloxidase in shrimp and lobster is shown to exist in latent form which could be activated by trypsin and by an endogenous enzyme with tryptic activity. On Sephadex G-100 gel, three isoenzymes, differing in molecular weights, were isolated from naturally activated lobster shell extracts. Mechanism of activation of ptephenoloxidase involving limited proteolysis by the activating enzyme to form isoenzymes has been proposed.
Resumo:
An outline is given of a sampling plan for prepacked fish products based on the net weight of the container, which may be used to make the inspection of fish and fish products easier and more effective.
Resumo:
Perna viridis exposed to different concentrations of copper and zinc for varying periods and then the rate of filtration estimated under metal free culture conditions. The concentrations under which the animals were maintained before the experiments were 0.025 to 0.150 p.p.m. of zinc and 0.005 to 0.08 p.p.m. of copper.